GeoVision GV-IPCamera Series Bedienungsanleitung

Quick Start Guide

GV-IPCamera

Before attempting to connect or operate this product,

please read these instructions carefully and save this manual for future use.

Vandal Proof IP Dome

Target Vandal Proof IP Dome

ICH265-A

Under the copyright laws, this manual may not be copied, in whole or in

part, without the written consent of GeoVision.

Every effort has been made to ensure that the information in this manual is

accurate. GeoVision, Inc. makes no expressed or implied warranty of any

kind and assumes no responsibility for errors or omissions. No liability is

assumed for incidental or consequential damages arising from the use of

the information or products contained herein. Features and specifications

are subject to change without notice. Note: no memory card slot or local

storage function for Argentina.

GeoVision, Inc.

9F, No. 246, Sec. 1, Neihu Rd.,

Neihu District, Taipei, Taiwan

Tel: +886-2-8797-8377

Fax: +886-2-8797-8335

0Uhttp://www.geovision.com.tw

Trademarks used in this manual: GeoVision, the GeoVision logo and GV

series products are trademarks of GeoVision, Inc. Windows is the

registered trademark of Microsoft Corporation.

November 2019

Contents

Caution.............................................................................. iv

Safety Notice .................................................................... iv

Options .............................................................................. v

Creating GV-IP Camera’s Login Credentials................. vi

Note for Adjusting Focus and Zoom............................. vii

Note for Installing Camera Outdoor............................. viii

Note for Silica Gel Bags ....................................................x

Note for TV-out Function...................................................x

Note for Avoiding IR Reflection.......................................xi

Chapter 1 GV-VD4711 / 5711............................................1

1.1 Packing List ..............................................................................2

1.2 Overview ..................................................................................5

1.3 Installation ................................................................................7

1.3.1 Installation of Weatherproof Shield.............................17

1.4 Connecting the Camera..........................................................18

1.4.1 Power Connection......................................................18

1.4.2 I/O Device Connections .............................................18

1.4.3 Voltage Load Expansion (Optional)............................19

1.5 Loading Factory Default..........................................................20

1.5.1 Using the Web Interface.............................................20

1.5.2 Directly on the Camera ..............................................21

Chapter 2 GV-VD2702 / 2712 / 4702 / 4712....................22

2.1 Packing List ............................................................................24

2.2 Overview ................................................................................26

2.3 Installation ..............................................................................29

2.4 Connecting the Camera..........................................................39

2.5 I/O Connector .........................................................................40

2.5.1 Voltage Load Expansion (Optional)............................40

2.6 Loading Factory Default..........................................................41

2.6.1 Using the Web Interface.............................................41

2.6.2 Directly on the Camera ..............................................41

Chapter 3 GV-EVD2100 / 3100 / 5100 ............................42

3.1 Packing List ............................................................................43

3.2 Overview ................................................................................45

3.3 Installation ..............................................................................47

3.4 Connecting the Camera..........................................................57

3.5 Loading Factory Default..........................................................58

3.5.1 Using the Web Interface.............................................58

3.5.2 Directly on the Camera ..............................................58

iii

Chapter 4 Accessing the Camera..................................59

4.1 System Requirement ..............................................................59

4.2 Accessing the Live View .........................................................59

4.2.1 Checking the Dynamic IP Address .............................60

4.2.2 Configuring the IP Address ........................................61

4.3 Adjusting Image Clarity...........................................................63

4.3.1 Using Focus Adjustment Cap.....................................65

Chapter 5 The Web Interface .........................................66

Chapter 6 Upgrading System Firmware .......................69

Caution

Risk of explosion if battery is replaced by an incorrect type.

Dispose of used batteries according to the instructions.

Safety Notice

The GV-IPCAM uses a Lithium battery as the power supply for its internal

real-time clock (RTC). The battery should not be replaced unless required!

If the battery does need replacing, please observe the following:

Danger of Explosion if battery is incorrectly replaced

Replace only with the same or equivalent battery, as recommended by

the manufacturer

Dispose of used batteries according to the manufacturer's instructions

Options

Optional devices can expand your camera’s capabilities and versatility.

Contact your dealer for more information.

Device Description

Power Adapter

The power adapter is available for all Vandal Proof

IP Dome. Contact our sales representatives for the

countries and areas supported.

GV-PA191 PoE

Adapter

The GV-PA191 PoE adapter is designed to provide

power and network connection to the cameras over

a single Ethernet cable.

GV-POE Switch

The GV-POE Switch is designed to provide power

along with network connection for IP devices. The

GV-POE Switch is available in various models with

different numbers and types of ports.

GV-Mount

Accessories

The GV-Mount Accessories provide a

comprehensive lineup of accessories for installation

on ceiling, wall corner and pole. For details, see GV-

Mount Accessories Installation Guide.

GV-Relay V2

The GV-Relay V2 is designed to expand the voltage

load of GV IP devices. It provides 4 relay outputs,

and each can be set as normally open (NO) or

normally closed (NC) independently as per your

requirement.

Metal PG21

Conduit

Connector

The metal PG21 conduit connector is used for

running the wires of GV-VD4711 / 5711, GV-VD2702

/ 2712 / 4702 / 4712, and GV-EVD2100 / 3100 /

5100 through a 3/4” conduit pipe.

Weatherproof

Shield

The weatherproof shield is made for GV-VD4711 /

5711 to protect the camera from rain and snow.

Creating GV-IP Camera’s Login

Credentials

The default Administrator and Guest accounts are no longer supported by

GV-IPCam H.265 series firmware V1.14 or later. When purchasing a new

camera or after resetting it, you need to set up a login username and

password for the camera.

1. Download and install GV-IP Device Utility from our website.

2. On the GV-IP Device Utility window, click to search for your GV-

IP camera.

3. Double-click your GV-IP camera in the GV-IP Device Utility list. This

dialog box appears.

4. Click the Change Username and Password tab to type a new

username and password. Note that the new password must meet

the password strength requirements.

5. Optionally click Upgrade all devices to use the same username

and password on all other devices.

vii

Note for Adjusting Focus and

Zoom

When adjusting the Focus and Zoom Screws, do not over tighten the

Focus and Zoom screws. The screws only need to be as tight as your

finger can do it. It is not necessary to use any tools to get them tighter.

Doing so can damage the structure of lens.

The maximum torque value for all the zoom and focus screws is 0.049 N.m

viii

Note for Installing Camera

Outdoor

When installing the camera outdoor, be sure that:

1. The camera is set up above the junction box to prevent water from

entering the camera along the cables.

2. Any PoE, power, audio and I/O cables are waterproofed using

waterproof silicon rubber or the like.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere GeoVision Sicherheitskamera Handbücher

GeoVision

GeoVision GV-VD8700 Bedienungsanleitung

GeoVision

GeoVision GV-IP SERIES Bedienungsanleitung

GeoVision

GeoVision GV Series Bedienungsanleitung

GeoVision

GeoVision GV-EBD4700 Bedienungsanleitung

GeoVision

GeoVision GV-OPAL S1 Bedienungsanleitung

GeoVision

GeoVision GV-LPR2800-DL Bedienungsanleitung

GeoVision

GeoVision GV-ADR Series Bedienungsanleitung

GeoVision

GeoVision PPTZV10-QG-A Bedienungsanleitung

GeoVision

GeoVision GV-GEBF4911 Bedienungsanleitung

GeoVision

GeoVision FETIV212-A Bedienungsanleitung

GeoVision

GeoVision GV-SD220 Series Bedienungsanleitung

GeoVision

GeoVision GV-SD2322-IR Bedienungsanleitung

GeoVision

GeoVision GV-GEBF4911 Bedienungsanleitung

GeoVision

GeoVision GV-IRCAM 10M EIA DC12V Bedienungsanleitung

GeoVision

GeoVision GV-BL8714 Bedienungsanleitung

GeoVision

GeoVision GV-TFD Series Bedienungsanleitung

GeoVision

GeoVision GV-BX130D-0 Bedienungsanleitung

GeoVision

GeoVision GV-BX110D Bedienungsanleitung

GeoVision

GeoVision GV-MFD320 Bedienungsanleitung

GeoVision

GeoVision GV-BX110D Bedienungsanleitung

GeoVision

GeoVision GV-SD2322-IR Bedienungsanleitung

GeoVision

GeoVision GV-EFER3700 Series Bedienungsanleitung

GeoVision

GeoVision GV-QFER12700 Bedienungsanleitung

GeoVision

GeoVision GV-VR360 Bedienungsanleitung

Beliebte Sicherheitskamera Handbücher anderer Marken

Okina USA

Okina USA SIR36-870VF650LP Bedienungsanleitung

Divio

Divio NDR155PA Bedienungsanleitung

Canon

Canon VB-C500D Bedienungsanleitung

Easy Access

Easy Access EasyGuard Bedienungsanleitung

Vivotek

Vivotek FD9389-EHV-v2 Bedienungsanleitung

TUYA

TUYA COSMO W2 Bedienungsanleitung

Eusso

Eusso UNC7500-IR Einrichtungshandbuch

urmet domus

urmet domus 1096/204 Bedienungsanleitung

VC VC20 series Bedienungsanleitung

Axis

Axis Q1614 Bedienungsanleitung

ieGeek

ieGeek DD201 Bedienungsanleitung

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Bedienungsanleitung

Vicon

Vicon V662-D-1 Betriebsanleitung

Grundig

Grundig GCH-K0274P Bedienungsanleitung

Lorex

Lorex VANTAGE LBC7032 Bedienungsanleitung

4xem

4xem WPT Bedienungsanleitung

Samsung

Samsung SCV-3082 Bedienungsanleitung

Vitek

Vitek VTC-C544 Bedienungsanleitung