Dometic TRIM LINE 9472 010 Series Bedienungsanleitung

This manual must be read and

understood before installation,

adjustment, service, or mainte-

nance is performed. This unit must

be installed by a qualied service

technician. Modification of this

product can be extremely hazard-

ous and could result in personal

injury or property damage.

Lire et comprendre ce manuel avant

de procéder à l'installation, à des ré-

glages, de l'entretien ou des répara-

tions. L'installation de cet appareil doit

être effectuée par un réparateur quali-

é. Toute modication de cet appareil

peut être extrêmement dangereuse et

entraîner des blessures ou dommages

matériels.

USA

SERVICE OFFICE

Dometic Corporation

1120 North Main Street

Elkhart, IN 46514

CANADA

Dometic Corporation

46 Zatonski, Unit 3

Brantford, ON N3T 5L8

CANADA

SERVICE CENTER &

DEALER LOCATIONS

Please Visit:

www.eDometic.com

RECORD THIS UNIT INFORMATION FOR

FUTURE REFERENCE:

Model Number ____________________

Serial Number ____________________

Date Purchased ____________________

Important: These Instructions

must stay with unit.

Owner read carefully.

REVISION A

Form No. 3307958.045 09/16

(French 3307959.043_A)

LaGrange, IN 46761 U.S.A.

INSTALLATION

INSTRUCTIONS

Models

9472XX.010

9472XX.013

9472XX.016

9472XX.5XX

9479XX.010

TRIM LINE

RV SCREEN ROOM

SAFETY INSTRUCTIONS

This manual has safety information and instruc-

tions to help users eliminate or reduce the risk

of accidents and injuries.

RECOGNIZE SAFETY INFORMATION

This is the safety-alert symbol. When you see this

symbol in this manual, be alert to the potential

for personal injury.

Follow recommended precautions and safe op-

erating instructions.

UNDERSTAND SIGNAL WORDS

A signal word , WARNING OR CAUTION is used

with the safety-alert symbol. They give the level

of risk for potential injury.

indicates a potentially hazard-

ous situation which, if not avoided, could result

in death or serious injury.

indicates a potentially hazard-

ous situation which, if not avoided, may result in

minor or moderate injury.

used without the safety alert

symbol indicates, a potentially hazardous situa-

tion which, if not avoided, may result in property

damage.

Read and follow all safety information and in-

structions.

TRIM LINE SCREEN ROOM

INSTALLATION

APPLICATION:

The A&E Trim Line Screen Room is available in sizes to

correspond with the various sizes of Trim Line Awnings.

TOOLS REQUIRED FOR INSTALLATION:

Pencil 1/8 Drill Bit

Measuring Tape Center Punch

Phillips Screwdriver Hammer/Mallet

Drill (for Hook Stakes)

IMPORTANT: Read the entire installation procedure

before starting the installation.

Dometic Corporation reserves the right to modify appear-

ances and specications without notice.

INSTALLATION

During installation, care must be taken not to scrape and

damage the panel and skirt.

1. In order to correctly match the Screen Room to

the right size Trim Line Awning, you must know the

length of the awning. See FIG. 1A.

The A&E Trim Line Screen Room consists of (1)

continuous panel for the front/sides, a rear skirt and

wheel cover. See FIG. 1B.

FIG. 1A

SELECTING THE

CORRECT SIZE

LENGTH

(AWNING SIZE)

FIG. 1B

FIG. 1C

SNAP

FASTENER &

SCREW

STAKE

FRONT & SIDE

PANELS ARE ONE PIECE

The above-mentioned panel and skirt are secured to

the vehicle, the awning and to the ground by means

of zippers, snap fasteners, PE clips, and hook

stakes (provided). See FIG. 1C.

SIDE OF

VEHICLE

FRONT

SUPPORT

SIDE RAFTER POLE

AWNING FABRIC

SIDE VIEW

FIG. 2

FIG. 3

Zippers sewn on side

and under valance

6. Be sure the aps are folded out from the screen

room. Starting at the roof, align top snap fasteners

on each side ap to wall of camper. Locate posi-

tions of snap fasteners and mark with pencil. Drill

1/8” holes and install snap fastener with protruding

section pointing toward the screen room. Repeat on

other side. See FIG. 5. (See also specic instruc-

tions in Constellation Supplement to Campers

Owner’s Manual.)

7. Align skirt at the right hand ap of screen room and

frame of camper. Attach PE clips sewn on skirt onto

frame ledge on underside of camper. See FIG. 4.

Attach PE clips or

hook strips to frame

Align skirt with right hand ap

of screen room

FIG. 4

Attach skirt to screen room

with hook & loop

fasteners.

8. Secure bottom of panels by driving the hook stakes

into the ground through the appropriate grommet.

Wrap screen room aps around roof jacks. (See

FIG. 5)

9. Attach skirt to Screen Room with hook and loop

fasteners sewn into room and skirt. See FIG. 4.

Tie straps attach

around support pole

Grommets (7)

sets per unit

FIG. 5

Snap fastener (3 or 4)

on each side ap.

Snap fasteners

to point towards

screen room.

Wrap aps around

roof jacks

Note: The inner and outer sides of all panels can be

checked by looking at the snap fasteners. The round

black plastic ring in the vertical edge hems is on the in-

side surface.

2. Set up awning for installation of Trim Line Screen

Room.

3. To facilitate accurate installation, vehicle should be

parked on reasonably at ground.

Open awning and install front support and side rafter

pole as shown in FIG. 2

4. After awning is set up, remove screen room from

carton, check for correct size and position it with

awning as shown in FIG. 3.

5. Fasten front of screen room to Trim Line bag awning

by joining zippers. Start at awning front and fasten

side panels to bottom side of awning. When attach-

ing screen room to awning at bag, pull bag down

and away from awning, making sure screen room is

fastened completely.

WHEEL COVER

MOUNTING INSTRUCTIONS

1. Place the wheel cover in position to cover the wheel

opening and mark the locations of the snap fasten-

ers. See FIG. 6.

Note: The .570 model wheel well skirt is supplied at a

longer length to cover a dual-axle wheel cover. Custom-

ers w/single –axle trailers will need to fold skirt in half so

that 3 snap fasteners are visible and then cut away the

excess panel.

2. With a 1/8” drill bit, pilot drill a shallow hole at each

marked location and install a snap fastener (provid-

ed in plastic bag) with the protruding section facing

down toward the ground See FIG. 6.

3. Install the wheel cover by eyelet on the wheel cover

under the protruding part of the snap fastener, and

then push the eyelet up and onto the snap fastener

to connect. See FIG. 6.

FIG. 6

STORING TRIM LINE SCREEN ROOM

A convenient storage bag is provided to store the Screen

Room.

Screen Room should be dry before storing.

IMPORTANT- SNAP STUD

OPERATION

To attach screen room side panel or wheel well cover

to side of camper, insert the protruding thumb-like por-

tion of the snap stud, on the side of the camper, into

the black plastic ring of the snap fastener crimped into

the hems. Push or snap, the other side of the fastener

over the back side of the stud.

To detach Screen Room Side Panel or Wheel Well

Cover from the side of the trailer, pull on the hem edge

lifting the grommet off of the non-protruding side of

the snap stud. Do not force or pull from the protruding

side of the stud, as this may cause grommets attached

to the fabric to become separated from the fabric or

may damage the snap fastener.

Do not operate appliances venting into this

room enclosure with privacy panels closed.

At least one panel must be open for ventila-

tion when using appliances. Death or seri-

ous injury from Carbon Monoxide Poisoning

could occur if not operated properly.

4. Take the 3 inch pieces of hook and loop strip; re-

move peel strip and stick them onto the screen room

skirting opposite the hook and loop strips on the

wheel cover. See FIG. 6.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Dometic Zubehör Handbücher

Dometic

Dometic PerfectWall PW1000 Bedienungsanleitung

Dometic

Dometic Coolfreeze CF11 Bedienungsanleitung

Dometic

Dometic CK40D Hybrid Bedienungsanleitung

Dometic

Dometic CFX50 Bedienungsanleitung

Dometic

Dometic LA-03 Bedienungsanleitung

Dometic

Dometic PerfectWall PW1000 Bedienungsanleitung

Dometic

Dometic PerfectWall PW1000 Bedienungsanleitung

Dometic

Dometic Waeco CoolMatic CS-SC Bedienungsanleitung

Dometic

Dometic CFX3 Series Bedienungsanleitung

Dometic

Dometic TROPICOOL TCX07 Bedienungsanleitung

Dometic

Dometic PR4500 Bedienungsanleitung

Dometic

Dometic PRO WINDBREAK 1 Bedienungsanleitung

Dometic

Dometic 9500 200 003 Series Bedienungsanleitung

Dometic

Dometic CFX65 Bedienungsanleitung

Dometic

Dometic CFX3 Series Bedienungsanleitung

Dometic

Dometic 103EAA Bedienungsanleitung

Dometic

Dometic A&E Systems 8500 Leitfaden

Dometic

Dometic CFX3 Series Bedienungsanleitung

Dometic

Dometic PERFECTWALL PW1100 Bedienungsanleitung

Dometic

Dometic CK40D Hybrid Bedienungsanleitung

Dometic

Dometic Waeco CoolFun PB 306 Bedienungsanleitung

Dometic

Dometic Solar Shade 200 Bedienungsanleitung

Dometic

Dometic CFX Series Bedienungsanleitung

Dometic

Dometic PERFECTROOF PR2500 Bedienungsanleitung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung