Kohler K-5415 Bedienungsanleitung

Installation Guide

Kitchen Sinks

K-5415, K-5416, K-5417

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page “Français-1”

Español, página “Español-1”

1224364-2-B

Tools and Materials

Before You Begin

IMPORTANT! Refer to the ″Roughing-In″section for cabinet

dimensional requirements.

IMPORTANT! This sink must be installed prior to the installation

of the countertop. Cut-line is based from the front face of the

cabinet.

IMPORTANT! Long screws may damage adjacent cabinets. Ensure

the screws are long enough to secure the support framing, but short

enough not to extend through the walls of adjacent cabinets.

Due to the nature of under-mount installations, Kohler Co.

recommends that under-mount sink installations be performed by

trained and experienced installers.

Use proper fasteners and techniques to ensure the frame will

support a minimum of 300 lbs (136 kg). Locate the fasteners for

easy access in the event the sink needs to be removed.

For K-5417 Only: This sink is intended for installation into a 30″

apron sink base cabinet.

For K-5415 and K-5416 Only: This sink is intended for

installation into a 36″apron sink base cabinet.

Observe all local plumbing and building codes.

1" Hole Saw

Painter's

Tape

Plus:

• Suitable support framing material

[3/4" (19 mm)] max thickness

• Screws

Silicone

Sealant

Construction

Adhesive

1224364-2-B 2 Kohler Co.

Roughing-In

A =

Ensure clearance for faucet installation.

of Doors

Top of Cabinet to Top

1-5/8"

(41 mm)

Front of Cabinet

1-5/8"

(41 mm)

Apron

18-1/8"

(460 mm)

IMPORTANT! Before installing

this sink, verify measurement

(A) is greater than the

apron height.

8-13/16" (224 mm) = Apron

Height

Kohler Co. 3 1224364-2-B

1. Preparation

IMPORTANT! Before installing this sink, verify that the distance

from the top of the cabinet to the top of the doors is greater than the

apron height.

TIP: Apply painter’s tape to the cabinet to mark cuts and protect

cabinet surfaces when cutting.

Measure and mark the hole locations.

Drill one inch holes at each marked location.

Mark vertical lines from the hole to the top of the cabinet as

shown.

Cut along the marked lines to form two slots.

Notch the cabinet to accommodate the thickness of the sink rim.

Top of sink should be ﬂush with the top of the cabinet when

installed.

(178 mm)

2-1/8"

(54 mm) Thickness

Sink Rim

1224364-2-B 4 Kohler Co.

2. Install Wood Supports

NOTICE: For proper countertop installation, the top of the sink

must not extend above the top of the cabinet.

Cut two lengths of support framing to extend horizontally along

the inside walls on each side of the cabinet.

Measure and mark the support mounting locations; ensure the

sink rim will sit at or slightly below the top of the cabinet.

Position and level the supports.

TIP: Use clamps to hold the supports in position.

Secure the supports with construction adhesive and screws (not

provided).

Cut four lengths of support framing to extend from the bottom of

the installed supports to the ﬂoor of the cabinet.

Secure the vertical supports with construction adhesive and

screws (not provided).

Support

Framing

Kohler Co. 5 1224364-2-B

3. Install the Sink

Lower the sink into the cabinet. Verify the sink is supported by

the frame.

Verify the sink is level, make any adjustments and shim as

needed.

Remove the sink.

Apply a bead of silicone sealant to the top of each support.

Lower the sink onto the supports and push in to ensure the apron

is ﬂush to the front of the cabinet.

1224364-2-B 6 Kohler Co.

4. Install the Countertop

Apply a bead of silicone sealant around the sides and back of the

sink.

Install the countertop.

Apply a thin bead of silicone sealant where the sink meets the

countertop and cabinet.

Immediately wipe away any excess sealant.

Kohler Co. 7 1224364-2-B

5. Secure the Sink

NOTE: Anchors are pre-installed by the countertop manufacturer.

Install the clips to the countertop, ensure each clip engages the

rim. Tighten evenly.

Wipe away any excess sealant.

6. Complete the Installation

Install the faucet and the strainers, according to the installation

instructions.

Connect the trap to the strainers.

1-5/8"

(41 mm)

1224364-2-B 8 Kohler Co.

Guide d’installation

Éviers de cuisine

Outils et matériaux

Avant de commencer

IMPORTANT! Voir les dimensions requises pour le meuble dans la

section ″Plan de raccordement″.

IMPORTANT! Cet évier doit être installé avant d’installer le

comptoir. La ligne de découpe est basée à partir de la face avant du

meuble.

IMPORTANT! Les vis longues peuvent endommager les meubles

adjacents. S’assurer que les vis sont suffisamment longues pour ﬁxer

le cadrage de support, mais suffisamment courtes pour ne pas

traverser les parois des meubles adjacent.

Vu la nature particulière des installations à encaster par le

dessous, Kohler Co. recommande que les installations à encastrer

par le dessous soient effectuées par des installateurs formés et

expérimentés.

Utiliser la visserie et les techniques qui conviennent pour

s’assurer que le cadre puisse soutenir un minimum de 300 lb (136

kg). Placer la visserie à des endroits accessibles au cas où l’évier

doit être déposé.

Pour les modèles K-5417 seulement: Cet évier est conçu pour

une installation dans un meuble bas pour évier à bandeau de 30″.

Ruban de

peintre Mastic à

la silicone

Plus:

• Matériau de cadrage de support

approprié épaisseur max.

[3/4" (19 mm)]

• Vis

Scie

cylindrique

de 1"

Colle

mastic

Kohler Co. Français-1 1224364-2-B

Avant de commencer (cont.)

Pour les modèles K-5415 et K-5416 seulement: Cet évier est

conçu pour une installation dans un meuble bas pour évier à

bandeau de 36″.

Respecter tous les codes de plomberie et de bâtiment locaux.

1224364-2-B Français-2 Kohler Co.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler K-11344 Kurzanleitung

Kohler

Kohler K-14663 Montageanleitung

Kohler

Kohler K-1124-G Kurzanleitung

Kohler

Kohler C3-225 K-4736T-0 Bedienungsanleitung

Kohler

Kohler K-3145 Montageanleitung

Kohler

Kohler Botticelli K-2333 Montageanleitung

Kohler

Kohler Mira Event XS Bedienungsanleitung

Kohler

Kohler 45432IN Bedienungsanleitung

Kohler

Kohler Aleo 77751X-4CD Bedienungsanleitung

Kohler

Kohler K-T314 Bedienungsanleitung

Kohler

Kohler K4915 Betriebsanleitung

Kohler

Kohler K-16010-2 Bedienungsanleitung

Kohler

Kohler 8959X-9 Bedienungsanleitung

Kohler

Kohler Centerset K-15885 Montageanleitung

Kohler

Kohler K-2953 Montageanleitung

Kohler

Kohler Coralais K-15186 Montageanleitung

Kohler

Kohler Fairfax K-12265 Montageanleitung

Kohler

Kohler Archer K-2359X Montageanleitung

Kohler

Kohler ELLISTON 75522T-4 Bedienungsanleitung

Kohler

Kohler K-78172-BN Bedienungsanleitung

Kohler

Kohler K-10088 Montageanleitung

Kohler

Kohler Mira Evoco Series Bedienungsanleitung

Kohler

Kohler Mira 1836.457 Bedienungsanleitung

Kohler

Kohler Bancrof K-2347 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung