Ekwb EK-Quantum Reaction AIO RX 6800/6900 D-RGB P240 - AMD Radeon... Bedienungsanleitung

USER GUIDE

EK-Quantum

Reaction AIO RX 6800/6900 D-RGB

P240 - AMD Radeon Edition

To ensure safe and easy installation, please read this manual

carefully before starting with the installation process!

Safety Precautions

Before you start using this product, please follow these basic guidelines:

Check the component list and condition of the product before

installation. If you encounter a problem, contact the vendor

where you purchased the product to get a replacement or a

refund.

EK is not responsible for any damages due to external causes,

including but not limited to: improper use, problems with

electrical power, accident, neglect, alteration, repair, improper

installation, and improper testing.

Carefully read the manual before beginning with the installation

process.

Remove your graphics card from the computer for the safest

mounting process to prevent any possible damage to your GPU

or its circuit board (PCB).

This product is an All-In-One liquid cooling solution.

Disassembling it and combining it with parts other than EK

products may lead to warranty loss.

The use of quality market-proven corrosion-inhibiting coolants

is always strongly recommended for any liquid cooling system.

Do not use pure distilled water as a cooling liquid! For best

results, EK recommends the use of EK-CryoFuel Coolants.

- 3 -

TABLE OF CONTENTS

BOX CONTENTS 4

DIMENSIONS 5

INSTALLING THE GPU WATER BLOCK AND BACKPLATE 6

FAN SPLITTER HUB 6

ELECTRICAL CONNECTIONS Option 1 7

CONNECTING THE HUB TO THE POWER SUPPLY 7

CONNECTING THE HUB TO THE MOTHERBOARD 7

ELECTRICAL CONNECTIONS Option 2 8

CONNECTING THE PUMP DIRECTLY TO THE MOTHERBOARD FAN HEADER 8

AIO UNIT ORIENTATION LIMITATIONS 9

INSTALLING THE AIO UNIT 10

CONNECTING THE D-RGB LIGHTS 11

ALTERNATIVE 12

SUPPORT AND SERVICE 13

SOCIAL MEDIA 13

- 4 -

BOX CONTENTS

Self-Tapping Fan Mounting Screws

All-In-One GPU Liquid Cooling Unit With the Mounting Mechanism and Connection Cables

EK D-RGB 6-Way Splitter Cable

EK Cable Y-Splitter 2-Fan PWM

- 5 -

DIMENSIONS

70 mm

292 mm

136 mm

105 mm

15 mm

105 mm

120 mm

- 6 -

INSTALLING THE GPU WATER BLOCK AND BACKPLATE

FAN SPLITTER HUB

To install the water block to your graphics card, follow the instructions

in the link below:

https://www.ekwb.com/shop/EK-IM/EK-IM-3831109833391.pdf

General Characteristics:

- 3x 4-Pin PWM Fan Header (Molex KK 254 Standard)

- 1x 4-Pin PWM Pump Header (Molex KK 254 Standard)

- 1x 2-Pin Tach/PWM Header (Molex KK 254 Standard)

- 1x 2-Pin Power Header (Molex Mini-Fit Standard)

- 1x Power LED Indicator Diode (Red) - Rectiﬁed PWM Input

- Uniform PWM Control on All Headers

All the elements that need electricity to run are connected to the fan

splitter hub, located on the back of the unit.

This fan splitter hub contains three 4-pin PWM fan

headers for three fans and one pump.

A 2-pin header is used to connect the hub to the motherboard CPU

fan header to allow the speed regulation of both fans and the pump.

The 2-pin PCI Express Mini-Fit power header is used to provide

power for the AIO unit.

Pump Fan 1Fan 2Fan 3

To the Power Supply Unit Fan Splitter

Hub

Pump

Header

Fan 1/2/3 Header

RPM (tacho) and PWM Header Power LED Light

Unit main

Power Header

- 7 -

ELECTRICAL CONNECTIONS Option 1

CONNECTING THE HUB TO THE POWER

SUPPLY

STEP 1

Take the enclosed power cable and plug the 2-pin PCI Express Mini-

Fit power connector into the fan splitter hub.

STEP 2

Use the SATA POWER connector and plug it into the female

connector found on the main power supply.

CONNECTING THE HUB TO THE MOTHERBOARD

To obtain the PWM fan speed control, you must follow these steps:

STEP 3

Take the enclosed connection cable and plug the 2-pin cable

connector into the fan splitter hub.

STEP 4

Use the 4-pin connector and plug it into the male connector header

located on the motherboard.

Always use a CPU fan header. On the majority of

motherboards, these headers offer the best PWM

regulation.

STEP 1 STEP 2

STEP 3 STEP 4

- 8 -

STEP 1

STEP 2

ELECTRICAL CONNECTIONS Option 2

CONNECTING THE PUMP DIRECTLY TO THE

MOTHERBOARD FAN HEADER

If you want to control the speed of the pump and fans separately, you

should follow these steps:

STEP 1

Disconnect the pump cable from the fan splitter hub. You need to

remove cable ties to do so.

STEP 2

Connect the pump’s connector to the CPU fan header (preferably)

on the motherboard.

- 9 -

Pump

AIO UNIT ORIENTATION LIMITATIONS

CAUTION: The unit’s orientation is critical since incorrect

installation can lead to poor cooling performance and

premature unit failure.

- 10 -

STEP 1

STEP 2

INSTALLING THE AIO UNIT

STEP 1

Mounting the AIO unit into your PC chassis requires special

attention. You will need eight fan mounting screws and a Phillips

head screwdriver.

STEP 2

The AIO unit’s position depends on the size, fan mounting holes, and

hardware you have installed inside your chassis. You must make sure

that the unit ﬁts into the chassis. Usually, the cases come with pre-

drilled standard fan mounting holes, and you should look for holes

that have 105mm spacing (for standard 120mm cooling fans).

Inhaltsverzeichnis

Andere ekwb Computerhardware Handbücher

ekwb

ekwb EK-FC680 GTX SOC water block Leitfaden

ekwb

ekwb EK-FC980 GTX Ti Strix Handbuch

ekwb

ekwb EK-FC980 GTX Classy KPE Backplate Leitfaden

ekwb

ekwb EK-Nucleus AIO CR360 Vision D-RGB Bedienungsanleitung

ekwb

ekwb EK-FB ASUS M8I Monoblock Bedienungsanleitung

ekwb

ekwb EK-FC285 GTX Classified Handbuch

ekwb

ekwb EK-FC480 GTX Handbuch

ekwb

ekwb EK-FC980 GTX Ti TF5 Series Handbuch

ekwb

ekwb EK-FB EVGA X58 LE Leitfaden

ekwb

ekwb EK-FC RX-480 Bedienungsanleitung

ekwb

ekwb EK-FC1080 G1 GTX Backplate Leitfaden

ekwb

ekwb EK-FC980 GTX Leitfaden

ekwb

ekwb EK-Vector FTW3 RTX 2080 Ti Bedienungsanleitung

ekwb

ekwb EK-Quantum Momentum ROG Crosshair VIII Hero Bedienungsanleitung

ekwb

ekwb EK-Quantum Volume FLT Series Bedienungsanleitung

ekwb

ekwb EK-FB ASUS Maximus XI HERO Bedienungsanleitung

ekwb

ekwb EK-FB ASUS Z270E Strix Monoblock Series Bedienungsanleitung

ekwb

ekwb EK-Thermosphere Handbuch

ekwb

ekwb EK-FC 780 GTX DCII Series Handbuch

ekwb

ekwb EK-FC 5870 V2 Handbuch

ekwb

ekwb EK-FC1080 GTX Ti FTW3 Bedienungsanleitung

ekwb

ekwb EK-FB ASUS Strix X299-E RGB Monoblock Bedienungsanleitung

ekwb

ekwb MSI MPG X570S Carbon EK X Bedienungsanleitung

ekwb

ekwb EK-FB ASUS CROSSHAIR 3 Handbuch

Beliebte Computerhardware Handbücher anderer Marken

EMC2

EMC2 VNX Series Betriebsanleitung

Panasonic

Panasonic DV0PM20105 Bedienungsanleitung

Mitsubishi Electric

Mitsubishi Electric Q81BD-J61BT11 Bedienungsanleitung

Gigabyte

Gigabyte B660M DS3H AX DDR4 Bedienungsanleitung

Raidon

Raidon iT2300 Bedienungsanleitung

National Instruments

National Instruments PXI-8186 Bedienungsanleitung

Hauppauge

Hauppauge WinTV-HVR-2250 Bedienungsanleitung

Kontron

Kontron CP6002 Bedienungsanleitung

Manhattan

Manhattan 702843 Bedienungsanleitung

Aphex

Aphex 230 Bedienungsanleitung

Intel

Intel NUC 12 Pro Bedienungsanleitung

Galaxy

Galaxy GHDX2-2430S-24F4D Bedienungsanleitung

Intel

Intel AXXRMFBU4 Bedienungsanleitung

Kontron

Kontron DIMM-PC/MD Bedienungsanleitung

ST X-NUCLEO-SAFEA1B Betriebsanleitung

STEINWAY LYNGDORF

STEINWAY LYNGDORF SP-1 Bedienungsanleitung

Advantech

Advantech ASMB-935 Series Bedienungsanleitung

Jupiter

Jupiter RAM PACK Bedienungsanleitung

ekwb EK-Quantum Reaction AIO RX 6800/6900 D-RGB P240 - AMD Radeon... Bedienungsanleitung

Beliebte Computerhardware Handbücher anderer Marken