Emerson Rosemount 702 Bedienungsanleitung

Quick Start Guide

00825-0200-4702, Rev HE

July2023

Rosemount™ 702 Wireless Discrete

Transmitter

Safety messages

Failure to follow these installation guidelines could result in death or serious injury. Only

qualified personnel should perform the installation.

WARNING

Explosion hazard that could result in death or serious injury.

Installation of this transmitter in an explosive environment must be in accordance with the

appropriate local, national, and international standards, codes, and practices. Review the

approvals section of this manual for any restrictions associated with a safe installation.

Before connecting a handheld communicator in an explosive atmosphere, ensure that the

instruments are installed in accordance with intrinsically safe or non-incendive field wiring

practices.

Magnetic hazard that can result in death or serious injury

This device contains magnets which could be harmful to pacemaker wearers.

Electrostatic hazard that can result in death or serious injury

Avoid contact with the leads and terminals. High voltage that may be present on leads can

cause electrical shock.

The power module may be replaced in a hazardous area. The power module has surface

resistivity greater than one gigaohm and must be properly installed in the wireless device

enclosure. Care must be taken during transportation to and from the point of installation to

prevent electrostatic charge build-up.

The polymer enclosure has surface resistivity greater than one gigaohm and must be

properly installed in the wireless device enclosure. Care must be taken during transportation

to and from the point of installation to prevent electrostatic charge build-up.

NOTICE

Shipping considerations for wireless products.

The unit was shipped to you without the power module installed. Remove the power module

prior to any re-shipping.

Primary lithium batteries are regulated in transportation by the U. S. Department of

Transportation, and are also covered by IATA (International Air Transport Association), ICAO

(International Civil Aviation Organization), and ADR (European Ground Transportation of

Dangerous Goods). It is the responsibility of the shipper to ensure compliance with these or

any other local requirements. Consult current regulations and requirements before shipping.

WARNING

Physical access

Unauthorized personnel may potentially cause significant damage to and/or

misconfiguration of end users’ equipment. This could be intentional or unintentional and

needs to be protected against.

Physical security is an important part of any security program and fundamental in protecting

your system. Restrict physical access by unauthorized personnel to protect end users’ assets.

This is true for all systems used within the facility.

Quick Start Guide July2023

2 Emerson.com/Rosemount

Contents

About this guide...........................................................................................................................5

Wireless considerations.............................................................................................................. 6

Mounting the transmitter with a strap......................................................................................9

Device network configuration.................................................................................................. 15

Verify operation..........................................................................................................................17

Reference information: wiring switch inputs, output circuits, and leak sensors...............21

Safety shower and eye wash monitoring................................................................................44

Product certification.................................................................................................................. 46

July2023 Quick Start Guide

Quick Start Guide 3

Quick Start Guide July2023

4 Emerson.com/Rosemount

1 About this guide

This guide provides basic guidelines for the Rosemount 702 Wireless

Discrete Transmitter. It does not provide instructions for detailed

configuration, diagnostics, maintenance, service, troubleshooting, or

installations. Refer to the Rosemount 702 Reference Manual for more

instruction. This guide and the manual are available electronically on

Emerson.com/Rosemount.

Model number Functionality Manual

702DX32/42 Two channel discrete I/O Rosemount 702 Reference

Manual

702DX61 One channel for

nVent™ RAYCHEM liquid

hydrocarbon leak

detection

Rosemount 702 Reference

Manual

702DX52 Discrete Transmitter for

Plunger Arrival Detection

Rosemount 702 Wireless

Discrete Transmitter for

plunger arrival Reference

Manual

July2023 Quick Start Guide

Quick Start Guide 5

2 Wireless considerations

2.1 Power up sequence

Verify the Wireless Gateway is installed and functioning properly

before any wireless field devices are powered. Install the Power

Module, SmartPower™ Solutions model number 701PBKKF into the

Rosemount 702 Wireless Discrete Transmitter to power the device.

Power up wireless devices in order of proximity from the Gateway,

beginning with the closest device, then working outward from the

Gateway. This results in a simpler and faster network formation.

Enable Active Advertising on the Gateway to ensure new devices are

able to join the network faster.

2.2 Antenna position

Position the antenna vertically, either straight up or straight down,

and approximately 3 ft. (1 m) from any large structure, building, or

conductive surface to allow for clear communication to other devices.

Figure 2-1: Antenna Position

2.3 Conduit entry

Upon installation, ensure each conduit entry is either sealed with

a conduit plug using approved thread sealant, or has an installed

conduit fitting or cable gland with appropriate threaded sealant.

Quick Start Guide July2023

6 Emerson.com/Rosemount

Note

The conduit entries are threaded ½–14 NPT.

Figure 2-2: Conduit Entry

A. Conduit entry

2.4 Field Communicator connections

The power module must be installed before the Field Communicator

can interface with the Rosemount 702 Wireless Discrete Transmitter.

For HART® Wireless Transmitter communication via a Field

Communicator, a Rosemount 702 Wireless Device Dashboard (DD)

is required. To obtain the latest DD, visit the Field Communicator

System Software and Device Description site at: Emerson.com/Field-

Communicator. This transmitter uses the Black Power Module; Order

model number 701PBKKF.

July2023 Quick Start Guide

Quick Start Guide 7

Figure 2-3: Connection Diagram

$&%1 2 3

4 5 6

7 8

A. Communication terminals

B. Handheld communicator

C. HART modem

After the Wireless Gateway has been installed and is functioning

properly, set up the transmitter and all other wireless devices.

Quick Start Guide July2023

8 Emerson.com/Rosemount

3 Mounting the transmitter with a strap

3.1 Direct mount installation

Note

Do not employ direct mount installation when using tubing and

connectors such as Swagelok® fittings.

Figure 3-1: Direct Mount

A. Rosemount 702 Wireless Discrete Transmitter

B. Float switch

Procedure

1. Install the switch according to standard installation practices

making sure to use thread sealant on all connections.

2. Using the threaded conduit entry, attach the Rosemount 702

housing to the switch.

3. Referring to the wiring diagram (see Reference information:

wiring switch inputs, output circuits, and leak sensors), attach

the switch wiring to the terminals.

4. Connect the Power Module.

July2023 Quick Start Guide

Quick Start Guide 9

Note

Wireless devices should be powered up in order of proximity

from the Wireless Gateway, beginning with the closest device

to the Gateway. This will result in a simpler and faster network

formation.

5. Close the housing cover and tighten to safety specification.

Always ensure a proper seal so the metal touches metal, but

do not over tighten.

6. Position antenna vertically, either straight up or straight down.

The antenna should be approximately 3 ft. (0.91 m) from any

large structures or buildings, to allow clear communication to

other devices.

3.2 Remote mount installation

Figure 3-2: Remote Mount

A. Rosemount 702 Wireless Discrete Transmitter

B. Float switch

Quick Start Guide July2023

10 Emerson.com/Rosemount

Andere Handbücher für Rosemount 702

Inhaltsverzeichnis

Andere Emerson Sender Handbücher

Emerson

Emerson Rosemount 1408A Bedienungsanleitung

Emerson

Emerson Rosemount 2051HT Bedienungsanleitung

Emerson

Emerson Rosemount 5408 Bedienungsanleitung

Emerson

Emerson Rosemount 3051SF Series Bedienungsanleitung

Emerson

Emerson Fisher 4211 Bedienungsanleitung

Emerson

Emerson Rosemount 248 Bedienungsanleitung

Emerson

Emerson Rosemount 3051 CF Series Bedienungsanleitung

Emerson

Emerson PT5-30L-FLR Bedienungsanleitung

Emerson

Emerson CSI 9420 Bedienungsanleitung

Emerson

Emerson Rosemount 2051 Wireless Series Bedienungsanleitung

Emerson

Emerson Micro Motion 3500 Bedienungsanleitung

Emerson

Emerson Rosemount 702 Bedienungsanleitung

Emerson

Emerson Rosemount 5408 Bedienungsanleitung

Emerson

Emerson Rosemount 3095 Bedienungsanleitung

Emerson

Emerson Rosemount 3051S Series Bedienungsanleitung

Emerson

Emerson Micro Motion 2500 Kurzanleitung

Emerson

Emerson Rosemount 3051 Bedienungsanleitung

Emerson

Emerson Micro Motion 5700 Kurzanleitung

Emerson

Emerson Rosemount 644 Bedienungsanleitung

Emerson

Emerson Micro Motion 1700 Kurzanleitung

Emerson

Emerson Rosemount 3051 CF Series Bedienungsanleitung

Emerson

Emerson Rosemount 3308 Bedienungsanleitung

Emerson

Emerson Rosemount Wireless Permasense WT210 Bedienungsanleitung

Emerson

Emerson Rosemount 4088B MultiVariable Bedienungsanleitung

Beliebte Sender Handbücher anderer Marken

NIVELCO

NIVELCO EasyTREK SCA-300 Series Betriebsanleitung

Honeywell

Honeywell 5816WMBR Bedienungsanleitung

Kamstrup

Kamstrup READy MTU Betriebsanleitung

Omega

Omega ZW Series Bedienungsanleitung

ABB

ABB Field 264H Leitfaden

Alinco

Alinco DJ-V17T Bedienungsanleitung

Dejero

Dejero EnGo 3x Bedienungsanleitung

Rosemount

Rosemount 4600 Bedienungsanleitung

Speaka Professional

Speaka Professional 2342740 Bedienungsanleitung

trubomat

trubomat GAB 1000 Bedienungsanleitung

Teledyne Analytical Instruments

Teledyne Analytical Instruments LXT-380 Bedienungsanleitung

Rondish

Rondish UT-11 Bedienungsanleitung

MG 10JRE Bedienungsanleitung

Burkert

Burkert 8177 Bedienungsanleitung

Firetide

Firetide HotPort 3203 Handbuch

Tele Radio

Tele Radio T9-02 Bedienungsanleitung

Rotronic

Rotronic HygroFlex HF3 Series Bedienungsanleitung

Jamara

Jamara FCX6 Pro Tel Bedienungsanleitung