Ekwb EK-FC670 GTX Backplate Handbuch

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 10th of July 2012.

Installation and mounting manual for EK-FC670 GTX Backplate

This product is intended for installation only by expert users. Please consult with a qualified technician for installation. Improper installation may result in damage to your equipment. EK Water Blocks assumes no liability

whatsoever, expressed or implied, for the use of these products, nor their installation. The following instructions are subject to change without notice. Please visit our web site at www.ekwaterblocks.com for updates. Before

installation of this product please read important notice, disclosure and warranty conditions printed on the back of the box.

STEP 1: GENERAL INFORMATION. Sample picture of nVidia GeForce 670 GTX graphics card.

STEP 2: PREPARING YOUR GRAPHICS CARD

EK-FC670 GTX Backplate is very easy to install. First install EK-FC670 GTX water block according to its manual. If you have it already installed the

water block please check the picture below to see which mounting screws are to be left in their position and which are to be removed. Please

remove the four (4) encircled screws.

STEP 3: APPLYING THE THERMAL PADS

EK-FC670 GTX Backplate features passive cooling of the printed circuit board and it’s components therefore it is mandatory to install the enclosed

thermal pad. Please place enclosed 1mm thick thermal pad (Thermal Pad A –1mm (100x16)) directly on the marked RAM chips (X) on the back of

the card as shown on the picture below. You may need to trim the excess thermal pad.

Thermal pad A –1mm

(100x16)

All disclosures, notices and warranty conditions are being written on the back of the box. Revision 1.0. Released on 10th of July 2012.

STEP 3: ATTACHING EK-FC670 GTX BACKPLATE TO THE GRAPHICS CARD

Take enclosed mounting screws and install them as shown on picture below. EKWB recommends users to start with two (2) M3x9 DIN7991 screws

(HINT: do not tighten screws until they are all positioned in their mounting holes) in the middle of the card and then continue with mounting of four

(4) remaining M3x9 DIN7991 screws. Backplate has milled in standoffs, so there is no fear of over tightening of the screws. Nevertheless do not

exaggerate with screwing force as there is no need for it.

(Please note that EKWB holds no responsibility of any kind if assembly is not made by instructions. This applies also for all products that are not out

of EKWB production line. Users must by all means also consider instructions that are being made for proper use of FC blocks.)

Use enclosed plastic washer underneath each milled standoff!

IMPORTANT DISCLOSURES

VERY IMPORTANT NOTICE: Once the installation is completed, it is a recommended practice to test the cooling circuit for leaks prior to powering up the

computer. We recommend a 24 hour leak test prior to powering up the computer. Do not test the water block using city water pressure. This will rupture the top

of the housing and render the block unusable (and will void your warranty).While all efforts have been made to provide the most comprehensive tutorial possible,

EK Water Blocks assumes no liability expressed or implied for any consequential damage(s) occurring to your equipment as a result of using EK Water Blocks

cooling products, either due to errors or omissions on our part in the above instructions, or due to failure or defect in the EK Water Blocks cooling products.

WARRANTY:

Our products are warranted against defects in materials or workmanship for a period of 24 months beginning from the date of delivery to the final user. During

this period, products will be repaired or have parts replaced at our discretion provided that: (I) the product is returned to the agent from whom it was

purchased; (II) the product has been purchased by an end user and has not used for commercial purposes; (III) the product has not been misused, handled

carelessly, or used in a manner other than in accordance with the instructions provided describing its installation and proper use. This warranty does not confer

rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This warranty is offered as an extra benefit and

does not affect your statutory rights as a consumer. This warranty is voided if the product comes in contact with aggressive UV additives or other improper

liquids.

EK blocks are sealed with warranty void circular label, which proves that the block has withstood a pressure leak test. Removing it will void leak-free guarantee

and not the guarantee on the product itself. Any other RMA issues can be reported to support@ekwaterblocks.com for further analysis.

REQUIRED TOOLS AND MOUNTING SCREWS:

scissors 2mm allen key

Use enclosed allen key on DIN7991

screws to attach backplate.

M3x9 DIN7991 screw

0.5mm M3 PVC washer

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FB GA Z87X-OC Force Leitfaden

ekwb

ekwb EK-Quantum Reflection2 PC-O11D EVO D5 PWM... Bedienungsanleitung

ekwb

ekwb EK-FB EVGA X58 CLASSIFIED Bedienungsanleitung

ekwb

ekwb EK-FC1080 G1 GTX Backplate Leitfaden

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Backplate Leitfaden

ekwb

ekwb EK-FB EVGA CLASSIFIED 4-SLI Leitfaden

ekwb

ekwb EK-FC1070 GTX Bedienungsanleitung

ekwb

ekwb EK-FC980 GTX Ti Strix Handbuch

ekwb

ekwb EK-Quantum Reflection2 PC-O11D EVO D5 PWM... Bedienungsanleitung

ekwb

ekwb EK-XTOP Revo Dual D5 Serial Handbuch

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb EK-FB ASUS CROSSHAIR 3 Handbuch

ekwb

ekwb EK-FC480 GTX Handbuch

ekwb

ekwb EK-FC 780 GTX Jetstream Bedienungsanleitung

ekwb

ekwb EK-D5 Dual TOP Leitfaden

ekwb

ekwb EK-Quantum Volume FLT Series Bedienungsanleitung

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Bedienungsanleitung

ekwb

ekwb EK-PRO GPU WB AMP/Trinity RTX 4090 - Ni +... Bedienungsanleitung

ekwb

ekwb EK-Quantum Vector Trinity RTX 3080/3090 Bedienungsanleitung

ekwb

ekwb EK-FC Fury X Handbuch

ekwb

ekwb EK-FCQK5000 Handbuch

ekwb

ekwb EK-Classic 115 D-RGB Series Bedienungsanleitung

ekwb

ekwb EK-FB KIT GA Z97X-SOC Force Leitfaden

ekwb

ekwb EK-Quantum Momentum2 ROG Strix Z690-I Gaming D-RGB -... Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-FC670 GTX Backplate Handbuch

Beliebte Computerhardware Handbücher anderer Marken