Comeup Cub3 Bedienungsanleitung

Powersports Winch

Model: Cub 3

PN: 123561 12V DC

PN: 123321 12V DC

Introduction

XFeature

Line pull: 1,361 kg / 3,000 lb wire rope first layer

Wire rope: 4.8 mm x 15.2 m (3/16" x 50') galvanized aircraft A7 × 19

Brake: Mechanical and dynamic brake for 100% braking

Clutch: Turn the shifter for rapid wire rope payout

Control: Handlebar rocker switch to power the winch

XUnpacking

．Winch assembly………………………………………………………

1 pc

．Handlebar rocker switch kit………………………………………… 1 pc

．4 way roller fairlead…………………………………………………. 1 pc

．Wire rope with hook except for PN 123321……………………. 1 pc

．Contactor pack ………………………………………………….……1 pc

XRead this manual carefully

You should carefully read and understand this manual before operating it.

Careless winch operation may result in personal injury hazards or property

damage.

XInformation requesting or parts ordering

Please specify the followings information:

．Winch PN ．Serial number

．Part description ．Replacement part number

．Quantity for each part

Installation

Before using the winch, make sure all electrical

components have no corrosion or damaged; the

environment should be clear and dry.

XWire rope replacement

．It is very important that the winch will be mounted

on a flat and hard surface of mounting channel in order to make sure

the motor, drum and gearbox housing are aligned correctly.

．Roller fairlead does not mount to winch directly.

．The wire rope shall be wound in an under-wound orientation only.

．

Four (4) M8 x 20L 8.8 grade high tensile steel bolts must be used in order

to sustain the loads imposed on the winch mounting.

．Two (2) M8 x 20L 8.8 grade high tensile steel bolts must be used for

fastening the roller fairlead into the mounting channel.

XWiring Diagram

Attach the black lead firmly to the negative (–) battery terminal and red lead

to the positive (+) battery terminal. The voltage drop for the winch motor

must not exceed 10% of the nominal voltage of 12V DC.

XNut fastening for motor & contactor

1.Holding the lower nut on the stub and fastening the upper nut clockwise.

2.The torque setting for nut is 5.7 N-m / 50 lb-in.

Warning

．The winch is not intended to be used in any manner for the movement or

lifting of personnel.

．The pulling capacity shown is based on the first layer of rope on the drum.

．The rope winding on the drum shall remain 5 wraps from the drum.

Handlebar Rocker Switch Mounting

Handlebar mounted rocker switch can be operated without removing your

hand from the grip.

Parts List

Item No. Description Part No. Qty

1 Motor w/housing 881331 1

2 Motor couple kit 880988 1

3 Drum bushing 880990 2

4 Drum kit 880991 1

5 Tie bar kit 880992 1

6 Tie bar kit 880993 2

7 Gearbox support rack 880994 1

8 3rd stage carrier 880995 1

9 2nd stage carrier 880996 1

10 1st stage carrier 880997 1

11 2nd ring gear kit 880998 1

12 1st shaft kit 880999 1

13 Gearbox kit 881000 1

14 Clutch base 881011 1

15 Friction block 881012 1

16 Clutch lever kit 881013 1

17 Shifter kit 881001 1

18 Wire rope w/hook 881954 1

19 Roller fairlead 880231 1

20 Contactor pack 881037 1

20-1 Contactor w/leads 881385 1

20-2 Battery lead (+) 880234 1

20-3 Battery lead (-) 880235 1

20-4 Motor lead (yellow) 880236 1

20-5 Motor lead (blue) 880237 1

21 Handlebar rocker switch kit 881003 1

22 Mounting hardware 881005 1

23 Handlebar hardware 880242 1

24 Handsaver strap 880026 1

25 Cable tie 880243 1

Winch Assembly

Andere Handbücher für Cub3

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Comeup Winde Handbücher

Comeup

Comeup CWG-10151 Bedienungsanleitung

Comeup

Comeup DV-18 Bedienungsanleitung

Comeup

Comeup GIO 80 Bedienungsanleitung

Comeup

Comeup CWS-80 Bedienungsanleitung

Comeup

Comeup CWS-80 Bedienungsanleitung

Comeup

Comeup Walrus 20.0 Bedienungsanleitung

Comeup

Comeup CP-250 Bedienungsanleitung

Comeup

Comeup CWG-30075 Bedienungsanleitung

Comeup

Comeup Cub3 Bedienungsanleitung

Comeup

Comeup Blazer M2 Bedienungsanleitung

Comeup

Comeup CP-500 Bedienungsanleitung

Comeup

Comeup CWL-200 Bedienungsanleitung

Comeup

Comeup Cub 2s Bedienungsanleitung

Comeup

Comeup Seal Gen2 9.5 Bedienungsanleitung

Comeup

Comeup Seal 9.5si Bedienungsanleitung

Comeup

Comeup CWG-30565 Bedienungsanleitung

Comeup

Comeup Cub 4s Bedienungsanleitung

Comeup

Comeup CWL-301 Bedienungsanleitung

Comeup

Comeup CWS-80 Bedienungsanleitung

Comeup

Comeup DH-300 Bedienungsanleitung

Comeup

Comeup DV-6000S Bedienungsanleitung

Comeup

Comeup CWG-10151 Bedienungsanleitung

Comeup

Comeup CWS-160 Bedienungsanleitung

Comeup

Comeup GTD-2800 Bedienungsanleitung

Beliebte Winde Handbücher anderer Marken

WARRIOR

WARRIOR Trojan 40PUS12 Kurzanleitung

SVERO

SVERO 16 Bedienungsanleitung

Warrior Winches

Warrior Winches C10000NH Bedienungsanleitung

Badland Winches

Badland Winches 68146 Bedienungsanleitung

Bush

Bush II Series Bedienungsanleitung

Badland

Badland APEX 5500 Bedienungsanleitung

Quadratec

Quadratec Q9000 Synthetic Handbuch

C-Max

C-Max VIGO Bedienungsanleitung

Orvea

Orvea Italwinch 805 Bedienungsanleitung

Prowinch

Prowinch PWJTHF300 Bedienungsanleitung

Clas Ohlson

Clas Ohlson LD2000-A Bedienungsanleitung

Topex

Topex 97X080 Bedienungsanleitung

Eastbound

Eastbound MotoWinch 1707001 Bedienungsanleitung

Runva

Runva EWD8000 Kurzanleitung

Ingersoll-Rand

Ingersoll-Rand LIFTSTAR FG 1500/CN Series Installationsanleitung

Granit

Granit 11157675 Bedienungsanleitung

TREX

TREX TB75 Bedienungsanleitung

Badland

Badland ZXR 2500 Bedienungsanleitung