La Crosse Technology WS-9014TWC Bedienungsanleitung

WS-9014TWC

Wireless 433 MHz

Temperature Station

Instruction Manual

TABLE OF CONTENTS

Topic Page

Inventory of Contents 3

Quick Setup 4-8

Detailed Setup Guide

Battery Installation 9-10

Setting the Time 11-12

Selecting Units of

Measurement

12-13

Features

Minimum and Maximum

Temperatures

Resetting Minimum and

Maximum Temperatures

Additional remote

temperature sensors

(optional)

14-17

Mounting 17-18

Troubleshooting 19-21

Maintenance and Care 21

Specifications 22-23

Warranty Information 24-27

INVENTORY OF CONTENTS

1. The indoor temperature station (Figure

2. The remote temperature sensor (TX6U)

and mounting bracket. (Figure 2)

3. 3 each, 1/2” Philips screws.

4. One strip of double sided adhesive tape.

5. Instruction Manual and Warranty Card.

Figure 1

Figure 2

ADDITIONAL EQUIPMENT

(not included)

1. 1 Philips screwdriver.

2. 2 Fresh AA 1.5V batteries.

3. 2 Fresh AA 1.5V batteries.

QUICK SETUP

Hint: Use good quality Alkaline

Batteries and avoid rechargeable

batteries.

1. Have the indoor

temperature station and

remote temperature sensor

3 to 5 feet apart.

2. Batteries should be out of

both units for 10 minutes.

3. Place the batteries into the

remote temperature

sensor first then into the

indoor temperature station.

(All remote temperature sensors must be

started before the indoor temperature

station)

4. DO NOT PRESS ANY

BUTTONS FOR 10

MINUTES.

In this time the indoor temperature

station and remote temperature sensor

will start to talk to each other and the

display will show both the indoor

temperature and an outdoor temperature.

If the indoor temperature station does

not display both temperatures after the

10 minutes please retry the set up as

stated above. After both indoor and

outdoor temperatures are displayed for

10 minutes you can place your remote

temperature sensor outdoors and set

your time.

The remote temperature sensor should

be placed in a dry, shaded area. The

remote temperature sensor has a range

of 80 feet. Any walls that the signal

will have to pass through will reduce

distance. An outdoor wall or window

will have 20 to 30 feet of resistance and

an interior wall will have 10 to 20 feet

of resistance. Your distance plus

resistance should not exceed 80 ft. in a

straight line.

NOTE: Fog and mist will not harm

your remote temperature sensor but

direct rain must be avoided.

To complete the set up of your indoor

temperature station after the 10 minutes

have passed please follow the steps

below.

1. Press and hold the “SET” button

for 5 seconds.

Note: A “12h” or “24h” will appear

on the top line. (“12h” for AM/PM,

“24h” for military time)

a. To change between “12h”

and “24h” press and

release the “MIN/MAX”

button.

b. When you have your

choice shown on the

display press and release

the “SET” button once.

2. Degree Fahrenheit will now show.

a. To change between

Fahrenheit and Celsius,

press and release the

“MIN/MAX” button.

b. When you have your

choice shown on the

display press and release

the “SET” button once.

3. An hour will now be flashing.

a. Press and release the

“MIN/MAX” button until

the correct hour is shown.

Note: When in the 12h mode

there is “PM” displayed under

the word TIME when in the

PM hours. During the AM

hours this area will be blank.

b. When the correct hour is

shown, press and release

the “SET” button once.

4. A minute will now be flashing.

a. Press and release the

“MIN/MAX” button until

the correct minutes are

displayed.

Press and release the SET button

once more and you are done.

DETAILED SETUP GUIDE

I. BATTERY INSTALLATION

A. REMOTE TEMPERATURE

SENSOR

1. Remove the mounting bracket.

2. Remove battery cover

3. Observing the correct polarity, install

2 AA batteries—make sure they do not

spring free, or start-up problems may

occur. Replace cover.

B. INDOOR TEMPERATURE

STATION

Note: After the batteries are installed, DO

NOT press any buttons. This may interfere

with the signals, causing temperatures to

1. Remove the battery cover on the

backside. To do

this, push up and

pull out.

2. Observing the

correct polarity,

install 2 AA

batteries.

3. Replace battery

cover.

4. Wait 10 minutes

or until both the indoor and outdoor

temperatures are shown on the indoor

temperature station.

Inhaltsverzeichnis

Andere La Crosse Technology Wetterstation Handbücher

La Crosse Technology

La Crosse Technology 512-807 Technisches Datenblatt

La Crosse Technology

La Crosse Technology WS-9060U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-7013U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology V10v2 Bedienungsanleitung

La Crosse Technology

La Crosse Technology 327-1414Wv2 Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology 308-1451 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WEATHER DIRECT WD-3103U Bedienungsanleitung

La Crosse Technology

La Crosse Technology C85845V3 Bedienungsanleitung

La Crosse Technology

La Crosse Technology The Weather Channel WS-8500TWC-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology S81120v2 Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-1516U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9118U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-9009-IT Betriebsanleitung

La Crosse Technology

La Crosse Technology WS-9077U-IT Abmessungen

La Crosse Technology

La Crosse Technology WS-7034U Bedienungsanleitung

La Crosse Technology

La Crosse Technology S82967 Abmessungen

La Crosse Technology

La Crosse Technology WS-7034U-IT Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS6890 Bedienungs- und Wartungshandbuch

La Crosse Technology

La Crosse Technology C84428 Bedienungsanleitung

La Crosse Technology

La Crosse Technology C75747-AU Bedienungsanleitung

La Crosse Technology

La Crosse Technology C79790 Abmessungen

La Crosse Technology

La Crosse Technology WA-1030U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WD-3102U Bedienungsanleitung

La Crosse Technology

La Crosse Technology WS-7220U-IT Bedienungsanleitung

Beliebte Wetterstation Handbücher anderer Marken

Auriol

Auriol AHFL 433 A1 Bedienungsanleitung

NexSens

NexSens G2-HYDROMET Bedienungsanleitung

Hyundai

Hyundai WS 2202 Bedienungsanleitung

IROX

IROX HBVR761 UV-X Bedienungsanleitung

ADE

ADE WS 1711 Bedienungsanleitung

Auriol

Auriol z29592 Bedienungsanleitung

Auriol

Auriol 296289 Bedienungsanleitung

Hyundai

Hyundai WS 2266 Bedienungsanleitung

Ventus

Ventus W177 Bedienungsanleitung

National Geographic

National Geographic VA Colour RC Bedienungsanleitung

Renkforce

Renkforce 1208067 Bedienungsanleitung

Levenhuk

Levenhuk Discovery Report WA40 Bedienungsanleitung

Instant Transmission

Instant Transmission MA 10410 Bedienungsanleitung

Lutron Electronics

Lutron Electronics PHB-318 Bedienungsanleitung

WAREMA

WAREMA EWFS Weather station eco Bedienungsanleitung

TFA

TFA 30.3013.IT Bedienungsanleitung

Alecto

Alecto WS-1200 Bedienungsanleitung

Oregon Scientific

Oregon Scientific RMR966PA Bedienungsanleitung