CommScope PICABOND 60944-6 Bedienungsanleitung

Figure 1

This instruction sheet covers loading the

reel–in–a–box connectors listed in Figure 1 into

MA–6U Applicator 231039–2 or MA–10 Applicators

229534–[ ].

Reasons for reissue of this instruction sheet are

provided in Section 4, REVISION SUMMARY.

Each reel–in–a–box is a water–resistant cardboard

box containing 1000 strip–form connectors. The

connectors are mounted on a three–piece, plastic,

rotating reel in the center of the box. The box serves

as the reel holder, thus eliminating the need for a

separate reel holder assembly. A rewind slot is

provided to reel the connectors back into the box.

1. Open the small tabs at the connector opening of

the box. Refer to Figure 1. Unroll 0.457 m [18 in.]

of connectors.

2. Check the end of the connector carrier strip, and

remove any damaged connectors. DO NOT feed

damaged connectors into the applicator; otherwise,

the applicator will jam.

3. Cut the ends of the carrier strip as shown in

Figure 2. For mini connectors, DO NOT cut

through the pilot holes.

4. Cycle the applicator to the “REST” position.

For manually–operated applicators, rotate the

operating lever

counterclockwise

to the 9 o’clock

position. For power–operated applicators, push the

buttons until the cycle stops.

5. Turn the feed knob

counterclockwise

until the

index mark on the feed knob aligns with the index

mark on the backup plate. See Figure 3.

9 JAN 17 Rev B

This product is covered by one or more U.S.

patents or their foreign equivalents. For patents, see

www.commscope.com/ProductPatent/ProductPatent.aspx

To obtain information on CommScope®products,visit our website at

http://www.commscope.com/SupportCenter/TechnicalSupport.aspx

Figure 2

Figure 3

6. Place the box directly below the applicator. The

box can be laid down or raised off the ground by

running a lacing cord or wire through the rewind

slot of the box. Position the box in a manner that

will allow the connector carrier strip to feed

vertically into the applicator. Feed the first

connector STRAIGHT into the strip guide as far as

it will go. See Figure 4.

7. Turn the feed knob

counterclockwise

one full

turn. See Figure 4.

8. Release the upper clamp handle, and place the

applicator in a horizontal position.

9. Cycle the applicator until the first connector

aligns with the top anvil as shown in Figure 5.

10. After use, using a straight instrument, turn the

rewind slot to reel the exposed connectors back

into the box.

Figure 4

Figure 5

Revisions to this instruction sheet include:

Updated document to corporate requirements

Removed obsolete applicators and connectors

Rebranded to CommScope

Dieses Handbuch passt für folgende Modelle

Andere CommScope Kabel und Steckverbinder Handbücher

CommScope

CommScope FDH1204-24SE2 Bedienungsanleitung

CommScope

CommScope FOSC-450D Bedienungsanleitung

CommScope

CommScope ETHERSEAL 1479563-2 Bedienungsanleitung

CommScope

CommScope HELIAX FiberFeed FDH1210-24SE2 Series Merkblatt

CommScope

CommScope AMP NETCONNECT 1933352 Series Bedienungsanleitung

CommScope

CommScope SYSTIMAX 360 iPatch PATCHMAX Bedienungsanleitung

CommScope

CommScope FD21206-48SRC Series Merkblatt

CommScope

CommScope AMP NETCONNECT 553454-1 Bedienungsanleitung

CommScope

CommScope HELIAX FiberFeed HTC1006 Series Merkblatt

CommScope

CommScope OmniReach FTTX Bedienungsanleitung

CommScope

CommScope NOVUX SEC 100 Bedienungsanleitung

CommScope

CommScope FOSC-OC-3 Bedienungsanleitung

CommScope

CommScope NOVUX Bedienungsanleitung

CommScope

CommScope ION-M7P Bedienungsanleitung

CommScope

CommScope FOSC-400BG Bedienungsanleitung

CommScope

CommScope FOSC-350C Bedienungsanleitung

CommScope

CommScope BUDI-S Bedienungsanleitung

CommScope

CommScope FIBER INDEXING TERMINAL Bedienungsanleitung

CommScope

CommScope QWIK MPO Series Bedienungsanleitung

CommScope

CommScope FOSC450 C Bedienungsanleitung

CommScope

CommScope LSX-288 Bedienungsanleitung

CommScope

CommScope AMP NETCONNECT MRJ21 1479452-1 Bedienungsanleitung

CommScope

CommScope SYSTIMAX VisiPatch CPC5562 Bedienungsanleitung

CommScope

CommScope SYSTIMAX 360 iPatch 360-iP-G2-1U-LC-FX Bedienungsanleitung

Beliebte Kabel und Steckverbinder Handbücher anderer Marken

Philips

Philips SWA6310 Bedienungsanleitung

StarTech.com

StarTech.com CRJ4550PK Bedienungsanleitung

Nohau

Nohau EMUL-IP2K-PC Bedienungsanleitung

Foxun

Foxun SX-SP144E-HD4K2K Bedienungsanleitung

Philips

Philips SWA3305W Bedienungsanleitung

opticis

opticis Stretch DVIM1-1P0x Bedienungsanleitung

Volkswagen

Volkswagen VAS 6558A Bedienungsanleitung

NEXIBO

NEXIBO N-13 Bedienungsanleitung

CYP

CYP PU-1H3HBTL Bedienungsanleitung

Allen-Bradley

Allen-Bradley 1784-u2dhp Bedienungsanleitung

Global Caché

Global Caché Flex Link Blaster Bedienungsanleitung

Hauppauge

Hauppauge USB-Live2 Bedienungsanleitung

Fenix

Fenix MPSV 15 Bedienungsanleitung

BEGA

BEGA 71 085 Bedienungsanleitung

Tesla

Tesla HPWC Bedienungsanleitung

GAMERON

GAMERON LUXURY TV CABLE Bedienungsanleitung

molex

molex Milli-Grid Dual row 87568 Series Bedienungsanleitung

Burndy

Burndy Continental Industries thermOweld CRE-7 Bedienungsanleitung