Desa Wall Mantel with Base and Trim WD26CPA Gebrauchsanweisung

www.desatech.com

IMPORTANT: Read entire instruction sheet before as-

sembling or installing mantel kit.

This mantel is only approved for use with any DESA

Heating Products 26" replace system. Do not use mantel

with any other product.

• Mantel pieces - unassembled and marked as follows:

Base #1 Left Front Leg #5 with arrow

Right Side #2 with arrow Header #6 with arrow

Right Front Leg #3 with arrow Top #7

Left Side #4 with arrow

• Hardware package 117197-03

• Trim kit GAB6094

• Trim kit hardware 102866-01

• Bracket hardware kit 118983-01

The hardware package 117197-03 contains the following:

• 2 - 3" screws

• 18 - 1 1⁄4" screws

The bracket hardware kit 118983-01 contains the following:

• 13 - Brackets

• 2 - Flat brackets

• 36 - Wood screws

Tools and items required:

• #2 Phillips driver bit (3 1/2" minimum length)

• Slotted screw driver

• Measuring tape

• Pencil

• Drill Driver

If any wood pieces are missing or damaged, contact the

dealer where you purchased this mantel for replacement.

If hardware or trim is missing or damaged, contact DESA

Heating Products at 1-866-672-6040 for referral and war-

ranty information. You can also visit DESA Heating Products'

technical service web site at www.desatech.com.

Note: Gather all mantel pieces together before assembling

mantel.

WARNING: Only use 1 1/4" screws in pocket holes

to assemble mantel. Damage to mantel will result if

other screws are used for this purpose.

WARNING: Use only 1/2" or 3/4" screws with brack-

ets in hardware pack 118983-01. Damage to mantel will

result if other screws are used for this purpose.

WS26CP and WD26CPA

Wall Mantel with Base and Trim

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Firebox

Perimeter

Trim Included

With This

Mantel

www.desatech.com 119793-01B

Left Side

Right Side

Header

ASSEMBLING MANTEL

IMPORTANT: More than one person is required to lift

assembled mantel. Lift mantel by leg assemblies. Lifting

by header or mantel top could damage mantel.

1. Layrightfrontleg(#3)onoor.Positionrightside(#2)as

shown in Figure 1. Align predrilled screw holes in front

legandside.Makesureendsareush.Attachwithtwo

or three 1 1/4" wood screws, depending on your model.

Repeat for other leg using #4 and #5.

2. Each leg assembly will use 3 brackets for stability. Your

bracket hardware kit will contain either 1/2" or 3/4" screws.

Using two 1/2" or 3/4" screws, install a bracket in the center

of each leg assembly and one at each end within 1" of but

not over the last pocket hole (see Figure 2).

3. Place header (#6) between right and left leg assemblies

(see Figure 3). The top of header must be ush with

top of side leg assemblies. Attach header using 1 1/4" in

pocket holes on each leg assembly as shown in Figure 3.

Be sure you have proper alignment between the header

andlegassemblies.Attachatbracketswith1/2"or3/4"

screwsusing1atbracketand4screwsperside(see

Figure 4).

Figure 3 - Installing Header

Attach Mantel

to Base

Attach Sides

to Top

Figure 1 - Assembling Legs

1 1/4"

Wood

Screws

Leg

Leg Side

Brackets

1/2" or 3/4"

Screw

1/2" or 3/4" Screw

Figure 2 - Installing Brackets to Legs

4. Turn top (#7) and leg assembly upside down. Place leg

assembly inside top (see Figure 5, page 3).

5. Makesurerearoflegassembliesareushwithbackof

top and mantel is centered left to right inside top. Square

leg assemblies evenly with sides of mantel top, making

certain gap between mantel top and leg assembly is

the same from front to back. Use 1 1/4" screws in pocket

holes in sides to attach to top of mantel (see Figure 5,

page 3).

6. Attach supplemental brackets using 1/2" or 3/4" screws

provided in bracket hardware pack. Use 3 brackets to

attach top to mantel assembly - one at back of each leg

assembly and one at center of header (see Figure 6,

page 3).

7. Place mantel base (#1) next to wall at installation location.

Seereplaceowner'smanualforinstallationclearances.

Flat

Bracket

1/2" or 3/4"

Screws

Header

Leg

Assembly

1 1/4"

Screws

Figure 4 - Installing Header Brackets

www.desatech.com

119793-01B 3

Figure 5 - Placing Mantel Assembly onto Mantel Top

Top

Leg

Assembly

Figure 8 - Assembling Trim

ASSEMBLING TRIM (FOR GAS FIREPLACES

ONLY)

1. Remove packaging from three pieces of trim.

2. Locate two adjusting plates with set screws, and two

shims in the hardware packet.

3. Align shim under adjusting plate as shown in Figure 8.

4. Slide one end of adjusting plate/shim in slot on mitered

edge of top trim (see Figure 8).

5. Slide other end of adjusting plate/shim in slot on mitered

edge of side trim (see Figure 8).

6. Whilermlyholdingedgesoftrimtogether,tightenboth

set screws on the adjusting plate with slotted screw-

driver.

7. Repeat steps 2 through 6 for other corner.

Side Trim

Slot

Top Trim

Mitered Edge

Shim

Set Screws

Adjusting

Plate

Slot

Figure 7 - Attaching Mantel Assembly to Base

Mantel

Base

Mantel

Assembly

8. Place mantel assembly onto mantel base and center

left to right with back of assembly ush with back of

base (see Figure 7, page 3). Use 1 1/4" screws in pocket

holes to attach mantel assembly to mantel base. Using

brackets and 1/2" or 3/4" screws from this hardware kit

(118983-01) attach support brackets to base and mantel

assembly - one at each back corner of the leg sides and

one on each leg front (see Figure 7).

Figure 6 - Adding Brackets to Mantel Top

1/2" or 3/4"

Screw

1 1/4"

Screws

Bracket

1 1/4"

Screws

1/2" or 3/4"

Screws

Bracket

2701 Industrial Drive

P.O. Box 90004

Bowling Green, KY 42102-9004

Technical Service and Parts:

1-866-672-6040

119793-01

Rev. B

09/06

NOT A UPC

119793 01

Figure 10 - Attaching Fireplace to Mantel Base

Shoulder

Screw

Assembled

Trim

Figure 9 - Inserting Fireplace Into Cabinet Mantel

INSTALLING FIREPLACE

1. Fireplace should be fully assembled. See Assembling

Fireplaceinreplaceowner’smanual.

2. Install gas line. See Connecting To Gas Supplyinre-

place owner’s manual. Remember to leave access to

the gas shutoff valve somewhere on the base or where

it is accessible to the user.

3. Check for leaks. See Checking Gas Connections in

replaceowner’smanual.

4. Positionreboxinsidemantel,carefullypositioninggas

lines (see Figure 9). IMPORTANT: Use caution when

positioningreplaceonmantelbase.Basemayscratch

easily.

Hole for Attaching

Fireplace to Wooden

Mantel Base

Bottom Louver

Door

5. Place trim kit on the shoulder screws located on the

sideandtopofthereplace.Firmlysnapthetrimover

theshoulderscrewsonreplace(seeFigure9).Align

replaceinmantelassemblysothatthetrimoverlaps

the mantel evenly on all three sides.

6. Lower bottom louver door. Use two 3" wood screws pro-

videdinhardwarepackageandattachreplacebaseto

wooden base (see Figure 10). Close louver door.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Desa Kaminzubehör Handbücher

Desa

Desa 102865-01 Bedienungsanleitung

Desa

Desa DVC36 Kurzanleitung

Desa

Desa W23FT Gebrauchsanweisung

Desa

Desa Proflame 584 Bedienungsanleitung

Desa

Desa Wall Mantel and Base W26ME Gebrauchsanweisung

Desa

Desa C26TO Gebrauchsanweisung

Desa

Desa Mantel and Base W26RO Gebrauchsanweisung

Desa

Desa W32GO Gebrauchsanweisung

Desa

Desa GA6050 Bedienungsanleitung

Desa

Desa Mantel and Base W32RO Gebrauchsanweisung

Desa

Desa Mantel and Base W26TO Gebrauchsanweisung

Desa

Desa W23OT Gebrauchsanweisung

Desa

Desa Wall Mantel and Base W32MF Gebrauchsanweisung

Desa

Desa W32CO Gebrauchsanweisung

Desa

Desa Wall Mantel and Base W32LT Gebrauchsanweisung

Desa

Desa Wall Mantel and Base W26LC Gebrauchsanweisung

Desa

Desa PC-BDV37N Bedienungsanleitung

Desa

Desa Wall Mantel and Base W32LS2 Gebrauchsanweisung

Desa

Desa Mantel and Base W21TO Gebrauchsanweisung

Desa

Desa GA3555 Bedienungsanleitung

Desa

Desa Wall Mantel and Base with Trim W32KCSA Gebrauchsanweisung

Desa

Desa W32AOSA Gebrauchsanweisung

Desa

Desa VCBK4L Bedienungsanleitung

Desa

Desa Wall Mantel and Base W26LT Gebrauchsanweisung

Beliebte Kaminzubehör Handbücher anderer Marken

Valor

Valor L2 1700K Bedienungsanleitung

Exodraft

Exodraft Xzense Bedienungsanleitung

Whalen

Whalen Ruso MNFP62BF23-6 Bedienungsanleitung

Lopi

Lopi Hearthview 864 Bedienungsanleitung

Woodstock Soapstone

Woodstock Soapstone Fireview 201 Bedienungsanleitung

EdilKamin

EdilKamin SERBATOIO 250 Kurzanleitung

Bronpi

Bronpi KIT-1 Bedienungsanleitung

Town & Country Fireplaces

Town & Country Fireplaces 22150051 Bedienungsanleitung

Travis Industries

Travis Industries 33 DVI Bedienungsanleitung

Superior

Superior ASD3628-TI Bedienungsanleitung

pleasant hearth

pleasant hearth OFP28WG Bedienungsanleitung

IHP

IHP Astria Series Bedienungsanleitung

Firegear

Firegear FG-H-2110SS Bedienungsanleitung

Nibe

Nibe Contura C i31 Bedienungsanleitung

kozy heat

kozy heat KZK-052 Bedienungsanleitung

SimpliFire

SimpliFire SF-WM36 Bedienungsanleitung

Bluegrass Living

Bluegrass Living BC18NR Kurzanleitung

pleasant hearth

pleasant hearth IRIS SCROLL Bedienungsanleitung