Endon EL-10049 Bedienungsanleitung

The product contains spot light with

connection terminal.

The following tools may be required:

Selection of cross and flat head screwdrivers.

Electric drill and assorted drill bits.

Wire strippers.

INSTRUCTION MANUAL

This product is only suitable for connection to a 240V~50Hz supply in accordance with current IEE

wiring Regulations and should be installed in accordance with local Building Regulations and is for

Domestic indoor ceiling use only (it must be mounted out of arms reach) and is not suitable for a

Bathroom location.

This product should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp

miniature circuit breaker).

If in doubt we recommend you contact a qualified electrician. Before installing your light fitting

always:

Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit

breaker before commencing installation.

Ensure that no one else has access to the supply such that it could be inadvertently reconnected.

Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may

cause overheating and damage the fitting.

The shades, and bulbs, become hot during use so please switch off and allow 10 minutes to cool

before replacing bulb, adjusting or cleaning.

This product contains glass parts – be careful during handling and maintenance to avoid breakage.

Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.

The “Minimum Distance” Label on the product – typical format shown below – indicates that lighted

objects should not be placed within the distance stipulated on the label. The example label below

indicates that lighted objects should not be placed within 0.5m (50cm) of the spotlight to prevent

them overheating.

If any modification is made it will invalidate the warranty and may render the product unsafe.

Before you start

Please read these instructions carefully before fitting your new spot light and retain for reference.

Make sure that there are no pipes or cables beneath the mounting surface.

Check the packaging and make sure that you have all the required parts.

Follow each assembly step in order to prevent incorrect assembly.

Make sure all screws / nuts, including electrical connections etc are fully tightened before use.

This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used (as

supplied). If a CFL/LED type bulb is fitted then these cannot (generally) be controlled by a dimmer.

EL-10049 (single spotlight).

Safety Warnings

0.5m

Assembly/ User Instructions

1. Decide on the position of the

light fitting / or remove existing

light fitting. Take a note of the

position of the electrical

connections. Ensure there is a

solid mounting surface,

preferably a wooden joist or

joist bridge to support the

weight of the light fitting.

2. Diagram 1. Remove the fixing

bracket by undoing the 2 side

screws (1), retain these for re-

use.

3. Use the fixing bracket (2) as a

template to mark the screw

holes, mark the screw holes

and secure to the ceiling with

the screws (3) supplied.

4. Diagram 2. Support your fitting

and connect the house wiring to

the terminal block (4) – see

wiring details. NOTE: This is a

Class I fitting and must be

earthed. The 4th terminal block

connector is used for the “loop”

wires of the “Ring Circuit”.

There may be more than one

set of cables in the “loop”

connections. If there is a “Ring

Circuit” and you do not

understand the connections

you must consult an

electrician. Any loose

terminal block –not secured to

ceiling cup - should always be

covered with 2 layers of good

quality insulation tape.

5. Diagram 3. Secure the fitting

back onto the fixing bracket

with the 2 side screws removed

in 2 above. Make sure that all

the internal cables and

connections are inside the

ceiling cup, taking care not to

trap or strain the internal

cables.

6. Fit the appropriate bulb (5) into

the lamp holder. NOTE; Never

fit bulbs of a higher wattage

than those specified on the

label (as these may cause

overheating and damage the

fitting).

7. Turn on the power and test.

Endon lighting

LS9 0SE

20160706

Y20 32

Diagram 1.

Diagram 2.

Diagram 3.

(1)

(4)

(3)

(2)

(5)

Inhaltsverzeichnis

Andere Endon Außenleuchte Handbücher

Endon

Endon Pagoda PIR Outdoor Wall Light Bedienungsanleitung

Endon

Endon YG-861-SS Bedienungsanleitung

Endon

Endon EL-40022 Bedienungsanleitung

Endon

Endon Canillo Bedienungsanleitung

Endon

Endon Leyton Bedienungsanleitung

Endon

Endon Burford Bedienungsanleitung

Endon

Endon Dean 82013 Bedienungsanleitung

Endon

Endon EL- 40094 Bedienungsanleitung

Endon

Endon Carlson Bedienungsanleitung

Endon

Endon EL- 40119 Bedienungsanleitung

Endon

Endon EL-40098 Bedienungsanleitung

Endon

Endon EL- 40101 Bedienungsanleitung

Endon

Endon Burford Wall Bedienungsanleitung

Endon

Endon YG-0923 Bedienungsanleitung

Endon

Endon 67702 Roko Bedienungsanleitung

Endon

Endon Cambridge Wall Light Bedienungsanleitung

Endon

Endon EL-40065 Bedienungsanleitung

Endon

Endon Middleton EL-40017 Bedienungsanleitung

Endon

Endon Burford Outdoor Post Light Bedienungsanleitung

Endon

Endon 77120 Bedienungsanleitung

Endon

Endon YG-6002-SS Bedienungsanleitung

Endon

Endon Elan 5lt Bedienungsanleitung

Endon

Endon EL-YG -5006 Bedienungsanleitung

Endon

Endon EL-40053 Bedienungsanleitung

Beliebte Außenleuchte Handbücher anderer Marken

Sealey

Sealey LED37 Bedienungsanleitung

nordlux

nordlux VEJERS Benutzerhandbuch

SImx

SImx ELITE LED LHTC637 Bedienungsanleitung

GEV

GEV CAROLINE 10833 Bedienungsanleitung

NEBO

NEBO NEB-LSP-0020 Bedienungsanleitung

WE-EF

WE-EF PFL540 LED Bedienungsanleitung

Lindby

Lindby 9949029 Bedienungsanleitung

HEPER

HEPER DOGO Side LW6048.585-US Montage- und Bedienungsanleitung

HEPER

HEPER LW8034.003-US Montage- und Bedienungsanleitung

Maretti

Maretti VIBE S 14.6080.04.A Bedienungsanleitung

BEGA

BEGA 84 253 Handbuch

HEPER

HEPER MINIMO Montage- und Bedienungsanleitung

LIGMAN

LIGMAN BAMBOO 3 Bedienungsanleitung

Maretti

Maretti TUBE CUBE WALL 14.4998.04 Bedienungsanleitung

Maxim Lighting

Maxim Lighting Carriage House VX 40428WGOB Bedienungsanleitung

urban ambiance

urban ambiance UQL1273 Bedienungsanleitung

TotalPond

TotalPond 52238 Bedienungsanleitung

Donner & Blitzen

Donner & Blitzen 0-02661479-2 Bedienungsanleitung