Hoover Dial-A-Matic 1120 Bedienungsanleitung

Instructions for

YOUR NEW HOOVER

DIAL-A-MA’I’IC CLEANER

Model 1120

HANDLE

GRIP

OPENING FOR

HANGING

CLEANER IN

STORAGE AREA

ON/OFF SWITCH

COVER LATCH

NOZZLE

HOSE

(CARRYING HANDLE

:ATOR

TO ATTACH HANDLE TO CLEANER

Remove tape and screw from h an d 1 e s o c ke t. Set screw aside for

later use.

2. Connect electric plug from bottom of handle to electric plug projecting

from handle socket. Make sure plug assembly is positioned as shown

in illustration.

3. Push handle into place in handle socket. The excess wire and electric

plugs are guided into handle tube.

4. Line up holes in handle and handle socket. Insert screw and tighten

with screwdriver.

HANDLE

ADJUSTMENTS

The handle on your clean-

er has three positions

storage, operating, and

low (for reaching under

low furniture). The handle

can be lowered by step-

ping on pedal at the left

rear of cleaner. The

handle should always be

in storage position when

cleaning tools are used.

THIS IS THE “HEART” OF YOUR

THE D/AL-A-MAT/C GIVES THE BEST AND MOST

EFFlClENT

SET THE DIAL FOR

CARPET AND RUG

CLEANING

Your new HOOVER DIAL-A

MATIC

is the most powerful up-

right cleaner ever built. Proper

suction control for your floor

coverings is most important for

cleaning effectiveness and ease

of operation.

FIRST, set the dial between

“MEDIUM” and “LOW”. This

will be the correct setting for

the majority of rug thicknesses.

For deep pile carpets, shag

rugs, cotton rugs, or lightweight

throw rugs, move the lever to-

ward “LOW’

if the cleaner does

not push easily.

For low pile, sculptured, or

multi-level rugs,

-it

may be

necessary to move the lever to-

ward “HIGH’

When you have the proper se

on the dial, your Hoover

push easily and clean

oughly.

‘tting

will

thor-

JEW

.HOOVER

DIAL-A-MATIC CLEANER

USE OF A VACUUM CLEANER THAT HAS EVER BEEN DEVISED.

SET THE DIAL FOR

CLEANING TOOLS

The handle of the cleaner

showld be in storage position

(see Page

when cleaning

tools are used. When the

handle is in this position, the

nozzle is raised and the

agitator does not come in

contact with the rug.

Attach hose and cleaning

tools (Page

6).

Set lever on

Suction Control Dial to

“HIGH” under “TOOL

SUCTION” for most cleaning.

For cleaning draperies and

delicate fabrics, move lever

toward “LOW”

The lever can be placed at

“HIGH”,

‘

’

MEDIUM’

‘

LOW”

or any space between these

markings

THE CLEANING T

MODEL 1121

(See Page 4 for setting Suction Control Dial when using tools.)

The cleaning tools have many uses. Some are listed below:

TUFFLEX HOSE Double vinyl reinforced with nylon mesh for

long, trouble-free life. The light flexible hose has a vinyl

tab,

so it can be hung on the cleaner or on a hook in a closet.

TELESCOPING WAND When you

require extra length for cleaning

bare floors or hard-to-reach places,

attach the telescoping extension

wand.

To lengthen the wand, push in on the

plastic latch and extend wand until

it locks in place. To shorten, use

oppos

ite

procedure.

3. FLOOR BRUSH For Hard Surface Floors and Carpeted Stairs.

UPHOLSTERY NOZZLE For Upholstered Furniture, Draperies,

Tapestries, Mattresses

Clothing, Automobile Interiors, Stairs.

DUSTING BRUSH For Carved Furniture, Table Tops, Books,

Lamps

Light Fixtures) Venetian Blinds, Registers, Baseboards

CREVICE TOOL For Upholstered Furniture, Edges of

Wall-to-

Wall Carpeting, Radiators, Dresser Drawers

TO CONNECT HOSE TO CLEANER

Insert hose connector in opening below dial. Turn hose connector

in either direction until it locks in place.

TO CONNECT TOOLS

To connect the cleaning tools to either the telescoping wand or

hose, press down on the plastic latch and fit the attachment into

place making sure the button on the attachment is locked in

place. To release,

press

down on plastic spring latch and remove.

TO STORE TOOLS

The vinyl tool kit has been designed

so the tools can be packed inside

and the hose attached, by strap, on

outside. The kit has two slots

located near the top for ease in

hanging on the cover latch of the

cleaner or on a hook in the closet.

While moving furniture, hose can be

conveniently hung on handle.

TO CLEAN TOOLS

To clean the hose, wipe off dirt with

a cloth, dampened with a liquid

detergent. Use a damp cloth to re-

move the detergent. Cleaning tools

can be washed in warm water with a

detergent. Rinse

and

let

dry

before

using.

Use the

comfortable handle grip for carrying your

Hoover cleaner, or move it from room to

room by tipping it back on wheels and

pushing it.

ICK UP TAC

sharp objects should not be picked up

by the cleaner. They may damage the

hose and the throw-away bag.

TAKE CARE OF COR It should

be wound loosely on cover latch and

lever on Suction Control Dial to avoid

unnecessary strain. The clip-on plug

snaps directly onto the cord. Don’t run

your cleaner over the cord

it may

damage the insulation.

THE BAG INDICATOR

Thebag

indicator, “CHECK BAG”, located on

the front of the cleaner, makes it

convenient for you to know when the

disposable bag should be changed.

The indicator will disappear when the

motor is turned on and the Dial-A-Matic

is used for cleaning carpets. If the

“CHECK BAG” indicator appears when

the cleaner is being used on carpets9

the cleaner is not operating satis-

factorily. You should:

1. Replace bag. (See Page 9.

)

some cases the bag may not be

filled. to capacity; but, due to varia-

tion in size and type of dirt par-

ticles, the bag has ceased to filter

satisfactorily.

2. Check secondary filter. (See Page

8.)

3. Check nozzle hose. (See Page 8.)

Note: The “CHECK BAG” indicator may be visible when cleaning

tools are used. This does not necessarily mean that the cleaner is

not operating satisfactorily. This can be checked by turning the

dial to CARPET SUCTION position and checking the indicat-or.

If it disappears, the bag does not need to be replaced.

THE THROW-AWAY BAG

To assure that

.your

Hoover cleaner

operates at peak performance it is

imperative that you use only gen-

uine Hoover Throw-Away Filter

Bags made by The Hoover

Company. Genuine Hoover Bags

can be identified by the

Hoover Medallion These

bags are made from a

special rnaterial which

is scientifically formulated to

filter out dust while allowing air

to flow through freely.

THE SECONDARY FILTER

The secondary filter protects the

motor from dirt. Before installing a

new bag, check the filter. Dirt

spilled in the bag housing will

accumulate on the filter and may

restrict motor performance. To clean

filter, remove wire holder and lift

out filter. Tap against a hard sur-

face, or rinse thoroughly with

warm water and dry. Replace in bag

housing and secure with holder.

THE NOZZLE HOSE

The nozzle hose on the cleaner

carries the dirt from the nozzle to

the throw-away bag. If the hose

becomes obstructed, remove it and

clear it. Pull the hose end from the

bottom of the bag housing and

unscrew the hose end by turning in

a clockwise direction. Turn clean-

er over, remove the bottom plate

(see Page

IO)

and pull hose from

cleaner. Clean hose and reinsert

it in the cleaner.

WHERE TO BUY BAGS

Throw-away bags may be

purchased at your local

Authorized Hoover Dealer

(listed in Yellow Pages of

Telephone Directory under

‘

‘Vacuum Cleaners’

’

Hoover) or from Hoover

Factory Branch Service

Stations listed on service

page of this book.

When ordering throw-away

be sure to mention

the model

your cleaner.

TO REPLACE THROW-

AWAY BAGS

Tip cleaner over, resting handle

on the floor. Open bag cover of

cleaner by turning latch in either

direction. Lift bag cover. Hold

throw-away bag by cardboard cover,

twist outward, and remove. Discard

used bag.

To attach new throw-away bag,

hold bag with cardboard collar

down and with arrows pointing

toward front of cleaner. Push hole

in cardboard firmly over tube,

twisting until bag is secure. Be

sure that throw-away bag is not

extending outside of cover and

that cover is in proper position

on the gasket before latching.

The belt of your Hoover cleaner

controls the speed of the agitator

and is important for the efficient

operation of your cleaner. Because

of this, when buying a new belt,

you should always insist on a gen-

uine Hoover belt. Some other belts

on the market, not manufactured

under Hoover design and quality controls, do not operate the agitator

correctly and create undue stress which will damage your Hoover

cleaner.

WHEN TO REPLACE

Remove bottom plate from cleaner (see Fig.

and check from time

to time to be sure the belt is in good condition. If it is stretched or

cut, it should be replaced.

Inhaltsverzeichnis

Andere Hoover Staubsauger Handbücher

Hoover

Hoover WindTunnel U5471-900 Bedienungsanleitung

Hoover

Hoover FM144GFJ Bedienungsanleitung

Hoover

Hoover POWER SCRUB Bedienungsanleitung

Hoover

Hoover F7458950 Bedienungsanleitung

Hoover

Hoover FloorMate, SpinScrub Floor Mate Spin Scrub Hard Floor... Bedienungsanleitung

Hoover

Hoover PUREPOWER Bedienungsanleitung

Hoover

Hoover S3520 Bedienungsanleitung

Hoover

Hoover CleanSlate FH14020V Bedienungsanleitung

Hoover

Hoover Guardsman C1631 Benutzerhandbuch

Hoover

Hoover Portapower S1029-075 Bedienungsanleitung

Hoover

Hoover TSBE2010 011 Bedienungsanleitung

Hoover

Hoover MAXLIFE TOTAL HOME PET Bedienungsanleitung

Hoover

Hoover UH40080 Bedienungsanleitung

Hoover

Hoover FH40160 Bedienungsanleitung

Hoover

Hoover HURRICANE Bedienungsanleitung

Hoover

Hoover ONEPWR Blade Max Bedienungsanleitung

Hoover

Hoover U8181900 Bedienungsanleitung

Hoover

Hoover SPIRIT Bedienungsanleitung

Hoover

Hoover Convertible U4039 Bedienungsanleitung

Hoover

Hoover UH70055 - Turbo Cyclonic Upright Bedienungsanleitung

Hoover

Hoover SPRINT BAGLESS TSU2001 Bedienungsanleitung

Hoover

Hoover Cordless Hand Vac LiNX Bedienungsanleitung

Hoover

Hoover FloorMate SpinScrub 800 Bedienungsanleitung

Hoover

Hoover Power 11 series Bedienungsanleitung

Beliebte Staubsauger Handbücher anderer Marken

Bissell

Bissell LittleGreen Proheat 1425 Series Bedienungsanleitung

Panasonic

Panasonic MC-YL637S147-AE Bedienungsanleitung

LG A9 Series Bedienungsanleitung

Oreck

Oreck Cordless Captura BK51700 Series Bedienungsanleitung

Kogan

Kogan KAVACROBVWA Bedienungsanleitung

Kränzle

Kränzle VENTOS 50 ID Benutzerhandbuch

NEFF

NEFF N17XH10 0 Series Bedienungsanleitung

EVVO

EVVO Ai35 Bedienungsanleitung

DeWalt

DeWalt DWH200D Bedienungsanleitung

Pontec

Pontec Pondomatic Vacuum Cleaner Bedienungsanleitung

Cleanmaxx

Cleanmaxx PC-P007E Bedienungsanleitung

RIDGID

RIDGID WD1685AU0 Bedienungsanleitung

Ezviz

Ezviz RE4P Bedienungsanleitung

STG global

STG global TANVAC HDV3000 Bedienungsanleitung

Shark

Shark ROTATOR PRO COMPLETE NV550 Series Bedienungsanleitung

Factory

Factory M3340 Bedienungsanleitung

Shop-Vac

Shop-Vac VN92 SERIES Bedienungsanleitung

Nobles

Nobles 608669 Produkthandbuch