Digital Equipment VAX 4000 500A Bedienungsanleitung

VAX4000

Model500A/505A/600A/700A/705A

InstallationChecklist

Order Number: EK–492AB–IC. B01

Digital Equipment Corporation

Maynard, Massachusetts

First Printing, December 1991

Revised, February 1992

Revised, April 1992

Revised, July 1992

Revised, July 1993

Revised, July 1994

The information in this document is subject to change without notice and should not be construed

as a commitment by Digital Equipment Corporation.

Digital Equipment Corporation assumes no responsibility for any errors that may appear in this

document.

The software, if any, described in this document is furnished under a license and may be used or

copied only in accordance with the terms of such license. No responsibility is assumed for the use

or reliability of software or equipment that is not supplied by Digital Equipment Corporation or its

afﬁliated companies.

Restricted Rights: Use, duplication or disclosure by the U.S. Government is subject to restrictions

as set forth in subparagraph (c)(1)(ii) of the Rights in Technical Data and Computer Software clause

at DFARS 252.227–7013.

The following are trademarks of Digital Equipment Corporation: CompacTape, CX, DDCMP, DEC,

DECconnect, DECdirect, DECnet, DECscan, DECserver, DECUS, DECwindows, DELNI, DEMPR,

DESQA, DESTA, DSRVB, DSSI, IVAX, KDA, KLESI, KRQ50, MicroVAX, MSCP, Q–bus, Q22–bus,

RA, RQDX, RV20, SA, SDI, ThinWire, TK, TMSCP, TQK, TS05, TU, VAX, VAX 4000, VAXcluster,

VAX DOCUMENT, VAXELN, VAXlab, VAXserver, VMS, VT, and the DIGITAL logo.

All other trademarks and registered trademarks are the property of their respective holders.

FCC NOTICE: The equipment described in this document generates, uses, and may emit radio

frequency. The equipment has been type tested and found to comply with the limits for a Class A

computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide

reasonable protection against such radio frequency interference.

Operation of the equipment in a residential area may cause interference, in which case the user

at his own expense will be required to take whatever measures may be required to correct the

interference.

S2577

This document was prepared using VAX DOCUMENT Version 2.1.

1 Preinstallation Requirements

Documents You Will Need

To install and use your system, you need the following documents.

• These manuals from the Customer Hardware Information Kit:

Site Preparation

Installation

Operation

Troubleshooting and Diagnostics

• Console terminal documents found with the console terminal

• Documents for any other devices such as expanders or printers

• Operating system and/or factory-installed software documents

If you are installing a DSSI VAXcluster conﬁguration, and you are a licensed

self-maintenance customer, you should be familiar with the contents of your

DSSI VMScluster Installation and Troubleshooting manual.

Caution

Review the system warranty. The terms of your agreement with Digital

may require that a Digital service representative install your system.

Contact your local Digital representative if you have any questions.

Questions, Problems or Concerns?

Call Digital’s toll-free hotline 24 hours a day:

In the U.S., 1–800–DEC–8000

In Canada, 1–800–267–5251

2 Installation Procedures

Assumptions

This checklist assumes that your entire system arrived and that you are ready to

unpack and place it in its appropriate location.

How to Use This Checklist

Use this checklist in conjunction with, not as a replacement for, your system

Installation manual. The numbered procedures in this checklist correspond to the

numbered procedures in that manual.

Each procedural step in this checklist makes reference (in parentheses) to the

manual that contains more information about the step. As you complete each

step in the Installation manual:

1. Refer back to this checklist.

2. Verify that you performed the required task.

3. Check the appropriate box.

2.1 Verify Site Preparation

Is there adequate power for your system and its peripherals? (Site

Preparation)

If you are installing a DSSI conﬁguration, did you make sure your site power

distribution system does not have any grounding faults? (Site Preparation)

Are you allowing enough space for your system? (Site Preparation)

Does your site maintain the proper environmental operating conditions? (Site

Preparation)

Did you gather the tools you will need? (Installation)

2.2 Check the Shipment

Did you unpack all the shipping cartons? (Installation)

Did you check the Product Delivery Document against the Content Listing or

Barcode Label for each carton? (Installation)

Did you compare the contents of your cartons with the Content Listing for

each carton? (Installation)

2.3 Position the System

Does the location for your system meet the system’s weight and space

requirements? (Installation, Site Preparation)

2.4 Open the System Doors

Did you ﬁnd the key to the lock in the shipping carton? (Installation)

Did you turn that key to the bottom position to unlock the upper and lower

doors? (Installation)

2.5 Install the Console Terminal

Did you unpack the console terminal components? (Terminal installation

guide)

Did you connect all console terminal components? (Terminal installation

guide)

Did you turn on the console terminal and observe proper self-tests? (Terminal

owner’s manual)

Did you perform setup operations for the console terminal? (Terminal owner’s

manual)

Did you turn off the console terminal? (Installation)

Did you connect the console terminal cable from the rear of the console

terminal to the system console module? (Installation)

2.6 Set the System Controls

Did you set the Power switch to off (0)? (Installation)

On each ISE did you set the Write-Protect button to the out (write-enabled)

position and the Run/Ready button to the in (ready) position? (Installation)

Did you verify that a uniquely numbered bus node ID plug is inserted

into each ISE and TF-series or TLZ04 tape drive installed in your system?

(Installation)

Did you set the Halt button to the out (run) position? (Installation)

Did you set the Power-Up Mode switch to Language Inquiry mode (indicated

by a human proﬁle)? (Installation)

Did you make sure that the system and console-terminal baud rate settings

are the same? (Installation)

Did you set the Break Enable/Disable switch to the up (enabled) position?

(Installation)

Does your system have a TK-series or TF-series tape drive? If so, did

you make sure the Cartridge Insert/Release handle is closed (pushed in)?

(Installation)

2.7 Connect Additional Devices to the System

Did you connect terminals and printers to the system? (Installation)

Did you connect telephone modems to the system? (Installation)

Did you connect the system to a network? (Installation)

Did you connect the KZQSA internal cable, if required? (Installation)

2.8 Connect an Expander, If Required

Are you installing an expander with your system? If so, begin installing the

expander now. When the installation is complete, return to this checklist.

(Expander manual, system Installation)

If you are installing a DSSI conﬁguration, did you connect a ground cable

between the expander and your system? (Installation)

2.9 Connect the System Power Cable

Did you turn off the system and all its devices? (Installation)

Did you connect the power cable to the system and to a wall outlet or other

power source? (Installation)

2.10 Turn On the System and Select a Language

Did you turn on the console terminal and observe proper self-tests? (Terminal

owner’s manual)

Did you turn on the system by setting the Power switch to on (1)?

(Installation)

Did you select a language and save it by turning the Power-Up Mode switch

to Run mode (indicated by an arrow)? (Installation)

2.11 Close the System Doors

Did you close the front doors? (Installation)

Did you turn the key to the middle position to lock both doors or to the top

position to leave the upper door unlocked? (Installation)

3 After Installation

Did you learn how to operate the system controls and mass storage devices?

(Operation)

Did you run the MicroVAX Diagnostic Monitor (MDM) software, if ordered?

(Troubleshooting and Diagnostics)

Did you start up and modify factory-installed software, if present? (VMS

Factory Installed Software User Guide)

Did you install the operating system software? (Software installation manual)

If you installed a DSSI conﬁguration, did you make sure that the ground

offset voltage does not exceed the limit? (Installation)

Andere Handbücher für VAX 4000 500A

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Digital Equipment Desktop Handbücher

Digital Equipment

Digital Equipment CELEBRIS Pentium PC Bedienungsanleitung

Digital Equipment

Digital Equipment AlphaStation 600 Series Handbuch

Digital Equipment

Digital Equipment VAX 4000 Model 300 Bedienungsanleitung

Digital Equipment

Digital Equipment Personal DECstation 5000 50 Handbuch

Digital Equipment

Digital Equipment VAX 4000 500A Bedienungsanleitung

Digital Equipment

Digital Equipment 7000 AXP System Bedienungsanleitung

Digital Equipment

Digital Equipment DEC 3000 300 AXP Series Gebrauchsanweisung

Digital Equipment

Digital Equipment DECstation 212LP Bedienungsanleitung

Digital Equipment

Digital Equipment VAXft Systems 810 Bedienungs- und Montageanleitung

Digital Equipment

Digital Equipment DECpc AXP 150 Bedienungsanleitung

Digital Equipment

Digital Equipment DEC 3000 500X AXP Bedienungs- und Montageanleitung

Digital Equipment

Digital Equipment PDP-12 Bedienungsanleitung

Digital Equipment

Digital Equipment VAX 4000 Model 300 Bedienungsanleitung

Digital Equipment

Digital Equipment DEC 3000 600 AXP Bedienungs- und Montageanleitung

Digital Equipment

Digital Equipment VAXstation VLC Kurzanleitung

Digital Equipment

Digital Equipment DECpc LP Bedienungsanleitung

Digital Equipment

Digital Equipment DECstation 5000 Kurzanleitung

Digital Equipment

Digital Equipment VAX 4000 100 Service-Handbuch

Digital Equipment

Digital Equipment EK-VT100-UG-001 Bedienungsanleitung

Digital Equipment

Digital Equipment DECstation 5000/100 Series Betriebsanleitung

Digital Equipment

Digital Equipment VT420 Bedienungsanleitung

Digital Equipment

Digital Equipment Digital AlphaStation 200 Series Handbuch

Digital Equipment

Digital Equipment VAXstation 4000/60 Bedienungs- und Montageanleitung

Digital Equipment

Digital Equipment Digital AlphaStation 400 Series Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung

HP Z1 Bedienungsanleitung

Everex

Everex eXplora Bedienungsanleitung