Lippert Curt 60654 Bedienungsanleitung

CURTMFG.COM •PRODUCT SUPPORT: 877.287.8634 •60654-INS-RA •01/24/2022 •ECN9271 •PAGE 1

Product Registration and Warranty

CURT stands behind our products with

industry-leading warranties. To get copies

of the product warranties, register your

purchase or provide feedback, visit:

warranty.curtgroup.com/surveys

Weight Carrying Capacity

Gross trailer weight (GTW) 30,000 lbs.

Tongue weight (TW) 7,500 lbs.

INSTALLATION MANUAL 60654

Tools Required

Allen key, 4mm --

Level of Difficulty

Easy

Installation difficulty levels are based on time

and effort involved and may vary depending on

the installer level of expertise, condition of the

vehicle and proper tools and equipment.

WARNING

Make sure the trailer ball assembly fully seats in the gooseneck and can be fully locked by the

pins of your gooseneck hitch.

Use of any pin other than what is provided by the manufacturer

could be a serious safety hazard and will void the warranty.

Ensure that the safety chains operate freely around the trailer ball system

and do not become entangled in the trailer ball system. Check for adequate

turning clearance between the front of all trailers and the truck cab.

If the ball is ever able to move with minimal force by hand more than five degrees

from the vertical position, the product must be replaced. Use of a heavily worn or

damaged trailer ball assembly may result in the trailer becoming separated from

the vehicle. Consult CURT Product Support if you have any questions.

Before every use, be sure the snap ring on the pivot pin

of the trailer ball assembly is in place and properly seated.

Immediately discontinue product use if the snap ring is missing on the end of the trailer ball

pivot pin or if the trailer ball pin has backed partially out of the trailer ball assembly.

When using the trailer ball assembly in a gooseneck designed for square shank

hitches, ensure that the shank adaptors are installed and hardware is tightened.

Parts List

Item Qty Description

1 1 Trailer ball assembly

2 1 Gooseneck hitch cap

3 2 Shoulder bolt, M6 x 11, 12mm

4 2 Shank adaptor

5 1 Carry Case

Product Photo

Torque Speciﬁcations

M6 bolt 6 ft-lbs.

Use above torque setting unless otherwise noted

CURTMFG.COM •PRODUCT SUPPORT: 877.287.8634 •60654-INS-RA •01/24/2022 •ECN9271 •PAGE 2

ASSEMBLY

Parts List

Item Qty Description

1 1 Trailer ball assembly

2 1 Gooseneck hitch cap

3 2 Shoulder bolt, M6 x 11, 12mm

4 2 Shank adaptor

5 1 Carry Case

Step 1

Disengage the lock pins and remove ball or any other accessory.

Place the round shank of the ball into the cylinder with the directional

arrow pointing towards the front of the vehicle and engage the

lock pins. Make sure that the pins fully engage the round shank

of the extender and pass through the cylinder completely.

NOTICE

When installing in a gooseneck designed for square shank hitches,

ensure that the shank adaptors (#4) are installed and hardware

is tightened to the torque specifications listed on page one.

Step 2

Grease the trailer ball assembly (#1) using the grease zerk

located at the front of the RockerBall™. Grease prior to

initial use and once every 3 months or 3,000 miles

of use with a high quality molybdenum-based grease.

DANGER

Failure to grease the trailer ball assembly may lead

to failure and can result in serious injury or death.

The RockerBall™is adequately lubricated when

grease can be seen in the areas marked below.

NOTICE

Visit www.curtmfg.com for a full-color copy of this instruction

manual, as well as helpful videos, guides and much more!

Before you begin installation, read all instructions thoroughly.

Proper tools will improve the quality of

installation and reduce the time required.

Periodic inspection of your product should be performed to

ensure all hardware and / or components remain secure.

To help prevent damage to the product or vehicle,

refer to the specified torque specifications when

securing hardware during the installation process.

Insert the RockerBall™assembly with the directional arrow pointing

towards the front of the vehicle. If the arrow is facing the rear of

the vehicle the performance of the RockerBall™will be diminished.

RockerBall™should be greased prior to initial

use and periodically as described below

Ensure the trailer ball size matches the trailer coupler.

If they do not, the trailer could become uncoupled.

Andere Lippert Autozubehör Handbücher

Lippert

Lippert 45940-85 Bedienungsanleitung

Lippert

Lippert 2000 Series Bedienungsanleitung

Lippert

Lippert Power Steps 2.0 Bedienungsanleitung

Lippert

Lippert ARIES 2500207 Bedienungsanleitung

Lippert

Lippert ARIES S224050 Bedienungsanleitung

Lippert

Lippert Power Step 2.0 Bedienungsanleitung

Lippert

Lippert 2021000090 Montageanleitung

Lippert

Lippert Ground Control 3.0 Bedienungsanleitung

Lippert

Lippert Thin Shade 806621 Montageanleitung

Lippert

Lippert LatchXtend RV Door Handle Bedienungsanleitung

Lippert

Lippert FLYSCREEN N Series Bedienungsanleitung

Lippert

Lippert TI-276 Bedienungsanleitung

Lippert

Lippert Vela Pop Up Bedienungsanleitung

Lippert

Lippert SMART BED UNIVERSAL KIT Bedienungsanleitung

Lippert

Lippert JT's Strong Arm Montageanleitung

Lippert

Lippert Promaster Bedienungsanleitung

Lippert

Lippert Tire Linc 2020106863 Montageanleitung

Lippert

Lippert Level-up Bedienungsanleitung

Lippert

Lippert 10570 Gebrauchsanweisung

Lippert

Lippert Stargazer Spirit XTR Bedienungsanleitung

Lippert

Lippert THEATER SEATING Gebrauchs- und Pflegehandbuch

Lippert

Lippert Curt 18150 Bedienungsanleitung

Lippert

Lippert RV ENTRY DOOR Bedienungsanleitung

Lippert

Lippert Project 2000 Sliding Step Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung