Fujitsu FI-800R Gebrauchs- und Pflegehandbuch

FUJITSU Image Scanner

fi-800R

Consumable Replacement and Cleaning Guide

CG00002-302301 Revision A

Daily Care

This section describes how to clean the scanner.

Cleaning

Materials

ATTENTION

In order to use the cleaning materials safely and correctly, read the precautions on each

product thoroughly.

Name

Part No.

Notes

Cleaner F1

PA03950-0352

100 ml

Liquid cleaner to use for removing dirt and stains

Cleaning Sheet

CA99501-0016

20 sheets/pack

This is an A4 size-cleaning sheet.

Use two sheets to clean once.

Cleaning Wipe

PA03950-0419

24 packets

Pre-moistened with Cleaner F1. It can be used

instead of moistening a cloth with Cleaner F1.

Cotton swab

Commercially

Available

Used to clean a tiny part such as the

document sensor.

Dry cloth

Used to wipe off dirt and stains. Moisten it

with Cleaner F1 for cleaning.

●

Do not use aerosol spray or spray that contains alcohol. Paper dust blown

up by strong air from the spray may enter inside the scanner, which may

cause the scanner to fail or malfunction.

Also note that sparks generated by static electricity may cause a fire.

●

The inside of the ADF becomes very hot when the scanner is being used.

Before you start cleaning the inside of the ADF, make sure to turn off the

power, unplug the power cable and wait for at least 15 minutes for the

inside of the ADF to cool down.

CAUTION

For more information about the cleaning materials, contact the distributor/dealer where you

purchased this product. Refer to the contact information in the Contact List or the Contact

for Inquiries section in Safety Precautions bundled with this product and make an inquiry.

Location and Frequency

ATTENTION

Cleaning cycles may vary depending on the condition of the documents. Also, cleaning

must be performed more frequently when the following types of documents are scanned:

●

Smooth-faced documents such as coated paper

●

Documents with printed text/graphics that almost cover the entire surface

●

Chemically-treated documents such as carbonless paper

●

Documents containing a large amount of calcium carbonate

●

Documents written in lead pencil

●

Documents on which the toner is not sufficiently fused

Cleaning Location

Frequency

Inside of the scanner

(ADF)

Pad unit

Every 1,000 sheets

Pick roller

Glass

Ultrasonic sensor

Document sensor

Feed roller

Eject roller

Outside of the scanner

Scanner

Clean when dust and dirt

are noticeable.

The inside of the scanner (ADF) needs to be cleaned regularly for every certain number of

sheets scanned. The scanner records the number of sheets scanned so that you can check

the number of sheets scanned after you cleaned it last.

The scanner including the ADF paper chute (feeder) and the stacker should be

cleaned with either a piece of dry cloth, a cloth moistened with Cleaner F1/mild

detergent, or a sheet of Cleaning Wipe.

Cleaning the Outside of the Scanner

ATTENTION

To avoid deformation and discoloration, never use paint thinner or any other

organic solvents.

Be careful not to let any moisture or water inside the scanner during cleaning.

It may take a long time to dry if an excessive amount of Cleaner F1/mild detergent

is used. Use only a small amount. Wipe off the cleaner completely to leave no

residue on the cleaned parts.

The inside of the ADF can be cleaned with a sheet of Cleaning Paper moistened with

Cleaner F1.

As the scanner continues to feed the documents, paper dust will accumulate inside the ADF

and it may cause scanning errors. Cleaning should be performed approximately every 1,000

sheets scanned. Note that this guideline varies depending on the types of documents you

scan. For instance, it may be necessary to clean the scanner more frequently when you

scan documents on which the toner is not sufficiently fused.

1. Turn on the scanner

2. Spray the Cleaning Paper with Cleaner F1

3. Insert the Cleaning Paper into the return path opening or load the Cleaning Paper in

the ADF paper chute (Feeder).

Inside the ADF should be cleaned from both the return path opening and the ADF

paper chute (feeder).

oFor the return path opening

Insert the Cleaning Paper into the return path opening.

Cleaning the Inside of the Scanner (ADF) with Cleaning

Paper

ATTENTION

Do not use water or mild detergent to clean the ADF.

It may take a long time to dry if an excessive amount of Cleaner F1 is used.

Use only a small amount. Wipe off the cleaner completely to leave no

residue on the cleaned parts.

oFor the ADF paper chute (feeder)

Open the ADF paper chute (feeder), load the Cleaning Paper, and move the

side guides so that there is no space between the side guides and the

Cleaning Paper.

Otherwise, the Cleaning Paper may be fed skewed.

4. Scan the document with the image scanning application.

5. Clear the sheet counter after cleaning using the Software Operation Panel.

The inside of the ADF can be cleaned with a piece of cloth moistened with Cleaner F1, or a

sheet of Cleaning Wipe.

As the scanner continues to feed the documents, paper dust will accumulate inside the ADF

and it may cause scanning errors. Cleaning should be performed approximately every 1,000

sheets scanned. Note that this guideline varies depending on the types of documents you

scan. For instance, it may be necessary to clean the scanner more frequently when you

scan documents on which the toner is not sufficiently fused.

Cleaning the Inside of the Scanner (ADF) with a Cloth

The inside of the ADF becomes very hot when the scanner is being used.

Before you start cleaning the inside of the ADF, make sure to turn off the power, unplug the

power cable and wait for at least 15 minutes for the inside of the ADF to cool down.

ATTENTION

Do not use water or mild detergent to clean the ADF.

It may take a long time to dry if an excessive amount of Cleaner F1 is used. Use

only a small amount. Wipe off the cleaner completely to leave no residue on the

cleaned parts.

1. Turn off the scanner, unplug the power cable and wait for at least 15 minutes.

2. Open the ADF paper chute (feeder).

3. Open the ADF.

4. Clean the following locations with a cloth moistened with Cleaner F1, or a sheet of

Cleaning Wipe.

When the ADF is open, it might close

accidentally. Be careful not to get your fingers caught.

oPick Roller 1

Gently wipe dirt and dust off the roller as you rotate the roller manually, taking

care not to damage the roller surface. Make sure that it is wiped properly

because black residue on the roller will affect the feeding performance.

oUltrasonic Sensor (x2) / Document Sensor (x4)

Gently wipe dirt and dust off the surface of the ultrasonic and document

sensors.

oGlass (x2)

Gently wipe dirt and dust off the glass sections.

oPad Unit (x1)

Wipe the rubber surface of the pad downward to remove any dirt and dust. Be

careful not to accidentally get your hand or a cloth on the pick spring (metal

part).

oFeed Roller (x4) / Eject Roller (x8)

The power must be turned on to rotate the feed/eject rollers for cleaning.

a. Plug in the power cable and turn on the scanner

b. Open the ADF

c. Press the [Scan/Stop] button for 3 seconds or more in order for the

scanner to enter cleaning mode.

d. Press the [Scan/Stop] button.

The feed/eject rollers rotate a certain amount simultaneously.

As a guideline, pressing the [Scan/Stop] button seven times will

rotate the feed rollers/eject rollers one revolution.

e. Put a piece of cloth moistened with Cleaner F1 or a sheet of

Cleaning Wipe against the surface of the rotating feed/eject roller,

and wipe horizontally to clean dirt and dust off the whole surface.

Make sure that it is wiped properly because black residue on the

roller will affect the feeding performance.

5. Close the ADF.

6. Clear the sheet counter after cleaning.

Start up the Software Operation Panel and clear the counter.

Andere Handbücher für FI-800R

Inhaltsverzeichnis

Andere Fujitsu Scanner Handbücher

Fujitsu

Fujitsu FI-4860C2 Bedienungsanleitung

Fujitsu

Fujitsu fi-65F Bedienungsanleitung

Fujitsu

Fujitsu S1500 - ScanSnap Deluxe Bundle Montageanleitung

Fujitsu

Fujitsu fi-6110 Handbuch

Fujitsu

Fujitsu FI 6140 - Document Scanner Bedienungsanleitung

Fujitsu

Fujitsu FI-6130 Bedienungsanleitung

Fujitsu

Fujitsu fi-4750L Konfigurationshandbuch

Fujitsu

Fujitsu FI-5120 Bedienungsanleitung

Fujitsu

Fujitsu S1500M - ScanSnap - Document Scanner Bedienungsanleitung

Fujitsu

Fujitsu fi-8190 Handbuch

Fujitsu

Fujitsu FI-6140c Konfigurationshandbuch

Fujitsu

Fujitsu Fi-4750c - Color Duplex Document Scanner 50ppm 90ipm... Bedienungsanleitung

Fujitsu

Fujitsu FI-5900C Bedienungsanleitung

Fujitsu

Fujitsu FI-4120C Bedienungsanleitung

Fujitsu

Fujitsu Fi-5110EOX2 - ScanSnap! - Document Scanner Bedienungsanleitung

Fujitsu

Fujitsu ScanSnap FI-4110EOX2 Bedienungsanleitung

Fujitsu

Fujitsu M3097E Plus Handbuch

Fujitsu

Fujitsu ScanSnap iScanner fi-6010N Bedienungsanleitung

Fujitsu

Fujitsu M3096EX Handbuch

Fujitsu

Fujitsu fi-4340C Konfigurationshandbuch

Fujitsu

Fujitsu fi-5650C Handbuch

Fujitsu

Fujitsu FI-4120C Handbuch

Fujitsu

Fujitsu fi-4860C Bedienungsanleitung

Fujitsu

Fujitsu M3093GX Bedienungs- und Wartungshandbuch

Beliebte Scanner Handbücher anderer Marken

Plustek

Plustek Scanner Bedienungsanleitung

Z/I Imaging

Z/I Imaging PhotoScan 2001 Bedienungsanleitung

Renkforce

Renkforce DS100-5M Bedienungsanleitung

Image Access

Image Access WideTEK A2 Bedienungsanleitung

Canon

Canon imageFORMULA CR-120N Bedienungsanleitung

GeoSlam

GeoSlam ZEB Horizon Montageanleitung

Kodak

Kodak i5800 Scanner Bedienungsanleitung

Kodak

Kodak i7300 Bedienungsanleitung

Revopoint

Revopoint POP Bedienungsanleitung

Eddyfi Technologies

Eddyfi Technologies Floormap X Bedienungsanleitung

Faselase

Faselase F6 Bedienungsanleitung

Uniden

Uniden BC340CRS Bedienungsanleitung

Infinite Peripherals

Infinite Peripherals INFINEA TAB M Bedienungsanleitung

Mustek

Mustek PageExpress 4800 Pro Bedienungsanleitung

Optex

Optex 750830 Bedienungsanleitung

Innova

Innova 5210 Bedienungsanleitung

Visioneer

Visioneer CardReader 100 Kurzanleitung

Rohde & Schwarz

Rohde & Schwarz TSME6 Bedienungsanleitung