Kohler 99859T Bedienungsanleitung

1293805-2A-B 1

BEFORE YOU BEGIN

All information is based on the latest product information available at the time of publication. Kohler Co.

reserves the right to make changes in product characteristics, packaging, or availability at any time without

notice.

Please leave these instructions for the consumer. They contain important information.

NOTES:

1. Flush the water supply pipes thoroughly to remove debris.

2. Shut off the water supplies to the fitting.

3. Observe local plumbing codes.

4. Maximum working pressure for spout: 0.5Mpa(5 bar).

5. Do not use alcohol and other organic solvents to wipe the spout.

DANGER: Risk of personal injury.

This product can not be used as a shelf or support bar. The misoperation may damage the product, and even

cause personal injury.

1293805-2A-B 4

INSTALLATION INSTRUCTIONS

99859T Decorative Bath Spout99859T Decorative Bath Spout

BEITOUBEITOU

ROUGH-IN DIMENSIONS

SERVICE PARTS

**Color code must be specified when ordering.

99859T

Ø10

140 34

225

G1/2˝

1287336**

1281468

1281465**

1287337

1183881

1058705

833730

1230337

834404

3008523

834638

3013706

1223568

20960

1293421

20960

1293418

1293420

1293417

1293422

1293419

1082904

1082902

1293805-2A-B 2

1293805-2A-B 3

INSTALLATION CHECKOUT

CLEANING INSTRUCTIONS

CARE AND MAINTENANCE

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

INSTALLATION

To perform installation, installer must provide G1/2″

female supply fitting(1), keep proper position in the

wall. NOTE: The supply fitting should be below the

finished wall 6~18mm, and be vertical with finished

wall as well. The hole in the finished wall should be

not more than Ø40.

Screw the tube(3) and base(2) into the wall, tighten

them by hex wrench(4).

Drill two Ø10 holes according to the mark. The depth

of the holes are 52mm.

Press the anchors(6) into the hole. Apply tape or

thread sealant to threads of the tube(3). Install the

tube into the wall through the base(2). Install the

screws(7) to secure the base on the wall. Tighten

the tube by hex wrench(4).

Install the connector(8) into the tube(3). Turn on the

water supply, run the hot and cold water through the

connector for about one minute to remove any

debris. Shut off water supply.

Install the spout kit(9) onto the base(2). Tighten the

screws(10) to secure the spout kit by hex

wrench(11). Press the plugs(12) into the hole.

Make sure the base(2) is horizontal by the attached

level(5). Mark the position of the hole on the wall

with a pencil.

Take out the screw(21) in the bottom of the spout by

hex wrench(14). Remove the escutcheon cover(18),

rectifier(19) and support ring(20).

Flush the filter of rectifier. Check the filter whether is

intact, if damaged replace it.

Reassemble the spout and body: put the support

ring(20), rectifier(19) and escutcheon cover(18) into

the spout. Tighten the screw(21) by hex wrench(14).

Put the O-ring(17) on the spout(13) bottom. Connect

the spout and body, fixed them by screw(15). Install

the spout kit to the base, fixed them by screw(10).

Clean Rectifier

If there is a lot of debris in the supply pipes or the

quality of water is bad, it will cause the flow in bad

condition. Please clean the filter as following steps:

Turn off the supply water. Take out the plugs(12),

remove the screws(10) by hex wrench(11). Remove

the spout kit(9).

Remove the screws(15) by hex wrench(14).

Uninstall the spout(13) from body(16).

Ensure that all connections are tightened.

Open the drain. Turn on the main water supply and check for leaks. Repair as required.

4① ②

③ ④

⑤ ⑥

① ②

③ ④

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Castia K-TS35917-4Y-2MB Bedienungsanleitung

Kohler

Kohler K-332 Bedienungsanleitung

Kohler

Kohler HiRise K-7344-4 Montageanleitung

Kohler

Kohler Trend K-11933 Bedienungsanleitung

Kohler

Kohler Mira Agile S Eco Bedienungsanleitung

Kohler

Kohler Lyntier K-T10333 Montageanleitung

Kohler

Kohler Sunstruck K-1966-GHW Bedienungsanleitung

Kohler

Kohler K-7344 Montageanleitung

Kohler

Kohler EOLIA 8623T-B Bedienungsanleitung

Kohler

Kohler K-3593 Bedienungsanleitung

Kohler

Kohler Karbon K-6227A Bedienungsanleitung

Kohler

Kohler 10373 Bedienungsanleitung

Kohler

Kohler K-1124-G Kurzanleitung

Kohler

Kohler K-6814 Montageanleitung

Kohler

Kohler Revival K-2950-1/8 Bedienungsanleitung

Kohler

Kohler ALTERNA Bedienungsanleitung

Kohler

Kohler Oblo K-124B16-SANA-CP Bedienungsanleitung

Kohler

Kohler K-2367 Bedienungsanleitung

Kohler

Kohler K-1418-GCR Kurzanleitung

Kohler

Kohler K-7179 Montageanleitung

Kohler

Kohler 1152813-A2-A Bedienungsanleitung

Kohler

Kohler K-14424 Bedienungsanleitung

Kohler

Kohler Elevation Bedienungsanleitung

Kohler

Kohler K-6340 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung