Formax FD 87HDS Bedienungsanleitung

12/2018

Maintenance

• Disconnect power by removing power cord plug from wall outlet.

• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use

a neutral detergent, then wipe again with a soft cloth.

CAUTION:

• Never put water directly on the surface of the shredder.

• Never clean the case with benzene or thinner, since it will cause discoloration.

• Do not dismantle the shredder. Contact your Formax Dealer for service.

Safety Devices and Other Features

Door Switch

If the door is open, the shredder will not operate.

Automatic Stop

When the waste bin is full, the “FULL” LED will light and the cutter stops operation.

Open the door, remove the waste bin and empty. Replace the waste bin, close the door,

and press START to resume operation.

Automatic Power Shut-Off

If the shredder operates continuously for more than 30 minutes, the power is

automatically shut off.

If the motor is overloaded, the “STOP” LED will ash until it cools down. When the

ashing stops the shredder is ready to be used again.

•Do not allow children to operate the shredder.

•Unplug the shredder when it is being moved, or not in use for an extended time.

•Do not disconnect the power by pulling only the cord.

•Keep the shredder away from direct sunlight.

•Do not sit on the shredder or place anything on top of it.

•Never open the xed switch or cover.

OPERATOR MANUAL

FD 87HDS Hard Drive Shredder

Safety Precautions

To avoid personal injury, and damage to the shredder, observe the following safety

precautions. Please keep these instructions for future reference.

•Keep hands, long hair, clothing, ties, jewelry and loose items away from the feed

opening and shred outlet.

•Do not use the shredder for anything other than its intended purpose. Never use

it to shred cloth, plastic, cardboard or any hard material that will cause damage to

the shredder blades.

•Do not operate with a damaged power cord or plug, or when the machine is

damaged in any manner.

Set-up Guidelines

1. Install the shredder on a level surface, away from heat sources and direct sunlight.

2. Insert plug into wall outlet with the appropriate voltage.

Specications Operation

1. Open the breaker panel door (lower

left side of shredder case). Flip ON the

breaker. Close door.

2. Insert key and turn Power switch to ON.

3. Slide open the appropriate shredding

chamber door (left for larger desktop

drives, right for smaller laptop drives).

4. Drop in one drive at a time (Fig. 1 or 2)

5. Slide shut the safety cover.

6. Press START on the control panel. The

shredding shredding will begin.

Wait until the shredding chamber is

clear before pressing STOP.

WARNING: DO NOT attempt to open

the shredding chamber door during

shredding. The motor and blades will

automatically stop turning, but particles

may y out before they have stopped.

If you need to stop the shredder before

the chamber is clear, press the red

Emergency Stop button.

7. Each shredding chamber has a

separate LED counter (Fig. 3). To reset

a counter, press the RESET button.

8. When shredding job is complete, press

the STOP button on the control panel,

and turn the key lock left to the OFF

position.

* Capacity may vary due to variations in power supply.

Control Panel

Reverse Operation

Push the REV button and the “REV” LED will light and

cutters will operate in reverse. This will help to clear a

jammed drive.

Waste Bin Full Sensor

If the waste bin is full, the “FULL” LED will light and the

shredder will stop automatically. Open the waste bin

door, remove and empty the waste bin (Fig. 4). Replace

the waste bin, close door, and press START to resume

shredding.

Fig. 1 Desktop drive infeed

Fig. 2 Laptop drive infeed

Waste Bin Full LED

Cleaning Mode LED

Door Open LED

Emergency Stop Button

Reverse Button

Start Button

Stop Button

ON / OFF Key Lock

3.5” Desktop Hard Drive 2.5” Laptop Hard Drive

Feed Opening: 4.72” (120mm) 3.54” (90mm)

Shred Particle Size: 1.6” (40mm) x random .19” (5mm) x random

Infeed Capacity: 1 hard drive at a time 1 hard drive at a time

Speed: 3 - 4 drives per minute 3 - 4 drives per minute

Dimensions: 19.68” W x 18.5” D x 35” H (500 x 470 x 890mm)

Weight: 1,102 lbs. (500kg)

Security Level: H-6 (DIN 66399 standard)

Power Supply: 220V 20Amp 3 Phase

NEMA Plug / Receptacle L1520P / L1520R

The control panel LEDs will light to indicate the shredder’s status.

Fig. 4

Fig. 3

Inhaltsverzeichnis

Andere Formax Aktenvernichter Handbücher

Formax

Formax FD 8500CC Bedienungsanleitung

Formax

Formax Formax FD 415 Betriebsanleitung

Formax

Formax FD 8254CC Bedienungsanleitung

Formax

Formax FD 8732HS Bedienungsanleitung

Formax

Formax FD 8732HS Bedienungsanleitung

Formax

Formax FD 8252CC Bedienungsanleitung

Formax

Formax FD 8250CC Bedienungsanleitung

Formax

Formax Formax FD 572 Bedienungsanleitung

Formax

Formax FD 8712HS Bedienungsanleitung

Formax

Formax FD 8714CC Cross Cut Bedienungsanleitung

Formax

Formax FD 8652CC Bedienungsanleitung

Formax

Formax FD 8202CC Bedienungsanleitung

Formax

Formax FD 8704CC Bedienungsanleitung

Formax

Formax FD 8500CC Bedienungsanleitung

Formax

Formax FD 8502AF Bedienungsanleitung

Formax

Formax FD 8850CC Bedienungsanleitung

Formax

Formax FD 8502CC Bedienungsanleitung

Formax

Formax FD 8500HS Bedienungsanleitung

Formax

Formax FD 8300HS Bedienungsanleitung

Formax

Formax FD 8202CC Cross-Cut Bedienungsanleitung

Formax

Formax FD 8802 series Bedienungsanleitung

Formax

Formax OnSite FD 87 Bedienungsanleitung

Formax

Formax FD 8402CC Bedienungsanleitung

Formax

Formax FD 8602CC Bedienungsanleitung

Beliebte Aktenvernichter Handbücher anderer Marken

Swingline

Swingline STACK-AND-SHRED200X&200XL 60X Bedienungsanleitung

GBC

GBC ShredMaster CC055 Bedienungsanleitung

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Bedienungsanleitung

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Bedienungsanleitung

Rexel

Rexel Optimum AutoFeed+ 45X Bedienungsanleitung

Martin Yale

Martin Yale 227284S1 Bedienungsanleitung

Bonsaii

Bonsaii DocShred C223-A Bedienungsanleitung

HSM

HSM Pure 740 max Bedienungsanleitung

TRU RED

TRU RED TR-BMC20A Bedienungsanleitung

Fellowes

Fellowes 50S Bedienungsanleitung

GBC

GBC SHREDMASTER 1236SE Bedienungsanleitung

Gude

Gude GH 2600 P Bedienungsanleitung

Ativa

Ativa DQ80M Bedienungsanleitung

Q-Connect

Q-Connect Q8CC Bedienungsanleitung

Fellowes

Fellowes POWERSHRED C-325CI Bedienungsanleitung

Olivetti

Olivetti Privacy 5000C Kurzanleitung

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Bedienungsanleitung

Dahle

Dahle paperSAFE 22022 Bedienungsanleitung