Grundig GSTB1701USB Bedienungsanleitung
Th
e Gold Technical Support Line:1902 215 259
Personal Product Support
(Charges will apply at $2.95 per minute)
GSTB1701USB
DIGITAL
TERRESTRIAL
RECEIVER
Thank you for buying this Grundig product, which is designed to give you many years of
trouble-free service.
You may already be familiar with using a similar unit, but please take time to read these
instructions. They are designed to familiarize you with the unit's many features and to ensure
you get the very best from your purchase.
Your safety and the safety of others is important. Please therefore, ensure you read the "Safety
Instructions" you operate this unit.
In the unlikely event that your product fails to work normally, please call the below Grundig
warranty number for support.
Safety is important
before
Warranty
Australia
Grundig Warranty: 1800 509 394
New Zealand
Grundig Warranty: 0800 450 259
INTRODUCTION
21
1
SAFETY INSTRUCTIONS
·Always read the safety instructions carefully
Keep this User's Manual for future reference
Keep this equipment away from humidity
Lay this equipment on a reliable flat surface before setting it up.
Do not stand it on soft furnishings.
If any of the following situation arises, get the equipment checked by a service technician:
- The equipment has been exposed to moisture.
- The equipment has been dropped and damaged.
- The equipment has obvious sign of breakage.
- The equipment has not been working well or you cannot get it work according to User's
Manual.
To prevent the risk of electric shock, do not open the cover or the back of the receiver and
Do not block the ventilation holes of the device. Leave appropriate gap above and around
it to allow for adequate ventilation.
Do not place the device in an unventilated cabinet or on top of a unit which emits heat.
No part of this publication may be reproduced in any form by any means without the
prior written permission. Other trademarks or brand names mentioned herein are trademarks
or registered trademarks of their respective companies.
Information in this document is subject to change without notice. The manufacturer does not
make any representations or warranties (implied or otherwise) regarding the accuracy and
completeness of this document and shall in no event be liable for any loss of profit or any
commercial damage, including but not limited to special, incidental, consequential, or other
damage.
·
·
·
·
·
·
·
·
Warning
Copyright Statement
Disclaimer
expose this apparatus to rain or colds.
2
2
1. INTRODUCTION........................................................................1
2. SAFETY INSTRUCTION.............................................................2
3. ABOUT THE SET TOP BOX.........................................................4
4. FRONT & REAR PANEL ILLUSTRATION......................................5
5. REMOTE CONTROL.................................................................. 6
6. SYSTEM CONNECTION.............................................................8
7. GETTING STARTED...................................................................9
8. OPERATION.............................................................................10
9. CHANNEL LIST.........................................................................12
10. SYSTEM SET-UP......................................................................13
11. FAVOURITE LIST......................................................................15
12. TROUBLE SHOOTING..............................................................16
13. SPECIFICATIONS....................................................................17
14. WARRANTY.............................................................................18
CONTENTS
3
3
This DVB-T TV Receiver is a Free-To-Air digital terrestrial receiver, allowing you
to access free-to-air digital terrestrial TV channels and radio broadcasts on your
TV set. Its digital reception covers VHF & UHF band. Compared with the analog TV
programs, digital TV programs eliminate the noise and interference but offer high
quality video and audio. An on-screen initial installation guide is provided so that
you can easily start to enjoy watching the programs. In addition, a fully featured
remote control is included that offers you access to every feature with a simple
press of a button.
- Full comply with Australia DVB-T standard
- Full MPEG2 ISO/IEC 13818 transport stream compliant audio/video decoding
- Bandwidth of 7MHz supported
- COFDM demodulator
- Automatic/manual channel search
- Channel lock, moving and deletion
- Parental lock control
- EPG (Electronic Program Guide) and teletext function (where available)
- USB port for upgrade software and playback of MP3 and JPG files
- Tuner RF in/loop through
CVBS/
al
Before installation, please check the items of the package. The package should
contain the following items:
1. DVB-T receiver x 1 pcs
2. Remote control x 1 pcs
3. AAA size battery for the remote control x 1 pair
4. Instruction manual x 1 pcs
5. AV cable(red/yellow/white) x 1 pcs
Main Features
Package Contents
- Component/ S-Video/Digital Audio via coaxial
- Full function remote control
ABOUT THE SET TOP BOX
21
4
AC 220-240V
~50/60Hz
USB
Front panel
Remote sensor Standby button
Channel up
Channel down
Power indicator
FRONT & REAR PANEL ILLUSTRATION
21
5
Rear panel
USB slot
(For
playback of
MP3 and JPG files)
update the software
and
Coaxial Digital Audio
RFin
for an external TV aerial
Loop though
for an external device
RF
AC Mains
S-Video
Composite Video
Down Mix Audio
2 Channel L/R
Component Video
(Y Cb Cr)
MENU
OK
DTV/ VCR
EXIT
CH+
CH
-
VOL
-
VOL
+
VOL
+
PAUSE FAVORITE
LANG INFO
RECALL
MUTE
TV/RADIO AUDIO
EPG
X
TTX SUBTITLE
MENU
OK
EXIT
CH+
CH
-
VOL
-
VOL
+
VOL
+
PAUSE FAVORITE
AUDIO INFO
RECALL
MUTE
TV/RADIO USB
EPG
X
TTX SUBTITLE
Power On/Standby
(Switch the STB ON/STANDBY mode)
Numeric entry
(Enter numeric values and to select the
channel directly by entering it's number)
Menu
(Open up menu)
Red Button
(To assist the operation of teletext function)
Cursor/ Enter
( to select sub-menu from the
main menu and channel +/-,
to select menu and sub-menu
from the menu and volume +/-,
Press to enter.)
Yellow Button
(To assist the operation of teletext function)
Mute
RECALL
(switch to previous channel)
EPG
(Open up Electronic Program Guide
menu)
TTX
(Open Teletext function)
EXIT
(Exit from menu)
Green Button
(To assist the operation of teletext function)
Blue Button
(To assist the operation of teletext function)
FAVOURITE
(Open up Favourite list)
PAUSE(To freeze the picture )
INFO
(To view the current channel information)
AUDIO
(Select audio mode: Left / Right /Stereo / Mono)
USB
(Select the USB device)
TV/RADIO
(Switch between TV and Radio)
SUBTITLE
(Switch On/Off Subtitle)
8
9
11
10
12
13
15
14
1
2
3
4
5
6
7
1
2
3
4
7
5
6
11
12
13
14
15
10
8
9
16
17
18
19
20
16
17
18
19
20
REMOTE CONTROL
6
REMOTE CONTROL
Remove the battery cover from the remote control and put two AAA size batteries
inside the compartment.
The diagram inside the battery compartment shows the correct way to install the
batteries.
1. To use the remote control, point it towards the front of the digital set top box.
2. The remote control has a range of up to 7 metres from the set top box at an angle of
up to 60 degrees.
3. The remote control will not operate if its path is blocked.
Using the Remote Control
Caution:
1. Keep batteries out of children's reach.
2. Don't attempt to recharge, short-circuit, disassemble, heat or throw the batteries
into the fire.
3. Always replace both batteries at the same time. Never mix new and old batteries or
batteries of a different type.
4. If you don't intend to use the remote control for an extended period, remove the
batteries to prevent possible leakage and corrosion.
5. Do not drop, apply shock or step on the remote control.
6. Do not spill water on the remote control.
Installing the batteries
NOTE
If the receiver does not operate when operating the remote control from a
close range, you need to replace the batteries.
NOTE
Sunlight or very bright light will decrease the sensitivity of the remote
control.
21
7
AC220-240V
~50/60Hz
AC220-240V
~50/60Hz
AC220-240V
~50/60Hz
There are many different types of TV/VCR and other equipment that you can connect to the STB.In this
manual you will see some of the most ways to connect your equipment.common
General
SYSTEM CONNECTION
Connecting to the video recorder
Connecting to a Hi-Fi system
Coaxial cable
Hi-Fi amplifier
Connecting to the TV with AV/Y Cb Cr
/ S-Video cable
Antenna
RF cable
Red
Yellow
White
Red
Green
Blue
Red
White
Yellow Green
Blue
Red
Antenna
RF cable
Red
Yellow
White
Red
Green
Blue
Red
White
Yellow Green
Blue
Red
VideoCassette Recorder
VCR
S-Video cable
Y Cb Cr cable
AV cable
Y Cb Cr cable
AV cable
8
5
8
Switching on
Turn on your TV set and select the corresponding AV input,then set the video system of your TV to PAL.
Connect the Set Top Box to mains power supply AC 220-240V 50/60Hz, the power indicator on the
front of the unit will turn red(Standby mode).Press the POWER button on unit or remote control to turn
on the unit,then the indicator will turn to green.
GETTING STARTED
Press the "MENU" button and enter the pin code to access the
setup menu of the STB (the default pin code is 888888).
Press the "LEFT" or "RIGHT" cursor button to highlight .
Press the "OK" Button to enter the sub-menu.
Highlight the "Scan Mode" and press the "LEFT" or "RIGHT" cursor
button to select "Auto scan".
Press the "UP" or "DOWN" cursor button to highlight the "Start Scan"
and then press the "OK" button to confirm.
Press the "EXIT"button to quit.
1
2
3
4
5
6
Automatic channel scan
Manual channel scan
Press the "MENU" button and enter the pin code to access
the setup menu of the STB.(The default pin code is 888888)
Press the "LEFT" or "RIGHT" cursor button to highlight .
Press the "OK" Button to enter the sub-menu.
Highlight the "Scan Mode" and press the "LEFT" or "RIGHT" cursor
button to select "Manual scan".
Press the "DOWN" cursor button to highlight "Channel Number."
option and input the desired channel number.
Press the "UP" or "DOWN" cursor button to highlight the "Start Scan" and then
press the "OK" button to confirm.
Press the EXIT"button to quit.
1
2
3
4
5
6
7
NOTE
Settings Scan
Favorites
Channels
Scan Mode
Channel Number
Start Scan
Auto Scan
Scan
Settings Scan
Favorites
Channels
Scan Mode
Channel Number
Start Scan
Manual Scan <>
21
MENU
EXIT
MENU
EXIT
Scan
All the settings in the setup menu are fixed. To change anything the correct password will be
required.
When the search is finished, the first channel of the channel list and the information banner is
displayed. You can now watch digital terrestrial televison.
9
Inhaltsverzeichnis
Andere Grundig Empfänger Handbücher
Grundig
Grundig DTR 2544 Bedienungsanleitung
Grundig
Grundig DSR 1750 MICRO Bedienungsanleitung
Grundig
Grundig SAT STC 1200 Bedienungsanleitung
Grundig
Grundig DSR 3735 CI Bedienungsanleitung
Grundig
Grundig DTR 2000 S Bedienungsanleitung
Grundig
Grundig STR 100 DX microSAT Bedienungsanleitung
Grundig
Grundig STR 7100 Bedienungsanleitung
Grundig
Grundig STR 622 TWIN Bedienungsanleitung
Grundig
Grundig STR 6100 Bedienungsanleitung
Grundig
Grundig DSR 1773 CY Bedienungsanleitung
Grundig
Grundig STR 631 Bedienungsanleitung
Grundig
Grundig Yacht Boy P 2000 Bedienungsanleitung
Grundig
Grundig DCR 1784 CO Bedienungsanleitung
Grundig
Grundig STR 1300 Bedienungsanleitung
Grundig
Grundig DTR 1520 Bedienungsanleitung
Grundig
Grundig Satellit 500 Bedienungsanleitung
Grundig
Grundig SER 251 Bedienungsanleitung
Grundig
Grundig DRS 100 CL Bedienungsanleitung
Grundig
Grundig RR 740 CD Bedienungsanleitung
Grundig
Grundig YACHT BOY 400 Bedienungsanleitung
