Keys Fitness STRENGTH TRAINER ST-DFIDL Bedienungsanleitung

Owner’s Manual ST-DFIDL

215-00081

08/06 Rev A

Model Name : ST-DFIDL

Manufactured Date :

PO # :

Model Name Decal Location

Questions?

Call Us Toll Free

Keys Fitness Helpline

1-888-340-0482

Table of Contents

Important Safety Information 3

Assembly 4-11

Parts List 12

Exploded View 13

Warranty Information 14

Important Safety Information

Please read all instructions carefully before using this product.

SAFETY TIPS

Consult with your physician before engaging in any vigorous exercise. Know your heart rate

and/or pulse as well as your physician-recommended heart rate training zone. Proper medical

clearance is recommended for anyone beginning an exercise program especially if you are 35

years of age or older or suffer from heart respiratory problems.

- Warm-up before any exercise program with 8 minutes of aerobic-like activity followed

by stretching from head to toe.

- Wear comfortable clothes that allow freedom of movement and are not tight or

restricting.

- Wear comfortable shoes made with good support and non-slip soles.

- Breath naturally, never holding your breath during an exercise.

- Perform exercises consistently with proper technique and pass through a full range of

motion.

- Increase resistance by adding heavier weights. Decrease resistance by using lighter

weights.

- Always use a spotter for safety.

- Avoid over-training. You should be able to carry on a conversation while exercising.

- After an exercise session. Cool down with slow stretching, cycling or walking.

EXERCISE DEFINITIONS:

Sets: A set is one complete routine of exercises. Complete 1-3 sets for each exercise.

Repetitions: (referred to as reps) Is the number of times you perform an exercise in a row.

We recommend beginning with 6 reps and increasing up to 12 reps as indicated below.

Novice: Start with one set of 8-12 reps. Once you can complete the entire set of 12 reps con-

secutively, progress to the intermediate level.

Intermediate: Complete 2 sets of 8-12 reps once you can complete two sets of 12 reps con-

secutively, progress to the advanced level.

Advanced: Complete 3 sets of 12 reps

DISCLAIMER:

Keys Fitness is not responsible for the misuse of any of its products or for any injury sustained

while using any Keys Fitness product. The consumer uses any or all of Keys Fitness Products at

their own risk.

BEFORE YOU BEGIN:

Before you begin assembly of your Keys Fitness product, please take a moment to review the

hardware and parts list on the following pages. Each part has been illustrated and numbered

for easy identification.

Check this list against the contents of your package to make sure you have all required parts.

If any parts are missing, please do not return this product to the store. Contact our service

department immediately at

1-888-340-0482

and we will rush you any parts you may require.

Assembly

Assembly Hardware

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

Attach the Main Frame (#1) to the Front Stabilizer (#2). Align the holes and secure it with

three M10×5/8" Allen Bolts (#31) and three 3/4" Washers (#39).

Attach the Main Frame (#1) to the Rear Stabilizer (#3). Align the holes and secure it with

two M10×5/8" Allen Bolts (#31) and two 3/4" Washers (#39).

Slide the Sliding Block (#9) onto the Incline Adjustment Bar (#10). Align the holes then

thread in a Knob Lock (#20) to hold the Sliding Block in position.

Push two Bushings (#23) into the Incline Adjustment Bar (#10). Then attach the Bar to the

front bracket on the Main Frame (#1). Secure it with one M10×3" Allen Bolt (#33), two 3/4"

Washers (#39) and one M10 Nylon Nut (#41).

Attach two Bushings (#23) to the side of Main Frame (#1). Attach two Bushings (#23) to

the pivot on top of the Main Frame (#1). Attach two Bushings (#23) to the pivot on the

Sliding Block (#9).

STEP 1

Assembly

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

DIAGRAM 2

Attach two Bushings (#23) to each Seat Support Frames (#6).

Attach one Backrest Support (#7) to the Seat Support Frame (#6). Align the holes and

secure them with one M10×1 5/8" Allen Bolt (#32) and one 3/4" Washer (#39). (Repeat

the same procedure to install the other side.

Attach the two Backrest Supports (#7) to the pivot on the Main Frame (#1). Align the

holes and secure them with one M10×6 1/4" Allen Bolt (#35), two 3/4" Washers (#39)

and one M10 Nylon Nut (#41).

STEP 2

Assembly

STEP 3

DIAGRAM 3

Align the holes on the two Backrest Supports (#7) to the pivot on the Sliding Block (#9).

Secure them with one M10×6 1/4" Allen Bolt (#35), two 3/4" Washers (#39) and one

M10 Nylon Nut (#41).

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

Assembly

DIAGRAM 4

STEP 4

Attach the Seat Incline Support Bracket (#8) to the Main Frame (#1).

Secure it with one M10×4 3/4" Allen Bolt (#34), two 3/4" Washers

(#39) and one M10 Nylon Nut (#41). Do not over tighten the nut

and bolt. The Bracket needs to be able to swivel. Attach two bushings

(#23) to the pivot on the Seat Incline Support Bracket (#8).

Attach the Seat Support Frames (#6) to the pivot of the Seat Incline

Support Bracket (#8). Align the holes and secure them with one

M10×8 1/4" Allen Bolt (#36), two 3/4” Washers (#39) and one M10

Nylon Nut (#41).

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

Assembly

STEP 5

DIAGRAM 5

Place the Seat Pad (#14) onto the Seat Support Frames (#6). Align

the holes and secure it with four M8×2" Allen Bolts (#37) and four

5/8" Washers (#40).

Place the Backrest Board (#15) onto the Backrest Supports (#7).

Align the holes and secure it with four M8×2" Allen Bolts (#37) and

four 5/8" Washers (#40).

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

Assembly

DIAGRAM 6

STEP 6

Insert the Arm Curl Stand (#17) into the top opening in front of the Seat. Secure it with

a Knob Lock (#20) underneath the Seat. Attach the Arm Curl Pad (#21) to the Arm

Curl Stand (#17). Secure it with two M8×5/8" Allen Bolts (#38) and two 5/8" Washers

(#40).

Attach the Leg Developer (#5) to the bracket of the Main Frame (#1). Secure it with an

M10 Nylon Nut (#41), two 3/4" Washers (#39) and two M10×3" Allen Bolts (#33).

Insert the Olympic Sleeve (#13) onto the weight post of the Leg Developer. Attach the

1" Spring Clip (#19) to the post. NOTE: When using the bench at a decline position to

do Ab exercises, place at least 30lbs of weights on the leg developer to hold it down.

NOTE: Hand tighten bolts and nylon nuts until machine is fully assembled.

Assembly

Inhaltsverzeichnis

Andere Keys Fitness Fitnessgeräte Handbücher

Keys Fitness

Keys Fitness Half Cage PeC Attachment KF-HCP Bedienungsanleitung

Keys Fitness

Keys Fitness Power Tower ST-PT Series Bedienungsanleitung

Keys Fitness

Keys Fitness Strength Trainer ST-LEG Bedienungsanleitung

Keys Fitness

Keys Fitness Leg Machine KF-LEGM Bedienungsanleitung

Keys Fitness

Keys Fitness Power Cage Lat Attachment KPS-PCL Bedienungsanleitung

Keys Fitness

Keys Fitness KF-PC Bedienungsanleitung

Keys Fitness

Keys Fitness Power System KPS-LCS Bedienungsanleitung

Keys Fitness

Keys Fitness Strength Trainer ST-VDB Bedienungsanleitung

Keys Fitness

Keys Fitness ST-DB3 Bedienungsanleitung

Keys Fitness

Keys Fitness KF-ABM Bedienungsanleitung

Keys Fitness

Keys Fitness Power System KPS-SCC Bedienungsanleitung

Keys Fitness

Keys Fitness Power System KPS-BTM Bedienungsanleitung

Keys Fitness

Keys Fitness ST-DB5 Bedienungsanleitung

Keys Fitness

Keys Fitness STRENGTH TRAINER ST-45 Bedienungsanleitung

Keys Fitness

Keys Fitness Functional Trainer KF-FT Bedienungsanleitung

Keys Fitness

Keys Fitness KF-PT Bedienungsanleitung

Keys Fitness

Keys Fitness 1550 Bedienungsanleitung

Keys Fitness

Keys Fitness Leg Attachment KPS-LEGA Bedienungsanleitung

Keys Fitness

Keys Fitness StrenghtTrainer ST-OBA2 Bedienungsanleitung

Keys Fitness

Keys Fitness KF-HCL Bedienungsanleitung

Keys Fitness

Keys Fitness Power System KPS-LEGM Bedienungsanleitung

Keys Fitness

Keys Fitness Power System KPS-ARMA Bedienungsanleitung

Keys Fitness

Keys Fitness Strength Trainer ST-MAB Bedienungsanleitung

Keys Fitness

Keys Fitness KF-PTO Bedienungsanleitung

Beliebte Fitnessgeräte Handbücher anderer Marken

NSD

NSD PB-188P Bedienungsanleitung

Performance

Performance HyperVibe Bedienungsanleitung

Scalamobil

Scalamobil S27 Bedienungsanleitung

Precor

Precor Experience Series Bedienungsanleitung

FYTTER

FYTTER RedMIUM BENCH BE-T6R Bedienungsanleitung

Taurus

Taurus TF-RK1312 Bedienungsanleitung

Nustep

Nustep T5 Bedienungsanleitung

Precor

Precor CW-507 Bedienungsanleitung

Movement

Movement BICEPS Idea Bedienungsanleitung

Kegel8

Kegel8 V For Men Bedienungsanleitung

BLK BOX

BLK BOX 21-0122-0B Bedienungsanleitung

Stamina

Stamina aeropilates premier 299 Bedienungsanleitung

SPORTSTECH

SPORTSTECH PBX300 Bedienungsanleitung

ParaBody

ParaBody Serious Steel 877102 Bedienungsanleitung

Weslo

Weslo Gym 650 Bedienungsanleitung

Rebel

Rebel ACTIVE RBA-1011 Bedienungsanleitung

4iiii

4iiii FLiiiight Bedienungsanleitung

Image

Image 540 Bedienungsanleitung