Kohler K-6330 Bedienungsanleitung

Installation Guide

Kitchen Sink Faucet

Mproduct numbers are for Mexico (i.e. K-12345M)

Los números de productos seguidos de

Mcorresponden a México (Ej.

K-12345M)

Français, page“ Français-1”

Español, página“ Español-1”

K-6330

1025493-2-B

Tools and Materials

Thank You For Choosing Kohler Company

We appreciate your commitment to Kohler quality. Please take a few

minutes to review this manual before you start installation. If you

encounter any installation or performance problems, please don’t

hesitate to contact us. Our phone numbers and web site are listed on

the back cover. Thanks again for choosing Kohler Company.

Before You Begin

Do not attach a dishwasher to the faucet spray outlet.

Observe all local plumbing and building codes.

Shut off the water supplies.

Carefully inspect waste and supply tubing for any sign of

damage and replace if necessary.

For new installations, assemble the faucet on the sink before

installing the sink.

Before installation, unpack the new faucet and inspect it for

damage. Return the faucet to the carton until you are ready to

install it.

Do not remove the faucet ground joints, as they contain

important back-siphonage protection.

Kohler Co. reserves the right to make revisions in the design of

faucets without notice, as speciﬁed in the Price Book.

Pencil Level

Assorted

Screwdrivers

Adjustable

Wrench

Tape

Measure

1025493-2-B 2 Kohler Co.

1. Supply Installation

NOTE: This spout and valve can be installed from 4″(10.2 cm) to 8″

(20.3 cm) between center-to-center.

NOTE: The water supply lines must be offset to the right or left as

shown to avoid interference with the pulley cover.

Install the water supplies and drain line according to the

illustration.

Flush the water supplies and stops.

2. Faucet Installation

Install the rubber gasket to the underside of the valve.

Fit the valve through the desired sink hole.

Position the valve so the handle faces forward.

Thread two screws into the threaded ring until they barely

protrude from the top of the threaded ring.

Fit the ﬁber washer and metal washer to the valve shank.

Install the threaded ring to the valve shank until the threaded

ring is just touching the sink.

Turn the threaded ring so the screws are to the front and back of

the faucet.

Securely tighten the screws.

Install valve to

right or left of

spout.

Pulley Cover Drain Line

Water

Supplies

Valve

Inlet

Sink

Screw

Valve

Shank

Rubber

Gasket

Fiber Washer

Threaded Ring

Metal Washer

Kohler Co. 3 1025493-2-B

3. Complete the Faucet Installation

Thread the two screws into the threaded ring until they barely

protrude from the top of the threaded ring.

Install the rubber gasket to the underside of the spout.

Fit the spout through the sink hole.

Position the spout so that it faces forward. The Kohler logo

should be facing the user.

Fit the ﬁber washer and metal washer on the spout shank.

Install the threaded ring to the spout shank until the threaded

ring is just touching the sink.

Turn the threaded ring so that the screws are to the front and

back of the spout.

Position the spout to obtain the desired range of rotation.

Securely tighten the screws.

Spout

Sink

Screw

Threaded

Ring

Fiber Washer

Rubber Gasket Spout Shank

Kohler Logo

Metal Washer

1025493-2-B 4 Kohler Co.

4. Position Channel

NOTE: Metal and plastic components may have sharp edges and

corners. Handle these parts carefully.

Fit the channel over the spout shank with the open end facing the

valve.

Insert two square-head bolts through the top holes in the channel.

Install the washers and hex nuts over the two square-head bolts.

Position the top of the channel so that it is even with the bottom

of the spout shank threads.

Securely tighten the hex nuts with a wrench.

Channel

Washer

Spout Shank

Hex Nut

Square-Head Bolt

Kohler Co. 5 1025493-2-B

5. Angle Bracket Installation

Install the angle bracket to the bottom of the channel with the

square-head bolt, washer and hex nut.

Hand tighten the hex nut. Do not tighten with a wrench at this

time.

When installing faucet with a stainless steel sink:

Use a level to make sure that the spout is plumb.

Position the channel as needed.

When installing faucet to any other sink:

Adjust the height of the angle bracket so that it rests on the

cabinet ﬂoor.

Secure the angle bracket to the cabinet ﬂoor with two screws

suitable for the material.

Securely tighten the angle bracket hex nut with a wrench.

Angle

Bracket

Square-Head

Bolt

Channel

Washer

Hex Nut Hex Nut

Screws

Channel Cabinet

Floor

1025493-2-B 6 Kohler Co.

6. Handspray Installation

Cover the sprayhead with clean packing wrap to protect it from

damage during installation.

Insert the spray hose into the spout.

Fit the gasket into the valve outlet.

Hold the valve outlet in place with a wrench.

Thread the spray hose to the valve outlet. Hand tighten only.

Remove the packing wrap from the sprayhead.

Open the valve. Water will ﬂow from the sprayhead.

Check for leaks. Adjust as needed.

Test the water ﬂow of the spray control. Water ﬂow will increase

when the handle is pushed lightly inward. Water ﬂow will stop

when the handle is pushed fully inward.

Close the valve.

Gasket

Spray

Hose Channel

Valve Outlet Spout

Sprayhead

Kohler Co. 7 1025493-2-B

7. Checkout Installation

Position a large plastic washer on each side of the pulley.

Fit the pulley over the spray hose, then inside the channel.

Install a plastic cover to each side of the channel.

Secure the plastic covers together with a bolt, washer, and wing

nut.

Hand tighten the wing nut onto the bolt. Do not overtighten.

Pull the sprayhead out of the spout several times to verify

smooth, unrestricted spray hose movement.

Channel

Spray Hose

Pulley

Wing Nut

Washer

Bolt

Large Washer

Cover

1025493-2-B 8 Kohler Co.

8. Water Temperature Adjustment

NOTE: Before adjusting the water temperature, ensure that the

handle is turned all the way to the left. This is the maximum hot

position.

Loosen the setscrew.

Remove the handle and bonnet.

Turn on the water to the maximum temperature by pushing the

valve stem up and turning it clockwise.

Mark the current position of the temperature stop tab (top edge)

on the mounting nut with a marker or pencil.

Lift the indexer and top disc just enough to clear the valve

splines and to allow rotation.

NOTE: Each spline notch is an average 9.5° F (5.3° C) change in

temperature.

Turn the indexer, top disc, and valve stem counterclockwise until

the desired temperature is achieved.

Reinstall the indexer and top disc to the valve, making sure the

top disc is snapped fully into the indexer.

Turn off the water by pulling the valve stem down.

Reinstall the bonnet and handle.

Tighten the setscrew.

Top Disc

Indexer

Handle

Setscrew

Bonnet

Mounting Nut

Splines

Valve Stem

Stop Tab

Kohler Co. 9 1025493-2-B

Guide d’installation

Robinet d’évier de cuisine

Outils et matériels

Merci d’avoir choisi la compagnie Kohler

Nous apprécions votre engagement envers la qualité Kohler. Veuillez

prendre s’il vous plaît quelques minutes pour lire ce manuel avant de

commencer l’installation. Ne pas hésiter à nous contacter en cas de

problème d’installation ou de fonctionnement. Nos numéros de

téléphone et adresse internet sont au verso. Merci encore d’avoir choisi

la compagnie Kohler.

Avant de commencer

Ne pas connecter un lave vaisselle à la sortie du vaporisateur du

robinet.

Respecter tous les codes de plomberie et de bâtiment locaux.

Couper les alimentations d’eau.

Vériﬁer avec soin si l’évacuation ou les tubes d’alimentation pour

déceler tout signe d’endommagement et remplacer si nécessaire.

Pour de nouvelles installations, installer le robinet sur l’évier

avant d’installer ce dernier.

Avant l’installation, déballer le nouveau robinet et l’examiner

pour en déceler tout dommage. Remettre le robinet dans son

emballage de protection jusqu’à être prêt à l’installation.

Tournevis

assortis Mètre ruban

Crayon à

papier Niveau à

bulle

Cléà

molette

Kohler Co. Français-1 1025493-2-B

Andere Handbücher für K-6330

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler 72762T-9MND Bedienungsanleitung

Kohler

Kohler K-702-N1 Bedienungsanleitung

Kohler

Kohler K-6812 Bedienungsanleitung

Kohler

Kohler K-7273 Montageanleitung

Kohler

Kohler K-72777 Montageanleitung

Kohler

Kohler K-45764X Montageanleitung

Kohler

Kohler July 16027 Bedienungsanleitung

Kohler

Kohler K-12177 Bedienungsanleitung

Kohler

Kohler K-T395 Montageanleitung

Kohler

Kohler Iron Works K-7104 Bedienungsanleitung

Kohler

Kohler GANDIDE 11685T-4 Bedienungsanleitung

Kohler

Kohler 10282 Bedienungsanleitung

Kohler

Kohler K-2804 Bedienungsanleitung

Kohler

Kohler Brenham K-1999-8-0 Bedienungsanleitung

Kohler

Kohler K-77767K Montageanleitung

Kohler

Kohler K-8855 Bedienungsanleitung

Kohler

Kohler K-7304 Montageanleitung

Kohler

Kohler Cabriole K-T14640 Montageanleitung

Kohler

Kohler K-72218 Bedienungsanleitung

Kohler

Kohler MAXISPACE K-77217T Bedienungsanleitung

Kohler

Kohler K-T15231 Bedienungsanleitung

Kohler

Kohler Mira Sport Thermostatic Bedienungsanleitung

Kohler

Kohler Kohler K-9245 Montageanleitung

Kohler

Kohler Rada 215 Series Bedienungsanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung