Gamma+ Rose XT LED 200 Zoom Montageanleitung

LED PAR LIGHT

CW&WW 2 IN1

200W Cob Led Par Zoom

User Instruction

This product manual contains important information about the safe installation and use of this projector.

Please read and follow these instructions carefully and keep this manual in a safe place for future reference.

Rosé XT LED 200 Zoom

CONTENTS

1. INSTRUCTION

1) Unpacking

2) Introduction

3) AC Power

4) Safety Instruction

5) Cleaning

2. FEATURE

3. SET UP

1) 3-Pin to 5-Pin Conversion Chart

2) Setting up a DMX Serial Data Link

3) Master/Slave Fixture Linking

4. DMX CHANNEL SUMMARY

1) Operation method

2) Dmx Channels

1. INSTRUCTION Led Par Light

Unpacking: Thank you for purchasing our products. Every unit has been thoroughly tested and

has been shipped in perfect operating condition. Carefully check the shipping carton for damage

that may have occurred during shipping. If the carton appears to be damaged, carefully inspect

your fixture for any damage and be sure all accessories necessary to operate the unit has arrived

intact. In the case damage has been found or parts are missing, Save the carton and all packing

materials. In the event a fixture must be returned to the factory. It is important that the fixture be

returned in the original factory box and packing.

Introduction: The unit is a DMX intelligent Led Par Light. This light can be used in a stand alone

mode or connected in a Master/Slave configuration. The unit can also be controlled via DMX

controller. This light has three operating modes: stand alone mode, Master/Slave and DMX control

mode.

AC Power: This fixture has an auto-switching power supply that can accommodate a wide range

of input voltages. The only thing necessary to do before powering on the unit is to make sure the

line voltage you are applying is within the range of accepted voltages. This fixture will

accommodate between 90V and 240V AC. All fixtures must be powered directly off a switched

circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit. Even if the rheostat or

dimmer channel is used solely for a 0-100% switch.

Safety Instructions:

To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture

 D  ill water or other liquids into or on to your unit.

 Be e ha he lcal e le match that of the required volt-age for your unit.

 D  aem  eae this unit if the power cord has been frayed or broken. Do not

attempt to remove or break off the ground prong from the electrical cord. This prong is used to

reduce the risk of electrical shock and fire in case of an internal short.

 Dicec fm mai e befe makig a e f ceci.

 D  eme he ce de a cdiis. There are no user serviceable parts inside.

 Nee eae hi i he i ce i emed.

 Nee lg hi i i  a dimme ack

Ala be e  m hi i i a aea ha ill all e

eilai. All ab 6 (15cm) beee this device and a wall.

 D  aem  eae hi i, if i becme damaged.

 This unit is intended for indoor use.

 Dig lg eid f -e, dicec he i mai e.

 Ala m hi i i afe ad able mae.

 Pe-supply cords should be routed so that they are not likely to be walked on or pinched

by items placed upon or against them, paying particular attention to the point they exit from

Please read these instructions carefully, which includes important information

about the installation, usage and maintenance of this product.

the unit.

 Cleaig -The fixture should be cleaned only as recommended by the manufacturer. See

page 3 for cleaning details.

 Hea -The appliance should be situated away from heat sources, such as radiators, heat

registers, stoves, or other appliances (including amplifiers) that produce heat.

 The fie hld be eiced b ualified service personnel when:

a) The power-supply cord or the plug has been damaged.

b) Objects have fallen, or liquid has been spilled into the appliance.

c) The appliance has been exposed to rain or water.

d) The appliance does not appear to operate normally or exhibits a marked change in

performance.

Caution! There are no user serviceable parts inside this unit. Do not attempt any repairs yourself,

doing so will void your manufacturers warranty. In the unlikely event your unit may require service

please contact us.

Cleaning: Due to fog residue, smoke, and dust cleaning the internal and external optical lenses

must be carried out periodically to optimize light output.

1. Use normal glass cleaner and a soft cloth to wipe down the outside casing.

2. Clean the external optics with glass cleaner and a soft cloth every 20 days.

3. Always be sure to dry all parts completely before plugging the unit back in.

Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog

residue, dust, dew).

2. Features Led Par Light

VOLTAGES:

AC 100V-240V，50/60Hz

POWER CONSUMPTION:

250W@230V

LED:

Light Source: Light Source: 200W Cool White & Warm White 2 IN 1 COB Led

Quantity: 1pcs

Manufacturers Rated LED Life 50000 Hours

COLOURS:

linear color mixing with Macro

DIMMER:

0-100% linearly adjustable

STROBE:

Electronic Strobe 0 -25F.P.S

ZOOM ANGLE: 5 -60°

CONTROL:

DMX512, 3 pins interfaces RDM Control Protocol

6 Channels in standard mode Master/Salve Synchronous

Control Mode:

DMX512 / Master-Slave / Auto / Sound

HOUSING:

Cast aluminum, IP20 Indoor

WORK ENVIRONMENT TEMPERATURE: -10°C-40°C

PRODUCT DIMENSION:

Size: 280*185*380MM

WEIGHT:

Net weight : 7.50Kg

3. Set Up Led Par Light

Notice: Be sure to follow figures two and three when making your own cables. Do not use the

gd lg  he XLR cec. D  cec he cable hield cductor to the ground lug

 all he hield cdc  cme i cac ih he XLR e caig. Gdig he hield

could cause a short circuit and erratic behavior.

Figure 3

XLR Pin Configuration

Pin 1 = Ground

Pin 2 = Data Compliment(negative)

Pin 3 = Data True(positive)

3-Pin to 5-Pin Conversion Chart:

Note! If you use a controller with a 5 pin DMX output connector,you will need to use a 5 pin to 3

pin adapter. The chart below details a proper cable conversion:

3-Pin to 5-Pin Conversion

Conductor

3 Pin Female(Output)

5 Pin Male(Input)

Ground/Shield

Pin 1

Data(-) signal

Pin 2

Data(+) signal

Pin 3

Not Used

Do not use

Not Used

Do not use

Setting up a DMX Serial Data Link:

Master/Slave Fixture Linking:

1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin

connector of the first fixture.

2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin

connector to the input connector of the next fixture consisting of a (male) 3 pin connector.

Then, proceed to connect from the output as stated above to the input of the following fixture

and so on.

4. DMX Channels Summary Led Par Light

4.1 Operation method

1. keystrokes 2. Basic usage

【MENU】 The main menu select or return to the higher level

【UP】 Increasing menu choices or parameters

【DOWN】 Menu to select or parameters

【ENTER】Enter or select submenu

4.2 Dmx Channels

LED Display Screen Operation:

4.2 Dmx Channels

NO.

Display

Functions

A001

6 channels address setting,（001512）

B、C key to plus/minus

L255

White1 dimminer (000-255)

H255

White 2 dimmer（000-255）

P255

All dimmer (000-255)

F255

Invalid

T00

Temperature display

EP-0/1

Dmx signal switch, EP-1 signal on, EP-0 signal off

DP-0/1

DP-1 Blank Screen, DP-0 Lighting Screen

DISP

Display reverse choice

Channel

Function

No.

CH1

Dimmer

Dimmer, dark-bright

CH2

Warm White

Warm White dimming

CH3

Cool white

Cool White dimming

CH4

Color Temperature

0-15 no function

16-30 3000K

31-45 3200K

46-60 3400K

***************

225-240 5800K

240-255 6000K

Remark: Each 15 value, Color temperature

increases by 200K

CH5

Strobe

All light-strobe, slow-fast

CH6

Zoom

Liner zoom

MENU UP DOWN ENTER

Inhaltsverzeichnis

Andere Gamma+ Beleuchtungsausrüstung Handbücher

Gamma+

Gamma+ TX6 LED 300 Beam Bedienungsanleitung

Gamma+

Gamma+ Xenon Par Bedienungsanleitung

Gamma+

Gamma+ SPKLEKO600 Bedienungsanleitung

Gamma+

Gamma+ Penn Mini Bedienungsanleitung

Gamma+

Gamma+ Penn XL Bedienungsanleitung

Gamma+

Gamma+ Helix 7 Bedienungsanleitung

Gamma+

Gamma+ Cove LED 200 Bedienungsanleitung

Gamma+

Gamma+ LED Leko 200 Bedienungsanleitung

Gamma+

Gamma+ Borealis XL Z Bedienungsanleitung

Gamma+

Gamma+ Rayon Bedienungsanleitung

Gamma+

Gamma+ Luxe Bianco 600 Bedienungsanleitung

Gamma+

Gamma+ I-Pix Bedienungsanleitung

Gamma+

Gamma+ Luxe Rose XT 200Z VW Bedienungsanleitung

Gamma+

Gamma+ Silhouette Oculus XL Z Bedienungsanleitung

Gamma+

Gamma+ TX5 Spot Bedienungsanleitung

Gamma+

Gamma+ Torrent Wash IP Bedienungsanleitung

Gamma+

Gamma+ Torrent Spot IP Bedienungsanleitung

Gamma+

Gamma+ Borealis R Bedienungsanleitung

Gamma+

Gamma+ Ditto 8 IP Bedienungsanleitung

Gamma+

Gamma+ Oculus 40 Bedienungsanleitung

Gamma+

Gamma+ Rose LED Zoom Bedienungsanleitung

Gamma+

Gamma+ Luxe Toro 600 RGBW Bedienungsanleitung

Gamma+

Gamma+ Luxe Cannon 600 Z IP Bedienungsanleitung

Gamma+

Gamma+ Luxe Cove 200 VW Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung