Miele CS1326 Y Bedienungsanleitung

Installation Instructions

CS1326 Y en - CA

Installation, repair and maintenance work should be performed by

a Miele authorized service technician in accordance with national

and local safety regulations and the provided installation instructions.

WARNING- When using your

appliance follow basic

precautions, including the

following:

Read all instructions before

installation or use to prevent

injury and appliance damage.

This appliance conforms to all

uniform safety codes and

regulations. The manufacturer

cannot be held responsible for

damage or injury caused by

improper use of this appliance.

Keep these operating instructions

in a safe place and pass them on

to any future user.

SAVE THESE INSTRUCTIONS

Correct usage

~Only use the Tepan Yaki for

residential cooking, and for the

purposes described in this manual.

Other uses are not permitted and can

be dangerous. The manufacturer will

not be held liable for damage caused

by unauthorized use or improper

operation of any kind.

~Persons who lack physical, sensory

or mental abilities, or experience with

the appliance should not use it without

supervision or instruction by a

responsible person.

Children

~Children should not be left

unattended in an area where the

appliance is in use. Never allow

children to sit or stand on any part of

the appliance.

Caution: Do not store items of interest

to children in cabinets above the

appliance. Children climbing on the

appliance to reach these items could

be injured.

~The appliance is hot during use and

remains so for some time after being

switched off. Keep children away from

the appliance.

~Ensure that any packing material, is

disposed of safely and kept out of the

reach of children. Danger of

suffocation!

IMPORTANT SAFETY INSTRUCTIONS

Technical Safety

~Installation, repair and maintenance

work should be performed by a Miele

authorized service technician. Work by

unqualified persons could be

dangerous and may void the warranty.

~Before installing the Tepan Yaki,

check for externally visible damage.

Do not operate a damaged appliance.

~To guarantee the electrical safety of

this appliance, continuity must exist

between the appliance and an effective

grounding system. It is imperative that

this basic safety requirement be met. If

there is any doubt, have the electrical

system of the house checked by a

qualified electrician. The manufacturer

will not be held responsible for

damages caused by the lack, or

inadequacy, of an effective grounding

system.

~Before installation, make sure that

the voltage and frequency listed on the

data plate correspond with the

household electrical supply. This data

must correspond to prevent injury and

appliance damage. Consult a qualified

electrician if in doubt.

~Do not use an extension cord to

connect this appliance to electricity.

Extension cords do not guarantee the

required safety of the appliance.

~Do not use the appliance until it has

been properly installed in the

countertop.

~Install the appliance so that the

power cord does not come into contact

with any portion of the appliance which

may become hot during use.

~Before servicing, disconnect the

appliance from the main power supply.

~Do not operate any appliance with a

damaged cord or plug, or if the

appliance has been damaged in any

manner. Contact Miele’s Technical Ser-

vice Department.

~Under no circumstances open the

outer casing of the appliance.

~While the appliance is under

warranty repairs should only be

performed by an authorized service

technician. Otherwise the warranty is

void.

~In the event of any damage to the

appliance, it must be turned off immedi-

ately and disconnected from the main

power supply. Contact Miele’s

Technical Service Department.

Do not use the appliance until it has

been repaired. Ensure power is not

supplied to the appliance until repair

work is completed.

~Defective components should be

replaced by Miele original spare parts

only. Only with these parts can the

manufacturer guarantee the safety of

the appliance.

IMPORTANT SAFETY INSTRUCTIONS

Safety

~The appliance is hot during use and

remains so for some time after being

switched off. Be careful not to touch the

appliance if it may still be hot.

~Protect your hands with oven mitts

or potholders when using the

appliance. Use only dry, heat resistant

potholders. Moist or damp potholders

used on hot surfaces can result in

steam burns. Do not let the potholder

touch the hot heating elements. Do not

use towels or other bulky items near the

appliance.

~Do not heat unopened containers.

Built-up pressure may cause the

container to burst and result in injury.

~Never use the appliance to heat a

room. Due to the high temperatures

radiated, objects left near the appliance

could catch fire.

~Do not use the appliance until it has

been properly installed in the

countertop.

~Never leave an appliance

unattended at high settings or when

cooking with oil or fat. Overheated oil

could ignite. Always heat oil slowly,

monitoring it as it heats.

~Do not use water on grease fires.

Smother or use a dry chemical or

foam-type extinguisher on any fire or

flame.

~Do not store items on the appliance

when not in use. Items could melt or

catch fire from residual heat or if the

appliance is turned on inadvertently.

~Never cover the appliance with a

cloth. A fire may result.

~Be aware of loose fitting or hanging

garments when operating the

appliance, they may present a fire

hazard.

~Make certain that the power cords of

small appliances do not come in

contact with the appliance. The

insulation of the cable could become

damaged. Danger of electric shock!

~To prevent burns and breathing

difficulty, allow the appliance to cool

before cleaning. Some cleaners may

produce toxic fumes if applied to a hot

surface.

~When wiping spills on a hot

appliance with a wet sponge or cloth,

be careful to avoid steam burns.

~Do not let flammable materials,

i.e. cooking grease, accumulate on the

appliance.

~Do not use a steam cleaner to clean

this appliance. Steam could penetrate

electrical components and cause a

short circuit.

The manufacturer cannot be held

liable for damage caused by

non-compliance with these

Important Safety instructions.

SAVE THESE INSTRUCTIONS

AND REVIEW THEM

PERIODICALLY

IMPORTANT SAFETY INSTRUCTIONS

Note to the installer:

Please leave this instruction book

with the consumer for the local

electrical inspector’s use.

The minimum distances given in

these Installation Instructions must

be observed in order to ensure safe

operation. Failure to do so increases

the risk of fire.

The cabinetry and venting hood

should be installed first to prevent

damage to the appliance.

~The countertop must be bonded

with heat resistant (212 °F/100 °C)

adhesive to prevent distortion or

dissolving.

Any back splashes must be

heat-resistant as well.

~The appliance must not be installed

over a dishwasher, washer, dryer,

refrigerator or freezer. Heat radiated by

the appliance may damage them.

~To eliminate the risk of burns or fire

by reaching over heated surfaces

cabinet storage space above the

appliance should be avoided. If cabinet

storage is necessary, the risk can be

reduced by installing a venting hood to

project horizontally a minimum of 5"

(127 mm) beyond the bottom of the

cabinets.

~This appliance has not been

designed for maritime use or for use in

mobile installations such as recreational

vehicles or aircraft. However, under

certain conditions it may be possible for

installation in these applications. Please

contact the Miele Technical Service

Department with specific requirements.

~The electrical connection should be

arranged in such a way that it remains

easily accessible once the appliance

has been installed.

~You must ensure the power cable

for the appliance will not be subject to

any mechanical strain after installation.

~The appliance must not be

permanently sealed into the countertop

when installed. The sealing strip under

the edge of the appliance provides a

sufficient seal for the countertop. See

"Sealing".

Keep this instruction book in a safe

place for reference and pass it on to

any future user.

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances above the

appliance

The minimum safety distance given by

the hood manufacturer must be

maintained between the cooktop and

the hood above it. See the installation

instructions of the hood for these safety

measurements.

If the hood manufacturers instructions

are not available or if flammable objects

are installed over the cooktop (e.g.

cabinets, utensil rail, etc.), a minimum

safety distance of 30" (760 mm) must

be maintained.

If there is more than one appliance

beneath a hood (e.g. wok burner

and electric cooktop), and they have

different minimum safety distances

always observe the greater

distance.

SAFETY INSTRUCTIONS FOR INSTALLATION

Safety distances to the sides

of the appliance

The appliance should only be installed

as shown in the illustrations, while

maintaining the required safety

distances shown. Do not install the

appliance between two tall cabinets,

this is a fire hazard.

A distance of alteast 2" (50 mm) must

be kept between the countertop cut-out

and the rear wall because of the high

temperatures radiated.

The minimum distance abetween the

worktop cut-out and a wall or tall unit to

the right or left of it is:

2" (50 mm) for CS 1112

CS 1122

CS 1212

CS 1221

CS 1223

CS 1326

CS 1411

6" (150 mm) for CS 1312

CS 1322

CS 1421

10" (250 mm) for CS 1011

CS 1012

CS 1028

recommended

not recommended

not permitted

SAFETY INSTRUCTIONS FOR INSTALLATION

2 " (50 mm)

(50mm)

Safety distance when installing the appliance near a wall with trim or a back

splash

A minimum distance of 2" (50 mm) between the trim or back splash and the

countertop cut-out if required.

This distance is only necessary if these items are made of combustible materials

e.g. wood. If the trim or back splash is made of a non-combustible material, the

required safety distance can be reduced by the thickness of the wall covering

material.

aWall frame

bSheet rock or wall board

cTrim or back splash

dCountertop

eCountertop cut-out

f2" (50 mm) minimum clearance

Installation

Installation dimensions

aSpring clips

bAppliance front

cInstallation height

dPower supply box with connection cable,

L=783/4" (2000 mm)

Installation

Cut out

^Make the worktop cut-out for one or

more appliances as applicable.

Remember to maintain a minimum

safety distance from the back wall,

as well as from any tall unit or side

wall to the right or left of the

appliance(s).

Beliebte Kochfeld Handbücher anderer Marken

Siemens

Siemens EX875KYV1E Technisches Datenblatt

AEG

AEG CERAMIC HOB 6010 K Bedienungsanleitung

VALERA

VALERA CT 70A Bedienungsanleitung

Zanussi

Zanussi ZGF 6420 Bedienungsanleitung

Gaggenau

Gaggenau CI 273 Bedienungsanleitung

G3 Ferrari

G3 Ferrari Energy Bedienungsanleitung

Pkm

Pkm IN4B Bedienungsanleitung

Award

Award H903BG Bedienungsanleitung

Zanussi

Zanussi VCH 5005 RZ Bedienungsanleitung

Hotpoint

Hotpoint IS67V8CCXT/E Bedienungsanleitung

AEG

AEG HK854870XB Bedienungsanleitung

Cookology

Cookology SEP600BK Bedienungsanleitung

Bauknecht

Bauknecht Hob Bedienungsanleitung

Zanussi

Zanussi ZGM 782 Bedienungsanleitung

dipo INDUCTION

dipo INDUCTION DIBK218S Bedienungsanleitung

Blomberg

Blomberg MKN 24201 W Bedienungsanleitung

Progress

Progress PAI3101F Bedienungsanleitung

Hotpoint Ariston

Hotpoint Ariston PKL 641 IX/HA Bedienungsanleitung