Cisco SNS-3515 series Handbuch
Cisco SNS 3500 Series Appliance Hardware Installation Guide
First Published: 2016-10-10
Americas Headquarters
Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408 526-4000
800 553-NETS (6387)
Fax: 408 527-0883
THE SPECIFICATIONS AND INFORMATION REGARDING THE PRODUCTS IN THIS MANUAL ARE SUBJECT TO CHANGE WITHOUT NOTICE. ALL STATEMENTS,
INFORMATION, AND RECOMMENDATIONS IN THIS MANUAL ARE BELIEVED TO BE ACCURATE BUT ARE PRESENTED WITHOUT WARRANTY OF ANY KIND,
EXPRESS OR IMPLIED. USERS MUST TAKE FULL RESPONSIBILITY FOR THEIR APPLICATION OF ANY PRODUCTS.
THE SOFTWARE LICENSE AND LIMITED WARRANTY FOR THE ACCOMPANYING PRODUCT ARE SET FORTH IN THE INFORMATION PACKET THAT SHIPPED WITH
THE PRODUCT AND ARE INCORPORATED HEREIN BY THIS REFERENCE. IF YOU ARE UNABLE TO LOCATE THE SOFTWARE LICENSE OR LIMITED WARRANTY,
CONTACT YOUR CISCO REPRESENTATIVE FOR A COPY.
The Cisco implementation of TCP header compression is an adaptation of a program developed by the University of California, Berkeley (UCB) as part of UCB's public domain version
of the UNIX operating system. All rights reserved. Copyright ©1981, Regents of the University of California.
NOTWITHSTANDING ANY OTHER WARRANTY HEREIN, ALL DOCUMENT FILES AND SOFTWARE OF THESE SUPPLIERS ARE PROVIDED “AS IS" WITH ALL FAULTS.
CISCO AND THE ABOVE-NAMED SUPPLIERS DISCLAIM ALL WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, THOSE OF
MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT OR ARISING FROM A COURSE OF DEALING, USAGE, OR TRADE PRACTICE.
IN NO EVENT SHALL CISCO OR ITS SUPPLIERS BE LIABLE FOR ANY INDIRECT, SPECIAL, CONSEQUENTIAL, OR INCIDENTAL DAMAGES, INCLUDING, WITHOUT
LIMITATION, LOST PROFITS OR LOSS OR DAMAGE TO DATA ARISING OUT OF THE USE OR INABILITY TO USE THIS MANUAL, EVEN IF CISCO OR ITS SUPPLIERS
HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
Any Internet Protocol (IP) addresses and phone numbers used in this document are not intended to be actual addresses and phone numbers. Any examples, command display output, network
topology diagrams, and other figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses or phone numbers in illustrative content is unintentional
and coincidental.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: http://
www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership
relationship between Cisco and any other company. (1110R)
©2016 Cisco Systems, Inc. All rights reserved.
CONTENTS
CHAPTER 1
Cisco SNS 3500 Series Appliance Overview 1
Cisco SNS 3500 Series Appliances 1
LED Indicators on Cisco SNS 3515 and 3595 Appliances 1
Cisco SNS-3515 and SNS-3595 Appliances Hardware Specifications 1
Cisco SNS-3515 or 3595 Appliance Front Panel View 3
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View 6
Internal Diagnostic LEDs 8
Regulatory Compliance 10
CHAPTER 2
Before You Begin 11
Safety Guidelines 11
Unpack and Inspect the Server 12
Prepare for Server Installation 13
Installation Guidelines 14
Rack Requirements 15
Equipment Requirements 15
Slide Rail Adjustment Range 15
Server Specifications 15
Physical Specifications 15
Environmental Specifications 16
Power Specifications 16
CHAPTER 3
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances 19
Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances 19
Install the Cisco SNS 3515 or 3595 Appliance in a Rack 20
Install the Side Rails 20
Install the Cable Management Arm (Optional) 23
Reverse the Cable Management Arm (Optional) 25
Cisco SNS 3500 Series Appliance Hardware Installation Guide
iii
Connect Cables 25
Connect the Network Interface 26
Ethernet Port Connector 26
Connect the Console 27
Connect the Keyboard and Video Monitor 28
Cable Management 29
Connect and Power On the Cisco SNS 3515 or 3595 Appliance 29
Connect and Power On the Server (Standalone Mode) 29
Local Connection Procedure 30
Remote Connection Procedure 30
Cisco Integrated Management Controller 31
Setup CIMC Configuration Utility 31
NIC Modes and NIC Redundancy Settings 33
Upgrade the BIOS and Cisco IMC Firmware 34
Access the System BIOS 36
Cisco SNS 3500 Series Appliance Hardware Installation Guide
iv
Contents
CHAPTER 1
Cisco SNS 3500 Series Appliance Overview
•Cisco SNS 3500 Series Appliances, page 1
Cisco SNS 3500 Series Appliances
The Cisco SNS 3515 or Cisco SNS 3595 appliance is designed for performance and density over a wide range
of business workloads, from web serving to distributed databases.
The SNS 3515 and SNS 3595 appliances support only Cisco ISE 2.0.1 or later releases. You cannot install
a release earlier than 2.0.1 on the SNS 3515 or SNS 3595 appliance.
Note
Support for UEFI Secure Boot
The SNS 3515 and SNS 3595 appliances support the Unified Extensible Firmware Interface (UEFI) secure
boot feature. This feature ensures that only a Cisco-signed ISE image can be installed on the SNS 3515 and
SNS 3595 appliances, and prevents installation of any unsigned operating system even with physical access
to the device. For example, generic operating systems, such as Red Hat Enterprise Linux or Microsoft Windows
cannot boot on this appliance.
LED Indicators on Cisco SNS 3515 and 3595 Appliances
This section describes the front- and rear-panel controls, ports, and LED indicators on the Cisco SNS 3515
and Cisco SNS 3595 appliances.
Cisco SNS-3515 and SNS-3595 Appliances Hardware Specifications
The following table describes the hardware specifications of Cisco SNS-3515 and Cisco SNS-3595 appliances.
Cisco SNS 3500 Series Appliance Hardware Installation Guide
1
DiagramsHardware SpecificationsCisco Identity Services
Engine Appliance
Cisco SNS-3515 or 3595 Appliance
Front Panel View, on page 3
Cisco SNS 3515 or SNS 3595
Appliance Back Panel View, on
page 6
•Cisco UCS C220 M4
•Single socket Intel Xeon E5-2620
v3 series CPU @ 2.40GHz, 6 total
cores, 6*2 total threads
•16 GB RAM
•1 x 600-GB disk
•6 GbE network interfaces
•For physical, environmental, and
power specifications, see Server
Specifications, on page 15
Cisco SNS-3515-K9
•Cisco UCS C220 M4
•Dual socket Intel Xeon E5-2640
v3 series CPU @ 2.60GHz, 8 total
cores, 8*2 total threads
64 GB RAM
4 x 600-GB disks
RAID 10
6 GbE network interfaces
For physical, environmental, and
power specifications, see Server
Specifications, on page 15.
Cisco SNS-3595-K9
Cisco SNS 3500 Series Appliance Hardware Installation Guide
2
Cisco SNS 3500 Series Appliance Overview
LED Indicators on Cisco SNS 3515 and 3595 Appliances
Cisco SNS-3515 or 3595 Appliance Front Panel View
The following figure shows the components of the Cisco SNS-3515 or Cisco SNS-3595 appliance front panel
view.
Figure 1: Front Panel LEDs
System status LED7Drive bays 1-8 support SAS/SATA drives1
Fan status LED8Drive bays 1 and 2 support SAS/SATA
and NVMe PCIe solid state drives (SSDs)
2
Temperature status LED9Pull-out asset tag3
Power supply status LED10Operations panel buttons and LEDs4
Network link activity LED11Power button/power status LED5
KVM connector (used with KVM cable that
provides two USB 2.0, one VGA, and one
serial connector)
12Unit identification button/LED6
The following table describes the LEDs located on the front panel of the Cisco SNS-3515 or Cisco SNS-3595
appliance.
Cisco SNS 3500 Series Appliance Hardware Installation Guide
3
Cisco SNS 3500 Series Appliance Overview
LED Indicators on Cisco SNS 3515 and 3595 Appliances
Front Panel LEDs
•Off—The hard drive is operating properly.
•Amber—Drive fault detected.
•Amber, blinking—The device is rebuilding.
•Amber, blinking with one-second
interval—Drive locate function activated.
Hard drive fault
•Off—There is no hard drive in the hard drive
tray (no access, no fault).
•Green—The hard drive is ready.
•Green, blinking—The hard drive is reading or
writing data.
Hard drive activity
•Off—There is no AC power to the server.
•Amber—The server is in standby power mode.
Power is supplied only to the Cisco IMC and
some motherboard functions.
•Green—The server is in main power mode.
Power is supplied to all server components.
Power button/LED
•Off—The unit identification function is not in
use.
•Blue—The unit identification function is
activated.
Unit identification
Cisco SNS 3500 Series Appliance Hardware Installation Guide
4
Cisco SNS 3500 Series Appliance Overview
LED Indicators on Cisco SNS 3515 and 3595 Appliances
Front Panel LEDs
•Green—The server is running in normal
operating condition.
•Green, blinking—The server is performing
system initialization and memory check.
•Amber, steady—The server is in a degraded
operational state. For example:
◦Power supply redundancy is lost.
◦CPUs are mismatched.
◦At least one CPU is faulty.
◦At least one DIMM is faulty.
◦At least one drive in a RAID configuration
failed.
•Amber, blinking—The server is in a critical
fault state. For example:
◦Boot failed.
◦Fatal CPU and/or bus error is detected.
◦Server is in an over-temperature condition.
System status
•Green—All fan modules are operating properly.
•Amber, steady—One or more fan modules
breached the critical threshold.
•Amber, blinking—One or more fan modules
breached the non-recoverable threshold.
Fan status
•Green—The server is operating at normal
temperature.
•Amber, steady—One or more temperature
sensors breached the critical threshold.
•Amber, blinking—One or more temperature
sensors breached the non-recoverable threshold.
Temperature status
Cisco SNS 3500 Series Appliance Hardware Installation Guide
5
Cisco SNS 3500 Series Appliance Overview
LED Indicators on Cisco SNS 3515 and 3595 Appliances
Front Panel LEDs
•Green—All power supplies are operating
normally.
•Amber, steady—One or more power supplies
are in a degraded operational state.
•Amber, blinking—One or more power supplies
are in a critical fault state.
Power supply status
•Off—The Ethernet link is idle.
•Green—One or more Ethernet LOM ports are
link-active, but there is no activity.
•Green, blinking—One or more Ethernet LOM
ports are link-active, with activity.
Network link activity
Cisco SNS 3515 or SNS 3595 Appliance Back Panel View
The following figure shows the components of the Cisco SNS-3515 and Cisco 3595 appliance back panel
view.
Figure 2: Back Panel LEDs
1-GbE Ethernet dedicated management port;
used to access CIMC
9Grounding-lug hole (for DC power
supplies)
1
Serial port (RJ-45 connector)10PCIe riser 1/slot 12
1-GbE Ethernet port (Eth 0)11PCIe riser 2/slot 23
1-GbE Ethernet port (Eth 1)121-GbE Ethernet port (Eth 2)4
VGA video port (DB-15)131-GbE Ethernet port (Eth 3)5
Rear unit identification button/LED141-GbE Ethernet port (Eth 4)6
Cisco SNS 3500 Series Appliance Hardware Installation Guide
6
Cisco SNS 3500 Series Appliance Overview
LED Indicators on Cisco SNS 3515 and 3595 Appliances
Andere Handbücher für SNS-3515 series
1
Dieses Handbuch passt für folgende Modelle
2
Inhaltsverzeichnis
Andere Cisco Server Handbücher
Cisco
Cisco UCS C200 Montage- und Wartungsanleitung
Cisco
Cisco UCS C24 Montage- und Wartungsanleitung
Cisco
Cisco UCS C220 M3 Installations- und Betriebshandbuch
Cisco
Cisco C880 M5 Bedienungsanleitung
Cisco
Cisco UCS C210 Montage- und Wartungsanleitung
Cisco
Cisco L2TP Bedienungsanleitung
Cisco
Cisco UCS B460 M4 Bedienungsanleitung
Cisco
Cisco UCS B200 M2 Bedienungsanleitung
Cisco
Cisco UCS C3160 Montage- und Wartungsanleitung
Cisco
Cisco Cisco MeetingPlace Express Betriebsanleitung
Cisco
Cisco expressway ce1100 Bedienungsanleitung
Cisco
Cisco UCS B200 M4 Handbuch
Cisco
Cisco C220 M3 Handbuch
Cisco
Cisco ONS 15454 SONET Bedienungsanleitung
Cisco
Cisco ONS 15454 Handbuch
Cisco
Cisco UCS C Series Montageanleitung
Cisco
Cisco SNS-3400 Series Montageanleitung
Cisco
Cisco S195 Bedienungsanleitung
Cisco
Cisco UCS B420 M4 Handbuch
Cisco
Cisco CSACS-1121-K9 Bedienungsanleitung
Beliebte Server Handbücher anderer Marken
iRobo
iRobo IPC2U Bedienungsanleitung
Nortel
Nortel 1000 Con?guration guide Bedienungsanleitung
Asus
Asus AP7500 Bedienungs- und Wartungshandbuch
Avid Technology
Avid Technology AirSpeed 5000 Bedienungsanleitung
HP
HP Integrity rx2600 Installationsanleitung
Milestone
Milestone Husky IVO 350T Bedienungsanleitung