Kohler 97631-G9 Montageanleitung

Installation and Care Guide

Locker with Wall Panels

Français, page ″Français-1″

Español, página ″Español-1″

1248925-2-C

Table of Contents

Tools and Materials ............................................................... 2

Before You Begin ................................................................. 3

Plan the Installation ............................................................... 4

Prepare the Site ................................................................. 5

Measure Components ............................................................. 6

Trim the Locker and Walls .......................................................... 8

Dry Fit the Locker and Walls ........................................................ 9

Install the Corner Joints (Optional) ................................................... 10

Install the First Wall Panel ......................................................... 11

Prepare the Locker Unit ........................................................... 12

Install the Locker Unit ............................................................ 13

Install the Second Wall Panel ....................................................... 14

Check the Locker Unit Fit .......................................................... 15

Prepare the Corner Joints (Optional) .................................................. 16

Install the Sidewall Panels ......................................................... 17

Install the Edge Trim (Optional) ..................................................... 18

Seal the Enclosure ............................................................... 19

Complete the Installation .......................................................... 20

Care and Cleaning ............................................................... 20

Warranty ...................................................................... 20

Tools and Materials

Jigsaw with

Grit Blade and

Fine Toothed Blade

Denatured Alcohol

Rags

Shop Vacuum

Breathing

Protection

Drill & Hole Saw

(size will vary)

Plus:

• Standard Woodworking Tools

• Spring Loaded Braces or Lumber

(to create bracing)

• Sawhorses

• Drop Cloth

Sanding Block

1-2 Tubes Color Matched

100% Silicone Sealant

Caulk Gun

7-1/4" Circular Saw

and Masonry Blade

8+ tubes Non-Solvent

Based Construction Adhesive

(Silicone Adhesive when installing over tile)

Masking

Tape

DENATURED

ALCOHOL

Duct

Tape

1248925-2-C 2 Kohler Co.

Before You Begin

WARNING: Risk of serious injury. When cutting walls and locker, take appropriate safety

measures including the use of breathing protection.

CAUTION: Risk of serious injury. Always wear safety glasses while cutting and drilling.

CAUTION: Risk of serious injury. If the ceiling will be covered with the wall material, the ceiling

must be installed prior to the wall panels. Allow sufficient time for the ceiling installation to cure

before installing the wall panels or the ceiling can fall during installation, causing injury.

CAUTION: Risk of product damage. The wall panels should be room temperature before cutting. Allow

the temperature to stabilize if the walls were in a cold environment.

IMPORTANT! Dust will be generated when cutting the wall panels and locker unit. Cutting the walls

and locker should be performed outside or in a well ventilated area.

IMPORTANT! For best results, cut the walls using a masonry blade. Do not use a blade with teeth.

IMPORTANT! Leave this manual for the end user.

Read these instructions before installing or using this product:

•The locker unit must only be trimmed in height. Do not cut down the sides.

•The existing rough walls must be within 3/8″(10 mm) of plumb.

•The locker unit must be braced using 2x4’s around the entire unit.

•Use color matched silicone sealant in the joints and around the locker unit.

•Check all joints, walls, and accessories for proper color before beginning installation.

•Cover the shower base with a drop cloth or other protective material to avoid damage.

•Follow the construction adhesive and silicone sealant instructions for application and curing time.

•Inspect all components for damage after unpacking, prior to installation.

•A router may be used to cut the walls and locker. The router bit will dull quickly.

•If the wall panels are being installed over existing tile, scuff the tile using 100 grit sandpaper for

better adhesive contact.

•If installing accessories, install 2x4 backing for handrails, shelves, and hooks.

Kohler Co. 3 1248925-2-C

Plan the Installation

NOTE: Determine which accessories will be installed and where before installing wallboard backing

material, as accessories may require wood bracing.

Install any required bracing.

2x4 bracing is required for the hook unless it is installed into the studding.

2x4 bracing is required for all handrails and shelves.

Accessories

Shelf

Hook

24" (610 mm) Handrail

36" (914 mm) Handrail

40" (1016 mm) Handrail

54" (1372 mm) Handrail

1248925-2-C 4 Kohler Co.

1. Prepare the Site

IMPORTANT! Water resistant wallboard backing material is recommended.

Install the rough plumbing for the bath and shower components.

Check the studs for plumb. Studs should be within 3/8″(10 mm) of plumb, shim if necessary.

The ledge of the locker unit can be used as a footrest. The recommended footrest height is 12” (305

mm) to 16” (406 mm), from the ﬂoor of the shower to the ledge of the locker unit.

Determine the height of the enclosure and the locker unit.

Install 2x4 bracing where the locker unit will be placed following the dimensions shown above.

To determine the height of the bottom bracing, subtract 1” (25 mm) from the desired height of the

footrest.

Install backing support for all accessories that require additional support. Refer to the installation

guides packed with each product for speciﬁc installation needs.

Install wallboard backing material over the locker unit opening with the same dimensions as the 2x4

bracing cut out.

65"

(1651 mm) K-97630: 9" (229 mm)

K-97631: 14-1/2" (368 mm)

2x4 Bracing

K-97630: 9" (229 mm)

K-97631: 14-1/2" (368 mm)

Wallboard

Backing

65"

(1651 mm)

11" (279 mm) Min

15" (381 mm) Max

11" (279 mm) Min

15" (381 mm) Max

Kohler Co. 5 1248925-2-C

2. Measure Components

Determine if edge trim will be installed.

Order optional edge trim as needed.

Back Wall Measurement

Measure the installation area to determine the cut dimensions for the wall panels.

Subtract half the total width of the locker unit from the width of each back wall panel.

If corner joints will be installed, subtract 1/16” (2 mm) from the width of the wall panels for each

corner joint.

Mark the cut lines on the back side of the back wall panels.

Sidewall Measurement

If corner joints will be installed, subtract 5/16” (8 mm) from the width of each wall panel before

cutting.

Record the location of the handle, showerhead, bath spout, and other components.

Mark the cut lines on the back side of the sidewall panels.

Optional: Installation with Ceiling Panels

CAUTION: Risk of injury. Install the ceiling panel prior to installing the wall panels. Allow the

adhesive to cure before installing the wall panels.

If the ceiling will be covered with the panel material, measure and cut the ceiling panel to size.

Construct bracing or use commercial bracing to hold the ceiling panel in place while it cures.

NOTE: Polyurethane based adhesive is recommended for the ceiling panel.

Apply construction adhesive to the ceiling material as shown in ″Install the First Wall Panel″

section.

With a partner, carefully lift the ceiling panel into place.

1248925-2-C 6 Kohler Co.

Measure Components (cont.)

Brace the ceiling panel tight against the ceiling and allow it to cure following the adhesive

instructions.

Kohler Co. 7 1248925-2-C

3. Trim the Locker and Walls

Cut Wall Placement

IMPORTANT! The cut edges of the wall panels MUST be positioned opposite the locker unit. The vertical

edge of the locker unit MUST mate to an uncut, bevel molded edge on the wall panels.

Cutting the Walls and Locker

IMPORTANT! It is recommended the wall panels be cut using a power saw and abrasive wheel or an

abrasive masonry blade.

IMPORTANT! Do not cut the sides of the locker unit. Only trim the top or bottom to ﬁt your wall length.

IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is

placed upside down the shelves will fall out.

Position the back wall panel face down on a stand or sawhorses that have a protective material on

them.

Cut the back wall panel to the required dimensions. Use a jigsaw with a grit blade for contour cuts.

Repeat with the sidewall panels.

From the front side of the sidewall panel, use a hole saw to cut the holes for valving and other

shower components.

NOTE: Remove any protective ﬁlms on the locker unit surface before cutting.

Cut the locker unit to the required height dimensions using a ﬁne toothed blade.

IMPORTANT! It is critical the wall panels and locker unit are clean for a strong bond to be created by the

adhesive.

Remove excess material and sand any rough edges using a sanding block.

Clean the back of the wall panels and locker unit with denatured alcohol.

Back Side

Sanding Block

Cut Edge

Uncut Edge

Sidewall

Panel

Shower Valving

1248925-2-C 8 Kohler Co.

4. Dry Fit the Locker and Walls

Dry ﬁt the corner joints to the back wall panels if they are being installed. See ″Install the Corner

Joints (Optional)″for correct orientation.

Dry ﬁt the locker unit, back, and sidewall panels with shims to conﬁrm ﬁt. Adjust as needed.

Remove the wall panels and locker unit. Remove the corner joints.

Shim

Kohler Co. 9 1248925-2-C

5. Install the Corner Joints (Optional)

Measure the height of the back wall panel.

Cut the corner joint to the height of the back wall panel using a small rotary tool with a cutting

wheel.

Apply color matched sealant in the deep channel groove on the corner joint. Apply enough sealant

to ﬁll 1/2 of the groove.

Install the deep channel of the corner joint on the side of the back wall panel.

Do Not apply sealant or install the second corner joint until you are ready to install the second back

wall panel.

Deep Channel

Sealant Shallow

Channel

Top View

Back Wall with Joints

Deep

Channel Shallow

Channel

Top View

1248925-2-C 10 Kohler Co.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler Escale 23264IN-NF Bedienungsanleitung

Kohler

Kohler 2451 Bedienungsanleitung

Kohler

Kohler K-2607 Montageanleitung

Kohler

Kohler VERDERA K-26376T Bedienungsanleitung

Kohler

Kohler Top Art K-14041 Bedienungsanleitung

Kohler

Kohler K-6334 Montageanleitung

Kohler

Kohler Kathryn K-2317-SN Bedienungsanleitung

Kohler

Kohler Verdera Bedienungsanleitung

Kohler

Kohler AMERISSIC K-99073T Bedienungsanleitung

Kohler

Kohler Fountainhead K-2441 Bedienungsanleitung

Kohler

Kohler Memoirs 485T Bedienungsanleitung

Kohler

Kohler 5900SP Montageanleitung

Kohler

Kohler MAXISPACE K-96103 Bedienungsanleitung

Kohler

Kohler K-2529 Montageanleitung

Kohler

Kohler K-2527 Montageanleitung

Kohler

Kohler K-CB-CLW2030DAW Montageanleitung

Kohler

Kohler K-20195 Montageanleitung

Kohler

Kohler K-72441T Bedienungsanleitung

Kohler

Kohler TOOBI II Series Bedienungsanleitung

Kohler

Kohler K-3082 Montageanleitung

Kohler

Kohler K-77123T Bedienungsanleitung

Kohler

Kohler K-15515T Bedienungsanleitung

Kohler

Kohler Purist K-3080 Bedienungsanleitung

Kohler

Kohler Jacob Delafon Idol Bedienungsanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung