Drive 15005L Montageanleitung

Owner’s Manual and Assembly Instructions

Model # 15005L

Drive Full Electric Low Height Bed

This manual must be given to the Owner/User

of this bed and should be read carefully before

putting this product into use. Keep manual in

an accessible location for future reference.

Click here to view detailed product information and pricing. Call 800-397-5899 to order today!

TABLE OF CONTENTS

Packaging and Handling........................................................................................................................ 1

Unpacking .......................................................................................................................................... 1

Inspection........................................................................................................................................... 1

Storage .............................................................................................................................................. 1

Assembly Instructions........................................................................................................................... 2

Operation................................................................................................................................................. 6

Hand Control...................................................................................................................................... 6

Caster Lock and Floor Lock Feature.................................................................................................. 6

Bed Rail Installation ............................................................................................................................... 7

Mattress Retainer Adjustment............................................................................................................... 8

Manual Hi/Lo Adjustment Crank ........................................................................................................... 8

Maintenance & Safety Checks............................................................................................................... 9

Warnings ............................................................................................................................................... 10

NOTE: DO NOT operate this product without rst reading and understanding this user manual. Damage or

injury may result from improper use of this product.

Packaging / Handling

Unpacking

1. Check cartons for any obvious damage to packaging or contents. If damage is evident,

contact your local Drive Medical dealer/provider.

2. Remove any lose packaging from the cartons.

3. Carefully remove all components from the cartons.

The Two Cartons will contain the following components:

#15215 HeadSpring and Head Board w/casters

#15216 Foot Spring and Foot Board w/ junction box, 3 motor/actuators,

Hand Pendant Control, Emergency Crank Handle.

Inspection

1. Examine each component carefully for damage, scratches, dents or any other visual damage.

2. Carefully remove Tie Wraps holding power cord, hand pendant and drive shaft.

3. Inspect power cord and plug for cuts or damage.

4. Inspect the junction box and motors for damage, loose connections, cuts or damage to the wires.

5. Ensure motor connections to junction box are connected correctly and secure.

Storage

1. If the bed is not assembled immediately, retain cartons and packaging for storage until assembly is

completed.

2. Store the packaged bed in a dry area.

3. DO NOT place other objects on top of the packaged bed cartons.

Assembly Instructions

1 Conrm that all parts are present:

A. Foot Spring w/

• 3 motor/actuators

• Junction Box

• Hand Pendant

• Power cord & plug

B. Head Spring

C. Low Height Head Board

D. Low Height Foot Board

E. Hi/Low Drive Shaft

F. Locking Pins (2)

G. Hand Crank

H. Casters (4) – 2 locking, 2 non-locking

I. Head/Foot Pull Tube Transport Straps

A B

Caution: DO NOT attempt to operate bed controls until completion of assembly as damage to bed

components and/or personal injury may occur.

Assembly Instructions (Continued)

2. With the Head and Foot Spring positioned upright, connect Head Spring by aligning with foot spring and

swinging both ends away from each other.

3. Optional: Insert lock pin through connected sleep surface and secure with spring clip.

4. Connect Head Spring and Foot Spring Pull Tube to provide the up/down motion/adjustment of the Head

and Foot Spring Sections:

A. Extend the Head Spring Pull Tube and connect to the Head Spring Lift Arm. Secure in place with the

tethered locking pin and clip

B. Extend the Foot Spring Pull Tube and connect to the Foot Spring Lift Arm.

Secure in place with the tethered locking pin and clip

Assembly Instructions Cont.

5. Install the casters by inserting the stem of the

caster into the leg receptacle. It is recommended

to install one locking caster and one non-locking

caster on each bed end. The locking casters

should be installed diagonally from each other.

The 15005L Low Height bed gives you the option of

installing the casters on the inboard non adjustable

legs or the outboard adjustable legs. To achieve

the full low height feature, install the casters on the

inboard non-adjustable legs.

6. Carefully lower the bed frame at onto the oor. Attach the Head

and Foot Boards by tilting the Boards toward your body and aligning

mounting pins located on the Spring Sections with the Hooks on the

Head/Foot Boards.

NOTE: The Head Board is taller than the Foot Board, however, they

are interchangeable with each other.

7. Assemble Hi/Lo Drive Shaft and adjust to the proper length so it will

t between the Head Board drive pin and Hi/Lo Motor drive pin at the

foot end.

• Lift the Head Spring and install the foot end of the Hi/Lo Drive Shaft to the Hi/Lo Motor drive pin, then

install head end of the Hi/Lo Drive Shaft to the Head Board drive pin.

• Hi/Lo Drive Shaft is spring loaded so it will t securely between these two points.

• Adjust length of Hi/Lo Drive Shaft if it is too long or too short.

StemLeg Receptacle

Assembly Instructions Cont.

8. Release the spring loaded shaft on

the hi/low motor and insert the shaft

into the gear box on the footboard.

9. Make sure the slot on the spring

loaded shaft engages the roll pin on

the gear box.

10. Raise the Head Spring and Foot Spring to release tension between the springs and connect Head and

Foot spring fabric by squeezing together and attaching with spring links.

Operation

Hand Control

The Model #15005L Low Height Bed comes with a 3 Function hand held Pendant.

• Top Buttons control raising and lowering the Head Section;

• Middle Buttons control raising and lowering the Foot Section;

• Lower Buttons control raising and lowering the entire bed.

Caster Lock and Floor Lock Feature

When the bed is in its lowest height position, the Casters will come in contact with the oor and

the bed will roll freely. Engaging the Caster Locks will help hold the bed in place.

When the bed height is raised, the legs will come in contact with the oor and the casters will be raised off the

oor providing a stable base for the bed frame.

Bed Rail Installation

The Deck Frame contains labels that provide the location for installing Half Rails and Full Rails.

• On the Head Section and Foot Sections, a Label will indicate the notch location for alignment of the Full

Rail Cross Brace that must be positioned in between the two black springs. A second Label will indicate

alignment for the Half Rail clamp to be positioned with the Black Spring centered between the clamp.

Half Rails Full Rails

Mattress Retainer Adjustment

Manual Hi/Lo Adjustment Crank

Before a mattress is laid on the bed, ip up the mattress guard to reduce the movement of the mattress.

In the event of a loss of power or Hi/Lo motor malfunction; the Hi/Lo feature can be manually adjusted using

the Hand Crank. The Hand Crank can be operated in two locations: directly into the Head or Foot board

gear box or from the top of the Head or Foot Board access port.

WARNING: Manual Hi/Lo Adjustment Crank MUST BE REMOVED before the bed is used. Failure to remove

the crank may cause damage to the bed and/or personal injury to those in the room.

Inhaltsverzeichnis

Andere Drive Medizinische Geräte Handbücher

Drive

Drive 16500BV Bedienungsanleitung

Drive

Drive Quad Cane With Gel Grip Bedienungsanleitung

Drive

Drive Winnie wagon Bedienungsanleitung

Drive

Drive HANDY-OX 18720 Bedienungsanleitung

Drive

Drive RTL12087 Bedienungsanleitung

Drive

Drive NEB KIT 500 Bedienungsanleitung

Drive

Drive AGF-5X Bedienungsanleitung

Drive

Drive Med-Aire Edge Bedienungsanleitung

Drive

Drive 12005KD-1 Bedienungsanleitung

Drive

Drive DeVilbiss Healthcare Vacu-Aide 7325 Series Handbuch

Drive

Drive 13069 Bedienungsanleitung

Drive

Drive 13605 Montageanleitung

Drive

Drive Evolution OM-900 Bedienungsanleitung

Drive

Drive DeVilbiss Healthcare Hybrid-Power Bedienungsanleitung

Drive

Drive Bonsai OM-824 Bedienungsanleitung

Drive

Drive DeVilbiss Med Aire DuoWave Bedienungsanleitung

Drive

Drive Gravity 6 Bedienungsanleitung

Drive

Drive AIRIAL CHAMBER Bedienungsanleitung

Drive

Drive DeVilbiss Eclipse II with Dial Pump Bedienungsanleitung

Drive

Drive Hercules Beetle 18016 Bedienungsanleitung

Drive

Drive Med Aire Plus 10" Bedienungsanleitung

Drive

Drive Delta 1000 Bedienungsanleitung

Drive

Drive OXYMIZER Pendant P-224 Bedienungsanleitung

Drive

Drive Vitaturn K Bedienungsanleitung

Beliebte Medizinische Geräte Handbücher anderer Marken

TekTone

TekTone Tek-CARE160 Bedienungsanleitung

NeuroMetrix

NeuroMetrix Quell 2.0 Bedienungsanleitung

AMT

AMT XLR8 Bedienungsanleitung

EDAN

EDAN SONOTRAX Pro Bedienungsanleitung

Restorative Therapies

Restorative Therapies RT300 Bedienungsanleitung

Gendex

Gendex Expert DC Bedienungsanleitung

Dexcowin

Dexcowin ADX4000W Bedienungsanleitung

Libelium

Libelium MySignals Bedienungsanleitung

Acelity

Acelity V.A.C.ULTA 4 Bedienungsanleitung

Caputron

Caputron ActivaDose II tDCS Bedienungsanleitung

Plinth 2000

Plinth 2000 93CDT Bedienungsanleitung

GE SENOGRAPHE 800T Bedienungsanleitung

GE Definium 5000 Bedienungsanleitung

Kanmed

Kanmed GE-1380 Bedienungsanleitung

Huntleigh

Huntleigh FD1 Bedienungsanleitung

Stryker

Stryker SPR Plus Bedienungsanleitung

Tobii Dynavox

Tobii Dynavox I-Series Bedienungsanleitung

S-Capepod

S-Capepod Evac Cocoon Bedienungsanleitung