Mercia Garden Products 02HIDE0705-V1-PEFC Gebrauchsanweisung

P 1

02HIDE0705-V1-PEFC

Hideout 7x5 playhouse

2mm Drill bit

x2 Winter = High Moisture = Expansion

Summer = Low Moisture = Contraction

All building’s should be

erected by two adults

For ease of assembly, you

MUST pilot drill all screw

holes and ensure all screw

heads are countersunk.

For assistance please contact customer care on: 01636 880514

Mercia Garden Products Limited,

Sutton On Trent,

Newark,

Nottinghamshire,

NG23 6QN

www.merciagardenproducts.co.uk

CAUTION

Every eort has been made during the

manufacturing process to eliminate the

prospect of splinters on rough surfaces of the

timber. You are strongly advised to wear gloves

when working with or handling rough sawn

timber.

**Protim Aquatan T5 (621)**

Your building has been treated with Aquatan.

Aquatan is a water-based concentrate which is diluted with water, the building has been treated by the

correct application of Aquatan solution and then allowed to dry.

Aquatan is a decorative nish to colour the wood, which is applied industrially to timber fence panels and

garden buildings.

Aquatan undiluted contains: boric acid, sodium hydroxide 32% solution, aqueos mixture of sodium dioctyl

sulphosuccinat and alcohols: 2, 4, 6-trichlorophenol.

Please retain product label and instructions for future reference

General Instructions

BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY

- Check the pack and make sure you have all the parts listed.

- When you are ready to start, make sure you have the right tools at hand (not supplied)

including a Phillips screwdriver, Stanley knife, wood saw, step ladder and drill with 2mm

bit.

- Ensure there is plenty of space and a clean dry area for assembly.

TIMBER

As with all natural materials, timber can be aected during various weather conditions.

For the duration of heavy or extended periods of rain, swelling of the wood panels may

occur. Warping of the wood may also occur during excessive dry spells due to an interior

moisture loss. Unfortunately, these processes cannot be avoided but can be helped. It is

suggested that the outdoor building is sprayed with water during extended periods of

warm sunshine and sheltered as much as possible during rain or snow.

Our buildings are pre treated with a water based treatment**; this only helps to protect

the product during transit and for upto 3 months against mould. To validate your

guarantee and ensure longevity of the product, it is ESSENTIAL the building is treated

with a wood preserver within the rst three months of assembly and thereafter in

accordance with the manufactures recommendations. Care must be taken to ensure

the product is placed on a suitable base.

BUILDING A BASE

When thinking about where the building and base is going to be constructed:

Ensure that there will be access to all sides for maintenance work and annual

treatment.

Ensure the base is level and is built on rm ground, to prevent distortion. Refer to

diagrams for the base dimensions, The base should be slightly smaller than the external

measurement of the building, i.e. The cladding should overlap the base, creating a run

o for water. It is also recommended that the oor be at least 25mm above the

surrounding ground level to avoid ooding.

TYPES OF BASE

- Concrete 75mm laid on top of 75mm hard-core.

- Slabs laid on 50mm of sharp sand.

Whilst all products manufactured are made to the highest standards of Safety and in

the case of childrens products independently tested to EN71 level, we cannot accept

responsibility for your safety whilst erecting or using this product.

Refer to the instructions pages for you specic product code

For ease of assembly, you

will need a tape measure to

check dimensions of

components.

WARNING: Only for domestic use

Not suitable for children under 36 month

To be used under direct supervision of an adult

P 2

02HIDE0705-V1-PEFC

Overall Dimensions:

Width = 2243mm

Depth = 1505mm

Height = 2020mm

Base Dimensions:

Width = 2082mm

Depth = 1448mm

Please retain product label and instructions for future reference

Before assembly

please make sure you have a

suitable base ready to erect your

building

MADE IN GREAT BRITAIN

123

Window Side

Door Gable Plain Gable Short Window side

Floor Large Roof Sheet

1481 x 1400mm

568

Door

Fixing Kit

Roof Eave - 1481mm x2

Roof Support Bar - 1448mm

Fascia - 1400mm x2

Fascia - 990mm x2

Door Stop

Wooden

door handle

19 21

Felt

Antique Hinge x3

Small Roof Sheet

1481x990mm

AI-02HIDE0705-V1DG AI-02HIDE0705-V1PG AI-02HIDE0705-V1WS AI-02HIDE0705-V1SWS

AI-02HIDE0705-V1F

PI-03-0340 PI-03-0339

AI-02HIDE0705-V1D

FS2828-1481MM

F2744-1448MM

S1295-1420MM

PLY TRIANGLE

PI-04-0024

PI-07-0113

Window strip - 102mm x14

Window strip - 704mm x8

Window strip - 460mm x4

Window strip - 501mm x4

S1227-102MM

S1227-704MM

S1227-460MM

S1227-501MM

S1295-1010MM

Window strip - 269mm x2

S1227-269MM

50mm Screw x 12

40mm Screw x 14

Felt Tacks x 80

20mm Screw x 60

30mm Screw x 31

60mm Screw x 2

30mm Black Screw x 14

Nail Bag

P 3

Please retain product label and instructions for future reference

Remove transportation blocks from the bottom of each

panel before beginning assembly. Each Panel should have

two blocks.

Pre-Assembly

Step 1

Lay the door gable face up on a at

surface, place the door within the door

aperture (support the door from

underneath until it is ush with the

boards). Position the door so that you

have a 12mm gap from the door to the

door gable on all four sides.

Useful tip: Use a12mm thick piece of

timber from your xing kit within the gaps

to ensure the door does not move.

Once you are happy the door is in the

correct position place a hinge at the top,

middle and bottom of the door, ensuring

the screws will go into the framing and

using 30mm black screws x the hinge to

the door and the door gable. Ensure to

pre-drill the holes rst.

*Please note that the door can be hung

from either side to suit your needs.

14x 30mm black screws

Pre drill

hole

30mm

screw

12mm

Step 2

Place the Floor (No. 5) on a rm and level base,

ensure base has suitable drainage free

from areas where standing water can

collect. (See front page on base

requirements).

Step 3

Fix the corners of the Plain Gable (No. 2)

and the Window Panel (No. 4) with 50mm

screws at as shown in diagram.

Position the panels so there is equal

spacing between the oor and cladding

on all 4 sides.

3x50mm screws

Pre drill

hole

50mm

screw

P 4

For assistance please contact customer care on: 01636 880514

Mercia Garden Products Limited,

Sutton On Trent,

Newark,

Nottinghamshire,

NG23 6QN

www.merciagardenproducts.co.uk

Please retain product label and instructions for future reference

Step 4

Fix Door Gable (No. 1) and the Short

Window Panel (No. 3) using the same

method shown previously.

9x50mm screws

Pre drill

hole

50mm

screw

Step 6

Fix a Roof Eave (No. 9) to each roof sheet

(No. 6 &No. 7) using 30mm screws.

Position the roof sheets on the building

and x to the roof support bar the rail

guard and the sides of the building using

30mm screws.

30x30mm Screws

Pre drill

hole

30mm

screw

Step 5

The Roof bearer (No.10) ts into position

between the gables and is xed into

postion as shown.

2x60mm screws

Pre drill

hole

60mm

screw

30mm

screw

Step 7

Once the roof is tted, secure the building to

the Floor xing the panels onto the oor using

50mm screws in alignment with the oor joists.

18x50mm Screws

Pre drill

hole

50mm

screw

P 5

Please retain product label and instructions for future reference

Step 9

Fix the Fascias (No. 11 & No. 12) using

40mm screws. Pre drill holes to avoid

splitting.

Ensure to trap the felt between the fascia

and building.

14x40mm Screws

Pre drill

hole

40mm

screw

Step 10

Use the Window strips (No. 13, No. 14,

No. 15, No. 16 & No. 17) to fully surround

the windows using 20mm screws as

shown. Pre drill holes to avoid splitting.

2x20mm screws per Window strip.

56x20mm Screws

Pre drill

hole

20mm

screw

13 14

Step 8

Cut felt (No. 21) into 3 sheets and lay onto

Roof as shown in diagram ensuring there

is a 50mm overhang around the sides.

Fix using felt tacks at 100mm intervals.

Felt

tacks

Step 11

Place the Wooden Door Handle (No. 19)

on the outside of the door and use a

60mm screw from the inside to secure.

Pre drill hole rst to avoid splitting.

On the inside of the door opening x the

ply triangle door stop (No. 18) to the

bottom left corner using 3x20mm screws.

3x20mm Screws

1x60mm Screw

Pre drill

hole

20mm

screw 60mm

screw

It is ESSENTIAL that you apply wood

treatment immediately after the building

has been assembled.

13 16

Andere Mercia Garden Products Gartenhaus Handbücher

Mercia Garden Products

Mercia Garden Products 0619LOG015-V5 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01TDM0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03PTMBPN0406STP-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01OVLPA0705SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0634RANE0504FGDD2TW1SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0628CSNE0404HGDD2SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01BEACH-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 02GARA0806-V1-PEFC Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTSHOSBRAX0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products Wessex 03WES1208-V3 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01OSBP0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01PTOSBRA0604SDFW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 0644RANE4535FGDD2TW1SW-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 01DTOVAX1006DDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 06LOG173SG-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 01DTSHAX0406SDFW-V1 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03DTSHAX0608FGD4MW-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 0619PNSH1227FBSD-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 03TGCOR0707-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 05DTOVPN0305DD-V1 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 02DTSHAX0505HGD1W-V1-PEFC Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 02HON51156-V2 Bedienungsanleitung

Mercia Garden Products

Mercia Garden Products 03BRN0705-V4 Gebrauchsanweisung

Mercia Garden Products

Mercia Garden Products 10DTDRK0806-V2 Gebrauchsanweisung

Beliebte Gartenhaus Handbücher anderer Marken

Lemeks

Lemeks Palmako PA120-5930-6 Installationshandbuch

Rion

Rion Hobby Gardener Bedienungsanleitung

Gartenhaus-King

Gartenhaus-King Valery Bedienungsanleitung

Select

Select ISAAC E9682 Bedienungsanleitung

Palmako

Palmako Saale Bedienungsanleitung

Lemeks

Lemeks Palmako Kira EL16-3623 Installationshandbuch

Palmako

Palmako Roger FR44-5953-2 Bedienungsanleitung

Pergola kits USA

Pergola kits USA PREMIUM VINYL PAVILION Bedienungsanleitung

G21

G21 Boston 882 Bedienungsanleitung

Lemeks

Lemeks Palmako Grace PM56-4529 Installationshandbuch

Shire

Shire Salcey Bedienungsanleitung

Rutland County

Rutland County Burley 6ft Bedienungsanleitung

Palmako

Palmako Roger 27,7 Bedienungsanleitung

Lemeks

Lemeks Palmako PA120-5930-9 Installationshandbuch

Lemeks

Lemeks Palmako PM70-6436 Installationshandbuch

Lemeks

Lemeks Palmako PM56-4435 Installationshandbuch

Lemeks

Lemeks 106214 Installationshandbuch

POD

POD Camping 480 Bedienungsanleitung