9403.CHRYSLER22 1.09 2022 Dodge/Ram Charger (Smart Key)
©2023 Directed. All rights reserved.
Vehicle connections
The connection information listed below is specific to the 2022 Dodge/Ram Charger (Smart Key). Refer to “Pre-installation and application warnings” for a list of important notes.
Data 14-pin blue connector (H1)
Module Connects To
Conn./Pin Color Description Wire Location (+/-) Wire Color
H1/1 Light Green No Connection No Connection
H1/2 Violet/Yellow No Connection No Connection
H1/3 Tan/Black (DATA) HS CAN High 2 White CAN Junction Block under driver dash, green 3 pin plug, pin 1 Data White/Gray (CAN IHS)
H1/4 Tan (DATA) HS CAN Low 2 White CAN Junction Block under driver dash, green 3 pin plug, pin 2 Data White/Orange (CAN IHS)
H1/5 Orange/Green (DATA) HS CAN High 1 Green CAN Junction Block behind glove box, white 3 pin plug, pin 1 Data White/Green (CAN C)
H1/6 Orange/Brown (DATA) HS CAN Low 1 Green CAN Junction Block behind glove box, white 3 pin plug, pin 2 Data White/Blue (CAN C)
H1/7 Brown Relay N.O. - No Connection No Connection
H1/8 Yellow Relay COM. - Immo. Data Interrupt (vehicle side) Keyless Ignition Node (Start Stop Button), black 6 pin plug, pin 5 Data White/Lt. Green
H1/9 Orange/Yellow Relay N.C. - Immo. Data Interrupt (conn.side) Keyless Ignition Node (Start Stop Button), black 6 pin plug, pin 5 Data White/Lt. Green
H1/10 Orange/Red Relay N.C. - No Connection No Connection
H1/11 Yellow/Red Relay COM. - No Connection No Connection
H1/12 Brown/Red Relay N.O. - No Connection No Connection
H1/13 Red (+) W2W Only - 12 Volt Remote Starter
H1/14 Black (-) W2W Only - Ground Remote Starter
Output 12-pin red connector (H2)
Module Connects To
Conn./Pin Color Description Wire Location (+/-) Wire Color
H2/1 Black/White No Connection No Connection
H2/2 Green/Black No Connection No Connection
H2/3 Green/White (-) W2W Only - Door Output Remote Starter
H2/4 Red/Black (-) W2W Only - Trunk Output Remote Starter
H2/5 Violet/White (AC) W2W Only - Tach Output [2] Remote Starter
An optional connection required on some remote starters, which do not
support a tach signal in D2D.
H2/6 Gray (+) W2W Only - Brake Output
H2/7 Gray/Black (+) PTS Output Keyless Ignition Node (Start Stop Button), black 6 pin plug, pin 4 + Violet/Lt. Blue
H2/8 Violet/Green No Connection No Connection
H2/9 Violet/Brown (MUX) Parking Light Output Headlight Switch, black 6 pin plug, pin 3 MUX White/Brown
H2/10 Yellow/Black No Connection No Connection
H2/11 Orange/Black No Connection No Connection
H2/12 Blue/Red (-) W2W Only - Hood Output Remote Starter
