Canon EF 70-200mm Bedienungsanleitung

EF70-200mm f/4L IS II USM

Instructions

ENG

ENG-1

Thank you for purchasing a Canon product.

Canon’s EF70-200mm f/4L IS II USM is a

telephoto lens for use with EOS cameras.

 “IS” stands for Image Stabilizer.

 “USM” stands for Ultrasonic Motor.

Camera Firmware

Please use the latest version of rmware with the camera

in use. For details on whether the rmware is the latest

version or not, and for details on updating the rmware,

please check the Canon website.

Conventions used in this instruction

Warning to prevent lens or camera malfunction

or damage.

Supplementary notes on using the lens and

taking pictures.

ENG-2

Precautions to ensure that the camera is used

safely. Read these precautions thoroughly. Make

sure all details are observed in order to prevent

risks and injury to the user and other people.

Warning Details pertaining to risks that may

result in death or serious injury.

 Do not look at the sun or a bright light source

through the lens or single-lens reflex camera.

Doing so could result in loss of vision. Looking at the

sun directly through the lens is especially hazardous.

 Whether it is attached to the camera or not, do

not leave the lens under the sun without the

lens cap attached. This is to prevent the lens from

concentrating the sun’s rays, which could cause a re.

Caution Details pertaining to risks that may

result in injury.

 Do not leave the camera in locations subject to

high or low temperatures. This may result in the

camera becoming excessively hot or cold, which may

cause burns or other injuries when touched.

Caution Details pertaining to risks that may

result in damage to property.

 Do not leave the lens in excessive heat such as in a

car in direct sunlight. High temperatures can cause the

lens to malfunction.

Safety Precautions

ENG-3

Handling Precautions

 If the lens is taken from a cold environment into a

warm one, condensation may develop on the lens

surface and internal parts. To prevent condensation in

this case, rst put the lens into an airtight plastic bag

before taking it from a cold to warm environment. Then

take out the lens after it has warmed gradually. Do the

same when taking the lens from a warm environment

into a cold one.

 Please also read any lens related handling precautions

listed in your camera’s instruction manual.

General Precautions

ENG-4

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

Do not make any changes or modications to the equipment

unless otherwise specied in the instructions. If such

changes or modications should be made, you could be

required to stop operation of the equipment.

This equipment has been tested and found to comply with

the limits for a class B digital device, pursuant to part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications.

However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference

by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and

receiver.

• Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician

for help.

CAN ICES-3 (B) / NMB-3 (B)

ENG-5

Filter mounting thread

(→ 16)

Focusing ring (→ 7)

Focus mode switch (→ 7)

Zoom position index (→ 8)

Image stabilizer switch (→ 10)

Hood mount (→ 14)

Image stabilizer mode selector switch

(→ 10)

Focusing distance range selector switch (→ 7)

Distance scale (→ 9)

Zoom ring (→ 8)

Rubber ring (→ 6)

Contacts (→ 6)

Lens mount index (→ 6)

Tripod mounting location (→ 13)

 For detailed information, reference page numbers are provided in parentheses (→ **).

Nomenclature

ENG-6

See your camera’s instructions for details on

mounting and detaching the lens.

 After detaching the lens, place the lens with

the rear end up to prevent the lens surface and

contacts from getting scratched.

 Contacts that are scratched, soiled, or have

ngerprints on them may result in faulty

connections or corrosion, which may lead to

malfunctions. If the contacts get soiled, clean

them with a soft cloth.

 Attach the lens cap and dust cap when

disconnecting the lens. When attaching the

dust cap, align the lens mount index with the 

index of the dust cap and rotate in a clockwise

direction as shown in the illustration. Follow the

reverse procedure to detach it.

The lens mount has a rubber ring for enhanced

dust- and water-resistance. The rubber ring may

cause slight abrasions around the camera’s lens

mount, but this will not cause any problems. If the

rubber ring becomes worn, it is replaceable by a

Canon Service Center at a cost.

1. Mounting and Detaching the Lens

ENG-7

To shoot in autofocus (AF) mode, set the focus

mode switch to AF.

To use only manual focusing (MF), set the focus

mode switch to MF, and focus by turning the

focusing ring.

The focusing ring always works, regardless of

the focus mode.

When AF operation is set to [ONE SHOT], manual

focus is possible after autofocusing has been

completed by continuing to press the shutter button

halfway (Full-time manual focus).

2. Setting the Focus Mode 3. Switching the Focusing

Distance Range

You can set the focusing distance range with a

switch. By setting a suitable focusing distance

range, the actual autofocusing time will be

shorter.

Ranges

1. FULL (1 m/3.28 ft. - ∞)

2. 3 m/9.84 ft. - ∞

ENG-8

To zoom, turn the lens’ zoom ring.

Be sure to nish zooming before focusing. Zooming

after focusing can affect the focus.

4. Zooming

ENG-9

Distance index

Innity compensation mark

Distance scale

To compensate for shifting of the innity focus

point that results from changes in temperature,

there is a margin at the innity (∞) position.

The innity position at normal temperature is the

point at which the vertical line of the distance

scale L mark is aligned with the distance index.

For accurate manual focusing of subjects at innity,

look through the viewnder or look at the magnied

image* on the LCD screen while rotating the

focusing ring.

* For cameras with Live View shooting capability.

Infrared IndexDistance scale

The infrared index corrects the focus setting when

using monochrome infrared lm. Focus on the subject

manually, then adjust the distance scale indicated by

the distance index by moving the focusing ring to the

corresponding infrared index mark before shooting.

Some EOS cameras cannot use infrared lm. See

the instructions for your EOS camera.

 The infrared index position is based on a

wavelength of 800 nm.

 The compensation amount differs depending

on the focal length (large at the wide end, small

at the telephoto end). Use the 100 or 70 (mm)

infrared index position as a guide when setting

the compensation amount manually.

 Be sure to observe the manufacturer’s

instructions when using infrared lm.

 Use a red lter when you take the picture.

Innity Compensation Mark

6. Infrared Index

Inhaltsverzeichnis

Andere Canon Kameraobjektiv Handbücher

Canon

Canon EF-S 18-13Smm f Bedienungsanleitung

Canon

Canon ULTRASONIC EF85MM F Bedienungsanleitung

Canon

Canon KH20x6.4 KRS Bedienungsanleitung

Canon

Canon EF16-35mm f/4l IS USM Bedienungsanleitung

Canon

Canon EF35mm f/1.4L II USM Bedienungsanleitung

Canon

Canon EF100 Bedienungsanleitung

Canon

Canon EF-S60mm f/2.8 MACRO USM Bedienungsanleitung

Canon

Canon EF 100mm f/2.8L MARCO IS USM Bedienungsanleitung

Canon

Canon KJ17ex7.7B Bedienungsanleitung

Canon

Canon EF 70-200mm f/2.8L IS II USM Bedienungsanleitung

Canon

Canon EF 24mm f/2.8 IS USM Bedienungsanleitung

Canon

Canon EF 400mm f/2.8L IS II USM Bedienungsanleitung

Canon

Canon EF 400mm 1:2.8 L USM Bedienungsanleitung

Canon

Canon EF35mm f/2 IS USM Bedienungsanleitung

Canon

Canon High Resolution Lenses Bedienungsanleitung

Canon

Canon EF-S 60mm f/2.8 Macro USM Bedienungsanleitung

Canon

Canon EF-S35MM F/2.8 MACRO IS STM Bedienungsanleitung

Canon

Canon TS-E17MM F/4L Bedienungsanleitung

Canon

Canon CN-E30-300mm T2.95-3.7 LS Bedienungsanleitung

Canon

Canon EF LENS TS-E24MM F/3.5L Bedienungsanleitung

Canon

Canon EF35mm f/2 IS USM Bedienungsanleitung

Canon

Canon CN-E30-105mm T2.8 L S Bedienungsanleitung

Canon

Canon FD Lens Bedienungsanleitung

Canon

Canon EF Lenses Bedienungsanleitung

Beliebte Kameraobjektiv Handbücher anderer Marken

THORLABS

THORLABS ELL15 Bedienungsanleitung

FUJICA

FUJICA ZC1000 Bedienungsanleitung

Tamron

Tamron A09 Handbuch

Sony

Sony SEL-55210 Bedienungsanleitung

Sony

Sony VCL-HG2037 Bedienungsanleitung

Honeywell

Honeywell HLM25V6F12 Bedienungsanleitung

Sony

Sony VCL-ST30 Bedienungsanleitung

Sony

Sony SAL-85F14Z - 85mm f1.4 Carl Zeiss Planar T Coated Telephoto... Bedienungsanleitung

ARRI

ARRI Lenses Bedienungsanleitung

Olympus

Olympus M.Zuiko Digital ES 300mm f4.0 IS PRO Bedienungsanleitung

Sony

Sony VCL-DE07T Bedienungsanleitung

Tamron

Tamron A036 Bedienungsanleitung

Samsung

Samsung 20-50mm F3.5-5.6 ED II Bedienungsanleitung

Tamron

Tamron 272E Bedienungsanleitung

Sinar

Sinar Rolleiflex 6008 AF Bedienungsanleitung

Rokinon

Rokinon SP 85mm F1.2 Bedienungsanleitung

Nikon

Nikon AF-S Zoom-Nikkor 17-35mm f/2.8D IF-ED Bedienungsanleitung

Samsung

Samsung Samsung 18-55mm Bedienungsanleitung