Kohler TOOBI II Series Bedienungsanleitung

-1-

BEFORE YOU BEGIN

TOOBI II

INSTALLATION INSTRUCTIONS

VANITY TOPS & CABINETS

Please read these instructions carefully to familiarize yourself with the required tools, materials, and

installation sequences. Follow the sections that pertain to your particular installation. This will help you

avoid costly mistakes.

All information in these instructions is based upon the latest product information available at the time of

publication. Kohler NZ reserves the right to make changes in product characteristics, packaging, or

availability at any time without notice.

These instructions contain important care, cleaning, and warranty information - please leave instructions

for the consumer.

Turn off the water supply.

The plumbing installation must comply with Water Supply Regulations / Bylaws. The installation of the

waste and tapware must be carried out by a plumber.

Before installation carefully inspect the vanity for any signs of damage, if damage has occurred do not

proceed with the installation, and advise your supplier immediately.

This installation covers the following products in the TOOBI II range:

Kohler products are should give continued superior and safe performance, provided:

1. They are installed, commissioned, operated and maintained in accordance with the recommendations

given in this Manual.

2. Periodic attention is given, as necessary, to maintain the products in good functional order. Refer to

‘User Information’ on page 6 of this manual.

3. When installing Kohler Products, manufacturers guidelines for power tool safety should be followed.

1403098-A02-A

TOOBI II 600 Single Drawer Vanity - Slate................................................25802A-NA

TOOBI II 600 Single Drawer Vanity - Midnight...........................................25803A-NA

TOOBI II 600 Single Drawer Vanity - Sand Dune......................................25804A-NA

TOOBI II 600 Vanity With Top Utility Drawer - Slate..................................25805A-NA

TOOBI II 600 Vanity With Top Utility Drawer - Midnight............................25806A-NA

TOOBI II 600 Vanity With Top Utility Drawer - Sand Dune........................25807A-NA

TOOBI II 900 Single Drawer Vanity - Slate................................................25808A-NA

TOOBI II 900 Single Drawer Vanity - Midnight...........................................25809A-NA

TOOBI II 900 Single Drawer Vanity - Sand Dune......................................25810A-NA

TOOBI II 900 Vanity With Top Utility Drawer - Slate..................................25811A-NA

TOOBI II 900 Vanity With Top Utility Drawer - Midnight............................25812A-NA

TOOBI II 900 Vanity With Top Utility Drawer - Sand Dune........................25813A-NA

ORDERING INFORMATION

SAFETY WARNING

CABINETRY ROUGH-IN

UNIT : mm

Reference Value

420

495

890

590

495

420

-2-

PLUMBING INSTALLATION

(a) Install the services. Hot and Cold inlets must be connected

to the correct inlet pipes.

(b) Install the waste in accordance with the manufacturers

instructions together with the overflow kit as shown

in Fig. 1.

Recommended: Kohler Click-Up DN32 Waste (7119A-*)

Kohler reserves the right to change marked dimensions without prior notice.

NOTE: The hot and cold water supplies must be installed with

isolating valves.

Caution! Make sure a watertight seal exists

on all drain connections.

Caution! Provide access to the plumbing connections

for future plumbing maintenance.

DN32 to DN40

adapter

Overflow

Waste

Fig. 1

COCONSTRUCTION REQUIREMENTS

A height of 750 to 800mm from the floor

to the top of the cabinet is recommended.

50mm from top of cabinet to centre of nog.

Toobi II cabinets must be fixed to two nogs in the wall, the nog size should be 50 x 75mm.

750 - 800

TOOLS & MATERIALS REQUIRED - (Not Supplied)

To suit pipework To suit screws

TOOLS MATERIALS - Not supplied & must be purchased separately

Fixing washers

20mm

Screws (Refer step 3)

10g x 75mm

INSTALLATION

(b) Pull & lift up the drawer until it detaches

from the rails.

1 Drawer removal

50%

(a) Open the drawer until at least 50% of the

drawer extends past the cabinet carcass.

-3-

2 Water supply and waste pipe holes

(a) Measure and mark the centres for water

supply & waste pipes on the back of the

cabinet. With a suitably sized hole saw drill

the holes for the water supply and waste.

(b) Having drilled the required holes, fit the

cabinet into position over the pipework.

3 Fixing the vanity to the wall

(a) Before fastening the cabinet make sure that

it is sitting level and square.

(b) Fix the cabinets to the wall using screws (min

10g x 75mm) and *20mm washers.

pattern as shown in Fig. 2.

• 600mm cabinets require a minimum of 5 screws

• 900mm cabients require a minimum of 7 screws

(a) Unpack the top and check for any damage that

might have occured in transit. Check and

confirm the fit of your selected tapware.

Please disregard the supplied fixing kit.

(b) Apply a continuous bead of silicone (not

supplied) to the top edge of the cabinet sides

and back. Ensure there are no gaps in the

sealant bead. This will ensure the top stays

securely fitted to the cabinet and no water

spillage will find its way into the cabinet.

that the back is flush against the wall and

there is an even overhang on either side of the

cabinet.

(d) Wipe off any excess sealant.

4 Vanity Top Installation

INSTALLATION

-4-

Fig. 2

INSTALLATION

5 Waste & Tapware

(a) Fit the tapware. Connect the water supply

to the taps and waste pipe to the waste

outlet.

(b) Run hot and cold water and check for leaks.

When satisfied with the results move on to the

next section.

6 Drawer re-installation

(a) To re-install the drawers, extend the runners

and place the drawer onto the runners.

(b) Gently push the drawer back until you hear

the runners click into place.

50%

7 Sealing

(a) All edges MUST be sealed with an approved

Silicone Sealant.

- Between cabinet and wall

- Between the vanity top and wall

Tap

Supply

Lines

Drain

Assembly

shown in Fig. 3.

P Trap

Please visit our website for warranty information:

Kohler NZ Kohler Australia

www.kohler.co.nz www.kohler.com.au

INSTALLATION COMPLETE

-5-

Fig. 3

Overflow

DRAWER ADJUSTMENT

± 1.5

± 2mm

Side-to-side

Up-and-down

Tilt back-and-forward

USER MAINTENANCE

1) Regular cleaning of your Kohler product is recommended and will help to avoid the build up of

dirt and grime that can damage and reduce the life of the product.

2) Do not use cleaning products containing:

Abrasives

Alcohol Bleach Ammonia or peroxides

Citrus

Harsh chemicals & disinfectants

Acid or alkaline Solvents

3) Recommended cleaning procedures:

Toobi Vanity Tops: Use non abrasive soap and water. It is recommended that the product surface

is wiped dry after each use to prevent the build up of soap and scum.

Toobi II Cabinets: Take care to dry up water spillage onto the cabinets surfaces. To maintain the

finish on your cabinets, clean with mild soapy water and dry with a soft cloth.

-6-

CAUTION

Material used in cabinet is highly water resistant but not waterproof.

Care must be taken to clean up all water spillage.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Kohler Inneneinrichtung Handbücher

Kohler

Kohler PERSUADE K-2527T Bedienungsanleitung

Kohler

Kohler PARADOX K-15050T Bedienungsanleitung

Kohler

Kohler MAXISPACE 2.0 K-24374T Bedienungsanleitung

Kohler

Kohler Vanity K-2435 Bedienungsanleitung

Kohler

Kohler TRESHAM K-45980T-L Bedienungsanleitung

Kohler

Kohler VERDERA K-29853T Bedienungsanleitung

Kohler

Kohler MAXISPACE Bedienungsanleitung

Kohler

Kohler K-96106X-L Montageanleitung

Kohler

Kohler 97631-G9 Montageanleitung

Kohler

Kohler Kathryn K-3020 Bedienungsanleitung

Kohler

Kohler 1221226-2-B Montageanleitung

Kohler

Kohler TRESHAM VANITY K-45980 Series Montageanleitung

Kohler

Kohler VERDERA K-26385T Bedienungsanleitung

Kohler

Kohler Memoirs 485T Bedienungsanleitung

Kohler

Kohler K-2684 Montageanleitung

Kohler

Kohler K-13013T Bedienungsanleitung

Kohler

Kohler FAMILY CARE K-31500T Bedienungsanleitung

Kohler

Kohler K-15515T Bedienungsanleitung

Kohler

Kohler 12128W Bedienungsanleitung

Kohler

Kohler BANCROFT Service-Handbuch

Kohler

Kohler K-11750 Montageanleitung

Kohler

Kohler RIVLET K-31534K-CP Bedienungsanleitung

Kohler

Kohler K-99003T-R Bedienungsanleitung

Kohler

Kohler K-3082 Montageanleitung

Beliebte Inneneinrichtung Handbücher anderer Marken

Homelegance

Homelegance California 1662PEK-1CK Bedienungsanleitung

Osmond Ergonomics

Osmond Ergonomics FLO Bedienungsanleitung

OVE

OVE ELOISE 42 Bedienungsanleitung

overstock

overstock MF286255 Bedienungsanleitung

Sonoma

Sonoma 160-801 Bedienungsanleitung

BOLERO

BOLERO Wicker Side Chair CF158 Installationsanleitung

Coaster

Coaster 4799N Bedienungsanleitung

Stor-It-All

Stor-It-All WS39MP Programmierhandbuch

Lexicon

Lexicon 194840161868 Bedienungsanleitung

Next AMELIA NEW 462947 Bedienungsanleitung

impekk

impekk Manual II Bedienungsanleitung

Elements

Elements Ember Nightstand CEB700NSE Bedienungsanleitung

JWA

JWA CARY 68429 Bedienungsanleitung

VIPACK

VIPACK AMORI AMKB9014 Bedienungsanleitung

Rowico

Rowico SANNA Bedienungsanleitung

Southern Enterprises

Southern Enterprises CK556000TX Bedienungsanleitung

hygena

hygena 314/5041 Bedienungsanleitung

VINNOVA

VINNOVA Kinsley 536060S Bedienungsanleitung