Bosch DS940Q Bedienungsanleitung

DS940Q

Passive Infrared Detector

Installation Instructions

1.0 Description

The DS940Q is a high performance Passive Infrared (PIR) Motion Detector which uses advanced signal processing to provide outstanding

catch performance and unsurpassed false alarm immunity. It is designed to detect movement in the interior of a structure by sensing the

Infrared energy emitted from the human body as it moves across the detector’s field of view. When motion is detected, the detector sends an

alarm signal to the Control Panel.

2.0 Specifications

•Input Power: 9-15 volts DC

•Current Draw: 12 mA @ 12 VDC standby and alarm

•Standby Power: No internal standby power. For UL Listed Product

Installations, 4 hours (48 mA-h) standby power

must be provided.

•Relay Form “A” Normally Closed (NC) contact set rated

for 125 mA @ 28 volts maximum DC or 18 volts

maximum AC for resistive loads.

•Tamper: Normally Closed (with cover on). Contacts rated

at 28 VDC, 125 mA max. Connect tamper circuit

to a 24-hour protection circuit.

•Temperature: -20°F to +120°F (-29°C to +49°C). For UL Listed

Product Installations, the temperature range is

+32°F to +120°F (0°C to +49°C).

•Humidity: 0 - 95% non-condensing.

•Dimensions: 3.75 in. x 2.25 in. x 1.5 in. (HxWxD)

(9.5 cm x 5.7 cm x 3.8 cm)

•Options: B335 Swivel Mount Bracket. Use of this bracket

may decrease the PIR range and increase dead

zones.

•Reading Bosch Security Systems, Inc. Product Date Codes

For Product Date Code information, refer to the Bosch Security

Systems, Inc. Web site at: http://www.boschsecurity.com/

datecodes/

3.0 Installation

3.1 Remove the cover using a

small flat-blade screwdriver.

3.2 Press the vertical adjust tab

toward the side of the case and

lift out the board.

3.4 Position detector at correct height.

3.3 Select a mounting location.

Mount the sensor where an intruder

will most likely cross through the

coveragepattern.

LED

7.5-9ft

OFF

Bottom of Detector

Insert screwdriver here or here

3.3 Avoid:

7.5-9 ft.

(2.3- 2.7 m)

Mount the detector 7.5 - 9 feet

(2.3 - 2.7 meters) above the floor

Moving Objects

Pets

Heat

Sources

Windows

and

Uninsulated

Walls

Air

Conditioning

Outlets

Direct Hot or

Cold

Drafts

Mounting

Outdoors

Direct Sunlight

2/11

DS940Q Installation Instructions

P/N: F01U035308-07 Page 2

130 Perinton Parkway, Fairport, New York 14450

www.boschsecurity.com

3.8 Wire the Detector.

3.7 Install the board into the case. Be

sure the vertical adjust tab aligns with

the correct mounting height.

3.9 Select LED Operation 3.10 If look-down is desired, peel

away the look-down mask. Do

not remove the clear plastic

lens.

5.0 Coverage Patterns

4.0 Walk test at the time of installation

and annually thereafter.

LED

9-15

VDC

040

012

Meters

Feet

11 12-

22 23-

33 34-

44 45-

55 56-

66 67-

10 20 30

0040

012

Meters

Feet1-

11 12-

22 23-

33 34-

44 45-

55 56-

66 67-

Look

Down

7.5

LED

7.5-9ft

OFF ON

OFF

LED

7.5-9ft

OFF

Peel away

the mask

3.6 Mount the unit, using the appropriate

mounting holes.

Thinwall knockouts

for wiring

Corner Mount

Surface

Mount Remove

Areas

if using the

B335 Bracket

Don't overtighten the mounting screws

Cover may not attach correctly

Note: To avoid

possible

circuit board

damage, use

only the

mounting

hardware

provided in

the

appropriate

punch-out

mounting

holes.

This detector contains an environmental

stabilization circuit which requires

approximately 2 minutes after initial

power-up to warm up. During this time

the detector will not respond to any

movement.

Please wait 2 minutes after initial power-up to

perform any walk tests.

Although generally not required, if

masking is desired, the lens diagram

shows the appropriate areas to be

masked (see shaded area on the

DS940Q lens diagram). Use an

opaque material (such as, electrical

tape) to mask the desired areas. DS940Q Lens

(inside view)

1234567891011

12 22

23 33

34 44

45 55

56 66

67 77

LED

7.5-9ft

OFF

7.5-9 ft = 2.3-2.7 m

7.5-9ft

Inhaltsverzeichnis

Andere Bosch Sicherheitssensor Handbücher

Bosch

Bosch DS915 Bedienungsanleitung

Bosch

Bosch DS820i Series Bedienungsanleitung

Bosch

Bosch 200 C Bedienungsanleitung

Bosch

Bosch ISC-SM-90 Bedienungsanleitung

Bosch

Bosch DS935Z Bedienungsanleitung

Bosch

Bosch F220 Bedienungsanleitung

Bosch

Bosch ISN?SM?80 Bedienungsanleitung

Bosch

Bosch PMD 7 Bedienungsanleitung

Bosch

Bosch ISC-BDL2-WP12 Bedienungsanleitung

Bosch

Bosch DS935LSN Bedienungsanleitung

Bosch

Bosch ISM-BLD1 Bedienungsanleitung

Bosch

Bosch UniversalDetect Bedienungsanleitung

Bosch

Bosch FCP-320 Series Bedienungsanleitung

Bosch

Bosch TriTech DS950 Series Bedienungsanleitung

Bosch

Bosch ISC-BPR2-WP12 Bedienungsanleitung

Bosch

Bosch AP1-P Bedienungsanleitung

Bosch

Bosch DS9370 TriTech Bedienungsanleitung

Bosch

Bosch DS9370E Bedienungsanleitung

Bosch

Bosch RF920 Bedienungsanleitung

Bosch

Bosch DS939 Bedienungsanleitung

Bosch

Bosch Blue Line Q1 Bedienungsanleitung

Bosch

Bosch MX934i Bedienungsanleitung

Bosch

Bosch TriTech+ ISC-PDL1-WA18G Bedienungsanleitung

Bosch

Bosch D-tect 150 Professional Bedienungsanleitung

Beliebte Sicherheitssensor Handbücher anderer Marken

THORLABS

THORLABS PDA10JT Bedienungsanleitung

Waeco

Waeco UV-DETECT Bedienungsanleitung

Intermatic

Intermatic IOS-DSIMF Bedienungsanleitung

urmet domus

urmet domus 1083 Bedienungsanleitung

Siemens

Siemens AZL66 Series Bedienungsanleitung

BTI

BTI Profiline Multi Finder Bedienungsanleitung

Challenger

Challenger SL01 Bedienungsanleitung

DMP Electronics

DMP Electronics 1122INT Bedienungsanleitung

Rielta

Rielta Ladoga MK-RK Bedienungsanleitung

Mirion Technologies

Mirion Technologies ACCURAD PRD Bedienungsanleitung

DBI SALA

DBI SALA EZ Stop Bedienerhandbuch

Lamptime

Lamptime ST05C Bedienungsanleitung

Ubiquiti

Ubiquiti MFI-MSC Bedienungsanleitung

Subsite

Subsite 910R Montageanleitung

Satel

Satel OPAL Pro Bedienungsanleitung

Aleph

Aleph XC-1XTEU Bedienungsanleitung

Pima

Pima LARIS QUAD Bedienungsanleitung

Solinst

Solinst 301 Bedienungsanleitung