GFA ELEKTROMAT SE 6.65-25,40 DU ER Bedienungsanleitung

Installation Instructions

ELEKTROMAT

SE 6.65-25,40 DU ER

Model: 10003346 10011

-en-

Status: 26.03.2021

GfA ELEKTROMATEN GmbH & Co. KG

Wiesenstraße 81

D-40549 Düsseldorf

www.gfa-elektromaten.de

[email protected]

Table of contents

1General safety information .............................................................................................. 4

Safe operation ......................................................................................................................... 4

2Technical Data ................................................................................................................ 6

3Mechanical installation .................................................................................................... 7

4Electrical installation ..................................................................................................... 11

5Limit switch adjustment ................................................................................................. 12

6Motor connection .......................................................................................................... 13

7Limit switch connection ................................................................................................. 13

8Emergency manual operation (release) ......................................................................... 14

9Completing commissioning / inspection ......................................................................... 16

10Declaration of incorporation / Declaration of conformity ................................................. 17



Symbols

Warning - Potential injury or danger to life!

Warning - Danger to life from electric current!

Note - Important information!

▶ Requirement - Required action!

Schematic representations are based on product examples. Deviations from delivered

products are possible.

1General safety information

Specified use

The drive unit is only intended for vertically moving sectional doors with full counter-

balancing.

The drive unit must be protected against moisture and aggressive environmental

conditions (such as corrosive substances). The drive units are only suitable for indoor use.

Appropriate protective measures must be taken for outdoor installation. The drive unit is

not intended for hazardous areas. The values specified in the technical data of the drive

unit must not be exceeded. The safe operation can only be ensured if used as specified.

Target audience of these installation instructions

These installation instructions are geared towards qualified persons trained in the handling

of door systems. Expert knowledge, relevant skills and practical experience are what set

apart qualified persons. They are capable of safely carrying out the tasks involving

installation, maintenance and modernisation according to the instructions.

Safe operation

The safe operation of the product can only be ensured if it is used as specified. Follow the

installation instructions. Observe all specifications, especially warnings, when installing the

product in the overall system. GfA is not liable for damage resulting from non-observance

of the installation instructions. The resulting overall system must be reassessed for its

safety in accordance with applicable standards and directives (e.g. CE marking). These

installation instructions refer only to a part of the overall system and are not sufficient as

the sole instructions for the overall system. The installer of the system must prepare the

instructions for the overall system.

We recommend entering the danger area of the system only when the drive unit is at a

standstill.

Warning - Failure to follow these installation instructions may result in severe injury or death.

Please read these instructions before using the product.

Keep these instructions handy.

Include these instructions when passing on the product to third parties.

Warning - Danger from improper use of the product!

Do not let children operate the product unsupervised or use as a toy.

Warning - Danger to life from incorrect installation!

Work carried out improperly may result in death or severe injury from electrical

current or falling parts.

Allow only competent people to carry out the work.

Disconnect all cables from the power supply.

Observe valid regulations and standards.

Use suitable tools.

2Technical Data

Type SG 50E

Output torque 60 Nm

Output speed 65 rpm

Output shaft / hollow shaft 25,40 mm

Maximum output speed open / close

for frequency inverter operation 65 / 30 rpm

Maximum holding torque 450 Nm

Maximum door weight 3000 N

Supply voltage 3N~ 400 V

Operating current 0,80 A

Operating frequency 50 Hz

Power factor cos φ 0,85

Maximum movement per hour 20 h-1

Class of protection IP 65

Limit switch range

(maximum revolutions of output shaft / hollow shaft) 20

Temperature range -10 / +40 (+60) °C

1) When using a temperature range of +40°...+60°C use half of maximum movements per hour.

3Mechanical installation

Prerequisites

The permissible loads on walls, fastenings, mountings and transmission elements must not

be exceeded, even for maximum holding torques or locking torques (▶ refer to technical

data).

Connection elements:

▶ Self-locking connection

elements with a minimum

strength of 800 N/mm2

(8.8) must be used.

▶ Utilize the hole diameter

to the full.

▶ Use adequately

dimensioned washers for

elongated holes.

BAGAB00002_Z002 BAGAB00003_ Z002

3 : 1

Permissible mounting positions

BAGAC01002_Z003

Mounting

Eight threads are provided for mounting.

▶ Use at least 2 of these (①).

Keys are used to connect to the door shaft.

▶ Use a key that is at least as long as the hollow shaft (②).

8 x (M8x16)

BAGAD01001_Z002

Installation

The descriptions below apply to general door specifications. The specifications of the door

manufacturer must also be observed during installation.

Warning - Potential injury or danger to life!

During installation, be sure to use a lifting device that has a sufficient load-

carrying capacity.

▶ Thoroughly grease the door shaft.

BAGAE01001_Z003

▶ Mount the keys. Observe possible variants

Ⓐ or Ⓑ.

BAGAE01002_Z003

▶ Attach the drive unit.

BAGAE01003_Z003

▶ Tighten all connection elements (M8) to 25

Nm. Install all other connection elements

according to the specifications of the door

manufacturer.

BAGAE01006_Z002

25 Nm

▶ Secure the keys (version Ⓑ only).

BAGAE01007_Z002

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere GFA Toröffner Handbücher

GFA

GFA ELEKTROMAT SI 25.20 FU-30,00 Bedienungsanleitung

GFA

GFA 10003624 10002 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 5.24 WS-25,40 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 6.80 FU-25,40 ER Bedienungsanleitung

GFA

GFA 10003805 00012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 10.100 FU-25,40 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 9.15-25,40 ER Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 6.80 FU-25,40 Bedienungsanleitung

GFA

GFA 10003371 00010 Bedienungsanleitung

GFA

GFA 10003871 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 14.80 FU-25,40 ER Bedienungsanleitung

GFA

GFA 10003600 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SE 14.80 FU-25,40 Bedienungsanleitung

GFA

GFA 10003981 10011 Bedienungsanleitung

GFA

GFA ELEKTROMAT KE 9.60 FU-25,00 Bedienungsanleitung

GFA

GFA ELEKTROMAT FT 80.5 FU-45,00 Bedienungsanleitung

GFA

GFA 10002374 10010 Bedienungsanleitung

GFA

GFA 10003831 10012 Bedienungsanleitung

GFA

GFA 10004055 10004 Bedienungsanleitung

GFA

GFA 10002245 10006 Bedienungsanleitung

GFA

GFA 10003917 10012 Bedienungsanleitung

GFA

GFA 10003738 10012 Bedienungsanleitung

GFA

GFA ELEKTROMAT SI 75.10-55,00 Bedienungsanleitung

GFA

GFA SG 50 Bedienungsanleitung

Beliebte Toröffner Handbücher anderer Marken

CAME

CAME FROG-PM4 Bedienungsanleitung

SOMFY

SOMFY FX230 Bedienungsanleitung

Aprimatic

Aprimatic ONDA 500 Bedienungsanleitung

Turnstiles

Turnstiles FSW 900 Bedienungsanleitung

Erreka

Erreka BUL BL33 Betriebsanleitung

Erreka

Erreka VULCAN S Bedienungsanleitung

Beninca

Beninca R1-2 WBV Bedienungsanleitung

Erreka

Erreka VULCAN D Bedienungsanleitung

Motorline professional

Motorline professional FORT Bedienungsanleitung

Beninca

Beninca BOB5024 Bedienungsanleitung

AGA

AGA GATEMASTER 900 HD Bedienungsanleitung

Cardin

Cardin BL Series Bedienungsanleitung

Westfalia

Westfalia 85 27 06 Bedienungsanleitung

CAME

CAME F500 Bedienungsanleitung

Extel

Extel VERA Bedienungsanleitung

Comunello Automation

Comunello Automation ABACUS 220 Bedienungsanleitung

CAME

CAME FA40230CB Bedienungsanleitung

Mighty Mule

Mighty Mule 200 E-Z GATE OPENER UL325 SERIES Bedienungsanleitung