
Introduction 5
Safety
The F-Drive Series W1 is intended for professional use only. Read the entire manual before
using this equipment.
IMPORTANTSAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed
including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS.
• Do not use outdoors.
• Do not let power supply cords touch hot surfaces.
• Do not mount near gas or electric heaters.
• Equipment should be mounted in locations and at heights where it will not
readily be subjected to tampering by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may
cause an unsafe condition.
• Do not use this equipment for other than intended use.
• To reduce the risk of fire and overheating, make sure all connections are
tight.
• Turn off electrical power before modifying the lighting system in any way.
SAVE THESE INSTRUCTIONS
Label Symbols
W1 Drivers are conveniently labeled with relevant symbols for your safety. Refer to the product
label to see which symbols apply to your product.
General warning Avertissement général
This product should not be discarded as unsorted
waste but must be sent to separate collection
facilities for recovery and recycling.
Ce produit ne doit pas être jeté avec les déchets ménagers
mais doit être déposé dans une collecte de déchets
électroniques ou dans un point de collecte.
The product input or output is suitable for direct
current only.
L’entrée et la sortie de ce produit convient uniquement au
courant continu.
The product input or output is suitable for
alternating current only.
L’entrée et la sortie de ce produit convient uniquement au
courant alternatif.
Safety extra low voltage device Dispositif de sécurité à très basse tension
Independent lighting control gear Appareil de contrôle d’éclairage indépendant.
Emergency lighting driver (non-battery powered)
according to EN-61347-2-13.
Pilote d’éclairage d’urgence (pas alimenté par piles)
conformément à la norme EN-61347-2-13.
Protective earth (ground) Protection Classe I Mise à la terre
tcor TcRated maximum case temperature Température maximale recommandée pour le boîtier