Extron electronics DTP HDMI 230 Bedienungsanleitung

DTP DVI 230 D and HDMI 230/330 D • Setup Guide

This setup guide provides instructions for an experienced installer to set up and operate the

Extron DTP DVI 230 D and DTP HDMI 230 and 330 D extenders.

Installation

Step 1 — Prepare the Mounting Surface

NOTE: Use a wall box with a depth of at least 3.0 inches (7.6 cm).

Alternatively, the included mud ring (MR 200) can be used.

For more information, see the full product user guides at

www.extron.com. The installation must comply with the

National Electric Code.

a. Place the wall box against the installation surface and mark the

opening guidelines.

TIP: Use a level to mark the opening.

b. Cut out the material from the marked area.

c. Secure the wall box with 10-penny nails or #8 or

#10 screws, leaving the front edge ush with the surface.

d. Run all required cables (see steps 4, 5, and 6) and secure them with

cable clamps.

TIP: In order to t the unit in the junction box, do not install

boots on TP cables and RJ-45 connectors.

Step 2 — Disconnect Power

Disconnect all equipment power sources.

Step 3 — Connect Inputs to the Transmitter

A DVI or HDMI input connector — Connect a DVI or HDMI cable between this port and the output port of the digital video source.

B Local output (DTP DVI 230 D only) — If desired, connect a DVI monitor for local monitoring of the input digital image.

C DDC Route DIP switch (DTP DVI 230 D only) — If the local output is not used,

set the DDC Route DIP switch to remote. Ensure that you power the local display

before powering the video source.

D Audio input — Connect an unbalanced stereo audio source to this 3.5 mm mini

stereo jack.

E RS-232/IR Pass-Through connector — Plug an RS-232 or modulated IR device

into the RS-232/IR Pass-Through port. Wire the cable as shown to the right.

Ground

Receive pin on connected unit

Transmit pin on connected unit

Connected RS-232

and IR Device Pins

Tx/Rx

Pins

Receive pin on connected unit

Transmit pin on connected unit

RxTx

RS-232 IR

RxTx

Signal Output

Cable

Clamp

Decora Faceplate

Extron

DTP DVI 230 D

Screws or

Nails

Wall opening is

ﬂush with edge of box.

Wall Stud

LOCAL OUT

Tx Rx G Tx Rx

RS-232 IR

INPUTS

DVI-D

AUDIO

INPUTS LOCAL OUT

DVI-D

AUDIO

Tx Rx G Tx Rx

RS-232 IR

INPUTS LOCAL OUT

DVI-D

AUDIO

REMOTE

DDC

ROUTE

LOCAL Tx Rx G Tx Rx

RS-232 IR

1 2

INPUTS

AUDIO

Tx Rx G Tx Rx

RS-232 IR

OVER DTP

DTP DVI 230 D Tx DTP HDMI 230/330 D Tx















68-2552-50 Rev. A

02 14

Extron Headquarters

+800.633.9876 Inside USA/Canada Only

Extron USA - West Extron USA - East

+1.714.491.1500 +1.919.850.1000

+1.714.491.1517 FAX +1.919.850.1001 FAX

Extron Europe

+800.3987.6673

Inside Europe Only

+31.33.453.4040

+31.33.453.4050 FAX

Extron Asia

+800.7339.8766

Inside Asia Only

+65.6383.4400

+65.6383.4664 FAX

Extron Japan

+81.3.3511.7655

+81.3.3511.7656 FAX

Extron China

+4000.EXTRON

+4000.398766

Inside China Only

+86.21.3760.1568

+86.21.3760.1566

FAX

Extron

Middle East

+971.4.2991800

+971.4.2991880 FAX

Extron Korea

+82.2.3444.1571

+82.2.3444.1575 FAX

Extron India

1.800.3070.3777

Inside India Only

+91.80.3055.3777

+91.80.3055 3737

FAX

Step 4 — Run Cables Between Units

NOTES:

• The DTP DVI/HDMI 230 D models can transmit video, control, and audio (if applicable) signals up to 230

feet (70m).

• The DTP HDMI 330 D model can transmit video, control, and audio (if applicable) signals up to 330 feet

(100m).

Connect the rear panel transmitter output to the rear panel receiver input using shielded twisted pair (STP) cable.

For optimal performance, Extron highly recommends the following:

zRJ-45 termination with STP cable must comply with TIA/EIA T 568B wiring standard for all connections. For more information on cable

wiring and termination, see the full product user guides at www.extron.com.

zUse shielded twisted pair cable, 24 AWG solid conductor or better, with a minimum cable bandwidth of

400 MHz.

ATTENTION: Do not use Extron UTP23SF-4 Enhanced Skew-Free AV UTP cable or STP201 cable.

zUse shielded RJ-45 plugs to terminate the cable.

zLimit the use of RJ-45 patches. Overall transmission distance capabilities vary depending on the number of patches used. If possible,

limit the number of patches to only 1 or 2 total.

zIf RJ-45 patches must be used in the system, shielded CAT 6 (or better) patches are recommended.

Step 5 — Connect Outputs from the Receiver

a. DVI or HDMI output connector — Connect a DVI or HDMI cable between this port and the input port of the display.

b. Audio output — Connect a stereo audio device to this 3.5 mm mini stereo jack to receive the passed through unbalanced audio.

c. RS-232/IR Pass-Through connector — Plug an RS-232 or modulated IR device into the

RS-232/IR Pass-Through port. Wire the connector as shown in step 3.

Step 6 — Power the Units

Wire the 2-pole captive screw connector for the included external 12 VDC power supply as shown at right.

Plug the power supply into either unit; the powered unit powers the other unit.

Step 7 — Final Installation

a. Make all connections and test the system for satisfactory operation.

b. At the power outlet, unplug the power supply.

c. Mount the transmitter or receiver into the wall box, and attach the supplied Decora faceplate to the

unit.

d. At the power outlet, reconnect the power supply. This powers up both units.

Operation

After all devices are powered up, the system is fully operational. See the denitions of the power indications below:

Transmitter and Receiver Power Indicator

A Power LED — This two-color front panel LED on both transmitter and receiver lights to indicate signal and

power status as follows:

Amber — The unit is receiving power but no signal on the DVI or HDMI input (TP input for receiver).

Green — The unit is receiving power and a signal is present on the DVI or HDMI input (TP input for

receiver).

SECTION A–A

Power Supply

Output Cord

Captive Screw

Connector

Ridges

Smooth

3/16"

(5 mm) Max.

LOCAL OUT

DVI-D

AUDIO

REMOTE

DDC

ROUTE

LOCAL Tx Rx GTxRx

RS-232 IR

SIG LINK

DTP OUT

SIG LINK

DTP IN

Andere Handbücher für DTP HDMI 230

Dieses Handbuch passt für folgende Modelle

Andere Extron electronics Extender Handbücher

Extron electronics

Extron electronics FOX3 101 Bedienungsanleitung

Extron electronics

Extron electronics EDID 101H 4K Bedienungsanleitung

Extron electronics

Extron electronics XTP T HD 4K Bedienungsanleitung

Extron electronics

Extron electronics DTP T DWP 4K 232 D Bedienungsanleitung

Extron electronics

Extron electronics DTP HDMI 4K D Series Bedienungsanleitung

Extron electronics

Extron electronics DTP2 T 204 Bedienungsanleitung

Extron electronics

Extron electronics DTP T UWP 4K 232 D Bedienungsanleitung

Extron electronics

Extron electronics XTP R HWP 201 Bedienungsanleitung

Extron electronics

Extron electronics FOX II T DP Bedienungsanleitung

Extron electronics

Extron electronics DTP HDMI 230 Bedienungsanleitung

Extron electronics

Extron electronics FOX3 101 Bedienungsanleitung

Extron electronics

Extron electronics DTP T/R DP 330 Bedienungsanleitung

Extron electronics

Extron electronics DTP T 3G-SDI 230 Bedienungsanleitung

Extron electronics

Extron electronics DDX 102 Tx Bedienungsanleitung

Extron electronics

Extron electronics Fiber Optic DVI Extenders DVI 104 RX Bedienungsanleitung

Extron electronics

Extron electronics Tx-Rx Bedienungsanleitung

Extron electronics

Extron electronics Extender Wall Mount Series Bedienungsanleitung

Extron electronics

Extron electronics DTP HDMI 330 Bedienungsanleitung

Extron electronics

Extron electronics FOX 500 DVI Bedienungsanleitung

Extron electronics

Extron electronics DTP DVI 301 Bedienungsanleitung

Extron electronics

Extron electronics VGAUXGA Line Drivers With Audio Extender... Bedienungsanleitung

Extron electronics

Extron electronics UCS FT 901 Bedienungsanleitung

Extron electronics

Extron electronics DTP DVI 4K 230 D Series Bedienungsanleitung

Extron electronics

Extron electronics TP Series Bedienungsanleitung

Beliebte Extender Handbücher anderer Marken

SY HDBT-60T Bedienungsanleitung

Appsys ProAudio

Appsys ProAudio ADX-16 Bedienungsanleitung

Atlona

Atlona RS232 Bedienungsanleitung

IDK

IDK OPF-TH1000-A Bedienungsanleitung

Enable-IT

Enable-IT 824WP Bedienungsanleitung

Worx

Worx Landroid RadioLink WA0864 Technisches Datenblatt

TP-Link

TP-Link TL-WA730RE Bedienungsanleitung

Camplex

Camplex CMX-HDMI-SFPL Bedienungsanleitung

SC&T

SC&T HE03-4K Bedienungsanleitung

Marmitek

Marmitek MegaView70 Bedienungsanleitung

Samsung

Samsung SCS-26UC4 Bedienungsanleitung

Foxun

Foxun SX-GES24 Bedienungsanleitung

MuxLab

MuxLab 500771 Bedienungsanleitung

foxunhd

foxunhd SX-AEX01 Bedienungsanleitung

TERK Technologies

TERK Technologies LFIRX2 Bedienungsanleitung

Devolo

Devolo Audio Extender Handbuch

Edimax

Edimax EW-7438RPn V2 Bedienungsanleitung

Shinybow USA

Shinybow USA SB-6335T5 Bedienungsanleitung