Larson Electronics HAL-RSL Series Bedienungsanleitung

HAL-RSL Series

Explosion Proof Colored LED Rope Light

Instruction Manual

Thank you for your purchase of the Larson Electronics HAL-RSL Series LED Rope Light.

WARNING

TO AVOID THE RISK OFFIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,

INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL

APPLICABLE ELECTRICAL CODES.

TO AVOID ELECTRIC SHOCK:

•BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.

•PRODUCT MUST BE CONNECTEDTOA WIRING SYSTEM WITHAN EQUIPMENT-GROUNDING

CONDUCTOR.

TO AVOID EXPLOSION:

•MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.

•ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS

ATMOSPHERE.

•DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT

NAMEPLATE.

•DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR

DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.

•ALL FASTENERS SHOULD BE PROPERLY SEATED.

The HAL-RSL Series from Larson Electronics is a Round 2-wire LED Rope Light that is rated for use in Class I Division 2

suitable for marine applications, including boat docks, ship yards and perimeter lighting systems in hazardous area

locations. The weatherproof luminary is available in many different lengths and emits a beam of light available in red, blue,

green, amber or purple output.

Mounting

We strongly encourage a licensed electrician install this product, in all locations, especially in outdoor areas where

weatherproofing may be required, and in hazardous area locations. Always follow all applicable local and national

electrical and building code when installing.

The rope light can be mounted in many different ways, such as with mounting clips or hangars, and should be mounted a

minimum of 12 feet above the hazardous area, such as in a tunnel or paint spray booth. Mounting specifics are left to the

end user, as there are many possible applications. Some models will feature a junction box with seal-offs and surface

mounting brackets that will also need to be mounted to a flat surface, such as a wall or ceiling. Be sure lights are secure

and mounted in a way that is capable of supporting the load, near enough to supply power, and follow all applicable local

and national electrical code when installing.

Wiring

We strongly encourage a licensed electrician install this product, in all locations, especially in outdoor areas where

weatherproofing may be required, and in hazardous area locations. Always follow all applicable local and national

electrical and building code when installing.

Warning: Check product label for correct input voltage!

Attach supply line wires to the appropriate light fixture wires as shown

in the applicable diagram 

Secure each pair of wires according to the diagram. Utilize a junction box or

similar device and take precautionary steps for weatherproofing all connections

if installed in a location where water may come in contact with the unit. Ensure the

unit is properly grounded and that wiring is done according to all local and national

electrical/building codes.

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 1of 2

Larson Electronics, LLC Phone: (877) 348-9680 Fax: (903) 498-3364 www.larsonelectronics.com 2of 2

HAL-RSL Series

THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.

SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT

SAL[email protected] OR BY PHONE AT 1-877-348-9680 FOR FURTHER ASSISTANCE.

PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.

MAINTENANCE

There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the

fixture for proper function.

•Disconnect power running to the lamp and be sure the fixture iscool to the touch.

•Use a non-abrasivecleaning solution to clean the tubing.

•Perform visual, mechanical and electrical inspections on a regular basis. We recommend routine

checks to be made at least on a yearly basis. Frequency of use and environment should determine

this. It is recommended to follow an Electrical Preventive Maintenance Program as described in NFPA

70B: Recommended practice for Electrical Equipment.

USE AND CARE

Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.

Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of

children when not in use.Inspect for good working condition prior to storage and before re-use.

REPLACEMENT PARTS

The HAL-RSL Series is designed to provide years of reliable performance. Should the need for replacement parts arise,

please contact Larson Electronics.

Inhaltsverzeichnis

Andere Larson Electronics Beleuchtungsausrüstung Handbücher

Larson Electronics

Larson Electronics EPL-48-2L-T12VHO Bedienungsanleitung

Larson Electronics

Larson Electronics EPEXC-1C-10.3-GFI-50C-BCE Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-16C-1MLED-50 Bedienungsanleitung

Larson Electronics

Larson Electronics ORS-120-8M-4X150W-LED Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-SL-10-20X-LED Bedienungsanleitung

Larson Electronics

Larson Electronics GVP-48-2L-LED-48VDC-R2 Bedienungsanleitung

Larson Electronics

Larson Electronics LEDLB-12E-F-M-1227 Bedienungsanleitung

Larson Electronics

Larson Electronics IND-HVAC-ACS-R1-DP-24-2L-XB Bedienungsanleitung

Larson Electronics

Larson Electronics LED18W-PAR36 Bedienungsanleitung

Larson Electronics

Larson Electronics IIND-DBL-36-1L-R1-120V Bedienungsanleitung

Larson Electronics

Larson Electronics VFD-1P-220.240-1HP-7A-DCM Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-LED-50W-RT-JB2 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-FL26-LED Series Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-DLC Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-MPM-150LED Handbuch

Larson Electronics

Larson Electronics EPL-PM-1X30LED-6XMB-10 Bedienungsanleitung

Larson Electronics

Larson Electronics C1D1-2 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-AMB-150LED-50-140DB Bedienungsanleitung

Larson Electronics

Larson Electronics LEDHWP-900-DNMS Bedienungsanleitung

Larson Electronics

Larson Electronics HAL-LI-48-2X50LED Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-DL-12-25-1523 Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-HB-150LED-RT-IBSC Bedienungsanleitung

Larson Electronics

Larson Electronics EPL-QP-1X150RT Bedienungsanleitung

Larson Electronics

Larson Electronics MMLP-1MLED-12P Bedienungsanleitung

Beliebte Beleuchtungsausrüstung Handbücher anderer Marken

Brizo

Brizo 8SP-MU-4 Bedienungsanleitung

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Bedienungsanleitung

IKEA

IKEA BJÖRKSPIREA Bedienungsanleitung

Laserworld

Laserworld Evolution Series ES-400RGB Bedienungsanleitung

Alien

Alien RG STAR Bedienungsanleitung

EuroLite

EuroLite LED B-40 Bedienungsanleitung

Qazqa

Qazqa Suplux SL 3 Black 103062 Bedienungsanleitung

Commercial Electric

Commercial Electric 54568141 Bedienungsanleitung

CREE LIGHTING

CREE LIGHTING 304 Series Bedienungsanleitung

Goobay

Goobay 49867 Bedienungsanleitung

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Bedienungsanleitung

Alkalite

Alkalite Krypton KT-81 Bedienungsanleitung

Clas Ohlson

Clas Ohlson GU10 Bedienungsanleitung

DTS

DTS DELTA 10 F Bedienungsanleitung

ring

ring Solar Steplight Bedienungsanleitung

One Stop Gardens

One Stop Gardens 57696 Montageanleitung

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Bedienungsanleitung

SIREM

SIREM Swimeo A2 Bedienungsanleitung