Mazda 0000-8G-K02 Bedienungsanleitung

AS 090-M11357cmc1105RevA

Page 1 of 4

Genuine Accessories

Installation Instructions

Part Number

0000-8G-K02

Applicable Models:

2004 Mazda RX8 Aero

Package Contents

Front Mask

U-Nut (Qty. 8)

Tools Required

Stubby Phillips

Screwdriver

Hood Cover (Qty. 1)

Snap Head Screw (Qty. 8) Front End Cover (Qty. 1)

0Before Installation

A. Area to be covered by mask must be clean. It is recommended that you wash and wax vehicle prior to installation.

B. Both vehicle and mask must be completely dry prior to installation. If moisture under mask is allowed to dry on

vehicle, paint may cloud.

C. Any repainted surfaces in contact with mask must be allowed to cure completely. Consult paint manufacturer or

repair facility if you are not sure.

1Install Hood Cover

A. With hood open, stretch hood cover (A)

onto hood, pulling each side one or two

inches at a time, until corners fit snugly.

Install hooks on ends of straps (B) into

corresponding holes in hood. Pull

evenly on ends of adjustable straps (B)

until tight. Secure loose ends in elastic

loops.

Washer (Qty. 8)

Page 2 of 4

AS 090-M11357cmc1105RevA

2Remove wheel well fasteners

A. Using stubby phillips screwdriver, remove five plastic

fasteners along front edge of both front wheel wells.

A. In both front wheel wells, lift wheel well liner to reveal holes.

B. Slip u-nuts (C) over top two and bottom two holes in metal edge,

making sure that holes are aligned.

C. Release liner to its original position. Using a stubby phillips

screwdriver, install washer (D) and snap head screws (E) into top

two and bottom two holes in each wheel well. Reinstall

original fastener into unoccupied middle hole.

3Install wheel well hardware

5Install wheel well

attachments

A. Press snaps (K) onto snap head screws

(E) in both front wheel wells.

GFG

4Install upper attachments

A. With hood open, lay front end cover over front of vehicle. On both sides of

vehicle, slide pockets (F) over front corners of fenders. Care

should be taken to prevent ripping of pockets (F).

B. Attach clips (G) to edge of fender rails.

C. On both sides of vehicle, insert pads (H) in slot under headlights.

D. Attach clips (J) to back inside edge of metal at center of vehicle under hood.

Page 3 of 4

AS 090-M11357cmc1105RevA

7Install bottom attachments

8Post Installation Inspection

A. Close hood and check alignment between hood

cover and front end cover along seam (between

fender and hood). If adjustment is necessary, adjust

the hood cover by adjusting the hood cover straps.

Refer to step 1.

B. If mask should flap due to high speed or wind

conditions, adjust or remove mask completely.

9Care and Cleaning

A. Always remove mask before washing vehicle.

B. Hand clean mask using mild soap, rinse thoroughly with

clean water and line dry completely. Do not machine dry!

C. Use Mazda Vinyl/Leather Protectant (or equivalent) to

preserve color and finish.

D. WARNING: Running up on curb will damage this product.

Manufacturer will not be responsible for damage to product

due to accident or misuse.

Place in vehicle glove compartment.

A. Attach clips (O) to back edge of facia in fog light and air intake areas. Attach clips (P) and elastics with hooks (Q) to back

edge of bumper facia.

OPPP

10x

6Install air intake attachments

A. Insert pads (L) into slot located between edge of front facia and top edge of grille area. Insert velcro loop (M) into nearby hole

in grille area and attach velcro hook (N) located at underside edge of bumper facia.

Andere Mazda Autozubehör Handbücher

Mazda

Mazda Auto-Dimming Mirror Bedienungsanleitung

Mazda

Mazda CX-5 Bedienungsanleitung

Mazda

Mazda Connect Bedienungsanleitung

Mazda

Mazda 0000 8C Z01 Bedienungsanleitung

Mazda

Mazda 0000-8L-K01 Bedienungsanleitung

Mazda

Mazda 0000-8C-Z05 Bedienungsanleitung

Mazda

Mazda 0000 81 L25 Bedienungsanleitung

Mazda

Mazda 0000-8E-G01 Bedienungsanleitung

Mazda

Mazda CX-3 Bedienungsanleitung

Mazda

Mazda 0000-8L-G03A Bedienungsanleitung

Mazda

Mazda GS2A -V1-132 Bedienungsanleitung

Mazda

Mazda BDEL-V7-410 Bedienungsanleitung

Mazda

Mazda CX-9 Bedienungsanleitung

Mazda

Mazda 6 GJ 2.2 D 2012 Bedienungsanleitung

Mazda

Mazda MVG 4507 F Bedienungsanleitung

Mazda

Mazda C830-V7-050A Bedienungsanleitung

Mazda

Mazda Highbay BY007P Bedienungsanleitung

Mazda

Mazda GENUINE SIDE UNDER SPOILER Bedienungsanleitung

Mazda

Mazda GENUINE ACCESSORIES Bedienungsanleitung

Mazda

Mazda 0000-8E-N31 Bedienungsanleitung

Mazda

Mazda 0000-8E-R10 Bedienungsanleitung

Mazda

Mazda KA0G V1 370 Bedienungsanleitung

Mazda

Mazda 0000-8L-R02 Bedienungsanleitung

Mazda

Mazda PROTEGE 5 Bedienungsanleitung

Beliebte Autozubehör Handbücher anderer Marken

James Baroud

James Baroud Odyssey Bedienungsanleitung

Motorola

Motorola i50sx Bedienungsanleitung

Yakima

Yakima 9MM STANDARD BIKE MOUNT Bedienungsanleitung

Feniex

Feniex T3 Bedienungsanleitung

Kia

Kia E8300-4D000 Bedienungsanleitung

Brink

Brink 756843 Bedienungsanleitung

Whispbar

Whispbar K085W Bedienungsanleitung

v.link

v.link CI-VL2-PC-HSD Bedienungsanleitung

Viking

Viking Stack-Rack Kurzanleitung zur Einrichtung

Aries

Aries 203015 Bedienungsanleitung

Choetech

Choetech AT0005 Bedienungsanleitung

ZZ2

ZZ2 ZZAIR-PRO Bedienungsanleitung

Holman

Holman 4A80L Bedienungsanleitung

Thule

Thule 2075 Bedienungsanleitung

Motorola

Motorola T325 Bedienungsanleitung

TAUBENREUTHER

TAUBENREUTHER 16-3950 Installationsanleitung

DV8

DV8 FBJL-02 Bedienungsanleitung

Prorack

Prorack K1163 Bedienungsanleitung