Dell PowerEdge R805 System Bedienungsanleitung

Dell™ PowerEdge™

R805 Systems

Getting Started

With Your System

Začínáme se systémem

Guide de mise en route

Erste Schritte mit dem System

Τα πρώτα βήµατα µε το σύστηµά σας

Rozpoczęcie pracy z systemem

Начало работы с системой

Procedimientos iniciales con el sistema

תכרעמה םע הדובעה תליחת

Dell™ PowerEdge™

R805 Systems

Getting Started

With Your System

Model EMS01

Notes, Notices, and Cautions

NOTE: A NOTE indicates important information that helps you make better use

of your computer.

NOTICE: A NOTICE indicates either potential damage to hardware or loss of data

and tells you how to avoid the problem.

CAUTION: A CAUTION indicates a potential for property damage, personal injury,

or death.

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly

forbidden.

Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.; AMD and AMD

Opteron are registered trademarks of dvanced Micro Devices; Microsoft, Windows, and Windows

Server are registered trademarks of Microsoft Corporation; Novell and NetWare are registered

trademarks of Novell, Inc.; Red Hat and Red Hat Enterprise Linux are registered trademarks

of Red Hat, Inc.; SUSE is a registered trademark of Novell Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming

the marks and names or their products. Dell Inc. disclaims any proprietary interest in trademarks and

trade names other than its own.

Model EMS01

August 2007 P/N JN204 Rev. A00

Getting Started With Your System 3

System Features

This section describes the major hardware and software features of your

system. It also provides information about other documents you may need

when setting up your system and how to obtain technical assistance.

• Two dual-core or quad-core AMD Opteron™ processors.

• A minimum of 2 GB single- or dual-ranked 667-MHz DDR2 (PC2-5300)

memory modules (installed in two sets of pairs). Memory is upgradable to

a maximum of 128 GB by installing combinations of 512-MB, 1-GB, 2-GB,

4-GB, or 8-GB memory modules in the 16 memory module sockets

(eight per CPU) on the system board.

• Support for up to two 2.5-inch, internal hot-pluggable Serial Attached

SCSI (SAS) or SATA hard drives.

• An optional slim-line SATA DVD-ROM drive, slim-line SATA DVD-RW

drive, or combination CD-RW/DVD drive (when available).

NOTE: DVD devices are data only.

• An intrusion switch that signals the appropriate systems management

software if the cover is opened.

• Up to two hot-pluggable, 700-W power supplies in an optional 1 + 1

redundant configuration.

• Six hot-pluggable system cooling fans.

• Optional support for iSCSI boot.

The system board includes the following features:

• A right riser card (riser 1) containing two PCIe (x4 and x8) slots. The right

riser card also contains an SD (Secure Digital) slot for embedded OS

support.

• A left riser card (riser 2) containing one full-length PCIe (x8) slot

and one half-length PCIe (x8) slot.

• An integrated SAS controller card (via a dedicated PCIe slot on the

sideplane board) supporting both SAS 6i/R and PERC 6/i adapters.

• Optional integrated PERC controller (PERC 6i) with integrated cache

and battery backup.

• Four integrated Gigabit Ethernet NICs, capable of supporting 10-Mbps,

100-Mbps, and 1000-Mbps data rates.

4Getting Started With Your System

• Four external USB 2.0-compliant connectors (two on the front and two

on the back) supporting a diskette drive, a DVD-ROM drive, a keyboard,

a mouse, or a USB flash drive.

• One internal USB 2.0-compliant connector supporting an optional

bootable USB flash drive or USB security key.

• Optional remote access controller (RAC) for remote systems management.

• An integrated VGA-compatible video subsystem based on an integrated

ATI ES1000 33-MHz PCI video controller. The video subsystem includes

32MB of graphics memory and supports various 2D graphics video modes.

Maximum resolution is 1600x1200 with 65,536 colors. (When the optional

RAC is installed, the maximum resolution of the integrated video

subsystem is 1280x1024.)

• Systems management circuitry that monitors operation of the system fans

as well as critical system voltages, temperatures, and system power

consumption. The systems management circuitry works in conjunction

with the systems management software.

• Standard Baseboard Management Controller (BMC) with serial and LAN

access.

• Back-panel connectors include one serial, one video, two USB,

and four NIC connectors.

• Front-panel connectors include a video and two USB connectors.

• Front-panel 1x5 LCD for system ID and error messaging.

• System ID button on the front and back panels.

For more information about specific features, see Technical Specifications.

Supported Operating Systems

• Microsoft

Windows Server

2003 R2 Standard and Enterprise Editions

(SP1 and later)

• Microsoft Windows Server 2003 R2 Standard and Enterprise x64 Editions

(SP1 and later)

• Red Hat Enterprise Linux Server 5 (x86)

• Red Hat Enterprise Linux Server 5 (x86_64)

• Red Hat Enterprise Linux Server ES (Version 4.5) (x86)

Getting Started With Your System 5

• Red Hat Enterprise Linux Server ES (Version 4.5) (x86_64)

•SUSE

Linux Enterprise Server 9 (x86_64)

• SUSE Linux Enterprise Server 10 (x86_64)

•VMware

ESX Server 3 (including embedded versions)

NOTE: For the latest information on supported operating systems, see www.dell.com.

NOTE: SUSE Linux Enterprise Server 9, prior to SP4, does not support SATA optical

devices. Installation must be performed using other methods, such as an external

USB CD-ROM drive.

Other Information You May Need

CAUTION: The Product Information Guide provides important safety and

regulatory information. Warranty information may be included within this

document or as a separate document.

• The

Rack Installation Guide

Rack Installation Instructions

included

with your rack solution describes how to install your system into a rack.

• The

Hardware Owner’s Manual

provides information about system

features and describes how to troubleshoot the system and install or

replace system components.

• CDs included with your system provide documentation and tools for

configuring and managing your system.

• Systems management software documentation describes the features,

requirements, installation, and basic operation of the software.

• Operating system documentation describes how to install (if necessary),

configure, and use the operating system software.

• Documentation for any components you purchased separately provides

information to configure and install these options.

• Updates are sometimes included with the system to describe changes

to the system, software, and/or documentation.

NOTE: Always check for updates on support.dell.com and read the updates

first because they often supersede information in other documents.

• Release notes or readme files may be included to provide last-minute

updates to the system or documentation or advanced technical reference

material intended for experienced users or technicians.

6Getting Started With Your System

Obtaining Technical Assistance

If you do not understand a procedure in this guide or if the system does

not perform as expected, see your Hardware Owner’s Manual.

Dell™ Enterprise Training and Certification is available; see

www.dell.com/

training

for more information. This service may not be offered in all locations.

Installation and Configuration

CAUTION: Before performing the following procedure, read and follow the

safety instructions and important regulatory information in your Product

Information Guide.

This section describes the steps to set up your system for the first time.

Unpacking the System

Unpack your system and identify each item.

Keep all shipping materials in case you need them later.

NOTE: Depending on options ordered, not all components shown may be

included.

Getting Started With Your System 7

Installing the Rails and System in a Rack

Once you have read the "Safety Instructions" located in the rack

installation documentation for your system, install the rails and the system

in the rack.

See your rack installation documentation for instructions on installing

your system in a rack.

Connecting the Keyboard, Mouse, and Monitor

Connect the keyboard, mouse, and monitor (optional).

The connectors on the back of your system have icons indicating

which cable to plug into each connector. Be sure to tighten the screws

(if any) on the monitor's cable connector.

8Getting Started With Your System

Connecting the Power

Connect the monitor’s power cable to the monitor (optional), and connect

the system’s power cable(s) to the system.

Installing the Power Cord Retention Bracket

Attach the power cord retention bracket on the right bend of the power

supply handle. Bend the system power cable into a loop as shown in the

illustration and attach to the bracket’s cable clasp. Repeat the procedure

for the second power supply.

Plug the other end of the power cables into a grounded electrical outlet

or a separate power source such as an uninterrupted power supply (UPS)

or a power distribution unit (PDU).

Andere Handbücher für PowerEdge R805 System

Inhaltsverzeichnis

Sprachen:

Andere Dell Server Handbücher

Dell

Dell PowerEdge C8000 Bedienungsanleitung

Dell

Dell POWEREDGE 1900 Bedienungsanleitung

Dell

Dell PowerEdge R620 Bedienungsanleitung

Dell

Dell EMC VxFlex Ready Node Benutzerhandbuch

Dell

Dell PowerEdge 1400SC Technisches Handbuch

Dell

Dell PowerEdge R730 Bedienungsanleitung

Dell

Dell PowerEdge C6105 Bedienungsanleitung

Dell

Dell Wyse C10LE Service-Handbuch

Dell

Dell PowerEdge 2500 Leitfaden

Dell

Dell PowerEdge R620 Bedienungsanleitung

Dell

Dell PowerEdge Bedienungsanleitung

Dell

Dell External OEMR T610 Kurzanleitung

Dell

Dell DR4000 Restore Manager Gebrauchsanweisung

Dell

Dell EMC PowerEdge R550 Bedienungsanleitung

Dell

Dell PowerEdge R415 Bedienungsanleitung

Dell

Dell PowerEdge R520 Bedienungsanleitung

Dell

Dell Wyse 5030 Bedienungsanleitung

Dell

Dell PowerEdge 4200 Series Bedienungsanleitung

Dell

Dell PowerEdge R330 Bedienungsanleitung

Dell

Dell PowerEdge C2100 Bedienungsanleitung

Dell

Dell PowerEdge 1500SC Bedienungsanleitung

Dell

Dell PowerEdge R630 Bedienungsanleitung

Dell

Dell PowerEdge T20 Betriebsanleitung

Dell

Dell PowerEdge Programmierhandbuch

Beliebte Server Handbücher anderer Marken

HP AlphaServer ES47 Bedienungsanleitung

PowerNAS

PowerNAS CMA Bedienungsanleitung

Supero

Supero FatTwin F617R3-FT Bedienungsanleitung

EtroVISION

EtroVISION EV3151 Bedienungsanleitung

HP ProLiant Gen9 Bedienungsanleitung

Compaq

Compaq ProLiant 3000 Handbuch

iRobo

iRobo IPC2U Bedienungsanleitung

Nortel

Nortel 1000 Con?guration guide Bedienungsanleitung

Asus

Asus AP7500 Bedienungs- und Wartungshandbuch

Avid Technology

Avid Technology AirSpeed 5000 Bedienungsanleitung

HP Integrity rx2600 Installationsanleitung

Milestone

Milestone Husky IVO 350T Bedienungsanleitung

Planet

Planet NAS-7410 Bedienungsanleitung

Lenovo

Lenovo ThinkSystem SR635 V3 Bedienungsanleitung

Fujitsu

Fujitsu PRIMERGY BX900 Bedienungsanleitung

Asus

Asus RS700DA-E6 PS4 Bedienungsanleitung

Vertiv

Vertiv Avocent ACS6000 Montage- und Wartungsanleitung

A & T Internationale

A & T Internationale Xserve Service-Handbuch