Crest Audio CDVS-4200 Series Bedienungsanleitung
CDVS-4200 Series
Embedded DVR
Setup And
Users Manual
Crest Electronics, Inc.
Version 08.12.15
i
Caution
This installation should be performed by qualied service personnel and should con form to all Federal State
and local laws.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates and uses radio
frequency energy, and if not installed and used in accordance with instructions, may cause harmful
in terference to radio communications. However, there is no guarantee that the interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following methods:
- Relocate the receiving antenna
- Increase the amount of space between the equipment and the receiver.
- Connect the equipment to an outlet which is on a separate circuit than that of the
receiver.
- Consult the dealer or an experienced radio/TV technician for help
CAUTION: Changes or modications not expressly approved by the party responsible for compliance
with the FCC Rules could void the user’s authority to operate this equipment.
RISK OF ELEC TRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK. DO NOT REMOVE COVER. NO
USER-SER VICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PER SONNEL.
The lightning ash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufcient mag ni tude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE
ii
Important Safeguards
Warning
1. Turn off power to the unit prior to changing the battery.
2. Check the polarity of the lithium battery while changing.
3. When changing battery use the same type as original or similar type recommended by your vendor.
4. Dispose of old battery in accordance with the manufacturer of the battery.
General Warning
Warning
1. Use the power cord which is supplied or recommended by the manufacturer. Failure to do so could cause
a re.
2. Use the power transformer which is supplied or recommended by the manufacturer. Failure to do so
could cause a re.
3. Do not dismantle or assemble the product. Doing so could cause malfunction or re.
4. Service should only be done by manufacturer or authorized vendor. Electrical shock or re could result if
repair is not done properly.
5. Do not touch product with wet hands as electric shock may occur.
6. Product must be installed by a qualied professional. Failure to do so could result in malfunction,
electrical shock or re.
7. Consult the place of purchase if the need for installation arises. Poor installation could cause
malfunction, electric shock or re.
8. Ground applies to video products equipped with a 3-wire grounding type plug having a third (grounding)
pin. This plug only ts into a grounding type power outlet. If grounding is not done, equipment malfunc-
tion or electric shock may occur.
9. Ground connection must not touch gas pipe, water pipe or telephone lines.
10. Prevent foreign metallic substance from going inside the product. Failure to do so could result in mal-
function or electric shock.
11. Prevent water or other liquids from entering inside the product. Use damp cloth to clean outside of
product. Failure to do so could result in malfunction or electric shock.
iii
Caution
1. Use the power cord and power transformer supplied by the manufacturer or one recommended by the
manufacturer.
2. The internal fan rotates at high speed and may cause injury.
3. Do not drop, give unit strong vibration or shock to the product; doing so will cause malfunction.
4. Slots and openings in the front and back of the cabinet are provided for ventilation, to ensure reliable
operation of the unit, and to protect it from overheating. These openings must not be blocked or covered.
The openings should never be blocked by placing the unit on a bed, sofa, rug or similar surface. The unit
should never be placed near or over a ra diator or heat source. This unit should not be placed in a built-
in installation such as a bookcase or rack unless proper ventilation is provided and/or the manufacturer’s
instructions are adhered to.
5. Do not install the product near or on top of heating source. The internal temperature of the product would
be greater than the allowable and could cause malfunction or re.
6. Do not install the product on inclined or unstable locations such as an unstable cart, slant tripod, bracket,
or table. The unit may fall, causing serious injury, and serious damage to the unit.
Cautions about the Power
Warning
1. This unit should be operated only from the type of power indicated on the power plate. If you are not
sure of the type of power supply at your location, consult your dealer or local power company. For units
intended to operate from battery power, or other sources, refer to the operating instructions.
2. Power supply cords should be routed so that they are not likely to be walked on or pinched by items
placed upon or against them, paying particular attention to the cord at plugs, convenience receptacles,
and the point where they exit from the appliance.
3. Do not cut power cord to connect in the middle of the power cord or use extension cord. Doing so could
generate heat or cause re.
4. Do not touch power cord in wet area or with wet hands.
5. Hold the body of the plug when removing the power cord. Do not pull cord as doing so may generate
heat or cause re.
6. Remove the power cord from the outlet when not in use for long periods of time. This will prevent
damage to unit due to lightning and power line surges.
iv
Table of Contents
Caution ................................................................................................................................................................i
Safeguards............................................................................................................................................................ii
Cautions...............................................................................................................................................................iii
Box Contents ......................................................................................................................................................1-1
Hardware Setup ..................................................................................................................................................2-1
4216H 16 Channel Embedded DVR.........................................................................................................2-1
4216L 16 Channel Embedded DVR..........................................................................................................2-2
4208 8 Channel Embedded DVR...............................................................................................................2-3
4204 4 Channel Embedded DVR...............................................................................................................2-4
4216H Embedded DVR Data Input and Output Terminal Pin Assignment.......................................2-5
4216L, 4208, 4204 Embedded DVR Data Input and Output Terminal Pin Assignment ...................2-6
Description of Hardware Connections.....................................................................................................2-7
Powering Up e DVR For e First Time ....................................................................................................3-1
Default User Name and Password .............................................................................................................3-1
Setting e Time Zone................................................................................................................................3-2
Dierent Time Zones Around the World.................................................................................................3-4
Default Settings ............................................................................................................................................3-6
Controlling the DVR..........................................................................................................................................4-1
Using e Remote Controller.....................................................................................................................4-1
Setting the ID on the remote controller ...................................................................................................4-2
Front Panel Functions .................................................................................................................................4-4
Screen Display.....................................................................................................................................................5-1
Camera Sequence.........................................................................................................................................5-3
Overview of the Main Screen ...........................................................................................................................6-1
Symbols .........................................................................................................................................................6-1
Channel Swapping .......................................................................................................................................6-2
Main System Menu Pop Up Box.......................................................................................................................7-1
Overview of Pop Up Menu.........................................................................................................................7-1
Setting Up e DVR....................................................................................................................................7-2
e System Menu.........................................................................................................................................7-3
System (Information) screen...................................................................................................................7-3
System (Time Setup) Screen....................................................................................................................7-4
Daylight Savings Time .............................................................................................................................7-4
Holiday Setup ...........................................................................................................................................7-5
Time Sync Function..................................................................................................................................7-5
System (Disk Manager)............................................................................................................................7-6
System (User Account).............................................................................................................................7-7
System (Covert Cameras) ........................................................................................................................7-8
System (Factory Default Function) ........................................................................................................7-8
System (Log O).......................................................................................................................................7-8
System (Shut Down).................................................................................................................................7-8
e Device Menu ........................................................................................................................................7-9
Device (Camera) Screen ..........................................................................................................................7-9
Device (Camera) PTZ Setup ...................................................................................................................7-11
Device (Camera) Color Control ............................................................................................................7-12
v
Device (Camera) Audio ...........................................................................................................................7-12
Device (Alarm) .........................................................................................................................................7-13
Device (Alarm) Sensor.............................................................................................................................7-13
4216H Embedded DVR Data Input and Output Sensor Pin Assignment ........................................7-14
4216L, 4208, 4204 Embedded DVR Data Input and Output Pin Assignment .................................7-15
Device (Alarm) Motion ...........................................................................................................................7-16
Device (Alarm) Video Loss .....................................................................................................................7-16
Device (Alarm) System ............................................................................................................................7-17
Device Sequence .......................................................................................................................................7-18
Device Buzzer............................................................................................................................................7-18
e Record Menu ........................................................................................................................................7-19
Record (Setup)...........................................................................................................................................7-20
Motion Area Setup Window ...................................................................................................................7-21
Record (Schedule).....................................................................................................................................7-22
Network ........................................................................................................................................................7-24
Network (IP Setup)...................................................................................................................................7-24
TCP/IP Information .................................................................................................................................7-25
Network (E-Mail Notication)................................................................................................................7-25
Network (Web Server Setup)...................................................................................................................7-26
Network DDNS Setup..............................................................................................................................7-26
Network Event Notication.....................................................................................................................7-27
Network Bandwidth Limit.......................................................................................................................7-27
Event Menu...................................................................................................................................................7-28
Searching Recorded Video ................................................................................................................................8-1
Search Menu.................................................................................................................................................8-1
Event (Calendar Search) ..........................................................................................................................8-2
Search (Motion Search) ...........................................................................................................................8-3
Search (Event Search)...............................................................................................................................8-4
Playback Screen Functions.........................................................................................................................8-5
Backing Up Recorded Video.............................................................................................................................9-1
Replay of Backup les..................................................................................................................................9-2
Replay using SimpleView.........................................................................................................................9-2
Digital PTZ..........................................................................................................................................................10-1
Dynamic PTZ......................................................................................................................................................11-1
Appendix .............................................................................................................................................................12-1
DDNS Registration......................................................................................................................................12-1
Client Soware setup using DDNS ........................................................................................................12-2
4200 Relay Characteristics..........................................................................................................................12-4
Network Communication Ports.................................................................................................................12-4
Input Box characteristics ............................................................................................................................12-5
1-1
Contents
Please check the package for the following items. If any items are missing please contact your dealer.
•4200DVR
•Powercord
•Remotecontroller
•USBMouse
•UtilitiesDisk
•LoopingOutputCable(16channelonly)
CDVS-4200 Remote Controller
Utilities CD Looping Output Cable
16 channel only.
USB Mouse
Rack Ear Mounts
25 Pin Connector 4216L,
4208, 4204 only
2-1
Hardware Setup
is section describes the front and back connections of the CDVS-4216H,4216L, 4208, 4204 Embedded
DVR.
USB PortsDVD/CD-RW Drive Front Panel Controls
On/O Button
Video Output
cable connection
Video Inputs 1 - 16
Spot monitor
Output
Audio Out Audio Input
Power plug
connection
Sensor/Relay/Ground/
422/485 connections
LAN connection
Two way
Audio In
NTSC/
PAL
Mon.
out S-Video
Out
VGA
out
USB
ports
Front Panel Controls
Back Panel Controls
(4216H shown)
4216H 16 Channel Embedded DVR
e images that follow show the hardware connections for the 16 channel embedded DVR.
Audio Out
2-2
USB PortsDVD/CD-RW Drive Front Panel Controls
On/O Button
Video Output
cable connection
Video Inputs 1 - 16
Spot monitor
Output
Audio Out Audio Input
Power plug
connection
Sensor/Relay/Ground/422/485
connections
LAN connection
Two way
Audio In
NTSC/
PAL
Mon.
out S-Video
Out
VGA
out
USB
ports
Front Panel Controls
Back Panel Controls
(4216L shown)
4216L 16 Channel Embedded DVR
e images that follow show the hardware connections for the 16 channel embedded DVR.
Audio Out
2-3
4208 8 Channel Embedded DVR
e images that follow show the hardware connections for the 8 channel embedded DVR.
Video Outputs 1 - 8
Video Inputs 1 - 8
Spot monitor
Output
Audio Out
Audio Input
Power plug
connection
Sensor/Relay/Ground/
422/485 connections
LAN connection
Two way
Audio In
NTSC/
PAL
Mon.
out
S-Video
Out
VGA
out
USB
ports
USB Ports
CD-RW Drive Front Panel Controls
On/O Button
Front Panel Controls
Back Panel Controls
Inhaltsverzeichnis
