HP Kayak XA-s Series 02 Bedienungsanleitung

HP Kayak XA-s 02xx PC Workstation -

Installing Accessories In Your

HP Minitower PC Workstation

Explains in detail how to install accessories, such as extra memory,

accessory boards, and additional disk drives.

M02inst.fm Page 1 Thursday, February 18, 1999 3:48 PM

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC

Workstation

Supported HP Accessories

2English

Supported HP Accessories

Contact your dealer for an up-to-date list of supported accessories.

Up to six accessory boards

can be installed:

- One AGP slot (graphics)

- Three 32-bit PCI slots (one used by SCSI/LAN board)

- One combination PCI or ISA slot

- One 16-bit ISA slot

Front Access Drives, for example:

- 3.5-inch 1.44 MB flexible disk drive

(one third height)

- 5.25-inch DDS tape drive (half height)

Internal Mass

Storage Devices

Pack of five pairs of rails for

Front Access Devices:

- 3.5-inch disk drives (D3566A)

- 5.25-inch disk drives (D2880A)

Main Memory Upgrades

DIMM slots for 100 MHz SDRAM:

- 32 MB Non-ECC (D6501A)

- 64 MB Non-ECC (D6502A)

- 128 MB Non-ECC (D6503A)

- 32 MB ECC (D6521A)

- 64 MB ECC (D6522A)

- 128 MB ECC (D6523A)

- 256 MB ECC (D6524A)

M02inst.fm Page 2 Thursday, February 18, 1999 3:48 PM

English 3

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation

Removing and Replacing the Cover

WARNING For your safety, never remove the PC Workstation’s cover without first

removing the power cord from the power outlet, and any connection to

a telecommunications network. Always replace the cover on the

PC Workstation before switching it on again.

Removing the Cover

1Switch off the display and computer.

2Disconnect all power cables and any telecommunications cables.

3If necessary, unlock the cover using the key on the back panel, and

remove any floppy diskettes from the floppy drive.

4Push the two latches on the sides of the computer upwards.

5Grasp the cover on both sides of the computer, and carefully slide it

forwards and off the computer.

Step 4

Step 5

M02inst.fm Page 3 Thursday, February 18, 1999 3:48 PM

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC

Workstation

Removing and Replacing the Cover

4English

Replacing the Cover

1Ensure that you have installed all your accessories and that all

internal cables are properly connected and safely routed.

2Ensure that the two latches on the front sides of the cover are lifted

up, and that the lock is unlocked.

3Slide the cover onto the computer, making sure that the two guides

at the bottom of the case slide into the two rails at the base of the

computer. Firmly slide the cover backwards into position.

4Lower the latches on the front sides of the cover. If required, lock

the cover using the key provided.

5Reconnect all the power cables.

Press here on both sides

of the PC’s cover.

M02inst.fm Page 4 Thursday, February 18, 1999 3:48 PM

English 5

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation

Removing and Replacing the Cover

Intrusion Monitor Your PC Workstation is equipped with an intrusion monitor, which is

located on the front of the PC Workstation, behind the Hardware

Control Panel. It is designed to detect whether your PC Workstation

has been opened since the last time it was used:

•If your PC Workstation has been opened, it is assumed that the

system configuration has changed and a full start-up check is carried

out.

•If your PC Workstation has not been opened, it is assumed that the

system configuration has not changed and a reduced start-up check

is carried out.

M02inst.fm Page 5 Thursday, February 18, 1999 3:48 PM

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC

Workstation

Moving the Power Supply

6English

Moving the Power Supply

1Disconnect the computer’s power cord and any telecommunications

cable.

2Remove the computer’s cover (see page 3).

3Remove the fan connection to the system board.

4Press the retaining buttons on each side of the HP UltraFlow airflow

guide and lift it out of the PC Workstation’s case.

5Unscrew the four self-retaining screws at the back of the power

supply.

HP UltraFlow

Airflow Guide

Retaining

button

Fan connection to

system board

Unscrew the

self-retaining screws

M02inst.fm Page 6 Thursday, February 18, 1999 3:48 PM

English 7

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation

Moving the Power Supply

WARNING To avoid electrical shock, do not open the power supply.

6Slide the power supply out of the computer until it stops—the

power supply unit remains connected to the computer.

Replacing the Power

Supply after Installing

Accessories

1Check that all internal cables are safely routed.

2Slide the power supply back into the computer.

3Tighten the four self-retaining screws.

4Replace the HP UltraFlow airflow guide.

5Reconnect the fan to the system board.

Slide the power

supply unit clear of

the computer

Power Supply

M02inst.fm Page 7 Thursday, February 18, 1999 3:48 PM

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC

Workstation

Installing Memory

8English

Installing Memory

Main Memory Modules

If you need more main memory to run your application software, you

can install up to 768 MB of memory in three DIMM slots.

Main memory upgrades are available in single 32 MB, 64 MB, 128 MB

and 256 MB Non-ECC SDRAM or 64 MB, 128 MB and 256 MB ECC

SDRAM memory modules. You should note that only 100 MHz memory

modules should be used to upgrade your PC Workstation.

CAUTION Static electricity can damage electronic components. Turn off all

equipment. Do not let your clothes touch the accessory.

To equalize the static electricity, rest the accessory bag on top of the

power supply while you are removing the accessory from the bag.

Handle the accessory as little as possible and with care.

To install a main memory module:

1Disconnect the computer’s power cord and any LAN or

telecommunications cable.

2Remove the computer’s cover (see page 3).

3Remove the fan connection to the system board.

NOTE Refer to the illustration on page 8 for steps 3 and 4.

4Press the retaining buttons on each side of the HP UltraFlow airflow

guide and lift it out of the PC Workstation’s case.

5Remove the transparent airflow guide covering the processor

sockets (if needed).

6Remove the floppy disk drive data cable from the system board.

7The location of the memory module slots is shown here.

M02inst.fm Page 8 Thursday, February 18, 1999 3:48 PM

English 9

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation

Installing Memory

8Slide the memory module into the slot at 90° to the system board

(with the cutouts furthest away from the processor).

9Firmly press the memory module completely into the connector

until the retaining clips click into position.

10 Repeat this procedure for each additional memory module you want

to install.

11 Install any other accessories if necessary, then replace all units and

reconnect all cables and power cords. Replace the cover (refer

to page 3).

12 Check the HP Summary Screen to verify the new configuration.

Video Adapter

Accessories Available

from Other Sources

Additional accessories, including a video MPEG module, are available

for your video adapter. However, these accessories cannot be ordered

from HP. Contact your dealer for more details about these accessories.

Slide the memory module into the slot at 90o

to the system board

Push the module until the retaining clips click

into position

Memory module

cutouts

M02inst.fm Page 9 Thursday, February 18, 1999 3:48 PM

HP Kayak XA-s 02xx PC Workstation - Installing Accessories In Your HP Minitower PC

Workstation

Installing Mass Storage Devices

10 English

Installing Mass Storage Devices

The computer has two internal shelves (for hard disk drives) and five

front-access drive shelves (for front-access drives and hard disk

drives).

Your computer is supplied with one 3.5-inch flexible disk drive and a

CD-ROM drive. If your computer is supplied with a hard disk, the hard

disk will be installed in the second internal shelf

Two internal shelves

for 3.5-inch disks

Two shelves for 3.5-inch

drives

Three shelves for 5.25-inch

drives

M02inst.fm Page 10 Thursday, February 18, 1999 3:48 PM

Andere Handbücher für Kayak XA-s Series 02

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere HP Zubehör Handbücher

HP MCS Bedienungsanleitung

HP TPA-M002P Bedienungsanleitung

HP Model 744 - VME Workstation Referenzhandbuch

HP L1520 - 15 Inch LCD Monitor Bedienungsanleitung

HP CC487-91209 Montage- und Wartungsanleitung

HP 8081A Service-Handbuch

HP 245161-B22 - 10642 42U Rack Shock Pallet Bedienungsanleitung

HP Support Anywhere Bedienungsanleitung

HP MPP 1.51 Bedienungsanleitung

HP 8NN78AA ABB Bedienungsanleitung

HP 11792A Bedienungsanleitung

HP Scanjet 5370C Series Bedienungsanleitung

HP 245161-B22 - 10642 42U Rack Shock Pallet Bedienungsanleitung

HP L1520 - 15 Inch LCD Monitor Bedienungsanleitung

HP 8691B Service-Handbuch

HP AJ765A - StorageWorks RDX Removable Disk Backup... Bedienungsanleitung

HP C8000 - Workstation - 0 MB RAM Bedienungsanleitung

HP 245161-B22 - 10642 42U Rack Shock Pallet Bedienungsanleitung

HP AA979A - StorageWorks SAN Switch 2/8V Bedienungsanleitung

HP E1399A Bedienungsanleitung

HP Model 744 - VME Workstation Referenzhandbuch

HP 245161-B22 - 10642 42U Rack Shock Pallet Bedienungsanleitung

HP 8517B Gebrauchsanweisung

Beliebte Zubehör Handbücher anderer Marken

Hillco

Hillco 2810 Bedienungsanleitung

Siemens

Siemens QSA2700D Bedienerhandbuch

Contours

Contours ZY024 Bedienungsanleitung

Saivod

Saivod VS621 Bedienungsanleitung

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS Bedienungsanleitung

Z-Wave

Z-Wave HSD-200Z Bedienungsanleitung

turck

turck FMX-IM-2UPLI63FX Bedienungsanleitung

Decagon Devices

Decagon Devices 10HS Bedienungsanleitung

UPPAbaby

UPPAbaby Cup Holder Bedienungsanleitung

Elko

Elko SmartSensor Leakage Wireless Bedienungsanleitung

Grizzly

Grizzly H8371 Bedienungsanleitung

Panasonic

Panasonic HG-T Series Bedienungsanleitung

IFM Electronic

IFM Electronic Efector 250 Series Referenzhandbuch

Virtuox

Virtuox VirtuCLEAN 2.0 Bedienungsanleitung

DigiDesign

DigiDesign 888/24 I/O Bedienungsanleitung

PROZIS

PROZIS QUAY Bedienungsanleitung

patagonia

patagonia PSI Vest Bedienungsanleitung

SFC Energy

SFC Energy EFOY GO! Bedienungsanleitung