Microlife XLSC Bedienungsanleitung

Important Product and Safety Information

Follow Instructions for Use. This document provides important

product operation and safety information regarding this blood

pressure monitor replacement cuff. Please read this document

thoroughly before using the component and keep for future

reference.

This blood pressure cuff is a replacement to the cuff included with your

upper arm, Microlife produced, automatic blood pressure monitor. This com-

ponent is only for use with Microlife produced automatic (oscillometric)

blood pressure monitors, by adults, at home or in the doctor’s office.

This replacement blood pressure monitor cuff IS intended to be used:

•As a replacement for your Microlife manufactured, automatic, blood pres-

sure monitor’s cuff.

•Within a home healthcare environment; whereas the person being meas-

ured may be the user/operator.

•With the cuff located upon the user’s upper arm; ½ inch above the elbow

over the artery as indicated on the cuff.

This replacement blood pressure monitor IS NOT intended for use with:

•Blood pressure monitors produced by other manufacturers than Microlife.

•Any body location other than that of the upper arm.

•Users under the age of 12.

WARNING – Potentially hazardous situation that if not avoided

may result in serious injury or death.

•Only use this component as a replacement to the cuff included in your

current Microlife produced, automatic, upper arm, blood pressure monitor.

For blood pressure measurements, continue to follow all instructions that

accompanied your original Microlife produced blood pressure monitor.

•Though not for use with children under 12, ensure that any children

around this component are supervised; some parts are small enough to be

swallowed and any present tubes or cables may provide a risk of strangu-

lation.

•Ensure the cuff tubing is not kinked during use as harmful injury may

occur due to the effect of blood flow interference caused by high pressure

in the cuff not releasing.

DO NOT:



Use this component if you think it is damaged or anything appears unusual.



Open/modify this component; inaccuracy and/or harmful injury may result.



Conduct many frequent measurements as this may result in harmful injury

due to blood flow interference.



Place the cuff over a wound as this may cause further injury.



Place and pressurize the cuff over/near any present intravascular access

or therapy, or arteriovenous shunt, as this may cause blood flow interfer-

ence and result in harmful injury.



Place and pressurize the cuff over a limb near the side of a mastectomy

as this may cause harmful injury.



Use this component on a limb simultaneously with other medical equipment

on the same limb due to possible interference with such medical equipment.



Maintain pressure in the cuff applied to the limb for a prolonged amount

of time. Ensure that circulation in the limb is not impaired by checking cir-

culation if prolonged/repeated exposure to pressure occurs.

CAUTION – Potentially hazardous situation that if not avoided

may result in minor/moderate injury, property damage, and/or

damage to the component

•To avoid inaccurate measurements and to lessen any discomfort from cuff

pressure, ensure the cuff is placed correctly on the limb and fits correctly

when snug (not tight), as indicated by markings on the cuff.

DO NOT:



Use this component outside of its specified operation temperature and

humidity rating, or if stored outside of its specified storage temperature

and humidity rating. Avoid storage in direct sunlight.

STANDARDS:

In addition to the standards stated in the Instruction Manual:

•Clinical Testing per standard ISO 81060-2:2013 was conducted on blood

pressure component using the same measurement technology.

TYPE:

Inflation Mode Technology

EXPECTED LIFE:

Cuff: 2 Years or 10,000 uses (whichever comes first)

XL Blood Pressure Cuff

Instruction Manual

Table of contents

1. Introduction

2. Components of your blood pressure cuff

2.1. Cuff Assembly

2.2. Cuff Assembly & Connector Types

3. Select your connector

4. Applying the cuff

5. Care and maintenance

6. Limited warranty

7. Technical specifications

8. How to contact us

1. Introduction

Thank you for purchasing a Microlife XL cuff. This cuff is suitable for arm cir-

cumferences of 12.6” to 20.5,” and is easy to adapt to most Microlife moni-

tors.

2. Components of your blood pressure cuff

2.1. Cuff

2.2. Cuff Assembly & Connector Types

Cuff Assembly:

Cuff, hose & cuff connector

Cuff hose Cuff

Advanced connector-1

(Blue)

Connector Types:

Advanced connector-2

(Yellow)

Advanced connector-3

(All Black)

Standard connector

3. Select your connector

IMPORTANT: This replacement package includes

multiple connector types. It is critical that the correct

connector be used.

1. Look at your old cuff and connector. Identify the cuff

connector’s shape and color. The connector is used

for plugging the cuff into your monitor, and is locat-

ed at the end of the cuff hose.

2. If your cuff has a standard connector:

a) Find the silver regulatory label (usually located on

the back of your device).

b) Review the label for ANY of the following:

b1. A triangular “IMT” symbol

b2. Any of the model numbers listed below:

c) If any of the conditions are met, use the

standard connector with your new cuff.

d) If you do not meet the conditions in b 1-2,

use the Advanced connector 3 (All Black).

DO NOT USE THE STANDARD CONNECTOR.

3. If your cuff has an advanced connector:

a) Select a new connector matching the tip color of

your current connector (yellow or blue).

Attach the cuff connector to the end of the cuff hose.

5. Connect the new cuff assembly (cuff, hose &

connector) to your Microlife automatic blood

pressure monitor, and ensure the connection fits

snugly. It should not be loose.

6. Once the cuff is properly connected to the monitor,

prepare the cuff for your measurement.

Questions? Contact customer service: 1-800-568-4147

Advanced

connector

Standard

connector

IMT Symbol

• BP3AR1-1PASC

• BP3BM1-3ALDR

• BP3MS1-3BLDR

• BP3MV1-3BHM

• BP3NM1-3WHM

• BP3NM1-3WSMARK

• BP3MV1-3BSMARK

• BP3MV1-3XCVS

• BP3MW1-4YCVS

• BP3NQ1-4BHEB

4. Applying the cuff

•Ensure clothing does not interfere with the

cuff. Remove any tight or bulky items which

might restrict the arm.

•Slide the cuff onto the arm, positioning it as

illustrated, so that the hose is closer to your

lower arm. Make certain that the lower edge

of the cuff lies approximately ½” (1 to 2 cm)

above the elbow and that the hose is closer to

the inner side of the arm.

IMPORTANT: The Artery Mark Indicator must

lie over the brachial artery. The artery is

located closer to the inside of the upper arm

(directly under the front of the armpit).

TIP: Align artery mark to pinky finger (NOT the

center of your arm).

•Tighten the cuff by pulling the end, and secure

the cuff by affixing the hook & loop material.

•Make sure the cuff is tightened correctly. It

should fit the arm snugly, and you should just

be able to slide two fingers between the arm

and the cuff.

•Once the cuff is in position and adjusted,

ensure the “Sizing Seam” marking falls within

the “Size Range” marking. If it does not, the

cuff may not be the correct size for your arm.

•Caution: Incorrect cuff sizing / application:

Incorrect sizing can cause your systolic blood

pressure measurement to swing up or down

by 10 mmHg. Similarly, a cuff that is applied

too loosely or too tightly will result in an inac-

curate reading.

Please contact customer service, or visit our

website, for help determining and obtaining

the correct sized cuff.

Artery

mark Artery

½”

12.6” - 20.5”

Comment:

If it is not possible to fit the cuff to your left arm,

it can also be placed on your right arm.

Using the cuff:

Follow all instructions included with your original

blood pressure monitor when taking a blood

pressure measurement.

Instruction manuals for most monitors produced

by Microlife are available on our website:

www.microlifeusa.com

Cuff on right arm

5. Care and maintenance

•The cuff contains a sensitive airtight bladder. Handle this cuff carefully.

Avoid applying stress which can occur if the cuff and/or hose are twisted

or folded.

Do not pull on the hose.

Keep both away from sharp objects.

•Clean the cuff exterior with a soft, dry cloth. Spots on the cuff can be

removed carefully with a damp cloth and soapsuds. Do not submerge in

water, place in dishwasher, or use chemical cleaning agents/solvents.

•

Do not use the device if you think it is damaged or if anything appears unusual.

6. Limited warranty

Your cuff is warrantied for one year by Microlife USA Inc, against manufac-

turer defects for the original purchaser only, from date of purchase.

The warranty does not apply to consequential and incidental damages, or

damage caused by improper handling, and accidents. Professional use, not

following the operating instructions, and alterations made to the cuff, are

also not included in this warranty. Some states do not allow the exclusion or

limitation of incidental or consequential damages, so the above limitation or

exclusion may not apply to you.

Microlife USA Inc will investigate your concern. A cuff as defined by this

warranty, determined to be out of specification, will be replaced and

shipped to you at no cost. A cuff as defined by this warranty, determined to

be within specification, will be returned to you with a report of findings, at

no cost.

Please use the below customer service contact information to reach

Microlife USA Inc. regarding any warranty concerns. We ask that you please

more quickly process, your concern.

This warranty gives you specific legal rights, and you may also have other

rights which vary from state to state.

7. Technical specifications

Cuff type: . . . . . . . . . . . . . . . . .XL cuff for arms

circumference

12.6” - 20.5,” 32 - 52 cm

Weight: . . . . . . . . . . . . . . . . . .160 g

Storage temperature: . . . . . . .-20 to +55°C (-4° to +131°F)

Operation temperature: . . . . . .10 to 40°C (50° to 104°F)

Operation/storage humidity:

. .15 to 90% relative humidity maximum

Expected service life: . . . . . . . .2 years or 10,000 uses

(whichever first)

Technical alterations reserved.

Made in China

8. How to contact us

Distributed by:

Microlife USA, Inc.

1617 Gulf to Bay Blvd.

Clearwater, FL 33755

Toll Free Help Line: 1-800-568-4147

Email: [email protected]

www.microlifeusa.com

Inhaltsverzeichnis

Sprachen:

Andere Microlife Blutdruckmessgerät Handbücher

Microlife

Microlife BP W100 Bedienungsanleitung

Microlife

Microlife W3 Comfort Bedienungsanleitung

Microlife

Microlife BP A100 Plus Bedienungsanleitung

Microlife

Microlife BP 3AG1 Bedienungsanleitung

Microlife

Microlife AFIB BT Bedienungsanleitung

Microlife

Microlife BP A3 PLUS Bedienungsanleitung

Microlife

Microlife BP AG1-30 Bedienungsanleitung

Microlife

Microlife WatchBP Home Bedienungsanleitung

Microlife

Microlife BP B1 Classic Bedienungsanleitung

Microlife

Microlife BP B2 Basic Bedienungsanleitung

Microlife

Microlife BP AG1-30 Bedienungsanleitung

Microlife

Microlife BP A3 PLUS Bedienungsanleitung

Microlife

Microlife BP B2 Basic Bedienungsanleitung

Microlife

Microlife BP AG1-40 Bedienungsanleitung

Microlife

Microlife WatchBP Home A Bedienungsanleitung

Microlife

Microlife WatchBP Office Targe Bedienungsanleitung

Microlife

Microlife BP A90 Bedienungsanleitung

Microlife

Microlife BP3NC1-1W Bedienungsanleitung

Microlife

Microlife bp3gx1-5x Bedienungsanleitung

Microlife

Microlife BP W2 Slim Bedienungsanleitung

Microlife

Microlife BP B1 Classic Bedienungsanleitung

Microlife

Microlife BP W150 IMT Bedienungsanleitung

Microlife

Microlife BP W90 Bedienungsanleitung

Microlife

Microlife BP AG1-40 Bedienungsanleitung

Beliebte Blutdruckmessgerät Handbücher anderer Marken

Little Doctor

Little Doctor LD7 Bedienungsanleitung

Omron

Omron M6W Handbuch

Mx Onda

Mx Onda MX-CP2395 Bedienungsanleitung

Braun

Braun VitalScan 1 Bedienungsanleitung

Little Doctor

Little Doctor LD-91 Bedienungsanleitung

Sanitas

Sanitas SBM 09 Bedienungsanleitung

A&D

A&D LifeSource UB-328 Bedienungsanleitung

König Electronic

König Electronic HC-BLDPRESS200 Bedienerhandbuch

Leicke

Leicke Sharon Bedienungsanleitung

Omron

Omron M6 Comfort Bedienungsanleitung

3B SCIENTIFIC

3B SCIENTIFIC U11395 Bedienungsanleitung

Soehnle

Soehnle SYSTO MONITOR 100 Bedienungsanleitung

Nasco Healthcare

Nasco Healthcare Simulaids Life/form LF01095U Referenzhandbuch

HoMedics

HoMedics MiBody 360 Bedienungsanleitung

ForaCare

ForaCare FORA P30 Plus Bedienungsanleitung

JOYTECH

JOYTECH DBP-6296B Bedienungsanleitung

Omron

Omron Silver BP5250 Bedienungsanleitung

visomat

visomat double comfort Bedienungsanleitung