Eureka NEN110 Series Bedienungsanleitung

Owner’s Guide

Thank you for purchasing your new Eureka vacuum!

Important instructions

For easy assembly, please

take a few moments to read

this owner’s guide.

NEN110 series

Canister vacuum cleaner, household type

Where to nd important vacuum information

Please Retain

We suggest you record the model, type and serial

numbers below. They are located on the bottom of your

cleaner. For prompt and complete service information,

always refer to these numbers when inquiring about

service.

Model & Type _________________________________

Serial No. ____________________________________

It is also important to keep your receipt as proof of

date of purchase.

This Owner’s Guide provides important instructions to

prolong the life of your Eureka vacuum cleaner.

Inspection: Carefully unpack and inspect your new Eureka vacuum cleaner for shipping damage.

Each unit is tested and thoroughly inspected before shipping.

Contents

Important safeguards. ..................................................... 3

How to identify parts of your vacuum cleaner................. 5

How to assemble your vacuum cleaner. ......................... 6

How to use your vacuum cleaner. ................................... 7

How to maintain your vacuum cleaner. ........................... 8

Problem solving............................................................. 10

The Eureka 2 years limited warranty. ............................ 11

ââââââ

Follow caution information wherever you see this symbol.

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed, including the following:

READALL INSTRUCTIONS BEFORE USING THIS VACUUMCLEANER

WARNING

To reduce the risk of

re, electric shock, or

injury:

• Do not use outdoors or on wet

surfaces.

• Do not leave vacuum cleaner

Turn off the

switch and unplug the electrical

cord when not in use and

before servicing.

• Do not allow to be used as a

toy. Close attention isnecessary

when used by or near children.

• Use only as described

in this manual. Use only

manufacturer's recommended

attachments.

• Do not use with damaged cord

or plug.

• Do not pull or carry by the

cord, use cord as a handle,

close door on cord, or pull cord

around sharp edges or corners.

Do not run vacuum cleaner over

cord. Keep cord away from

heated surfaces.

• Do not use extension cords or

outlets with inadequate current

carrying capacity.

• Turn off all controls before

unplugging.

• Do not unplug by pulling on

cord. To unplug, grasp the plug,

not the cord.

• Do not handle the vacuum

cleaner with wet hands or

operate without shoes.

• Do not put any objects into

openings. Do not use with any

opening blocked; keep free of

dust, lint, hair and anything that

may reduce airow.

• This vacuum cleaner creates

suction. Keep hair, loose

clothing, ngers, and all parts of

body away from openings and

moving parts.

• Do not pick up anything that

is burning or smoking, such

as cigarettes, matches, or hot

ashes.

• Do not use without dust cup or

lter(s) in place.

• Use extra care when cleaning

on stairs.

• Do not use to pick up ammable

or combustible liquids such as

gasoline, or use on areas where

they may be present.

• Store your cleaner indoors in a

cool, dry area.

• Keep your work area well lit.

• Unplug electrical appliances

before vacuuming them.

• Belt pulleys can become hot

•

during normal use. To prevent

burns, avoid touching the belt

pulley when servicing the drive

belt.

• Turn off the power switch and

•

unplug cleaner before rotating

the nozzle.

SAVE THESE INSTRUCTIONS

To reduce the risk of electric shock,this appliance has a polarized plug (one blade is widerthen the other). This

plug will t in a polarized outlet only one way. If the plug does not fullyt into the outlet, reverse the plug.

If it still does not t,contact a qualied electrician to install the proper outlet. Do NOT change the plug in any way.

Thermal Cut Off

This vacuum cleaner has a special thermostat that protects the cleaner in case of motor overheating. If the

cleaner suddenly shuts off, push the on/off switch off (0) and unplug the cleaner. Check the cleaner for a

possible source of overheating such as a full dust cup, a blocked hose or clogged lter. If these conditions are

plug the cleaner back in and push the on/off switch on (I).

Do Not Oil the motor or the brushroll at any time. The bearings are permanently

lubricated and sealed.

This appliance can be used

by children aged from 8

years and above and per-

sons with reduced physical,

sensory or mental capabili-

ties or lack of experience

and knowledge if they have

been given supervision or

instruction concerning use

of the appliance in a safe

way and understand the

hazards involved. Children

shall not play with the appli-

ance. Cleaning and user

maintenance shall not be

made by children without

supervision.

If the supply cord is damaged,

it must be replaced by the

manufacturer, its service

agent or similarly qualied

persons in order to avoid a

hazard.

How to identify parts of your vacuum cleaner

1Handle

2Dust cup release button

3Power button

4Cord rewind button

5Filter

6Dust cup

Accessories

This vacuum cleaner includes the following accessories:

1Telescoping metal wand

2Hose

3Floor brush

How to assemble your vacuum cleaner

ASSEMBLY

Always disconnect the vacuum cleaner from the electrical socket before attaching or

removing accessories.

1. Attach the hose to the front of the vacuum cleaner by inserting it into the air inlet and

twisting to the right. To remove the hose twist to the left and pull to detach.

2. Attach the telescoping wand to the hose at the bend by pushing the two components

together.

3. Attach the oor nozzle to the wand by connecting the two parts. And then twist them into

position.

How to use your vacuum cleaner

CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the

hose/attachments or removing and emptying the dust cup.

IMPORTANT: The vacuum cleaner is equipped with a thermal cut-off. If for any reason the

vacuum cleaner does overheat, the thermostat will automatically turn the vacuum cleaner

off. If this happens, switch the vacuum cleaner off and unplug it from the electrical socket.

Remove and empty the dust cup and check the vacuum deaner for blockages. Allow the

vacuum cleaner to cool for approximately 1 hour (if you have cleaned the incorrect space,

please wait 24 hours for the lters to fully dry before putting them back into the machine).

Operation

Pull the power cord out of the vacuum cleaner and stop when you

see the yellow mark. Make sure the red mark is not visible or you

have pulled too far. When done cleaning, turn off the power, pull

the plug out of the electrical socket, and then push the rewind

button until the cord is completely retracted.

To turn on the vacuum cleaner, push the plug into an electrical

socket and press the power button.

Switching between carpet & hard oor

There is a switch located on the oor nozzle that can be pressed

with your foot to switch betweenoor modes. The symbols shown

below correspond to the type of oor the setting is for.

Position 1: Bristles extended for hard oor

Position 2: Bristles retracted for carpet

Position 1

Hard oor

Position 2

Carpet

How to maintain your vacuum cleaner

Emptying the dust cup

Always switch off the vacuum and unplug it from the electrical socket before conducting any

maintenance or cleaning.

Empty the dust cup after each use. Also be sure to empty the dust cup anytime dust reaches

the max ll line.

A full dust cup will reduce the efciency of the vacuum cleaner so be sure to empty the dust

cup regularly.

1. Press the dust cup release button and take the dust cup out of the vacuum.

2. Bring the dust cup over a trash receptacle and then press the release button to open the

lower lid. The dust will fall out the bottom and into the trash.

3. Close the dust cup lid after dust has been fully emptied. Return the dust cup to the

vacuum cleaner.

How to maintain your vacuum cleaner

Cleaning the Filter

The lter is an effective system for removing dust.

Sponge lters require cleaning on a monthly basis (or more depending on use frequency).

1. To remove the lter, pull on the dust cup lid clip and lift the cover upwards.

2. The lter is located inside the top cover of the dust

cup.

Pull on the handle of the lter housing then remove it.

3. Tap the lter over a bin to remove the dust.

4. Take the sponge lter out of the lter

housing.

DO NOT USE DETERGENTS to clean any part.

Leave it out to dry for 24 hours or until fully dry before placing it back in the vacuum cleaner.

6. Put the lter back into the housing. Put the housing and lter back into the dust cup lid.

Finally, close the dust cup lid.

7. Place the dust cup back into the vacuum cleaner until a click is heard.

Filter frame handle

Cyclone separation

system

Filter

Problem solving

Make sure vacuum is turned off and power cord is unplugged.

NOTICE: Thermal cut-off

This vacuum cleaner has a special thermostat that protects the vacuum in case of motor

overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Push the power

switch to off and unplug the vacuum. 2) Check the vacuum for a possible source of

overheating such as a full dust cup, blocked hose or clogged lter. If these conditions

are found, x them and wait at least 30 minutes before attempting to use the vacuum. 3)

After the 30 minute period, plug the vacuum back in and turn on the switch.

Problem Possible cause Solution

The vacuum

cleaner does not

turn on

• Too much dust in the cup

• Filter is blocked

• Hose is blocked

• Empty the dust cup

• Rinse the lter

• Clear the blockage

The vacuum

cleaner does not

work

• Electrical outlet is not

connected or not working

• Power switch was not

turned on

• Ensure the plug is properly

connected in the socket and

the socket is active

• Press the power button

The vacuum

cleaner suddenly

stops

• The dust cup is lled

• The lter is blocked

• Suction inlet of brush or

accessories is blocked

• Empty the dust cup

• Clean the lter

• Clear the blockage

Connecting to an electrical socket

Please check that the voltage indicated on the product corresponds with your supply voltage.

Andere Handbücher für NEN110 Series

Inhaltsverzeichnis

Andere Eureka Staubsauger Handbücher

Eureka

Eureka AS2000 series Bedienungsanleitung

Eureka

Eureka 96 Bedienungsanleitung

Eureka

Eureka 910 Series Bedienungsanleitung

Eureka

Eureka 5740 series Bedienungsanleitung

Eureka

Eureka 1400 series Bedienungsanleitung

Eureka

Eureka Swan HYPER CLEAN Bedienungsanleitung

Eureka

Eureka 4670 Series Bedienungsanleitung

Eureka

Eureka AS3020 series Bedienungsanleitung

Eureka

Eureka 8850 Series Bedienungsanleitung

Eureka

Eureka 79 SERIES Bedienungsanleitung

Eureka

Eureka AS1000 Series Bedienungsanleitung

Eureka

Eureka ReadyForce 900A Bedienungsanleitung

Eureka

Eureka 100-110 Bedienungsanleitung

Eureka

Eureka AS1000 Series Bedienungsanleitung

Eureka

Eureka 6700 Series Bedienungsanleitung

Eureka

Eureka CV190 Series Bedienungsanleitung

Eureka

Eureka 4750 Series Bedienungsanleitung

Eureka

Eureka 4230 Series Bedienungsanleitung

Eureka

Eureka 4235AZ Bedienungsanleitung

Eureka

Eureka Central Vacuum Cleaner Bedienungsanleitung

Eureka

Eureka Power-Touch Handle Bedienungsanleitung

Eureka

Eureka 3690 Bedienungsanleitung

Eureka

Eureka Air Extreme 6500 Bedienungsanleitung

Eureka

Eureka AS3001 series Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch