Ekwb EK-Quantum Momentum VRM Bridge ROG Maximus XII Formula D-RGB -... Bedienungsanleitung

USER GUIDE

EKQuantum

Momentum VRM Bridge ROG Maximus XII Formula D-RGB - Plexi

This product is intended for installation only by expert users.

Please consult with a qualiﬁed technician for installation. Improper

installation may result in damage to your equipment. EK Water

Blocks assumes no liability whatsoever, expressed or implied,

for the use of these products, nor their installation. The following

instructions are subject to change without notice. Please visit our

web site at www.ekwb.com for updates. Before installation of this

product please read important notice, disclosure and warranty

conditions printed on the back of the box.

Before you start using this product please follow these basic guidelines:

Please carefully read the manual thoroughly before beginning

with the installation process!

Please remove your motherboard from the computer to assure

safest mounting process in order to prevent any possible

damages to your CPU and/or motherboard’s circuit board (PCB).

The EK- Fittings require only a small amount of force to screw

them ﬁrmly in place since the liquid seal is ensured by the

rubber o-ring gaskets.

The use of quality, market proved corrosion inhibiting coolants

is always strongly recommended for any liquid cooling system.

- 3 -

STEP 2

Unscrew the M4 x 22 screw using the enclosed 2.5mm Allen key and

remove it from the block.

STEP 2

STEP 1

Install your EK-Quantum Velocity or Velocity Strike CPU water block in

the illustrated orientation and place the motherboard on a secure ﬂat

surface. Using the enclosed 8mm Allen key, install all four (4) ﬁxation

ﬁttings to the pre-installed VRM block and CPU block.

Always consult the latest available manual for CPU block

installation. Do not use excessive force when tightening

the ﬁttings.

STEP 1

Fixation Fitting

M4 x 22 Screw

- 4 -

STEP 4

Before attempting to mount the water block, apply a small amount

of the supplied grease to each of the four (4) O-Rings on the ﬁxation

ﬁttings. Next, position the water block over the ﬁxation ﬁttings and

force it into place evenly.

STEP 4

STEP 3

Slide the black acetal stand-out with stainless steel ﬁxation plate away

from the plexi components until it stops (approximately at 3mm).

STEP 3

Black acetal

Stand-out

O-Ring

3 mm Gap

- 5 -

STEP 6

Install your ﬁttings to the water block and pay attention that the

inlet port is now on the right-hand side (closest to the stand-out). EK

recommends the use of EK-Quantum Torque ﬁttings.

STEP 6

STEP 5

Push the black acetal stand-out back to its original position and screw

back the M4 x 22 screw that was removed at Step 2.

If the water block does not ﬁt or the stand-out will not

return to its original position, this could be due to the

misalignment of the CPU block. Loosen the four (4) thumb

nuts so that the CPU block is free to move and temporarily

position the bridge block. Lastly, re-tighten the four (4)

thumb nuts and start over from Step 4.

STEP 5

M4 x 22 Screw

Black acetal

Stand-out

Thumb Nut

INLET

EK-Fitting

- 6 -

STEP 7

Plug the 4-pin D-RGB connector from the bridge block in a D-RGB

header on your motherboard or controller. The LED strip will only

work if the pin layout on the header is as follows: +5V, Digital,

Empty, Ground.

Incorrect installation or installation to the incorrect header

could result in damage to the LED strip or the header itself.

D-RGB Header

RGB Header

STEP 7

For assistance please contact:

http://support.ekwb.com/

EKWB d.o.o.

Pod lipami 18

1218 Komenda

Slovenia - EU

EKWaterBlocks

@EKWaterBlocks

ekwaterblocks

EKWBofﬁcial

SUPPORT AND SERVICE

SOCIAL MEDIA

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-DBAY DCP 2.2 Handbuch

ekwb

ekwb EK-FC RX-480 Bedienungsanleitung

ekwb

ekwb EK-FC Titan Series Handbuch

ekwb

ekwb EK-FC670 GTX Backplate Handbuch

ekwb

ekwb EK-Vector RTX 2080 FTW3 Bedienungsanleitung

ekwb

ekwb EK-FC Titan Z Handbuch

ekwb

ekwb EK-Quantum Vector FE RTX 3080 Bedienungsanleitung

ekwb

ekwb EK-FC780 GTX WF3 Handbuch

ekwb

ekwb EK-XRES 100 Revo D5 Series Handbuch

ekwb

ekwb EK-Quantum Vector2 Trio RTX 3080/90 ABP Set... Bedienungsanleitung

ekwb

ekwb 3831109831618 Leitfaden

ekwb

ekwb EK-FB MSI X399 GAMING RGB Monoblock Bedienungsanleitung

ekwb

ekwb EK-7970 Leitfaden

ekwb

ekwb EK-Quantum Momentum ROG Zenith II Extreme Bedienungsanleitung

ekwb

ekwb EK-FC970 GTX Handbuch

ekwb

ekwb EK-FB ASUS P7P55 KIT Leitfaden

ekwb

ekwb EK-FC R9-285 Handbuch

ekwb

ekwb EK-XTOP D5 Handbuch

ekwb

ekwb Barebones Leitfaden

ekwb

ekwb EK-Vector Radeon VII Backplate Bedienungsanleitung

ekwb

ekwb EK-Backplate ASUS P6X58D Premium Leitfaden

ekwb

ekwb EK-FC770 GTX GW Leitfaden

ekwb

ekwb EK-FB KIT RE4 Handbuch

ekwb

ekwb EK-FC980 GTX Ti WF3 Handbuch

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-Quantum Momentum VRM Bridge ROG Maximus XII Formula D-RGB -... Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken