Intel NUC10i7FNKN Bedienungsanleitung

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Intel® NUC Kit NUC10i7FNKN

Intel® NUC Kit NUC10i5FNKN

Intel® NUC Kit NUC10i3FNKN

User

Guide

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Before You Begin

CAUTIONS

The steps in this guide assume you’re familiar with computer terminology and with the safety

practices and regulatory compliance required for using and modifying computer equipment.

Disconnect the computer from its power source and from any network before performing any of the steps

described in this guide.

Failure to disconnect power, telecommunications links, or networks before you open the computer or

perform any procedures can result in personal injury or equipment damage. Some circuitry on the board

can continue to operate even though the front panel power button is off.

Follow these guidelines before you begin:

 Always follow the steps in each procedure in the correct order.

 Create a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

 Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station isn’t available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

 Sharp pins on connectors

 Sharp pins on circuit boards

 Rough edges and sharp corners on the chassis

 Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

 Damage to wires that could cause a short circuit

Observe all warnings and cautions that instruct you to refer computer servicing to qualified

technical personnel.

Observe Safety and Regulatory Requirements

If you don’t follow these instructions, you increase your safety risk and the possibility of noncompliance

with regional laws and regulations.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

This guide tells you how to:

•

Install and remove memory

•

Install an M.2 SSD

•

Install a VESA mount bracket

•

Connect power

•

Install an operating system

•

Install the latest drivers

Open the Chassis

Unscrew the four corner screws on the bottom of the chassis and lift the cover.

Installing and Removing Memory

Intel NUC Kits NUC10i7FNKN, NUC10i5FNKN and NUC10i3FNKN have two 260-pin DDR4 SO-DIMM

sockets. Memory requirements:

 1.2V low voltage memory

 2666 MHz SO-DIMMs

 Non-ECC

Find compatible memory modules in the Intel Product Compatibility Tool

 NUC10i7FNKN

 NUC10i5FNKN

 NUC10i3FNKN

NOTE If you plan to install only one memory module, install it in the lower memory

socket.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Install SO-DIMMs

If you plan to install just one SO-DIMM, install it in the lower memory socket.

To install the SO-DIMMs, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and disconnect

the AC power cord.

3. Align the small notch at the bottom edge of the SO-DIMM with the key in the socket.

4. Insert the bottom edge of the SO-DIMM into the socket.

5. When the SO-DIMM is inserted, push down on the outer edge of the SO-DIMM until the

retaining clips snap into place. Make sure the clips are firmly in place.

Removing SO-DIMMs

To remove a SO-DIMM, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer.

3. Remove the AC power cord from the computer.

4. Remove the computer’s cover.

5. Gently spread the retaining clips at each end of the SO-DIMM socket. The SO-DIMM pops out of

the socket.

6. Hold the SO-DIMM by the edges, lift it away from the socket, and store it in an anti-static

package.

7. Reinstall and reconnect any parts you removed or disconnected to reach the SO-DIMM sockets.

8. Replace the computer’s cover and reconnect the AC power cord.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Install an M.2 SSD

Intel NUC Kits NUC10i7FNKN, NUC10i5FNKN and NUC10i3FNKN support 80mm and 42mm SSDs.

Find compatible M.2 SSDs at the Intel® Product Compatibility Tool:

 NUC10i7FNKN

 NUC10i5FNKN

 NUC10i3FNKN

NOTE Before changing the Intel Optane memory module, it needs to be disabled. Follow Removing

Intel Optane Memory on this page first, before taking the module out.

If you’re installing an 80mm M.2 SSD:

1. Remove the small silver screw from the 80mm (A) and 42mm (B) metal standoff on the

motherboard.

2. Align the small notch at the bottom edge of the M.2 card with the key in the connector.

3. Insert the bottom edge of the M.2 card into the connector (C).

4. Secure the card to the standoff with the small silver screw (D).

If you’re installing a 42mm M.2 SSD:

1. Remove the small silver screw from the metal standoff on the motherboard (A).

2. Align the small notch at the bottom edge of the M.2 card with the key in the connector.

3. Insert the bottom edge of the M.2 card into the connector (B).

4. Secure the card to the standoff with the small silver screw (C).

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Close the Chassis

After all components have been installed, close the Intel NUC chassis. Intel recommends this be done by

hand with a screwdriver to avoid over-tightening and possibly damaging the screws.

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Connect Power

Country-specific power cords are included in the Intel NUC Kit box.

Connect AC power

Each Intel NUC model includes either a region-specific AC power cord or no AC power cord (only the power

adapter).

Product codes

Power cord type

The

connector on the power adapter is a C5 type connector.

BXNUC10i7FNKN1,

BXNUC10i5FNKN1,

BXNUC10i3FNKN1,

US power cord included.

BXNUC10i7FNKN2,

BXNUC10i5FNKN2,

BXNUC10i3FNKN2

EU power cord included.

Install an Operating System

Refer to Supported Operating Systems for a list of Intel-validated Windows* operating systems and

versions of Linux that have been reported as compatible by Intel NUC owners.

Refer to Operating System Installation for system requirements and installation steps.

User Guide for NUC10i7FNKN, NUC10i5FNKN, NUC10i3FNKN

Install Intel NUC Drivers

To download the latest Microsoft* Windows* drivers and BIOS updates, go to Download Center:

Links:

 NUC10i7FNKN

 NUC10i5FNKN

 NUC10i3FNKN



Drivers are available for the following features:

 Chipset

 Graphics

 Intel® Management Engine

 Wireless and/or Gigabit Ethernet (depending on how you connect)

 Bluetooth®—required if you use Bluetooth devices

 Thunderbolt

 Consumer Infrared (CIR)—required if you use an infrared remote control

 Card Reader—required if you use an SD card for extra storage

 Intel® Rapid Storage Technology—required if you plan to configure RAID

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Intel Desktop Handbücher

Intel

Intel Compute Card Dock Bedienungsanleitung

Intel

Intel Compute Stick STCK1A8LFC Bedienungsanleitung

Intel

Intel NUC 11 Performance Bedienungsanleitung

Intel

Intel NUC 12 Pro Kit NUC12WSHi3 Bedienungsanleitung

Intel

Intel NUC8i5BEH Bedienungsanleitung

Intel

Intel CareFusion DMS-SA1300-A1E Bedienungsanleitung

Intel

Intel NUC6i7KYK Bedienungsanleitung

Intel

Intel NUC 11 Performance Bedienungsanleitung

Intel

Intel NUC 8 Mainstream-G NUC8i7INH Bedienungsanleitung

Intel

Intel NUC Kit DE3815TYKHE Bedienungsanleitung

Intel

Intel SR1530AH - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel SR4850HW4 - Server Platform - 0 MB RAM Bedienungsanleitung

Intel

Intel NUC 13 Pro Desk Edition Bedienungsanleitung

Intel

Intel SR2520SAXSR - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel NUC 8 Pro NUC8v7PN Bedienungsanleitung

Intel

Intel NUC6i3SYK Bedienungsanleitung

Intel

Intel SC5650SCWS Bedienungsanleitung

Intel

Intel NUC 7 ENTHUSIAST Bedienungsanleitung

Intel

Intel NUC7CJYSAL Bedienungsanleitung

Intel

Intel NUC Series Bedienungsanleitung

Intel

Intel NUC8i3BEK Bedienungsanleitung

Intel

Intel Classmate PC Bedienungsanleitung

Intel

Intel NUC 13 Pro Mini PC NUC13ANKi7 Bedienungsanleitung

Intel

Intel NUC 7 HOME Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Lenovo

Lenovo ThinkCentre Edge 72 Handbuch

Lenovo

Lenovo ThinkStation D20 Handbuch

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung