Kohler Kumin K-103K36-SANA-CP Bedienungsanleitung

1557656-2-A

Installation Instructions

Record your model number:

Noter le numéro de modèle:

Anote su número de modelo:

Français, page 20

Español, página 39

Electronic Bathroom Sink Faucet

Thank You for Choosing KOHLER

Need help? Contact our Customer Care Center.

• USA/Canada: 1-800-4KOHLER (1-800-456-4537) Mexico: 001-800-456-4537

•Service parts: kohler.com/serviceparts

•Care and cleaning: kohler.com/clean

•Patents: kohlercompany.com/patents

Warranty

This product is covered under the KOHLER® One-Year Limited Warranty, found at

kohler.com/warranty. For a hardcopy of warranty terms, contact the Customer Care

Center.

1557656-2-A2 Kohler Co.

Tools

Plumbers Puy Sealant Tape 1/8" Drill Bit 1-1/4" to 1-1/2" Hole Bit

3/8" Supply Stop

Before You Begin

WARNING: When using electrical products, basic precautions should

always be followed, including the following:

DANGER: Risk of electric shock. Connect only to a circuit protected by a

Ground-Fault Circuit-Interrupter (GFCI)*.

WARNING: Risk of electric shock. Grounding is required. A qualied

electrician should make all electrical connections.

WARNING: Risk of electric shock. Disconnect the power before servicing.

WARNING: Risk of injury or property damage. Read all instructions

thoroughly before beginning installation.

Kohler Co. 3 1557656-2-A

CAUTION: Risk of fresh water contamination. This faucet contains

backsiphonage protection. To prevent water contamination, do not remove any

internal components.

CAUTION: Risk of product damage. This product contains sensitive

electronic components. Do not store open containers of chemical or cleaning

products near this product. Cleaning rags or sponges must be rinsed with

fresh water before storage.

*Outside North America, this may be known as a Residual Current Device (RCD).

Provide a constant unswitched 120 VAC electrical outlet located below the sink

within 5’ (1.5 m) of the control box.

Follow all local plumbing and building codes.

Turn OFF the water supplies.

This faucet is for a single-hole bathroom sink.

For new installations, install the faucet and drain to the sink before installing the sink.

The faucet shown in this guide may dier from your actual product. The installation

steps still apply.

For installation with a mixing valve, two 3/8" compression supply hoses are required.

1557656-2-A4 Kohler Co.

1. Install the Faucet

Cables

Nut

Metal Washer

Threaded Stud

Rubber Washer

Gasket

Spout

Sensor

Water Inlet Tubing

NOTE: Before drilling the mounting hole, use the following dimensions for proper

placement:

Dimensional Requirements

Mounting Hole: 1-1/4" (32 mm) minimum to 1-1/2" (38 mm) maximum diameter.

Spout to Wall: 1-3/4" (44 mm) minimum distance between the back of the spout

and the wall.

Spout to Sink: 1-1/8" (29 mm) maximum distance between the spout base and the

edge of the sink bowl.

Install the Faucet

Determine the mounting-hole location.

Drill a hole through the mounting surface according to the surface manufacturer’s

instructions.

Install the stud to the boom of the faucet.

Install the gasket to the boom of the faucet.

Insert the faucet, water inlet tubing, and cables through the mounting hole.

Verify that the gasket is in between the escutcheon and the sink/deck surface.

Kohler Co. 5 1557656-2-A

From under the sink, install the rubber washer and metal washer onto the stud.

Thread the nut onto the stud until the faucet is secure.

1557656-2-A6 Kohler Co.

2. Install the Control Box

G1/2 Inlet

Filter

Screen

Mounting Holes

NOTE: Verify that the ex hose can be connected to the supply stop and the control

box inlet before aaching the control box to the wall.

NOTE: Refer to the Specication Sheet to determine the control box installation

location.

Position the control box below the deck and mark the locations for the mounting

holes.

Verify that the sensor cable is below the countertop.

Drill 1/8" (3 mm) pilot holes.

Use the standard wall anchors (provided) depending on your wall material.

Aach the control box to the wall with the arrow pointing upward. Secure with

the two screws (provided).

Unthread the control box screws to remove the cover.

Kohler Co. 7 1557656-2-A

3. Connect the Control Box

Valve

Box

3-Pin

Sensor

cable

Solenoid

Cable

3-Pin

Sensor

Cable

2-Pin

Sensor

Cable

Spout

Wires

2-Pin

Sensor

cable

2-Pin

Power

Connector

2-Pin Power Molex

Connector to

Battery/AC/Hybrid

Battery

2-Pin

Solenoid

Connector

DC-DC Booster Assembly

2-Pin Power

Connector

to control box

Slots

IMPORTANT! The control box and cover have slots for the sensor cables. Use care

not to pinch the sensor cables when installing the cover.

Connect the 2-pin power connector (white) from the DC-DC booster assembly to

the 2-pin power connector (white) of the control box.

Connect the 3-pin sensor cable from the valve cover to the 3-pin sensor cable from

the spout (red, white, and green cables).

Connect the 2-pin sensor cable from the valve cover to the 2-pin sensor cable from

the spout (orange and black cables).

Guide the sensor cables through the slots in the control box.

Loosely secure the cover to the control box for future access.

1557656-2-A8 Kohler Co.

4. Connect the Supplies

Outlet

Inlet

Flex Hose Tube

From Spout

Supply Stop

Flex Hose

Inlet Connections

Connect the ex hose to the supply stop.

Place a bucket under the supply stop and turn ON the water supply.

Slowly open the supply stop to ush debris.

Turn OFF the water.

Connect the provided ex hose from the supply stop to the control box.

Outlet Connections

Verify that the tube from the spout is the appropriate length to reach the control

box. Cut the tube if necessary. Remove any burrs and sharp edges.

Insert the tube into the ing (control box outlet end) until the tube stops.

Verify that the tube is secure.

Kohler Co. 9 1557656-2-A

5. Install the Mixing Valve (If Included)

Outlet

Hot Cold

Lock Screw

3/8" Compression

Adjustment plate to

set water temperature.

Flex

Hose

3/8"

G1/2

3/8"

If a mixing valve is included with your product, connect the ex hoses as shown.

Aach the provided ex hose to the control box inlet and the outlet of the mixing

valve.

Use a 3/8" compression connection (not provided) to aach the cold supply to the

cold inlet on the mixing valve (marked cold on the adjustment plate).

Use a 3/8" compression connection (not provided) to aach the hot supply to the

hot inlet on the mixing valve (marked hot on the adjustment plate).

Temperature Adjustment

Loosen the lock screw on the adjustment plate.

Rotate the adjustment plate to adjust the temperature.

Retighten the lock screw.

1557656-2-A10 Kohler Co.

Inhaltsverzeichnis

Sprachen:

Andere Kohler Sanitärprodukte Handbücher

Kohler

Kohler Triton Rite-Temp K-T6910-2A Bedienungsanleitung

Kohler

Kohler C3-150 Bedienungsanleitung

Kohler

Kohler K-11797T Bedienungsanleitung

Kohler

Kohler K-7437 Bedienungsanleitung

Kohler

Kohler CUFF 37310M-4 Bedienungsanleitung

Kohler

Kohler K-4774 Montageanleitung

Kohler

Kohler Botticelli K-2333 Bedienungsanleitung

Kohler

Kohler K-8724 Bedienungsanleitung

Kohler

Kohler Mira Azora Bedienungsanleitung

Kohler

Kohler K-1112 Montageanleitung

Kohler

Kohler TOOBI 8965IN-9FP Bedienungsanleitung

Kohler

Kohler 7098M Bedienungsanleitung

Kohler

Kohler PATIO Series Bedienungsanleitung

Kohler

Kohler Kumin K-104K37-SANA-CP Bedienungsanleitung

Kohler

Kohler Stillness 954T-4 Bedienungsanleitung

Kohler

Kohler K-5814 Montageanleitung

Kohler

Kohler K-5797 Montageanleitung

Kohler

Kohler K-29221T Series Bedienungsanleitung

Kohler

Kohler K-332 Bedienungsanleitung

Kohler

Kohler K-6945 Bedienungsanleitung

Kohler

Kohler 9076 Bedienungsanleitung

Kohler

Kohler K-T16225 Montageanleitung

Kohler

Kohler CLICKER DRAIN 7119A Bedienungsanleitung

Kohler

Kohler K-12286-4 Montageanleitung

Beliebte Sanitärprodukte Handbücher anderer Marken

Weka

Weka 506.2020.00E Betriebsanleitung

American Standard

American Standard DetectLink 6072121 Bedienungsanleitung

Uponor

Uponor Contec TS Bedienungsanleitung

Pfister

Pfister Selia 49-SL Bedienungsanleitung

Fortis

Fortis VITRINA 6068700 Bedienungsanleitung

Maxxus

Maxxus MX-M206-01 Bedienungsanleitung

Viega

Viega Prevista Pure 8512 Bedienungsanleitung

Viega

Viega Prevista Dry 8522.33 Bedienungsanleitung

Sanela

Sanela Lema SLP 59RB Bedienungsanleitung

Elkay

Elkay EDF15AC Installationshandbuch

Hans Grohe

Hans Grohe AXOR Citterio E 36702000 Handbuch

baliv

baliv WT-140 Bedienungsanleitung

BELLOSTA

BELLOSTA romina 0308/CC Bedienungsanleitung

Bristan

Bristan PS2 BAS C D2 Verdrahtungsschema

Crosswater

Crosswater Heir 18-31 Bedienungsanleitung

Sanela

Sanela SLVN 07 Bedienungsanleitung

Glacier bay

Glacier bay DORIND HD67478W-6001 Montageanleitung

Sterling Plumbing

Sterling Plumbing C741 Bedienungsanleitung