EPOX KP6-LA Bedienungsanleitung

TRADEMARK

All products and company names are trademarks or

registered trademarks of their respective holders.

These specifications are subject to change without notice.

Manual Revision 1.5

September 9, 1997

KP6-LA

A Pentium®II Processor based

AGP mainboard

KP6-LA

Technical Support Services

If you need additional information, help during installation or normal use of this

product, please contact your retailer. If your retailer can not help, you may E-Mail

us with any questions at the following address [email protected].

Record your serial number before installing your KP6-LA mainboard. (the serial

number is located near the ISA slots at the edge of the board)

EPoX KP6-LA serial number:

__________________________

BIOS Upgrades

Please use either our Web Site or BBS for current BIOS Upgrades.

Internet Access

http://www.epox.com

[email protected]

Modem Access

886-2-218-0997 (Taiwan)

31-182-618451 (The Netherlands)

You can access this number via a Hayes-compatible modem with a 2,400 to

28,800 baud rate. The following setup format is required:

8 Data Bits, No Parity, 1 Stop Bit.

If your modem is unable to connect at higher baud rates, try connecting at

2,400 baud before contacting Technical Support.

Thank you for using EPoX mainboards!

KP6-LA

User Notice

No part of this product, including the product and software may be reproduced,

transmitted, transcribed, stored in a retrieval system, or translated into any language

in any form by any means without the express written permission of EPoX Computer

Company (hereinafter referred to as EPoX) except documentation kept by the

purchaser for backup purposes.

EPoX provides this manual “as is” without warranty of any kind, either express or

implied, including but not limited to the implied warranties or conditions of mer-

chantability or fitness for a particular purpose. In no event shall EPoX be liable for

any loss or profits, loss of business, loss of use or data, interruption of business or

for indirect, special incidental, or consequential damages of any kind, even if EPoX

has been advised of the possibility of such damages arising from any defect or error

in the manual or product. EPoX may review this manual from time to time without

notice. For updated BIOS, drivers, or product release information you may visit

EPoX’s home page at: http://www.epox.com

Products mentioned in this manual are mentioned for identification purposes only.

Product names appearing in this manual may or may not be registered trademarks or

copyrights of their respective companies.

The product name and revision number are both printed on the mainboard

itself.

Handling Procedures

Static electricity can severely damage your equipment. Handle the KP6-LA and

any other device in your system with care and avoid unneccessary contact with

system components on the mainboard.

Always work on an antistatic surface to avoid possible damage to the motherboard

from static discharge.

We assume no responsibility for any damage to the KP6-LA mainboard that results

from failure to follow installation instructions or failure to observe safety precau-

tions. CAUTION

The KP6-LA mainboard is subject to

damage by static electricity. Always

observe the handling procedures.

KP6-LA

Table of Contents

Section 1 Introduction

Components Checklist.................................1-1

Overview

Pentium II ...................................................1-2

S.E.C. Cartridge Terminology .....................1-3

Accelerated Graphics Port ...........................1-4

Hardware Monitoring ..................................1-4

Desktop Management Interface ...................1-4

LANDesk Client Manager ...........................1-4

KP6-LA Form-Factor ..................................1-6

I/O Shield Connector...................................1-7

Power-On/Off (Remote) ..............................1-7

System Block Diagram................................1-8

Section 2 Features

KP6-LA Features.........................................2-1

Section 3 Installation

KP6-LA Detailed Layout.............................3-2

Easy Installation Procedure

Configure Jumpers ......................................3-3

System Memory Configuration....................3-5

Installing a Pentium®II Processor................3-9

Device Connectors ......................................3-11

Section 4 Award BIOS Setup

BIOS Instructions........................................4-1

Standard CMOS Setup ................................4-2

BIOS Features Setup ...................................4-3

Chipset Features Setup ................................4-8

KP6-LA

Power Management Setup ...........................4-13

PNP/PCI Configuration ...............................4-16

Load Setup Defaults ....................................4-18

Integrated Peripherals ..................................4-19

Change Supervisor or User Password ..........4-23

IDE HDD Auto Detection............................4-24

HDD Low Level Format..............................4-26

Save & Exit Setup .......................................4-26

Exit Without Saving ....................................4-27

Section 5 DMI

DMI Access ................................................5-1

Section 7 Appendix

Appendix A

Memory Map...............................................A-1

I/O Map.......................................................A-1

Timer & DMA Channels Map .....................A-2

Interrupt Map ..............................................A-2

RTC & CMOS RAM Map...........................A-3

Appendix B

POST Codes................................................A-5

Unexpected Errors .......................................A-8

Appendix C

Load Setup Defaults ....................................A-9

IntroductionKP6-LA

Page 1-1

Section 1

INTRODUCTION

Components Checklist

üA. (1) KP6-LA mainboard

üB. (1) KP6-LA user’s manual

üC. (1) Floppy ribbon cable

üD. (2) Hard drive ribbon cables

üE. (1) Retention Module

üF. (1) Heatsink Support Unit

üG. (1) PS/2 to AT keyboard connector adapter (option)

üH. (1) Bus master drivers

(1) DMI (option)

USERS

MANUAL

KP6-LA

Top Half

Bottom Half H

Introduction KP6-LA

Page 1-2

Overview

Pentium II

The Pentium®II Processor is the follow-on to the Pentium®Processor. The

Pentium®II Processor, like the Pentium®Pro processor, implements a Dynamic

Execution micro-architecture -- a unique combination of multiple branch prediction,

data flow analysis, and speculative execution. This enables the Pentium®II Proces-

sor to deliver higher performance than the Pentium®processor, while maintaining

binary compatibility with all previous Intel architecture processors.

A significant feature of the Pentium®II Processor, from a system perspective, is the

built-in direct multiprocessing support. In order to achieve multiprocessing, and

maintain the memory and I/O bandwidth to support it, new system designs are

needed. For systems with dual processors, it is important to consider the additional

power burdens and signal integrity issues of supporting multiple loads on a high

speed bus. The Pentium®II Processor card supports both uni-processor and dual

processor implementations.

The Pentium®II Processor utilizes Single Edge Contact (S.E.C.) (Figure 1) cartridge

packaging technology. The S.E.C. cartridge allows the L2 cache to remain tightly

coupled to the processor, while maintaining flexibility when implementing high

performance processors into OEM systems. The second level cache is performance

optimized and tested at the cartridge level. The S.E.C. cartridge utilizes surface

mounted core components and a printed circuit board with an edge finger connec-

tion. The S.E.C. cartridge package introduced on the Pentium®II Processor will also

be used in future Slot 1 processors.

The S.E.C. cartridge has the following features: a thermal plate, a cover and a PCB

with an edge finger connection. The thermal plate allows standardized heatsink

attachment or customized thermal solutions. The thermal plate enables a reusable

heatsink to minimize fit issues for serviceability, upgradeability and replacement.

The full enclosure also protects the surface mount components. The edge finger

connection maintains socketabilty for system configuration. The edge finger con-

nector is denoted as ‘Slot 1 connector’ in this and other documentation.

The entire enclosed product is called the Pentium®II Processor. The packaging

technology and each of the physical elements of the product are referred to using

accurate technical descriptions. This allows clear reference to the products as just a

Andere Handbücher für KP6-LA

Inhaltsverzeichnis

Andere EPOX Hauptplatine Handbücher

EPOX

EPOX 9npa Bedienungsanleitung

EPOX

EPOX EP-GXB-M Bedienungsanleitung

EPOX

EPOX EP-8RDAE Bedienungsanleitung

EPOX

EPOX 61BXA-M Bedienungsanleitung

EPOX

EPOX PP6-NF Bedienungsanleitung

EPOX

EPOX EP-4PEAE 11 Bedienungsanleitung

EPOX

EPOX LX370Y Bedienungsanleitung

EPOX

EPOX EP-61BXC-A Bedienungsanleitung

EPOX

EPOX KP6-LA Bedienungsanleitung

EPOX

EPOX EP-3VBM+ Bedienungsanleitung

EPOX

EPOX EP-MVP4G Bedienungsanleitung

EPOX

EPOX EP-3VBA Bedienungsanleitung

EPOX

EPOX EP-8HDA5J Bedienungsanleitung

EPOX

EPOX EP-BX7+ Bedienungsanleitung

EPOX

EPOX BXB Bedienungsanleitung

EPOX

EPOX EP-BX6 Bedienungsanleitung

EPOX

EPOX P2-112A Bedienungsanleitung

EPOX

EPOX MVP4G Bedienungsanleitung

EPOX

EPOX P55TV2 Bedienungsanleitung

EPOX

EPOX 3XCA2 Bedienungsanleitung

EPOX

EPOX EP-6WEA4 Bedienungsanleitung

EPOX

EPOX EP-8KTA Bedienungsanleitung

EPOX

EPOX EP-4PEA Bedienungsanleitung

EPOX

EPOX EP-BX3 Bedienungsanleitung

Beliebte Hauptplatine Handbücher anderer Marken

DFI

DFI SD170 Bedienungsanleitung

ASROCK

ASROCK ROMED8-2T Bedienungsanleitung

Asus

Asus P2L97A Bedienungsanleitung

Winmate

Winmate IC70 Bedienungsanleitung

Asus

Asus MES-B Bedienungsanleitung

Grantech

Grantech SYS8F377VGGA-3OMN Bedienungsanleitung

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Bedienungsanleitung

Gigabyte

Gigabyte GA-9IVDT Bedienungsanleitung

Texas Instruments

Texas Instruments ADS8372EVM Bedienungsanleitung

Commell

Commell MS-C73 Bedienungsanleitung

IBT Technologies

IBT Technologies MB860 Bedienungsanleitung

Nvidia

Nvidia TEGRA DG-04927-001_V01 Bedienungsanleitung

Biostar

Biostar M7VIT Bravo Bedienungs- und Montageanleitung

Intel

Intel D33217CK Bedienungsanleitung

Asus

Asus F1A55-M LX PLUS R2.0 Bedienungsanleitung

EPC

EPC EPC9147C Bedienungsanleitung

Asus

Asus EX-B760M-V5 D4 Bedienungsanleitung

Ski-Doo

Ski-Doo Bombardier MPEM 219 700 090 Bedienungsanleitung