Gigabyte GN-WIAG Bedienungsanleitung

GN-WIAG

IEEE 802.11b/g Wireless LAN Mini-PCI Card

User’s Manual

http://www.gigabyte.com.tw

Rev. 1.0 First Edition

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

- Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance,any changes or modifications not

expressly approved by the party responsible for compliance could void the user's authority

to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. End users must follow the specific operating instructions for satisfying RF

exposure compliance.

This transmitter must not be co-located or operating in conjunction with any other antenna

or transmitter.

Contents

CHAPTER 1. PRODUCT OVERVIEW 1

1-1. INTRODUCTION...........................................................................................................1

1-2. FEATURES .................................................................................................................1

1-3. PHYSICAL DIMENSIONS/PACKAGING.............................................................................1

1-4. LED INDICATING LIGHT...............................................................................................1

1-5. SYSTEM REQUIREMENTS ...........................................................錯誤!尚未定義書籤。

CHAPTER 2. INSTALLING THE WLAN CARD 2

2-1. INSTALLING THE DRIVER &UTILITY (APPLICABLE TO ANY SUPPORTED OS)......................2

CHAPTER 3. USING THE UTILITY 4

3-1. LINK STATUS..............................................................................................................4

3-2. SITE SURVEY.............................................................................................................6

3-3. CONFIGURATION ........................................................................................................7

3-4. STATISTICS..............................................................................................................13

3-5. DRIVER INFO............................................................................................................14

CHAPTER 4. SPECIFICATION 15

Chapter 1. Product Overview

1-1. Introduction

This 802.11b/g Wireless Local Area Network (WLAN) card is composed of the MAC,

Baseband, and radio components, Mini-PCI interface, and two built-in antennas. It

operates in 2.4GHz frequency bands, providing fast (up to 108Mbps) and secure (support

AES, 802.1x & WEP and WAP) connections to 802.11b and 802.11g networks from a

single card.

1-2. Features

Conforms to 802.11b/802.11g specification.

Transmits data rate up to the maximum speed of 108Mbps.

Dynamically scales the data rate.

Automatic power management to reduce battery consumption.

Built-in diversity antenna.

Seamless roaming between 802.11b and 802.11g networks.

Supports AES (Advance Encryption System), enterprise-class 802.1x security and

multiple levels of WEP encryption (64-bit /128-bit/152-bit), and WPA (Wi-Fi

Protected Access)..

Driver supports Windows 98SE/Me/2000/XP.

1-3. Physical Dimensions/Packaging

Dimensions: 59mm* 44mm* 4mm

Before the installation procedures, please ensure the components are not damaged during

the shipping. The shipment of the GN-WIAG includes:

One GN-WIAG Wireless LAN Card

One Installation CD (including User’s Guide and Driver)

One User Guide

Please contact your local distributor or authorized reseller immediately for any missing or

damaged components. If you require returning the damaged product, you must pack it in

the original packing material or the warranty will be voided.

1-4. System Requirements

1-4-1. Supported Platform:

IBM PC/AT compatible computer

1-4-2. Supported Operation System:

Windows 98SE/Me/2000/XP

Chapter 2. Installing the WLAN Card

2-1. Installing The Driver & Utility (Applicable to any supported OS)

Step 1: Please make sure that you don’t plug your card yet.

Step 2: Insert our setup CD into your CDROM drive, the following window will pop up.

Step 3: Click “Install Wireless LAN Driver”.

Step 4: Please remove the WLAN Card from your PCMCIA adapter and Click “OK”.

Step 5: Click “Finish”.

Step 6: Please plug-in your “Gigabyte” WLAN card device ! and will install the device

driver Click “OK”.

Step 7: Click “Yes”, and then your installation is ok..

Chapter 3. Using The Utility

The Configuration & Monitor Utility is a powerful application that helps you to configure the

card and monitor the statistics of the communication link. Unlike the standard method of

configuring the card via the operating system utilities (e.g. Control Panel), this application

permits the dynamic modification of the configuration parameters while the card is

operating. It also offers some more configuration options. It appears as an icon on the

Windows system tray whenever the card is running (see Figure 3-1). The icon can tell you

the received signal strength by four small green lights. You can open it by double-clicking

on this icon.

Figure 3-1. The icon of the Configuration & Monitor Utility

You can hide or show Tray-board by clicking mouse right key on this icon(see Figure 3-2).

Figure 3-2. The icon of the Function Utility

3-1. Link Status

The “Link Status” tab shows you the current association information about the card’s

connection with a wireless network. In the middle of the screen, you can see transmit and

received signal strength for this card(see Figure 3-3).

Figure 3-3. Current link status of the wireless LAN card

If you want to turn off the card’s radio, click the radio icon at the bottom of the screen, Fig

3-4 shows the result Click “Yes” (see Figure 3-5). Just click it again to turn on the radio.

Click “Yes” (see Figure 3-6).In order to exit, click the “X” button at the bottom of the

screen.

Figure 3-4. Turn off the card’s radio

Figure 3-5 Disabled WLAN Card.

Figure 3-6 Enabled WLAN Card.

Other items reports the following information:

Association State: The field shows you if WLAN card is communicating with an access

point or peer-to peer group.

MAC Address: This card’s physical address.

Channel [Freq]: The current channel and center frequency used by the WLAN card.

Security: The current security setting.

IP Address: WLAN Card IP Address.

Profile: various wireless settings for different environments.

SSID: Wireless network name.

BSSID: Basic service set identification.

Type: The current network type.

Country: Language.

3-2. Site Survey

The “Site Survey” tab shows you the list of reachable access points and/or peer-to-peer

stations. In Fig 3-7, the card three 802.11b and one 802.11g wireless devices.

Figure 3-7. Reachable access points and/or peer-to-peer stations

Other items reports the following information:

SSID: Wireless network name.

BSSID: Basic service set identification.

(Security):(Encrypt data) or not

Signal Strength: It shows the received signal strength from the detected wireless device.

Channel: The current channel number used by the WLAN card.

Wireless Mode: 2.4GHz11Mbps(802.11b) or 2.4GHz54Mbps (802.11g) network.

Refresh: Rescan the available network and then refresh the result.

3-3. Configuration

The “Configuration” Tab contains several fields where operating parameters of the driver

can be viewed or changed. Just click “APPLY” button, changes to any of the parameters

in this panel can be applied to the driver without the need to reset the WLAN card. If you

want to restore the default value, click “Default” button. (see Figure 3-8)

3-3-1. Basic setting:

Profile Name: You can save various wireless settings for different environments.

Network Mode: This field allows you to select the mode from a list of supported network

Inhaltsverzeichnis

Andere Gigabyte PCI-Karte Handbücher

Gigabyte

Gigabyte GN-WP01GT Bedienungsanleitung

Gigabyte

Gigabyte GN-WPEAG Bedienungsanleitung

Gigabyte

Gigabyte GN-WPKG Bedienungsanleitung

Gigabyte

Gigabyte GN-WP01GS Bedienungsanleitung

Gigabyte

Gigabyte GN-WI02GM Bedienungsanleitung

Gigabyte

Gigabyte G1.ASSASSIN2 Bedienungsanleitung

Gigabyte

Gigabyte GC-WB1733D-I Bedienungsanleitung

Gigabyte

Gigabyte GC-WB11ACD-I Bedienungsanleitung

Gigabyte

Gigabyte GN-FE605 Bedienungsanleitung

Gigabyte

Gigabyte GT-PS700 Bedienungsanleitung

Gigabyte

Gigabyte GN-FE605(M) Bedienungsanleitung

Gigabyte

Gigabyte GN-WP01GS Bedienungsanleitung

Beliebte PCI-Karte Handbücher anderer Marken

ERMA

ERMA SSI 1417 Bedienungsanleitung

SIIG

SIIG CyberSerial Dual PCI Montageanleitung

Moxa Technologies

Moxa Technologies CP-102E Bedienungsanleitung

I-Bus

I-Bus IBC2602 Bedienungsanleitung

Exsys

Exsys EX-60102 Bedienungsanleitung

Chelsio Communications

Chelsio Communications T5 Series Bedienungsanleitung

Conrad Electronic

Conrad Electronic 97 46 71 Bedienungsanleitung

Micro Innovations

Micro Innovations USB650A Bedienungsanleitung

KTI Networks

KTI Networks KF-310 Bedienungsanleitung

Asus

Asus SpaceLink WL230 Bedienungsanleitung

SIIG

SIIG SC2475 Bedienungsanleitung

TRENDnet

TRENDnet TEW-703PI Bedienungsanleitung

Belkin

Belkin F5D7000F Bedienungsanleitung

Pericom

Pericom PI7C7100 Bedienungsanleitung

ADLINK Technology

ADLINK Technology cPCI-3548 Bedienungsanleitung

Digium

Digium TE200 Series Bedienungsanleitung

Allo.com

Allo.com 2nd Gen E1/T1/J1 Bedienungsanleitung

Western Digital

Western Digital FireWire PCI Adapter Bedienungsanleitung