Intel NUC7i3BNHXF Bedienungsanleitung

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Intel® NUC7 Home, a Mini PC with Windows® 10 –NUC7i3BNHXF

Intel® NUC7 Home, a Mini PC with Windows® 10 –NUC7i5BNHXF

Intel® NUC7 Enthusiast, a Mini PC with Windows® 10 –NUC7i7BNHXG

User Guide

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Before You Begin

CAUTIONS

The procedures in this guide assume familiarity with the general terminology associated with

personal computers and with the safety practices and regulatory compliance required for using

and modifying electronic equipment.

Always disconnect the computer from its power source and from any network before performing any

of the procedures described in this guide.

Failure to disconnect power or networks before you open the computer or perform any procedures can

result in personal injury and/or equipment damage. Some circuitry on the board can continue to

operate even though the front panel power button is off.

Follow these guidelines before you begin:

Always follow the steps in each procedure in the correct order.

Create a log to record information about your computer, such as model, serial numbers,

installed options, and configuration information.

Electrostatic discharge (ESD) can damage components. Perform the procedures described in

this chapter only at an ESD workstation using an antistatic wrist strap and a conductive foam

pad. If such a station is not available, you can provide some ESD protection by wearing an

antistatic wrist strap and attaching it to a metal part of the computer chassis.

Installation Precautions

When you install and test the Intel NUC, observe all warnings and cautions in the installation

instructions.

To avoid injury, be careful of:

Sharp pins on connectors

Sharp pins on circuit boards

Rough edges and sharp corners on the chassis

Hot components (such as SSDs, processors, voltage regulators, and heat sinks)

Damage to wires that could cause a short circuit

Observe Safety and Regulatory Requirements

If you do not follow these instructions, you increase your safety risk and the possibility of

noncompliance with regional laws and regulations.

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

This guide tells you how to:

•

Upgrade memory (RAM)

•

Change/install an M.2 SSD

•

Change/install a 2.5-inch drive

•

Use a VESA mount bracket

•

Connect power

•

Install an operating system

•

Keep device drivers current

Open the Intel NUC Chassis

To open the Intel NUC chassis, follow these steps:

1. With a screwdriver unscrew the four corner screws on the bottom cover of the chassis and lift the

cover (using an electric or battery operated screw driver can damage the NUC).

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Upgrading System Memory

The Intel NUC Kits NUC7i3BNHXF, NUC7i5BNHXF and NUC7i7BNHXG have two 260-pin DDR4 SO-

DIMM sockets.

Pre-installed memory

NUC7i3BNHXF

One 4GB memory module

NUC7i5BNHXF

One 4GB memory module

NUC7i7BNHXG

One 8GB memory module

To upgrade memory, be sure to select memory modules that meet these requirements:

1.2V low voltage memory

2133 MHz SO-DIMMs

Non-ECC

Find compatible memory modules in the Intel Product Compatibility Tool

NUC7i3BNHXF

NUC7i5BNHXF

NUC7i7BNHXG

NOTE

If you plan to install only one memory module, install it in the lower memory

socket.

To upgrade or add memory, follow these steps:

1. Observe the precautions in "Before You Begin" on page 2.

2. Turn off all peripheral devices connected to the computer. Turn off the computer and

disconnect the power cord.

3. Remove the computer’s bottom chassis cover.

Upgrade to different memory

a. Remove the pre-installed memory module

i. Gently spread the retaining clips at each end of the memory socket, which causes

the module to pop out of the socket (C).

ii. Holding the module by the edges, lift it away from the socket, and store it

in an anti-static package.

b. Install the new memory module

i. Align the small space at the bottom edge of the memory module with the

key in the socket.

ii. Insert the bottom edge of the module at a 45 degree angle into the socket

(A).

iii. When the module is inserted, push down on the outer edges of the

module until the retaining clips snap into place (B). Make sure the clips

are firmly in place (C).

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Install an additional memory module

a. Align the small space at the bottom edge of the memory module with the key on the

socket.

b. Insert the bottom edge of the module at a 45 degree angle into the socket (A).

c. When the module is inserted, push down on the outer edges of the module until

the retaining clips snap into place (B). Make sure the clips are firmly in place (C).

4. Reinstall and reconnect any parts you removed or disconnected to reach the memory sockets.

5. Replace the computer’s cover and reconnect the power cord.

Changing an M.2 SSD or Intel® Optane™ Memory Module

The Intel NUC Kits NUC7i3BNHXF, NUC7i5BNHXF and NUC7i7BNHXG support either an 80mm or

42mm SSD.

Pre-installed M.2

NUC7i3BNHXF

One 16GB Intel Optane Memory module

NUC7i5BNHXF

One 16GB Intel Optane Memory module

NUC7i7BNHXG

One 16GB Intel Optane Memory module

Find compatible M.2 SSDs in the Intel Product Compatibility Tool

NUC7i3BNHXF

NUC7i5BNHXF

NUC7i7BNHXG

NOTE

Before changing the Intel Optane memory module, it needs to be disabled. Follow

Removing Intel Optane Memory on this page first, before taking the module out.

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

To Change an M.2 SSD:

1. Remove the small silver screw from the 80mm or 42mm metal standoff on the board (A).

2. Remove the pre-installed SSD/Intel Optane Memory from the connector.

3. Align the space at the bottom of the new M.2 SSD to the key on the connector.

4. Insert the bottom edge of the M.2 SSD into the connector (B).

5. Secure the card to the standoff with the small silver screw (C).

Changing a 2.5” SSD or Hard Drive

The Intel NUC Kits NUC7i3BNHX1, NUC7i5BNHX1 and NUC7i7BNHX1 support an additional 2.5” Solid

State Drive (SSD) or Hard Disk Drive (HDD).

Find compatible 2.5” drives in the Intel Product Compatibility Tool:

NUC7i3BNHXF

NUC7i5BNHXF

NUC7i7BNHXG

1. Unscrew the 4 screws holding the current drive in the bay.

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

2. Remove the pre-installed drive from the drive bay.

3. Slide the new 2.5” drive into the drive bay, ensuring the SATA connectors are fully seated into the

connectors of the SATA daughter card (A).

4. Secure the drive into the drive bay with the four screws that were used in step 1. Set the drive bay

bracket down inside the chassis (C).

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Close the Chassis

After all components have been installed, close the Intel NUC chassis (using an electric or battery

operated screw driver can damage the NUC).

Attach and Use the VESA Bracket (Optional)

Follow these instructions to attach and use the VESA mount bracket:

1. Using the four small black screws that were included in the box, attach the VESA bracket to the

back of the monitor or TV.

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

2. Attach the two slightly larger black screws to the bottom chassis cover of the Intel NUC.

3. Slide the Intel NUC onto the VESA mount bracket.

User Guide for NUC7i3BNHXF, NUC7i5BNHXF, NUC7i7BNHXG

Connect Power

Country-specific power plug attachments are included in the Intel NUC Kit box.

1. Choose the attachment for your region.

Plug

Code

AUS

Country

United States

United Kingdom

European Union

Australia

Plug

Code

CHN

IND

KOR

ARG

Country

China

India

South Korea

Argentina

Plug

Code

BRA

Country

Brazil

Andere Handbücher für NUC7i3BNHXF

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Intel Desktop Handbücher

Intel

Intel SRSH4 - Server Platform - 0 MB RAM Bedienungsanleitung

Intel

Intel NUC7i5BNHXF Bedienungsanleitung

Intel

Intel INTELLEC Kurzanleitung

Intel

Intel NUC10i7FNKN Bedienungsanleitung

Intel

Intel DC53427HYE Bedienungsanleitung

Intel

Intel NUC7i5DNKPC Bedienungsanleitung

Intel

Intel NUC8i3CYSM Bedienungsanleitung

Intel

Intel NUC 12 Pro X Bedienungsanleitung

Intel

Intel NUC8 Home Bedienungsanleitung

Intel

Intel Euclid Bedienungsanleitung

Intel

Intel NUC Kit NUC5PGYH Konfigurationshandbuch

Intel

Intel NUC Kit NUC5i3RYHSN Bedienungsanleitung

Intel

Intel NUC5i5RYK Bedienungsanleitung

Intel

Intel NUC Series Bedienungsanleitung

Intel

Intel NUC5i3RYH Bedienungsanleitung

Intel

Intel NUC Series Bedienungsanleitung

Intel

Intel NUC8i7HVK Bedienungsanleitung

Intel

Intel NUC5i7RYH Bedienungsanleitung

Intel

Intel NUC8CY Kurzanleitung zur Einrichtung

Intel

Intel BOXNUC8i7BEKQA Bedienungsanleitung

Intel

Intel NUC8i7HNK Bedienungsanleitung

Intel

Intel SR2600UR - Server System - 0 MB RAM Bedienungsanleitung

Intel

Intel NUC Kit DE3815TYKHE Bedienungsanleitung

Intel

Intel NUC 13 Pro Kit NUC13ANHv7 Bedienungsanleitung

Beliebte Desktop Handbücher anderer Marken

HP m9060n - Pavilion - Elite Technisches Datenblatt

Asus

Asus E210 Series Bedienungsanleitung

Dell

Dell Inspiron 600m Bedienungsanleitung

Dell

Dell Inspiron 3662 Bedienungsanleitung

TotalFlow

TotalFlow uFLO Bedienungsanleitung

HP Presario SV7000 - Desktop PC Bedienungsanleitung

HP ProDesk 400 G5 Handbuch

Logitech

Logitech MK320 Bedienungsanleitung

Dell

Dell XPS 730 H2C Bedienungsanleitung

Sony

Sony Vaio Series Bedienungsanleitung

Sony

Sony VGC-LT32E - Vaio All-in-one Desktop Computer Bedienungsanleitung

Alto

Alto MD 250 Bedienungsanleitung

Lenovo

Lenovo ThinkCentre Edge 72 Handbuch

Lenovo

Lenovo ThinkStation D20 Handbuch

Arbor Technology

Arbor Technology FPC-7800 Series Bedienungsanleitung

Sony

Sony VAIO VGX-TP1 Series Bedienungsanleitung

Asus

Asus Eee Box B204 Bedienungsanleitung

Dell

Dell Optiplex 9010 All In One Bedienungsanleitung