Gamma+ Torrent Wash IP Bedienungsanleitung

Torrent Wash IP

480w IP65 LED Wash Light

GAMMA LED Vision – Torrent Wash IP

Page 1 of 16

User Manual

Table of Contents
1  Introduction and Setup 3
Unpacking and In the Box 3
Mounting and Operation 3
Features 3
Safety Precautions 4
Customer Support 5
2  Setup and Operation 6
Using the LCD Menu and Buttons 6
Menu Operation 7
DMX Setup 7
DMX Basics 7
DMX Wiring 8
DMX Modes and Configuration 9
3  Maintenance 11
Routine Maintenance 11
Troubleshooting Problems 11
A  The unit does not work: 11
B  Not Responding to the DMX Controller 11
4  Technical Specifications 12
5  Photometrics 14
GAMMA LED Vision – Torrent Wash IP
Page 2 of 16

1. Introduction and Setup

Unpacking and In the Box

Thank you for choosing or Torrent Wash IP. For your own safety, please read this manual

before installing or using the device. This manual covers the important information on

installation and applications. Please install and operate the fixture with following instructions.

eanwhile, please keep this manual for future needs.

In the box you will find:

•Torrent Wash IP Fixture 1

•D X 3 Pin to IP Plug Adapters 2

•Integrated Power and Signal Cables (1.4m)

•Integrated Swivel-Clamps 2

Mounting and peration

Clamp ounting: The Torrent Wash IP provides a unique mounting bracket assembly with

integrated clamps in the base of the fixture. The clamps fold flat for table-top operation.

As an added safety measure be sure to attach at least one properly rated safety cable to

the fixture using on of the handles.

Features

•12 x 40w RGBW LED’s

•5°~50° Motorized Zoom

•Pan: 540°, 16 Bit

•Tilt: 245°, 16 Bit

•Dimmer: 16 Bit

•Supports RDM addressing

•Variable-speed cooling fans

•3 pin XLR input and output cords

•13 3kg / 29lbs

GAMMA LED Vision – Torrent Wash IP

Page 3 of 16

Safety Precautions

Please keep this User Guide for future consultation If you sell the unit to another user, be

sure that they also receive this instruction manual

Always release pan and tilt locks before operating

Do NOT operate if the fixture is not capable of a full range of unrestricted motion.

ove any objects away from the unit, do not allow the moving head to hit any objects. Always

clear snow from the path of movement before powering on. Failure to do so may cause

damage outside of scope of the warranty.

Caution: For added protection mount the fixtures in areas outside walking paths, seating

areas, or in areas were the fixture might be reached by unauthorized personnel.

Before mounting the fixture to any surface, make sure that the installation area can hold a

minimum point load of 10 items the device’s weight.

Fixture installation must always be secured with a secondary safety attachment, such as an

appropriate safety cable.

Never stand directly below the device when mounting, removing, or servicing the fixture.

From a ceiling, or set on a flat level surface (see illustration below). Be sure this fixture is kept

at least 0.5m (1.5ft) away from any flammable materials (decoration etc.).

Always use and install the supplied safety cable as a safety measure to prevent accidental

damage and/or injury in the event the clamp fails.

DO NOT connect the device to any dimmer pack.

During initial start-up some smoke or smell may arise. This is a normal process and does not

necessarily mean that the device is defective, and it will decrease gradually within 15 minutes.

Don’t try to modify the fixture without any instruction by the manufacturer.

Warranty is voided if there are any malfunctions from not following the user manual while

operating or any hazardous operation, like shock, short circuit, electronic shock, etc.

Fixture must be 1’ from any flammable materials. Do not light any flammable objects closer

than 6.5 feet.

Do not allow other fixtures to shine a focused beam upon the display of this fixture.

GAMMA LED Vision – Torrent Wash IP

Page 4 of 16

Customer Support

WARRANTY POLICY

GAMMA LED Vision warrants its products for the periods set below from the date of

purchase to be free of manufacturer and workmanship defects Warranty does not cover

normal wear and tear caused by force, negligence or misuse of products GAMMA LED

Vision is not responsible for any damages or injury caused by misuse or improper

handling of the products and in accordance with instructions and specifications of manual

Always release all pan and tilt locks before operating and ensure fixture is able to

move through it’s full range of motion unrestricted.

Warranty terms are as follows:

LED Fixtures:

Indoor: 2 Years

Outdoor (IP 54 or higher): 1 Year

Lamp Fixtures: 1 year / excludes the lamp

LED Video Products:

Indoor: 2 Years

Outdoor (IP 54 or higher): 1 Year

Controllers: 2 years

Batteries: 6 months

All Trussing Related Products and Accessories: 1 Year

Please visit WWW GAMMALEDVISON COM for complete Limited Warranty terms and

contact information

GAMMA LED Vision – Torrent Wash IP

Page 5 of 16

2. Setup and peration

Using the LCD Menu and Buttons

Turn on the light, press the MENU button to enter the menu mode, use the UP and D WN

buttons to find the menu item, and ENTER to enter the menu.

When the preset menu is displayed on the display screen, press the ENTER button to

confirm, use the UP and D WN buttons to select the sub menu, press the ENTER button to

save the settings or automatically return to the previous menu.

Press the MENU button to return, or wait for one minute to exit the menu mode automatically.

GAMMA LED Vision – Torrent Wash IP

Page 6 of 16

Menu peration

MENU Address DMX Address Set DMX Address, 1-512

Work Mode DMX Mode Set the signal mode, the only option is

DMX mode for this fixture

CH Mode Set the DMX

Channel

Mode

14 CH – Default mode for xLights Model

Supplied

17 CH – 16 bit mode, good for use with

stage lighting consoles

Test Mode Sets the unit in TEST mode – allowing you to manually

scroll and set values for each parameter of the light

XY Setup Allows you to

invert and

modify the

pan and tilt

X Invert: Inverts the pan of the light

Y Invert: Inverts the tilt of the light

XY Speed: Can be used to slow down the

speed of the light Default is “High”

Signal Allows you to see a readout of the DMX values being

received

System Allows you to

change

system-wide

setttings

Backlight Time

Screen Direction

Language – English or Chinese – CHANGE

WITH CAUTION!

Reset Does a re-homing of the unit

DMX Setup

DMX Basics

DMX512 stands for digital multiplex 512 This means that 512 channels are controlled

digitally through 1 data cable

A channel is a set of 255 steps that are assigned to control attributes in each light This

may be a color like red, green or blue, and intensity, strobe, pan/tilt or other attributes

GAMMA LED Vision – Torrent Wash IP

Page 7 of 16

Multiple sets of 512 “universes” may be used Only 1 universe will travel on a DMX cable,

but through networked DMX (Art-Net or sACN E1 31), many universes can travel over a

network

DMX Wiring

DMX works by connecting 1 or multiple lights to the output of a DMX lighting console or

software with a DMX interface

DMX lights connect in what is called a “daisy-chain” Your first DMX cable will plug it’s

male DMX connector into the female DMX connector on your lighting console The

remaining female connector will then connect to the DMX input on your first light

You may then connect your next fixture to the output of your first light, and continue the

chain

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy

chain for signal strength Sometimes, depending on the fixtures and cable length, this

number is less (or more)

DMX Cables can be 3-pin or 5-pin These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used The cable should be a 2 conductor, shielded cable of at

least 110 ohms resistance Microphone cable is not DMX cable

Please refer to the diagram below:

For installations where the DMX cable has to run a long distance or is in an electrically

noisy environment, it is recommended to use a DMX terminator This helps in preventing

corruption of the digital control signal by electrical noise and reflections The DMX

terminator is simply an XLR plug with a 120 Ω resistor connected between pins 2 and 3,

which is then plugged into the output XLR socket of the last fixture in the chain Please

see illustrations below:

GAMMA LED Vision – Torrent Wash IP

Page 8 of 16

DMX Modes and Configuration

The Torrent Wash IP has multiple DMX modes, sometimes called “personalities”, “profiles”,

or as we will use here “modes”

In general, modes with more DMX channels offer a greater level of control or options but

take up more of your output channels on your lighting console or software

Modes with less DMX channels often offer less control, but may be plenty for your needs

Depending on your needs and control solution, you may not need channels for

automated programs, strobes, or macros – your console may have great effects! In this

case, you can use a lesser channel mode and fit more lights per DMX universe

View the DMX mode charts below to find the mode that best suits your needs

MX Channel Mode Sheet:

On the left side of the sheet you will see the different modes and which channel

corresponds to each function listed on the right in the given mode.

16CH Mode 1 20CH Mode 2 Function Channel Value escription

1 1 Dimmer 0-255 Intensity, Low to High

2 2 Strobe 0-5 Open

6-64 Variable Speed Strobe,

Slow to Fast

65-195 Open

196-249 Random Strobe, Slow to

Fast

250-255 Open

3 3 Red 0-255 Red

4 4 Green 0-255 Green

GAMMA LED Vision – Torrent Wash IP

Page 9 of 16

5 5 Blue 0-255 Blue

6 6 White 0-255 White

7 Macro 0-10 No Function

11-41 Macro 1

42-72 Macro 2

73-103 Macro 3

104-134 Macro 4

135-165 Macro 5

166-196 Macro 6

197-227 Macro 7

228-255 Macro 8

8 Macro

Speed

0-255 Macro Speed, Slow to Fast

9 Zoom 0-255 5 to 50° Zoom

10 Reserved – Reserved

11 Pan 0-255

12 Pan Fine

13 Tilt

14 Tilt Fine

15 Pan Tilt

Speed

0-255 Pan Tilt Speed, Fast to

Slow

16 Control 0-231 No Function

232-255 Reset ALL (Hold Value for

Greater than 3s)

GAMMA LED Vision – Torrent Wash IP

Page 10 of 16

Inhaltsverzeichnis

Andere Gamma+ Beleuchtungsausrüstung Handbücher

Gamma+

Gamma+ Luxe Bianco 600 Bedienungsanleitung

Gamma+

Gamma+ Penn XL Bedienungsanleitung

Gamma+

Gamma+ Leko Toro Bedienungsanleitung

Gamma+

Gamma+ Rose XT LED 200 Zoom Montageanleitung

Gamma+

Gamma+ TX6 LED 300 Beam Bedienungsanleitung

Gamma+

Gamma+ Torrent Spot IP Bedienungsanleitung

Gamma+

Gamma+ Rose LED Zoom Bedienungsanleitung

Gamma+

Gamma+ Xenon Par Bedienungsanleitung

Gamma+

Gamma+ Rayon Bedienungsanleitung

Gamma+

Gamma+ Oculus 40 Bedienungsanleitung

Gamma+

Gamma+ Starburst 7x18w Bedienungsanleitung

Gamma+

Gamma+ Silhouette Oculus XL Z Bedienungsanleitung

Gamma+

Gamma+ Luxe Rose XT 200Z VW Bedienungsanleitung

Gamma+

Gamma+ SPKLEKO600 Bedienungsanleitung

Gamma+

Gamma+ Helix 7 Bedienungsanleitung

Gamma+

Gamma+ Ditto 8 IP Bedienungsanleitung

Gamma+

Gamma+ Borealis XL Z Bedienungsanleitung

Gamma+

Gamma+ Luxe Toro 600 RGBW Bedienungsanleitung

Gamma+

Gamma+ Luxe Cannon 600 Z IP Bedienungsanleitung

Gamma+

Gamma+ Luxe Cove 200 VW Bedienungsanleitung

Gamma+

Gamma+ TX5 Spot Bedienungsanleitung

Gamma+

Gamma+ LED Leko 200 Bedienungsanleitung

Gamma+

Gamma+ I-Pix Bedienungsanleitung

Gamma+

Gamma+ Cove LED 200 Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung

Silvair

Silvair MESH-CEDRP Bedienungsanleitung

S&P

S&P PCRL80 Bedienungsanleitung