Edelbrock Axle-Back Exhaust Systems 5773 Bedienungsanleitung

Inhaltsverzeichnis

Andere Edelbrock Automobilteil Handbücher

Edelbrock

Edelbrock 2860 Bedienungsanleitung

Edelbrock

Edelbrock 7111 Bedienungsanleitung

Edelbrock

Edelbrock 5624 Bedienungsanleitung

Edelbrock

Edelbrock 72230 Bedienungsanleitung

Edelbrock

Edelbrock 5202 Bedienungsanleitung

Edelbrock

Edelbrock 5776 Bedienungsanleitung

Edelbrock

Edelbrock Russell 651107 Bedienungsanleitung

Edelbrock

Edelbrock 71003 Bedienungsanleitung

Edelbrock

Edelbrock Performer 4754 Bedienungsanleitung

Edelbrock

Edelbrock 3824 Bedienungsanleitung

Edelbrock

Edelbrock Q-Jet 1932 Bedienungsanleitung

Edelbrock

Edelbrock 70080 Bedienungsanleitung

Edelbrock

Edelbrock 4737 Bedienungsanleitung

Edelbrock

Edelbrock 29565 Bedienungsanleitung

Edelbrock

Edelbrock Torker 2930 Bedienungsanleitung

Edelbrock

Edelbrock 65732 Bedienungsanleitung

Edelbrock

Edelbrock 29575 Bedienungsanleitung

Edelbrock

Edelbrock 65232 Bedienungsanleitung

Edelbrock

Edelbrock Victor 77459 Bedienungsanleitung

Edelbrock

Edelbrock CHEVROLET V8 302-400 C.I.D. Bedienungsanleitung

Edelbrock

Edelbrock Quiet-Flo 1791 Bedienungsanleitung

Edelbrock

Edelbrock Honda 99-LATER Betriebsanleitung

Edelbrock

Edelbrock 307 Bedienungsanleitung

Edelbrock

Edelbrock 72700 Bedienungsanleitung

Beliebte Automobilteil Handbücher anderer Marken

Dakota Digital

Dakota Digital 650277 Bedienungsanleitung

bosal

bosal 037031 Bedienungsanleitung

Vintage Air

Vintage Air 571063 Bedienungsanleitung

GFB

GFB EX38 Bedienungsanleitung

bosal

bosal 028091 Bedienungsanleitung

Dodge

Dodge 8W-43 Kurzanleitung

ICI

ICI Magnum FBM10DGN Bedienungsanleitung

Volant Perfomance

Volant Perfomance 19435 Bedienungsanleitung

BENDIX

BENDIX GEN 4 GEN 5 ABS Bedienungsanleitung

Vintage Air

Vintage Air 571065 Bedienungsanleitung

Rugged Ridge

Rugged Ridge 11503.13 Bedienungsanleitung

BENDIX

BENDIX CYCLONE DURADRAIN TRAILER WATER Bedienungsanleitung

Porsche

Porsche 968 - ASSEMBLY INSPECTION PROCEDURE AND MAINTENANCE... Leitfaden

Sumitomo

Sumitomo FINE CYCLO FC-A 15 G Bedienungsanleitung

Toshiba

Toshiba 48-1250 A Bedienungsanleitung

aldes

aldes EHT2 Bedienungsanleitung

Go Rhino

Go Rhino 24371T Bedienungsanleitung

BBK

BBK 18950 Bedienungsanleitung

©2008 Edelbrock Corporation

Catalog #5773

Brochure #63-5773

Rev. 1/08- AJ/mc

EDELBROCK AXLE-BACK EXHAUST SYSTEMS

For 2007 Jeep Wrangler 3.8L V6

Catalog #5773

INSTALLATION INSTRUCTIONS

®

Please study these instructions carefully before installing your new Axle-Back Exhaust System. If you have any questions,

please contact our Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific

Standard Time or e-mail us at [email protected].

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Toll-Free Tech Line: 1-800-416-8628

Tech E-Mail: [email protected]

DISASSEMBLY

1. Raise rear of vehicle on flat stable surface and

support using jackstands.

2. Use penetrating oil on OE clamp that hold muffler

to overaxle pipe. Loosen clamp, remove the stock

muffler isolator brackets from frame and remove

the stock muffler from vehicle.

WARNING!!!

Exhaust gas contains carbon monoxide, a deadly

invisible gas. Correct any leaks before driving.

Suggested tools needed for installation:

❑13mm & 15mm deep sockets and ratchet

❑Floor jack & jackstands

❑Penetrating oil

IMPORTANT NOTE:

Proper installation is the responsibility of the

installer. Improper installation will void warranty

and may result in poor performance and engine or

vehicle damage.

ASSEMBLY

1. Install muffler inlet pipe onto OE overaxle pipe.

Install one of the supplied band clamps and snug

the clamp.

2. Install the muffler with a band clamp on the inlet

end. Rotate muffler for best ground clearance, and

only snug the clamp at this time.

NOTE: The inlet of the muffler is marked.

3. Install a band clamp on the outlet end of the

muffler, then insert the outlet pipe into the muffler

and slip hanger into factory isolator.

4. Install the tailpipe using the last remaining band

clamp.

5. Starting with the overaxle pipe, align and tighten

the axle back system for the best clearance around

chassis, suspension, and bumper.

Qty. Part # Description

❑125-3296 Inlet Pipe

❑125-3297 Outlet Pipe

❑125-5582 Tailpipe Tip

❑125-55721 Muffler

KIT CONTENT

INSTALLATION INSTRUCTIONS