Kohler K-2829 Bedienungsanleitung

Installation Guide

Self-Rimming/Above-the-Counter Lavatory

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

K-2829

1061941-2-B

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and website are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

CAUTION: Risk of personal injury or product damage. Cast

iron lavatories are very heavy. Get help lifting the lavatory into

place.

Observe all local plumbing and building codes.

If you are replacing an existing lavatory, turn off the water supply

to the faucet. Open the faucet valves to relieve pressure, then

disconnect the supply lines. Disconnect the drain assembly,

remove the trap, then remove the lavatory.

For new installations, ensure the water supply lines, drain piping,

vanity, and/or countertop is in place before proceeding with the

lavatory installation.

When selecting a faucet for the lavatory, ensure the spout will

reach a minimum of 4″(10.2 cm) over the rim of the lavatory and

the stream of water is directed toward the center of the lavatory

basin. A wall-mount faucet is recommended.

Never rest or store the lavatory on the drain surface.

Prior to installation, unpack the new lavatory and inspect it for

damage. Return the lavatory to its protective carton until you are

ready to install it.

Pencil

Scissors

Drill

• Template (supplied)

• Rags or Paper Toweling

• Assorted Drill Bits

• Marker

Plus:

Tape

Measure

Safety

Glasses

Silicone

Sealant

Jigsaw

Masking Tape

Adjustable

Wrench

1061941-2-B 2 Kohler Co.

Before You Begin (cont.)

This instruction guide contains both self-rimming and

above-counter installation techniques. Follow the instructions that

apply to your installation.

For replacement installations, make sure the existing cutout is the

same size or smaller than needed for the new lavatory.

If installing multiple components (such as a cabinet, countertop,

or lavatory), read all product installation instructions before

beginning the lavatory installation. Some components should be

installed before others. Refer to Homeowners Guide for sample

conﬁgurations.

Kohler Co. reserves the right to make revisions in the design of

products without notice, as speciﬁed in the Price Book.

Kohler Co. 3 1061941-2-B

Roughing-In

NOTE: To determine the faucet and lavatory placement, consider the

faucet and handle escutcheon diameters, the length of the spout,

and the clearance between the spout and the lavatory rim. Ensure:

•the faucet spout will reach a minimum of 4″(10.2 cm) over the

rim of the lavatory.

•adequate clearance for hand washing.

•the stream of water is directed toward the center of the lavatory

basin.

5-9/16"

(14.1 cm)

5/8" (1.5 cm)

1-9/16"

(4 cm)

25-13/16" (65.6 cm)

1-1/4" OD

3/8" Cold

3/8" Hot

(10.2 cm)

12-7/8"

(32.7 cm)

14"

(35.6 cm)

19-5/16"

(49 cm)

4" (10.2 cm)

27"

(68.6 cm)

Min

(20.3 cm)

Min

(22.9 cm)

Min

11"

(27.9 cm)

Recommended ADA Installation

24" (61 cm)

12-15/16" (32.8 cm) 9-5/8" (24.5 cm)

34" (86.4 cm)

1-1/4" (3.2 cm)

Standard Installation

1061941-2-B 4 Kohler Co.

1. Self-Rimming – Prepare the Site

Cut along the self-rimming cut-out line on the cut-out template

with a scissors.

Using the centerlines as a guide, squarely position the cut-out

template on the countertop. Ensure there is adequate clearance

between the lavatory, backsplash, and faucet.

Use a pencil to trace around the self-rimming cut-out line on the

countertop.

Remove the cut-out template from the countertop.

Recheck the clearance between the lavatory, backsplash, and

faucet. Adjust the traced cut-out line, if necessary.

Cut along the inside of the marked pencil line for the lavatory

with jigsaw.

Cut-Out

Template

Self-Rimming

Cut-Out Line

Kohler Co. 5 1061941-2-B

2. Self-Rimming Installation – Install the Lavatory

CAUTION: Risk of personal injury or product damage. Cast

iron lavatories are very heavy. Get help lifting the lavatory into

place.

Temporarily position the lavatory in the countertop cutout so the

″Kohler″logo is to the back. Verify proper ﬁt and clearance.

Remove the lavatory from the countertop.

Install the faucet and drain according to the manufacturer’s

instructions.

NOTE: For installations using tile, wood, or other porous materials,

apply waterproof sealer around the cutout area of the countertop

surface. Allow the sealer to dry before proceeding.

Carefully position the lavatory in the countertop cutout so the

″Kohler″logo is to the back. Verify proper ﬁt and clearance.

Apply a thin, continuous bead of sealant around the lavatory

edges. Immediately wipe away any excess sealant.

Fill any voids between the lavatory and the cutout with sealant.

Verify that the lavatory had not moved out of position.

Allow the sealant to cure for at least 30 minutes before

proceeding.

Sealant

Seal along the edge of lavatory.

1061941-2-B 6 Kohler Co.

3. Above-the-Counter – Prepare the Site

Cut along the above-the-counter cut-out line on the cut-out

template with a scissors.

Using the centerlines as a guide, squarely position the cut-out

template on the countertop. Ensure there is adequate clearance

between the lavatory, faucet, and backsplash.

Use a pencil to trace around the above-the-counter cut-out line

on the countertop.

NOTE: Ensure the faucet spout will reach a minimum of 4″(10.2

cm) over the rim of the lavatory and the stream of water is directed

toward the center of the lavatory basin.

Recheck the clearance between the lavatory, faucet, and

backsplash. Adjust the traced cut-out line, if necessary.

Use a pencil to mark the exact centers of the four mounting hole

locations on the countertop.

Remove the cut-out template.

Cut along the inside of the marked pencil line for the lavatory

with a jigsaw.

Drill the four 3/8″(1 cm) mounting holes at the marked centers.

Outside Edge

of Lavatory

Above-the-Counter

Cut-Out Line

Backsplash

Kohler Co. 7 1061941-2-B

4. Above-the-Counter – Install the Lavatory

CAUTION: Risk of personal injury or product damage. Cast

iron lavatories are very heavy. Get help lifting the lavatory into

place.

Mark a spot 5/16″(8 mm) in on each threaded stud, as shown.

Handtighten the threaded studs into each of the four drilled

mounting holes of the countertop. Do not tighten past the marked

points on the threaded studs.

Temporarily position the lavatory in the countertop cutout so the

″Kohler″logo is to the back.

Inspect for proper ﬁt.

Remove the lavatory, then place it upside down on a soft cloth.

Install the faucet according to the manufacturer’s instructions.

Install the drain to the lavatory according to the drain installation

instructions.

Apply a thin continuous bead of silicone sealant around the ﬂat

outside edge of the bottom surface of the lavatory.

Carefully position the lavatory in the countertop cutout so the

″Kohler″logo is to the back.

Thread a washer and nut onto each of the threaded studs from

underneath the countertop.

Tighten the nuts 1/2 turn past hand-tight with an adjustable

wrench.

5/16" (8 mm)

Marker

Bottom View

of Lavatory

Mounting Stud Holes

1061941-2-B 8 Kohler Co.

Above-the-Counter – Install the Lavatory (cont.)

Wipe away any excess sealant with a clean cloth. Fill any voids as

needed.

Allow the sealant to cure for at least 30 minutes before

proceeding.

5. All Installations – Installation Checkout

Connect and tighten the trap to the drain, and complete the water

supply connections to the faucet according to the instructions

packed with the faucet.

Run water into the lavatory and check for leaks.

Clean up with a non-abrasive cleaner.

Kohler Co. 9 1061941-2-B

Guide d’installation

Lavabo rebord intégré/sur comptoir

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de performance. Nos numéros de téléphone

et notre adresse du site internet sont au verso. Merci encore d’avoir

choisi la compagnie Kohler.

Avant de commencer

ATTENTION : Risque de blessure corporelle ou

d’endommagement du produit. Les lavabos en fonte sont très

lourds. Demander de l’assistance pour soulever et mettre en

place ce lavabo.

Respecter tous les codes de plomberie et de bâtiment locaux.

Dans le cas de remplacement d’un lavabo existant, couper

l’alimentation d’eau au robinet. Ouvrir les valves de robinet pour

libérer la pression et déconnecter les lignes d’alimentation.

Débrancher le drain, retirer le siphon et retirer le lavabo.

Crayon

à papier

Ciseaux

Perceuse

• Gabarit (fourni)

• Chiffons ou papier essuie-tout

• Jeu de mèches

• Marqueur

Plus :

Mètre

ruban

Lunettes de

protection

Mastic à

silicone

Scie sauteuse

Ruban-cache

Clé à

molette

Kohler Co. Français-1 1061941-2-B

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler K-3671 Montageanleitung

Kohler

Kohler K-7114 Bedienungsanleitung

Kohler

Kohler K-697 Montageanleitung

Kohler

Kohler 8524T Bedienungsanleitung

Kohler

Kohler K-T10594 Montageanleitung

Kohler

Kohler K-77963-8A-BL Bedienungsanleitung

Kohler

Kohler K-10215 Montageanleitung

Kohler

Kohler Mira Response Handset L19A Bedienungsanleitung

Kohler

Kohler K-168 Bedienungsanleitung

Kohler

Kohler PureWash K-98804 Bedienungsanleitung

Kohler

Kohler PURIST UPGRADE Bedienungsanleitung

Kohler

Kohler Deerfield 5815W Bedienungsanleitung

Kohler

Kohler WaterTile K-8030 Bedienungsanleitung

Kohler

Kohler KARAT K-17555 Bedienungsanleitung

Kohler

Kohler MAXISPACE K-77217T Bedienungsanleitung

Kohler

Kohler K-877 Montageanleitung

Kohler

Kohler Purewash K-98804-CP Bedienungsanleitung

Kohler

Kohler CFI230G Bedienungsanleitung

Kohler

Kohler K-3396 Montageanleitung

Kohler

Kohler K-72218 Bedienungsanleitung

Kohler

Kohler FAIRFAX 12177T-B Bedienungsanleitung

Kohler

Kohler K-6448 Montageanleitung

Kohler

Kohler Portrait K-2226 Bedienungsanleitung

Kohler

Kohler K-7514 Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung