Formax FD 8500CC Bedienungsanleitung

Paper Shredders

FD 8500CC Cross-Cut

FD 8500SC Strip-Cu

OPERATOR MANUAL

SECOND EDITION

4/2007

Safety Devices and Other Features

Formax 8000 Series Shredders are equipped with various safety features:

Automatic Reverse Rotation

When too much paper is inserted, the cutter stops operating

and

automatically rotates in reverse to discharge the jammed paper. An

alarm sounds. Reduce the amount of paper and restart the operation.

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the shredded paper ﬁ lls the wastebasket, the “FULL”

light

comes on and the cutter stops operation. Open the door, remove

the wastebasket and empty paper scraps. Replace the wastebasket,

close the door and continue operation.

Automatic Power Shut-Off

• If the shredder operates continuously for more than 30

minutes, the power is automatically shut off.

• If the motor is overloaded, the “STOP” LED will ﬂ ash until it cools

down. When the ﬂ ashing stops the shredder is ready to be used again.

Oil Indicator

The “MANUAL” LED will ﬂ ash after every four (4) hours of operation as an

indicator to oil the shredder cutting blades. The LED will continue to ﬂ ash until

oiled. NOTE: the shedder will still operate when the LED is ﬂ ashing but at a

decreased load capacity.

To oil:

Spread shredder oil onto the cutters through the feed opening, and allow

the oil to sit for a few minutes to permeate the cutting blades, then press the “REV”

button and hold for ﬁ ve seconds. “MANUAL” and “REV” LED indicators on control

panel will light. The shredder will operate in reverse for one minute, then the

“AUTO” LED will light indicating the shredder is ready.

Maintenance

• Disconnect power by pulling power cord plug from wall outlet.

• To clean the exterior, wipe the surface with a soft cloth. If the surface is

very dirty, use a neutral detergent, then wipe again with a soft cloth.

CAUTION:

• Never put water directly on the surface of the shredder.

• Never clean the case with benzene or thinner, since it will cause

discoloration.

• Do not dismantle the shredder. Contact your Formax Dealer for service.

Operation

1. Open the door and turn the power switch “ON.” Close door.

Auto Start/Auto Stop

When the “START A/M” button is pushed, the signal lamp

“AUTO” will light. Insert paper to shred. The shredder will start

and stop automatically when using this function.

Manual Operation

If paper is too small for the shredder’s sensors to detect, shred

it manually. Push the “START A/M” button once more and the

“MANUAL” lamp will light. Insert paper to be shredded. Three

minutes after shredding, the cutter automatically stops rotating.

Set-up Guidelines

1. Install the shredder on a level surface, away from heat sources and direct

sunlight.

2. Insert plug into wall outlet with the appropriate voltage, 110V. If the outlet

is shared with another electronic device, the total current should not exceed 30A

(at 110V).

Speciﬁ cations

Cutting Style:

Cross Cut

Strip Cut

Shred Size:

5/32” x 1-1/5”

5/32”

Sheet Capacity:

16 to 18

20 to 22

Speed:

31 feet per minute

33 feet per minute

Feed Opening:

16”

Dimensions:

24” W x 20” D x 35” H

Bin Capacity:

26 gal.

Weight:

242 lbs.

Power supply:

110-120V, 60Hz

Cutting heads accept credit cards, staples and paper clips.

FD 8500CC FD 8500SC

Reverse Operation

Push the “REV” button and the signal lamp “REV” will light and cutters will operate

in reverse. If too much paper is inserted at one time in standard modes, the

shredder will automatically operate in reverse. If this occurs, remove the inserted

paper and shred in smaller amounts. NOTE: The maximum amount of paper to be

shredded differs according to paper quality, humidity and voltage. If the shredder is

to be used continuously, do not insert more than half of the maximum capacity.

Full Sensor

If the wastebasket is full, the “FULL” lamp will light and the cutter will stop

automatically. Open the door, empty the wastebasket of paper strips/chips, replace

the wastebasket, close door, and continue to shred.

Safety Precautions

To avoid personal injury, and damage to the shredder, observe the following safety

precautions. Please keep these instructions for future reference.

NOTE:

In case of emergency, push the

“Power Switch” to cut off power and/or

pull the plug out of the wall outlet.

•

Keep hands, long hair, clothing, ties, jewelry

and loose items away from the feed opening

and shred outlet.

•

Do not use the shredder for anything other

than its intended purpose. Never use it to shred cloth, plastic, cardboard or any

hard material that will cause damage to the shredder blades.

•

Do not allow children to use the machine.

•

Do not operate with a damaged power cord or plug, or when the machine

damaged in any manner.

•

Unplug the shredder when it is being moved, or if it is not in use for an

extended

period of time.

•

Do not disconnect the power by pulling only the cord. Hold the plug when

disconnecting.

•

Keep the shredder away from direct sunlight.

•

Do not sit on the shredder or place anything on top of it.

•

Never open the ﬁ xed switch or cover.

Dieses Handbuch passt für folgende Modelle

Andere Formax Aktenvernichter Handbücher

Formax

Formax FD 8400HS Bedienungsanleitung

Formax

Formax FD 8252CC Bedienungsanleitung

Formax

Formax FD 8712HS Bedienungsanleitung

Formax

Formax FD 8906CC Cross-Cut Bedienungsanleitung

Formax

Formax FD 8202CC Bedienungsanleitung

Formax

Formax Formax FD 415 Betriebsanleitung

Formax

Formax FD 8732HS Bedienungsanleitung

Formax

Formax FD 8250CC Bedienungsanleitung

Formax

Formax Cut-True 29A Bedienungsanleitung

Formax

Formax FD 8254CC Bedienungsanleitung

Formax

Formax FD 8302SC Bedienungsanleitung

Formax

Formax Formax FD 572 Bedienungsanleitung

Formax

Formax FD 87HD Bedienungsanleitung

Formax

Formax OnSite FD 87 Bedienungsanleitung

Formax

Formax FD 8650CC Bedienungsanleitung

Formax

Formax FD 8730HS Bedienungsanleitung

Formax

Formax FD 8702CC Bedienungsanleitung

Formax

Formax FD 87HDS Bedienungsanleitung

Formax

Formax FD 8206 Bedienungsanleitung

Formax

Formax FD 8500AF Bedienungsanleitung

Formax

Formax FD 8502AF Bedienungsanleitung

Formax

Formax FD 8602CC Bedienungsanleitung

Formax

Formax FD 8714CC Cross Cut Bedienungsanleitung

Formax

Formax FD 8802 series Bedienungsanleitung

Beliebte Aktenvernichter Handbücher anderer Marken

Swingline

Swingline STACK-AND-SHRED200X&200XL 60X Bedienungsanleitung

GBC

GBC ShredMaster CC055 Bedienungsanleitung

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Bedienungsanleitung

Rexel

Rexel Optimum AutoFeed+ 45X Bedienungsanleitung

Martin Yale

Martin Yale 227284S1 Bedienungsanleitung

Bonsaii

Bonsaii DocShred C223-A Bedienungsanleitung

HSM

HSM Pure 740 max Bedienungsanleitung

TRU RED

TRU RED TR-BMC20A Bedienungsanleitung

Fellowes

Fellowes 50S Bedienungsanleitung

GBC

GBC SHREDMASTER 1236SE Bedienungsanleitung

Gude

Gude GH 2600 P Bedienungsanleitung

Ativa

Ativa DQ80M Bedienungsanleitung

Q-Connect

Q-Connect Q8CC Bedienungsanleitung

Fellowes

Fellowes POWERSHRED C-325CI Bedienungsanleitung

Olivetti

Olivetti Privacy 5000C Kurzanleitung

Dahle

Dahle paperSAFE 22022 Bedienungsanleitung

GEHA

GEHA Home & Office S7 CD Bedienungsanleitung

Fellowes

Fellowes Powershred M-3C Bedienungsanleitung